Analysis and Experimental Verification of a Fault-Tolerant HEV Powertrain
The DOI matches its Crossref record; 41 of the 41 references it cites were found in a registry or an index.
Abstract
This paper presents a fault-tolerant powertrain topology for series hybrid electric vehicles (SHEVs). The introduction of a redundant phase-leg that is shared by three converters in a standard SHEV powertrain allows us to maximize the reliability improvement with minimal part-count increase. Therefore, the cost increase is kept to minimum as well. The new topology features fast response in fault detection and isolation, and postfault operation at rated power throughput. Two implementations of the fault-tolerant design are presented in conjunction with elaborated discussion of the operating principles, control schemes, and fault diagnostic methods. The substantially improved reliability over standard SHEV powertrains is demonstrated by analysis of the Markov reliability model. Time-domain simulation based on a Saber model has been conducted and the results have verified the feasibility and performance of the proposed SHEV drive system. A scaled-down laboratory prototype has been built and the experimental results further validate the robust fault detection/isolation scheme and uncompromised postfault performance.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
In the citing paper
“Recently, phase redundancy approaches [239], [309] have gained popularity due to their full fault recovery without oversizing the drive.”
From Fault Diagnosis and Fault-Tolerant Control of PMSM Drives–State of the Art and Future Challenges (2022) · cites this paper as [309]
Citations
Cites
Khaligh, A., & Li, Z. (2010) · IEEE Transactions on Vehicular Technology · doi:10.1109/tvt.2010.2047877 · Cited by 1,817
Modern electric, hybrid electric, and fuel cell vehicles fundamentals, theory, and design
Ehsani, M., Gao, Y., & Emadi, A. (2005) · Cited by 1,613
Overview of Permanent-Magnet Brushless Drives for Electric and Hybrid Electric Vehicles
Chau, K. T., Chan, C. C., & Liu, C. (2008) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2008.918403 · Cited by 1,496 · cited 12×
“The reduced reliability of HEVs not only discounts fuel-saving premium, but also increases repair time and repair cost.”
BackgroundInfluentialSurvey on Reliability of Power Electronic Systems
Song, Y., & Wang, B. (2013) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2012.2192503 · Cited by 861 · cited 1×
“In fact, aggregation of many power electronic devices into drive systems of vehicles may adversely affect reliability of the overall system [16], [17].”
BackgroundSelf-citationWelchko, B. A., Lipo, T. A., Jahns, T. M., & Schulz, S. E. (2004) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2004.830074 · Cited by 724 · cited 1×
“Based on performance metrics proposed in [35], the new topology can obtain the post-”
BackgroundSystem Reliability Theory: Models, Statistical Methods, and Applications
Rausand, M., & Høyland, A. (1994) · Wiley Series in Probability and Statistics · doi:10.1002/9780470316900 · Cited by 674
Modeling and Control of a Power-Split Hybrid Vehicle
Liu, J., & Peng, H. (2008) · IEEE Transactions on Control Systems Technology · doi:10.1109/tcst.2008.919447 · Cited by 662 · cited 1×
“ment [9]–[12], and control in the system level [13]–[15], while significantly less attention has been devoted to the reliability and fault mitigation of HEVs’ powertrains.”
BackgroundHegazy, O., Mierlo, J. V., & Lataire, P. (2012) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2012.2183148 · Cited by 394 · cited 1×
“A literature survey conducted by the authors of this paper suggests that major research effort has been focused on power electronic converter topologies [2]–[7], design and control of traction motors related to HEVs [8], energy storage unit and energy manage-”
BackgroundInvestigation of fault modes of voltage-fed inverter system for induction motor drive
Kastha, D., & Bose, B. K. (1994) · IEEE Transactions on Industry Applications · doi:10.1109/28.297920 · Cited by 386
Experimental fault-tolerant control of a PMSM drive
Bolognani, S., Zordan, M., & Zigliotto, M. (2000) · IEEE Transactions on Industrial Electronics · doi:10.1109/41.873223 · Cited by 382
Research works printed but not linked: 1
- hoyland, 1994, System Reliability Theory
Cited by
Survey on Fault-Tolerant Techniques for Power Electronic Converters
Zhang, W., Xu, D., Enjeti, P. N., Li, H., Hawke, J. T., & Krishnamoorthy, H. S. (2014) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2014.2304561 · Cited by 587
“I. INTRODUCTION POWER electronic converters—featuring higher efficiencyand higher power density—play an increasingly important role in adjustable-speed drives, utility interface of renewable energy resources, flexible high-voltage direct current (HVDC) transmission systems, and electric or hybrid electric vehicles (HE…”
BackgroundMethodFault Diagnosis and Fault-Tolerant Control of PMSM Drives–State of the Art and Future Challenges
Orlowska-Kowalska, T., Wolkiewicz, M., Pietrzak, P., Skowron, M., Ewert, P., Tarchala, G., Krzysztofiak, M., & Kowalski, C. T. (2022) · IEEE Access · doi:10.1109/access.2022.3180153 · Cited by 328
Reliability Improvement of a T-Type Three-Level Inverter With Fault-Tolerant Control Strategy
Choi, U.-M., Blaabjerg, F., & Lee, K.-B. (2015) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2014.2325891 · Cited by 258
“The fault-tolerant methods using an additional leg have also been proposed in many papers [8], [10], [14], [15].”
MethodModel-Based Fault Detection and Identification for Switching Power Converters
Poon, J., Jain, P., Konstantakopoulos, I. C., Spanos, C., Panda, S. K., & Sanders, S. R. (2017) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2016.2541342 · Cited by 257
Review on fault‐diagnosis and fault‐tolerance for DC–DC converters
Kumar, G. K., & Elangovan, D. (2019) · IET Power Electronics · doi:10.1049/iet-pel.2019.0672 · Cited by 156
Metadata
- Authors
- Song, Y., & Wang, B.
- Affiliations
- Michigan State University (US)
- ORCID
- Wang, Bingsen
- Venue
- IEEE Transactions on Power Electronics
- Published
- 2013-12
- Volume
- 28
- Issue
- 12
- Pages
- 5854-5864
- ISSN
- 0885-8993 (ISSN-L)
- 1941-0107
- OpenAlex
- W2001075346
- Cited by
- 81
- References
- 41
- Citations by year
- 2025: 2 · 2024: 6 · 2023: 3 · 2022: 12 · 2021: 5 · 2020: 9 · 2019: 8 · 2018: 6 · 2017: 8 · 2016: 8 · 2015: 5 · 2014: 8 · 2013: 1
- FWCI
- 11.42
- Type
- journal article
- Language
- en
- Open access
- closed
- Licence
- Locations
- IEEE Transactions on Power Electronics (publishedVersion)
- Topics
- Physical Sciences › Engineering › Automotive Engineering › Electric and Hybrid Vehicle Technologies
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Multilevel Inverters and Converters
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Advanced DC-DC Converters
- Keywords
- series hybrid electric vehicle, converter redundancy, fault detection and isolation, Markov reliability model, fault diagnosis
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Analysis and Experimental Verification of a Fault-Tolerant HEV Powertrain. https://app.cochat.ai/papers/10.1109/tpel.2013.2245513
- The paper
- Song, Y., & Wang, B. (2013). Analysis and Experimental Verification of a Fault-Tolerant HEV Powertrain. IEEE Transactions on Power Electronics. https://doi.org/10.1109/tpel.2013.2245513
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.