A Physical RC Network Model for Electrothermal Analysis of a Multichip SiC Power Module
Open accessThe DOI matches its Crossref record; 35 of the 38 references it cites were found in a registry or an index.
Abstract
This paper is concerned with the thermal models which can physically reflect the heat-flow paths in a lightweight three-phase half-bridge two-level SiC power module with six MOSFETs and can be used for coupled electrothermal simulation. The finite-element (FE) model was first evaluated and calibrated to provide the raw data for establishing the physical resistor-capacitor (RC) network model. It was experimentally verified that the cooling condition of the module mounted on a water cooler can be satisfactorily described by assuming the water cooler as a heat exchange boundary in the FE model. The compact RC network consisting of 115 R and C parameters to predict the transient junction temperatures of the six MOSFETS was constructed, where cross-heating effects between the MOSFETs are represented with lateral thermal resistors. A three-step curve fitting method was especially developed to overcome the challenge for extracting the R and C values of the RC network from the selected FE simulation results. The established compact RC network model can physically be correlated with the structure and heat-flow paths in the power module, and was evaluated using the FE simulation results from the power module under realistic switching conditions. It was also integrated into the LTspice model to perform the coupled electrothermal simulation to predict the power losses and junction temperatures of the six MOSFETs under switching frequencies from 5 to 100 kHz which demonstrate the good electrothermal performance of the designed power module.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
In the citing paper
“Analytical methods such as coupled electro-thermal analysis, lumped thermal models (LTM), and the finite element method (FEM) are used to predict T j and identify hotspots [64,68-70].”
From Thermal Management of Wide-Bandgap Power Semiconductors: Strategies and Challenges in SiC and GaN Power Devices (2025) · cites this paper as [69]
In the citing paper
“In electro-thermal simulations, FEM-derived compact RC electro-thermal network models predict T j dynamics and support RUL assessment [68,69,78].”
From Thermal Management of Wide-Bandgap Power Semiconductors: Strategies and Challenges in SiC and GaN Power Devices (2025) · cites this paper as [69]
Citations
Cites
Ma, K., Liserre, M., Blaabjerg, F., & Kerekes, T. (2015) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2014.2312335 · Cited by 460
Fine structure of heat flow path in semiconductor devices: A measurement and identification method
Székely, V., & Van Bien, T. (1988) · Solid-State Electronics · doi:10.1016/0038-1101(88)90099-8 · Cited by 438
Real-Time Compact Thermal Models for Health Management of Power Electronics
Musallam, M., & Johnson, C. M. (2010) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2010.2040634 · Cited by 196
Self-citationThermal component model for electrothermal analysis of IGBT module systems
Yun, C.-S., Malberti, P., Ciappa, M., & Fichtner, W. (2001) · IEEE Transactions on Advanced Packaging · doi:10.1109/6040.938309 · Cited by 153
Simulating the dynamic electrothermal behavior of power electronic circuits and systems
Hefner, A. R., & Blackburn, D. L. (1993) · IEEE Transactions on Power Electronics · doi:10.1109/63.261007 · Cited by 148
Power Electronic Modules: Design and Manufacture
Sheng, W. W., & Colino, R. P. (2004) · Thammasat University Digital Collections · Cited by 141
Hsu, J. T., & Vu‐Quoc, L. (1996) · IEEE Transactions on Circuits and Systems I Fundamental Theory and Applications · doi:10.1109/81.536742 · Cited by 136
Combination of thermal subsystems modeled by rapid circuit transformation
Gerstenmaier, Y. C., Kiffe, W., & Wachutka, G. (2007) · 2007 13th International Workshop on Thermal Investigation of ICs and Systems (THERMINIC) · doi:10.1109/therminic.2007.4451758 · Cited by 103
Swan, I., Bryant, A., Mawby, P. A., Ueta, T., Nishijima, T., & Hamada, K. (2012) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2011.2148730 · Cited by 87
Reichl, J., Ortiz-Rodriguez, J. M., Hefner, A. R., & Lai, J. (2014) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2014.2338278 · Cited by 84
Research works printed but not linked: 6
- 2011, Datasheet CPMF-1200-S080B SiC MOSFET N-Channel Enhancement Mode Bare Die Cree Inc
- zahn, 0, Comprehensive solder fatigue and thermal characterization of a silicon based multichip module package utilizing finite element analysis, Proc 9th Int ANSYS Conf Exhib, 1
- 2006, AP16097 XC164 Different PWM Waveforms Generation for 3-Phase AC Induction Motor With XC164CS Application Note V1 0 Infineon Technologies
- 2008, CPS AlSiC Composites C T Corporation
- sofia, 1995, Fundamentals of thermal resistance measurement, Analogic Tech, 1
- bryant, 0, Validation of a fast loss and temperature simulation method for power converters, Proc 2010 IEEE 6th Int Conf on Integr Power Electron Syst, 27, 1
Cited by
Evaluation of Aging's Effect on Temperature-Sensitive Electrical Parameters in SiC mosfets
Yang, F., Ugur, E., & Akin, B. (2020) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2019.2950311 · Cited by 121
Ma, M., Guo, W., Yan, X., Yang, S., Zhang, X., Chen, W., & Cai, G. (2020) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2020.2991926 · Cited by 119
Yang, X., Heng, K., Dai, X., Wu, X., & Liu, G. (2021) · IEEE Journal of Emerging and Selected Topics in Power Electronics · doi:10.1109/jestpe.2021.3128017 · Cited by 86
Chen, M., Wang, H., Pan, D., Wang, X., & Blaabjerg, F. (2020) · IEEE Journal of Emerging and Selected Topics in Power Electronics · doi:10.1109/jestpe.2020.2984586 · Cited by 83
Graphite-Embedded High-Performance Insulated Metal Substrate for Wide-Bandgap Power Modules
Gurpinar, E., Chowdhury, S., Ozpineci, B., & Fan, W. (2020) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2020.3001528 · Cited by 74
Self-citation
Metadata
- Authors
- Li, J., Castellazzi, A., Eleffendi, M. A., Gurpinar, E., Johnson, C. M., & Mills, L.
- Affiliations
- University of Nottingham (GB)
- Semelab (United Kingdom) (GB)
- Venue
- IEEE Transactions on Power Electronics
- Published
- 2018-03
- Volume
- 33
- Issue
- 3
- Pages
- 2494-2508
- ISSN
- 0885-8993 (ISSN-L)
- 1941-0107
- OpenAlex
- W2608241360
- Cited by
- 105
- References
- 38
- Citations by year
- 2026: 14 · 2025: 14 · 2024: 16 · 2023: 10 · 2022: 10 · 2021: 7 · 2020: 16 · 2019: 13 · 2018: 5
- FWCI
- 3.87
- Type
- journal article
- Language
- en
- Open access
- Locations
- IEEE Transactions on Power Electronics (publishedVersion)
- Nottingham ePrints (University of Nottingham) (submittedVersion)
- Repository@Nottingham (University of Nottingham) (submittedVersion, cc-by)
- Funders
- European Union Clean Sky JTI Program for the Robust Silicon Carbide Technology for Aerospace DC–DC Conversion Project
- Topics
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Silicon Carbide Semiconductor Technologies
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Advanced DC-DC Converters
- Physical Sciences › Engineering › Mechanical Engineering › Heat Transfer and Optimization
- Keywords
- SiC power modules, electro-thermal simulation, RC network model, thermal modeling, water cooling, transient thermal analysis, curve fitting, power losses, switching frequency
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: A Physical RC Network Model for Electrothermal Analysis of a Multichip SiC Power Module. https://app.cochat.ai/papers/10.1109/tpel.2017.2697959
- The paper
- Li, J., Castellazzi, A., Eleffendi, M. A., Gurpinar, E., Johnson, C. M., & Mills, L. (2018). A Physical RC Network Model for Electrothermal Analysis of a Multichip SiC Power Module. IEEE Transactions on Power Electronics. https://doi.org/10.1109/tpel.2017.2697959
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.