The DOI matches its Crossref record; 3 of the 3 references it cites were found in a registry or an index.
High-Performance SAW Resonator on New Multilayered Substrate Using LiTaO3Crystal
Abstract
To develop the high-performance filters and duplexers required for recent long-term evolution frequency bands in mobile handsets, a surface acoustic wave (SAW) resonator is needed that has a higher quality (Q) and a lower temperature coefficient of frequency (TCF). To achieve this, the authors focused on acoustic energy confinement in the depth direction for a rotated Y-X LiTaO3(LT) substrate. Characteristics of multilayered substrates with low-impedance and high-impedance layers under LT layer were studied numerically in terms of acoustic energy distribution, phase velocity, coupling coefficient, and temperature characteristics employing a finite-element method simulation. After several calculations, a novel multilayered structure was developed that uses SiO2for a low-impedance layer and AlN for a high-impedance layer under the thin LT layer. A one-port resonator using the new substrate was fabricated, and its experimental results showed that the developed resonator had a Bode-Q over 4000 and TCF of -8 ppm/°C, which are four times higher than and one-fifth as small as those of a conventional 4° YX-LT SAW resonator, respectively. By applying this technology, a band 25 duplexer with very narrow duplex gap was successfully developed, which shows extremely low insertion loss, steep cutoff characteristics, and stable temperature characteristics.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Surface Acoustic Wave Devices in Telecommunications
Hashimoto, K. (2000) · Springer eBooks · doi:10.1007/978-3-662-04223-6 · Cited by 709
After 60 years: A new formula for computing quality factor is warranted
Feld, D. A., Parker, R., Ruby, R., Bradley, P., & Dong, S. (2008) · 2008 IEEE Ultrasonics Symposium · doi:10.1109/ultsym.2008.0105 · Cited by 301
Analysis of Rayleigh wave radiations from leaky SAW resonators
Inoue, S., Nakamura, K., Nakazawa, H., et al. (2013) · IEEE International Ultrasonics Symposium · doi:10.1109/ultsym.2013.0498 · Cited by 14
Cited by
The 2019 surface acoustic waves roadmap
Delsing, P., Cleland, A. N., Schuetz, M. J. A., Knörzer, J., Giedke, G., Cirac, J. I., Srinivasan, K., Wu, M., Balram, K. C., Bäuerle, C., et al. (2019) · Journal of Physics D: Applied Physics · doi:10.1088/1361-6463/ab1b04 · Cited by 396
Yan, Y., Huang, K., Zhou, H., Zhao, X., Li, W., Li, Z., Yi, A., Huang, H., Lin, J., Zhang, S., et al. (2019) · ACS Applied Electronic Materials · doi:10.1021/acsaelm.9b00351 · Cited by 83
Suppression of Transverse Modes in 50°YX-LiTaO3/SiO2/Si POI SAW Resonator with Groove Configuration
Li, M., Qi, M., Chen, Y., Cheng, Y., Cao, L., & Mu, X. (2024) · ACS Applied Materials & Interfaces · doi:10.1021/acsami.4c07223 · Cited by 6
Metadata
- Authors
- Takai, T., Iwamoto, H., Takamine, Y., Yamazaki, H., Fuyutsume, T., Kyoya, H., Nakao, T., Kando, H., Hiramoto, M., Toi, T., Koshino, M., & Nakajima, N.
- Venue
- IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control
- Published
- 2017-09
- Volume
- 64
- Issue
- 9
- Pages
- 1382-1389
- ISSN
- 0885-3010 (ISSN-L)
- OpenAlex
- W2743983656
- Cited by
- 280
- References
- 3
- FWCI
- 6.52
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: High-Performance SAW Resonator on New Multilayered Substrate Using LiTaO3Crystal. https://app.cochat.ai/papers/10.1109/tuffc.2017.2738119
- The paper
- Takai, T., Iwamoto, H., Takamine, Y., Yamazaki, H., Fuyutsume, T., Kyoya, H., Nakao, T., Kando, H., Hiramoto, M., Toi, T., Koshino, M., & Nakajima, N. (2017). High-Performance SAW Resonator on New Multilayered Substrate Using LiTaO3Crystal. IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control. https://doi.org/10.1109/tuffc.2017.2738119
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.