The DOI matches its Crossref record; 37 of the 37 references it cites were found in a registry or an index.
Heat Transfer in Microchannels—2012 Status and Research Needs
Abstract
Heat transfer and fluid flow in microchannels have been topics of intense research in the past decade. A critical review of the current state of research is presented with a focus on the future research needs. After providing a brief introduction, the paper addresses six topics related to transport phenomena in microchannels: single-phase gas flow, enhancement in single-phase liquid flow and flow boiling, flow boiling instability, condensation, electronics cooling, and microscale heat exchangers. After reviewing the current status, future research directions are suggested. Concerning gas phase convective heat transfer in microchannels, the antagonist role played by the slip velocity and the temperature jump that appear at the wall are now clearly understood and quantified. It has also been demonstrated that the shear work due to the slipping fluid increases the effect of viscous heating on heat transfer. On the other hand, very few experiments support the theoretical models and a significant effort should be made in this direction, especially for measurement of temperature fields within the gas in microchannels, implementing promising recent techniques such as molecular tagging thermometry (MTT). The single-phase liquid flow in microchannels has been established to behave similar to the macroscale flows. The current need is in the area of further enhancing the performance. Progress on implementation of flow boiling in microchannels is facing challenges due to its lower heat transfer coefficients and critical heat flux (CHF) limits. An immediate need for breakthrough research related to these two areas is identified. Discussion about passive and active methods to suppress flow boiling instabilities is presented. Future research focus on instability research is suggested on developing active closed loop feedback control methods, extending current models to better predict and enable superior control of flow instabilities. Innovative high-speed visualization and measurement techniques have led to microchannel condensation now being studied as a unique process with its own governing influences. Further work is required to develop widely applicable flow regime maps that can address many fluid types and geometries. With this, condensation heat transfer models can progress from primarily annular flow based models with some adjustments using dimensionless parameters to those that can directly account for transport in intermittent and other flows, and the varying influences of tube shape, surface tension and fluid property differences over much larger ranges than currently possible. Electronics cooling continues to be the main driver for improving thermal transport processes in microchannels, while efforts are warranted to develop high performance heat exchangers with microscale passages. Specific areas related to enhancement, novel configurations, nanostructures and practical implementation are expected to be the research focus in the coming years.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
High-performance heat sinking for VLSI
Tuckerman, D. B., & Pease, R. F. W. (1981) · IEEE Electron Device Letters · doi:10.1109/edl.1981.25367 · Cited by 5,291
Self-citationHeat transfer characteristics of nanofluids: a review
Wang, X.-Q., & Mujumdar, A. S. (2007) · International Journal of Thermal Sciences · doi:10.1016/j.ijthermalsci.2006.06.010 · Cited by 2,151
Fundamental issues related to flow boiling in minichannels and microchannels
Kandlikar, S. G. (2002) · Experimental Thermal and Fluid Science · doi:10.1016/s0894-1777(02)00150-4 · Cited by 1,006
Self-citationEvolution of Microchannel Flow Passages--Thermohydraulic Performance and Fabrication Technology
Kandlikar, S. G., & Grande, W. J. (2003) · Heat Transfer Engineering · doi:10.1080/01457630304040 · Cited by 960
Self-citationImproved Friction Pressure Drop Correlation for Horizontal and Vertical Two-Phase Pipe Flow
Friedel, L. (1979) · Cited by 948
Single-phase convective heat transfer in microchannels: a review of experimental results
Morini, G. L. (2004) · International Journal of Thermal Sciences · doi:10.1016/j.ijthermalsci.2004.01.003 · Cited by 679
Condensation in Horizontal Smooth Tubes: A New Heat Transfer Model for Heat Exchanger Design
Cavallini, A., Col, D. D., Doretti, L., Matkovic, M., Rossetto, L., Zilio, C., & Censi, G. (2006) · Heat Transfer Engineering · doi:10.1080/01457630600793970 · Cited by 546
High flux boiling in low flow rate, low pressure drop mini-channel and micro-channel heat sinks
Bowers, M. B., & Mudawar, I. (1994) · International Journal of Heat and Mass Transfer · doi:10.1016/0017-9310(94)90103-1 · Cited by 483
A COMPARATIVE ANALYSIS OF STUDIES ON HEAT TRANSFER AND FLUID FLOW IN MICROCHANNELS
Sobhan, C. B., & Garimella, S. V. (2001) · Microscale Thermophysical Engineering · doi:10.1080/10893950152646759 · Cited by 400
Self-citationKandlikar, S. G. (2012) · Journal of Heat Transfer · doi:10.1115/1.4005126 · Cited by 389
Self-citation
Cited by
A critical review of traditional and emerging techniques and fluids for electronics cooling
Sohel Murshed, S. M., & Nieto de Castro, C. A. (2017) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2017.04.112 · Cited by 987
Review of micro- and mini-channel heat sinks and heat exchangers for single phase fluids
Dixit, T., & Ghosh, I. (2015) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2014.09.024 · Cited by 339
Dropwise Condensation on Micro- and Nanostructured Surfaces
Enright, R., Miljkovic, N., Alvarado, J. L., Kim, K., & Rose, J. W. (2014) · Nanoscale and Microscale Thermophysical Engineering · doi:10.1080/15567265.2013.862889 · Cited by 278
Andhare, R. S., Shooshtari, A., Dessiatoun, S. V., & Ohadi, M. M. (2016) · Applied Thermal Engineering · doi:10.1016/j.applthermaleng.2015.10.133 · Cited by 106
The role of microchannel geometry selection on heat transfer enhancement in heat sinks: A review
Dash, B., Nanda, J., & Rout, S. K. (2022) · Heat Transfer · doi:10.1002/htj.22357 · Cited by 41
Metadata
- Authors
- Kandlikar, S. G., Colin, S., Peles, Y., Garimella, S., Pease, R. F., Brandner, J. J., & Tuckerman, D. B.
- Venue
- Journal of Heat Transfer
- Publisher
- ASME International
- Published
- 2013-07-26
- Volume
- 135
- Issue
- 9
- ISSN
- 0022-1481 (ISSN-L)
- 1528-8943
- OpenAlex
- W2012055589
- Cited by
- 285
- References
- 37
- FWCI
- 30.55
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Heat Transfer in Microchannels—2012 Status and Research Needs. https://app.cochat.ai/papers/10.1115/1.4024354
- The paper
- Kandlikar, S. G., Colin, S., Peles, Y., Garimella, S., Pease, R. F., Brandner, J. J., & Tuckerman, D. B. (2013). Heat Transfer in Microchannels—2012 Status and Research Needs. Journal of Heat Transfer. https://doi.org/10.1115/1.4024354
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.