The DOI matches its Crossref record.
Anisotropic Etching of Crystalline Silicon in Alkaline Solutions: II . Influence of Dopants
Abstract
The etching behavior of highly boron doped silicon in aqueous solutions based of ethylenediamine, KOH , NaOH , and LiOH was studied. For all etchants, a strong reduction of the etch rate for boron concentrations exceeding approximately 2 · 10 19 cm − 3 was observed. This value is in good agreement with published data for the onset of degeneracy of p‐type silicon. The reduction of the etch rate was found to be inversely proportional to the fourth power of the boron concentration. For a given high boron concentration, the etch stop effect was found to be most effective for ethylenediamine‐based solutions and low concentration KOH and least effective for highly concentrated KOH . On the basis of these results, a model is proposed attributing the etch stop phenomenon to electrical effects of holes rather than chemical effects of boron. Due to the high dopant concentration the width of the space charge layer on the silicon surface shrinks drastically. Therefore, electrons injected into the conduction band by an oxidation reaction cannot be confined to the surface and rapidly recombine with holes from the valence band. The lack of these electrons impedes the reduction of water and thereby the formation of new hydroxide ions at the silicon surface. Since the transfer of four electrons is required for the dissolution of one silicon atom the observed fourth power law for the decrease of the etch rate can be explained. The reduction of the etch rate on silicon doped with germanium or phosphorus is much smaller and follows a different mechanism.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
Etch rates for micromachining processing-part II
Williams, K. R., Gupta, K., & Wasilik, M. (2003) · Journal of Microelectromechanical Systems · doi:10.1109/jmems.2003.820936 · Cited by 1,027
Bulk micromachining of silicon
Kovacs, G. T. A., Maluf, N. I., & Petersen, K. E. (1998) · Proceedings of the IEEE · doi:10.1109/5.704259 · Cited by 733
Etch rates for micromachining processing
Williams, K. R., & Muller, R. S. (1996) · Journal of Microelectromechanical Systems · doi:10.1109/84.546406 · Cited by 646
Dissolvable Metals for Transient Electronics
Yin, L., Cheng, H., Mao, S., Haasch, R., Liu, Y., Xie, X., Hwang, S., Jain, H., Kang, S., Su, Y., et al. (2014) · Advanced Functional Materials · doi:10.1002/adfm.201301847 · Cited by 487
Enabling Silicon for Solar-Fuel Production
Sun, K., Shen, S., Liang, Y., Burrows, P. E., Mao, S. S., & Wang, D. (2014) · Chemical Reviews · doi:10.1021/cr300459q · Cited by 393
Microfabrication in Biology and Medicine
Voldman, J., Gray, M. L., & Schmidt, M. A. (1999) · Annual Review of Biomedical Engineering · doi:10.1146/annurev.bioeng.1.1.401 · Cited by 344
Microfabricated Microneedles for Gene and Drug Delivery
McAllister, D. V., Allen, M. G., & Prausnitz, M. R. (2000) · Annual Review of Biomedical Engineering · doi:10.1146/annurev.bioeng.2.1.289 · Cited by 335
Materials and Fabrication Processes for Transient and Bioresorbable High‐Performance Electronics
Hwang, S., Kim, D., Tao, H., Kim, T., Kim, S., Yu, K. J., Panilaitis, B., Jeong, J., Song, J., Omenetto, F. G., et al. (2013) · Advanced Functional Materials · doi:10.1002/adfm.201300127 · Cited by 256
Conductively coupled flexible silicon electronic systems for chronic neural electrophysiology
Li, J., Song, E., Chiang, C.-H., Yu, K. J., Koo, J., Du, H., Zhong, Y., Hill, M., Wang, C., Zhang, J., et al. (2018) · Proceedings of the National Academy of Sciences · doi:10.1073/pnas.1813187115 · Cited by 65
Metadata
- Authors
- Seidel, H., Csepregi, L., Heuberger, A., & Baumgärtel, H.
- Venue
- Journal of The Electrochemical Society
- Publisher
- The Electrochemical Society
- Published
- 1990-11-01
- Volume
- 137
- Issue
- 11
- Pages
- 3626-3632
- ISSN
- 0013-4651 (ISSN-L)
- 1945-7111
- OpenAlex
- W1568890842
- Cited by
- 385
- References
- 0
- FWCI
- 5.24
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.