The DOI matches its Crossref record; 31 of the 31 references it cites were found in a registry or an index.
Experimental Analysis of Thermal Runaway and Propagation in Lithium-Ion Battery Modules
Open accessAbstract
While the energy and power density of lithium-ion batteries (LIBs) are steadily improving, thermal safety continues to remain a critical challenge. Under abuse conditions, exothermic reactions may lead to the release of heat that can trigger subsequent unsafe reactions. The situation worsens in a module configuration, as the released heat from an abused cell can activate a chain of reactions in the neighboring cells, causing catastrophic thermal runaway. This work focuses on experimental elucidation and analysis of different LIB module configurations to characterize the thermal behavior and determine safe practices. The abuse test consists of a heat-to-vent setting where a single cell in a module is triggered into thermal runaway via a heating element. The cell-to-cell thermal runaway propagation behavior has been characterized. Results have shown that increasing the inter-cell spacing in a module containing cylindrical cells significantly decreases the probability of thermal runaway propagation. Additionally, it was determined that appropriate tab configuration combined with cell form factors exhibit a major influence on thermal runaway propagation. Different thermal insulation materials have been analyzed to determine their ability to ameliorate and/or potentially mitigate propagation effects.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Fundamentals of heat and mass transfer
Hewitt, G. F. (2008) · Begellhouse eBooks · Cited by 12,932
Fundamentals of Heat and Mass Transfer
Incropera, F. P. (1985) · Cited by 3,677
Thermal runaway caused fire and explosion of lithium ion battery
Wang, Q., Ping, P., Zhao, X., Chu, G., Sun, J., & Chen, C. (2012) · Journal of Power Sources · doi:10.1016/j.jpowsour.2012.02.038 · Cited by 3,103
A critical review of thermal issues in lithium-ion batteries
Bandhauer, T. M., Garimella, S., & Fuller, T. F. (2011) · Journal of The Electrochemical Society · doi:10.1149/1.3515880 · Cited by 2,192
Abuse behavior of high-power, lithium-ion cells
Spotnitz, R., & Franklin, J. (2003) · Journal of Power Sources · doi:10.1016/s0378-7753(02)00488-3 · Cited by 1,373
Safety mechanisms in lithium-ion batteries
Balakrishnan, P. G., Ramesh, R., & Prem Kumar, T. (2006) · Journal of Power Sources · doi:10.1016/j.jpowsour.2005.12.002 · Cited by 1,132
(1998) · Wiley eBooks · doi:10.1002/9783527611676 · Cited by 972
(2010) · Cited by 909
A three-dimensional thermal abuse model for lithium-ion cells
Kim, G.-H., Pesaran, A., & Spotnitz, R. (2007) · Journal of Power Sources · doi:10.1016/j.jpowsour.2007.04.018 · Cited by 877
Thermal Model of Cylindrical and Prismatic Lithium-Ion Cells
Hatchard, T. D., MacNeil, D. D., Basu, A., & Dahn, J. R. (2001) · Journal of The Electrochemical Society · doi:10.1149/1.1377592 · Cited by 624
A General Discussion of Li Ion Battery Safety
(2012) · Electrochemical Society Interface · doi:10.1149/2.f03122if · Cited by 592
Investigation on the fire-induced hazards of Li-ion battery cells by fire calorimetry
Ribière, P., Grugeon, S., Morcrette, M., Boyanov, S., Laruelle, S., & Marlair, G. (2012) · Energy Environ. Sci. · doi:10.1039/c1ee02218k · Cited by 505
Thermal Stability Studies of Li‐Ion Cells and Components
Maleki, H., Deng, G., Anani, A., & Howard, J. (1999) · Journal of The Electrochemical Society · doi:10.1149/1.1392458 · Cited by 437
Multi-Domain Modeling of Lithium-Ion Batteries Encompassing Multi-Physics in Varied Length Scales
Kim, G.-H., Smith, K., Lee, K.-J., Santhanagopalan, S., & Pesaran, A. (2011) · Journal of The Electrochemical Society · doi:10.1149/1.3597614 · Cited by 431
Study on preparation and fire-retardant mechanism analysis of intumescent flame-retardant coatings
Gu, J., Zhang, G.-C., Dong, S.-L., Zhang, Q., & Kong, J. (2007) · Surface and Coatings Technology · doi:10.1016/j.surfcoat.2007.03.020 · Cited by 413
Overcharge reaction of lithium-ion batteries
Ohsaki, T., Kishi, T., Kuboki, T., Takami, N., Shimura, N., Sato, Y., Sekino, M., & Satoh, A. (2005) · Journal of Power Sources · doi:10.1016/j.jpowsour.2005.03.105 · Cited by 382
PA-6 clay nanocomposite hybrid as char forming agent in intumescent formulations
Bourbigot, S., Bras, M. L., Dabrowski, F., Gilman, J. W., & Kashiwagi, T. (2000) · Fire and Materials · doi:10.1002/1099-1018(200007/08)24:4<201::aid-fam739>3.0.co;2-d · Cited by 324
Yang, H., Bang, H., Amine, K., & Prakash, J. (2005) · Journal of The Electrochemical Society · doi:10.1149/1.1836126 · Cited by 270
Thermal abuse performance of high-power 18650 Li-ion cells
Roth, E. P., & Doughty, D. H. (2004) · Journal of Power Sources · doi:10.1016/j.jpowsour.2003.09.068 · Cited by 270
Flame-retardant additives for lithium-ion batteries
Hyung, Y. E., Vissers, D. R., & Amine, K. (2003) · Journal of Power Sources · doi:10.1016/s0378-7753(03)00225-8 · Cited by 253
Jhu, C.-Y., Wang, Y.-W., Wen, C.-Y., & Shu, C. (2012) · Applied Energy · doi:10.1016/j.apenergy.2012.05.064 · Cited by 230
Modeling Nail Penetration Process in Large-Format Li-Ion Cells
Zhao, W., Luo, G., & Wang, C.-Y. (2015) · Journal of The Electrochemical Society · doi:10.1149/2.1071501jes · Cited by 187
Kandola, B. K., & Horrocks, A. R. (1996) · Polymer Degradation and Stability · doi:10.1016/s0141-3910(96)00054-7 · Cited by 176
Effects of additives on thermal stability of Li ion cells
Doughty, D. H., Roth, E. P., Crafts, C. C., Nagasubramanian, G., Henriksen, G. L., & Amine, K. (2005) · Journal of Power Sources · doi:10.1016/j.jpowsour.2005.03.170 · Cited by 148
Tobishima, S., Takei, K., Sakurai, Y., & Yamaki, J. (2000) · Journal of Power Sources · doi:10.1016/s0378-7753(00)00409-2 · Cited by 144
Vehicle Battery Safety Roadmap Guidance
USDOE Office of Energy Efficiency and Renewable Energy (EERE), O. O. S. T. V. T. O. (., & Doughty, D. H. (2012) · doi:10.2172/1055366 · Cited by 137
Thermal/electrical modeling for abuse-tolerant design of lithium ion modules
Smith, K. A., Kim, G., Darcy, E. C., & Pesaran, A. A. (2009) · International Journal of Energy Research · doi:10.1002/er.1666 · Cited by 132
Investigation of the kinetic mechanism in overcharge process for Li-ion battery
Belov, D. G., & Yang, M. (2008) · Solid State Ionics · doi:10.1016/j.ssi.2008.04.031 · Cited by 114
Thermal runaway inhibitors for lithium battery electrolytes
Mandal, B. K., Padhi, A. K., Shi, Z., Chakraborty, S., & Filler, R. (2006) · Journal of Power Sources · doi:10.1016/j.jpowsour.2006.06.008 · Cited by 104
Lithium battery thermal models
Doughty, D. H., Butler, P. C., Jungst, R. G., & Roth, E. P. (2002) · Journal of Power Sources · doi:10.1016/s0378-7753(02)00198-2 · Cited by 90
Thermal runaway features of 18650 lithium-ion batteries for LiFePO4 cathode material by DSC and VSP2
Wen, C.-Y., Jhu, C.-Y., Wang, Y.-W., Chiang, C.-C., & Shu, C. (2012) · Journal of Thermal Analysis and Calorimetry · doi:10.1007/s10973-012-2573-2 · Cited by 78
Cited by
A review of safety strategies of a Li-ion battery
Chombo, P. V., & Laoonual, Y. (2020) · Journal of Power Sources · doi:10.1016/j.jpowsour.2020.228649 · Cited by 596
Immersion cooling for lithium-ion batteries – A review
Roe, C., Feng, X., White, G., Li, R., Wang, H., Rui, X., Li, C., Zhang, F., Null, V., Parkes, M., et al. (2022) · Journal of Power Sources · doi:10.1016/j.jpowsour.2022.231094 · Cited by 590
Wilke, S., Schweitzer, B., Khateeb, S., & Al-Hallaj, S. (2017) · Journal of Power Sources · doi:10.1016/j.jpowsour.2016.11.018 · Cited by 475
A 3D thermal runaway propagation model for a large format lithium ion battery module
Feng, X., Lu, L., Ouyang, M., Li, J., & He, X. (2016) · Energy · doi:10.1016/j.energy.2016.08.094 · Cited by 466
Toxic fluoride gas emissions from lithium-ion battery fires
Larsson, F., Andersson, P., Blomqvist, P., & Mellander, B.-E. (2017) · Scientific Reports · doi:10.1038/s41598-017-09784-z · Cited by 462
Metadata
- Authors
- Lopez, C. F., Jeevarajan, J. A., & Mukherjee, P. P.
- Venue
- Journal of The Electrochemical Society
- Publisher
- The Electrochemical Society
- Published
- 2015
- Volume
- 162
- Issue
- 9
- Pages
- A1905-A1915
- ISSN
- 0013-4651 (ISSN-L)
- 1945-7111
- OpenAlex
- W1885776340
- Cited by
- 386
- References
- 31
- FWCI
- 16.39
- Type
- journal article
- Language
- en
- Open access
- hybrid
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.