Effect of pyrolysis temperature on chemical and physical properties of sewage sludge biochar
The DOI matches its Crossref record; 8 of the 8 references it cites were found in a registry or an index.
Abstract
The objective of this study was to evaluate the effects of pyrolysis temperatures (300, 400, 500, 600 and 700°C) on properties of biochar produced from an urban sewage sludge. Biochar yield significantly decreased from 72.5% at 300°C to 52.9% at 700°C, whereas an increase in temperature increased the gas yield. Biochar pH and electrical conductivity increased by 3.8 and 1.4 dS m−1, proportionally to the increment of temperature. Biochar produced at low temperatures had higher total nitrogen and total organic carbon content but a lower C/N ratio, calcium carbonate equivalent, and total P, K and Na contents. Total and diethylene triamine penta acetic acid (DTPA)-extractable concentrations of Fe, Zn, Cu, Mn, Ni, Cr and Pb increased with increment of temperature. Lower DTPA-extractable concentrations of Fe, Zn, Cu, Mn, Ni and Pb were found in biochars compared to the sewage sludge. Pyrolysis decreased bulk density, whereas particle density and porosity increment was observed upon pyrolysis with increment of temperature. Sewage sludge saturated water content ( θ s) was 130.4 g 100g−1 and significantly greater than biochar, but biochar θ s significantly increased with temperature (95.7 versus 105.4 g 100g−1 at 300 and 700°C, respectively). Pyrolysis decreased the biochar’s water repellency, assessed by molarity of ethanol droplet (MED), compared to the sewage sludge. The lowest MED of 0.2 and water repellency rating of 3 were found for the biochar produced at 700°C. Based on our results and considering the energy consumption, pyrolysis temperature in the range of 300–400°C may be suggested for sewage sludge pyrolysis.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Lehmann, J. (2007) · Nature · doi:10.1038/447143a · Cited by 2,477
The forms of alkalis in the biochar produced from crop residues at different temperatures
Yuan, J.-H., Xu, R.-K., & Zhang, H. (2011) · Bioresource Technology · doi:10.1016/j.biortech.2010.11.018 · Cited by 2,029 · cited 5×
“In addition, sewage sludge pyrolysis concentrated the P components in the biochars (Yuan et al., 2011).”
BackgroundInfluentialImpact of biochar amendments on the quality of a typical Midwestern agricultural soil
Laird, D. A., Fleming, P., Davis, D. D., Horton, R., Wang, B., & Karlen, D. L. (2010) · Geoderma · doi:10.1016/j.geoderma.2010.05.013 · Cited by 1,385 · cited 2×
“Biochar application to the soil increases the soil aeration (Laird, 2008), porosity and specific surface area (Laird et al., 2010; Steiner et al., 2007), water-holding capacity and drainage condition (Ibrahim et al.”
BackgroundReview of the stability of biochar in soils: predictability of O:C molar ratios
Spokas, K. A. (2010) · Carbon Management · doi:10.4155/cmt.10.32 · Cited by 1,160 · cited 2×
“However, decomposition of hydrophobic groups at high temperatures would decrease the water repellency (Spokas, 2010).”
BackgroundBiochar reduces the bioavailability and phytotoxicity of heavy metals
Park, J. H., Choppala, G. K., Bolan, N. S., Chung, J. W., & Chuasavathi, T. (2011) · Plant and Soil · doi:10.1007/s11104-011-0948-y · Cited by 1,157 · cited 1×
“…the soil aeration (Laird, 2008), porosity and specific surface area (Laird et al., 2010; Steiner et al., 2007), water-holding capacity and drainage condition (Ibrahim et al., 2013; Steiner et al., 2007), soil fertility and following plant yield responses (Major et al., 2010; Park et al., 2011).”
BackgroundInfluentialEvaluation of biochar effects on nitrogen retention and leaching in multi-layered soil columns
Ding, Y., Liu, Y.-X., Wu, W.-X., Shi, D.-Z., Yang, M., & Zhong, Z.-K. (2010) · Water, Air, & Soil Pollution · doi:10.1007/s11270-010-0366-4 · Cited by 462
Characteristics of Biochar: Microchemical Properties
(2012) · OSTI OAI (U.S. Department of Energy Office of Scientific and Technical Information) · doi:10.4324/9781849770552-10 · Cited by 388
Glaser, B., Parr, M., Braun, C., & Kopolo, G. (2009) · Nature Geoscience · doi:10.1038/ngeo395 · Cited by 164 · cited 3×
“When biochar is applied to the soils, it remains in an essentially permanent form and leads to net removal of carbon from the atmosphere (Glaser et al., 2009; Laird, 2008; Lehmann, 2007).”
Background
Cited by
Jin, J., Li, Y., Zhang, J., Wu, S., Cao, Y., Liang, P., Zhang, J., Wong, M. H., Wang, M., Shan, S., et al. (2016) · Journal of Hazardous Materials · doi:10.1016/j.jhazmat.2016.08.050 · Cited by 646
Biochar for crop production: potential benefits and risks
Hussain, M., Farooq, M., Nawaz, A., Al-Sadi, A. M., Solaiman, Z. M., Alghamdi, S. S., Ammara, U., Ok, Y. S., & Siddique, K. H. M. (2017) · Journal of Soils and Sediments · doi:10.1007/s11368-016-1360-2 · Cited by 532
“In a recent study, Khanmohammadi et al. (2015) reported that pH and electrical conductivity (EC) of urban sewage sludge biochar were increased by 3.8 and 1.4 dS m−1, proportionally to the increment of temperature from 300 to 700 °C, respectively.”
BackgroundInfluentialWang, L., Ok, Y. S., Tsang, D. C. W., Alessi, D. S., Rinklebe, J., Wang, H., Mašek, O., Hou, R., O'Connor, D., & Hou, D. (2020) · Soil Use and Management · doi:10.1111/sum.12592 · Cited by 393
Xu, X., Zhao, Y., Sima, J., Zhao, L., Mašek, O., & Cao, X. (2017) · Bioresource Technology · doi:10.1016/j.biortech.2017.06.023 · Cited by 374
Compositional heterogeneity of different biochar: Effect of pyrolysis temperature and feedstocks
Das, S. K., Ghosh, G. K., Avasthe, R. K., & Sinha, K. (2021) · Journal of Environmental Management · doi:10.1016/j.jenvman.2020.111501 · Cited by 363
Metadata
- Authors
- Khanmohammadi, Z., Afyuni, M., & Mosaddeghi, M. R.
- Venue
- Waste Management & Research: The Journal for a Sustainable Circular Economy
- Publisher
- SAGE Publications
- Published
- 2015-01-16
- Volume
- 33
- Issue
- 3
- Pages
- 275-283
- ISSN
- 0734-242X (ISSN-L)
- 1096-3669
- OpenAlex
- W2169339823
- Cited by
- 141
- References
- 8
- FWCI
- 3.46
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Effect of pyrolysis temperature on chemical and physical properties of sewage sludge biochar. https://app.cochat.ai/papers/10.1177/0734242x14565210
- The paper
- Khanmohammadi, Z., Afyuni, M., & Mosaddeghi, M. R. (2015). Effect of pyrolysis temperature on chemical and physical properties of sewage sludge biochar. Waste Management & Research: The Journal for a Sustainable Circular Economy. https://doi.org/10.1177/0734242x14565210
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.