CoChat
Sign Up
Cited by 114Innovations in Medical EducationPsychometric Methodologies and TestingMedical Education and Admissions

The DOI matches its Crossref record; 8 of the 8 references it cites were found in a registry or an index.

The standard error of measurement is a more appropriate measure of quality for postgraduate medical assessments than is reliability: an analysis of MRCP(UK) examinations

Open access
Tighe, Jane, McManus, IC, Dewhurst, Neil G, Chis, Liliana, Mucklow, John·2010·BMC Medical Education
DOI 10.1186/1472-6920-10-40PMC PMC2893515
Open this paper in CoChat — free accountOpen PDF

Abstract

Background: Cronbach's alpha is widely used as the preferred index of reliability for medical postgraduate examinations. A value of 0.8-0.9 is seen by providers and regulators alike as an adequate demonstration of acceptable reliability for any assessment. Of the other statistical parameters, Standard Error of Measurement (SEM) is mainly seen as useful only in determining the accuracy of a pass mark. However the alpha coefficient depends both on SEM and on the ability range (standard deviation, SD) of candidates taking an exam. This study investigated the extent to which the necessarily narrower ability range in candidates taking the second of the three part MRCP(UK) diploma examinations, biases assessment of reliability and SEM. Methods: a) The interrelationships of standard deviation (SD), SEM and reliability were investigated in a Monte Carlo simulation of 10,000 candidates taking a postgraduate examination. b) Reliability and SEM were studied in the MRCP(UK) Part 1 and Part 2 Written Examinations from 2002 to 2008. c) Reliability and SEM were studied in eight Specialty Certificate Examinations introduced in 2008-9. Results: The Monte Carlo simulation showed, as expected, that restricting the range of an assessment only to those who had already passed it, dramatically reduced the reliability but did not affect the SEM of a simulated assessment. The analysis of the MRCP(UK) Part 1 and Part 2 written examinations showed that the MRCP(UK) Part 2 written examination had a lower reliability than the Part 1 examination, but, despite that lower reliability, the Part 2 examination also had a smaller SEM (indicating a more accurate assessment). The Specialty Certificate Examinations had small Ns, and as a result, wide variability in their reliabilities, but SEMs were comparable with MRCP(UK) Part 2. Conclusions: An emphasis upon assessing the quality of assessments primarily in terms of reliability alone can produce a paradoxical and distorted picture, particularly in the situation where a narrower range of candidate ability is an inevitable consequence of being able to take a second part examination only after passing the first part examination. Reliability also shows problems when numbers of candidates in examinations are low and sampling error affects the range of candidate ability. SEM is not subject to such problems; it is therefore a better measure of the quality of an assessment and is recommended for routine use.

Overview

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1186/1472-6920-10-40

Cites

8 of 8 references verified0 citation errors · 0 not checkable

Statistics

Figures

Figure 1 In a Monte Carlo analysis, a simulated group of 10,000 candidates take an examination with a true mean of 50%, a true SD of 10%, a true reliability of 0.9, and a pass mark of 60%. Figure 1a shows the candidates' marks on the first attempt (horizontal axis), with the pass mark shown as the vertical dashed grey line, the failing candidates shown in red and the passing candidates shown in black. All of the simulated candidates then take the examination again, and their marks on that second occasion are shown on the vertical axis, with the horizontal dashed line showing the same pass mark as was used on the first occasion. Figure 1b is restricted to the 1565 candidates who passed the examination on the first assessment, and shows the marks they obtained when they took the examination for the second time (horizontal axis), and then again on taking it for a third time (vertical axis). Once again the notional pass mark of 60% is indicated by the vertical and horizontal grey dashed lines.
Figure 1 In a Monte Carlo analysis, a simulated group of 10,000 candidates take an examination with a true mean of 50%, a true SD of 10%, a true reliability of 0.9, and a pass mark of 60%. Figure 1a shows the candidates' marks on the first attempt (horizontal axis), with the pass mark shown as the vertical dashed grey line, the failing candidates shown in red and the passing candidates shown in black. All of the simulated candidates then take the examination again, and their marks on that second occasion are shown on the vertical axis, with the horizontal dashed line showing the same pass mark as was used on the first occasion. Figure 1b is restricted to the 1565 candidates who passed the examination on the first assessment, and shows the marks they obtained when they took the examination for the second time (horizontal axis), and then again on taking it for a third time (vertical axis). Once again the notional pass mark of 60% is indicated by the vertical and horizontal grey dashed lines.CC BY · PubMed Central

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Show all 8 references

Research works printed but not linked: 3

  1. Postgraduate Medical Education and Training Board: Principles for an assessment system for postgraduate training: A working paper from the Postgraduate Medical Education Training Board. 2004, London: PMETB
  2. Postgraduate Medical Education and Training Board: Standards for curricula and assessment systems. 2008, London: PMETB
  3. Postgraduate Medical Education and Training Board: Reliability issues in the assessment of small cohorts (Guidance 09/1). 2009, London: PMETB, [http://www.pmetb.org.uk]

Cited by

Sorted by citations

Related

See all

Metadata

Authors
Tighe, J., McManus, I., Dewhurst, N. G., Chis, L., & Mucklow, J.
Affiliations
University College London (GB)
Corresponding author
McManus, IC
ORCID
McManus, IC
Venue
BMC Medical Education
Publisher
Springer Science and Business Media LLC
Published
2010-06-02
Volume
10
Issue
1
Pages
40-40
ISSN
1472-6920 (ISSN-L)
DOI
10.1186/1472-6920-10-40
PMC
PMC2893515
OpenAlex
W2110536261
Cited by
113
References
8
Citations by year
2026: 7 · 2025: 15 · 2024: 13 · 2023: 6 · 2022: 9 · 2021: 8 · 2020: 6 · 2019: 7 · 2018: 6 · 2017: 7 · 2016: 3 · 2015: 10 · 2014: 1 · 2013: 5 · 2012: 6
FWCI
4.77
Type
journal article
Language
en
Open access
Licence
Locations
  • BMC Medical Education (publishedVersion, cc-by)
  • PubMed Central (publishedVersion, cc-by)
  • PubMed (publishedVersion)
  • DOAJ (DOAJ: Directory of Open Access Journals) (submittedVersion, cc-by-sa)
  • UCL Discovery (University College London) (submittedVersion)
Topics
  • Social Sciences › Education › Innovations in Medical Education
  • Social Sciences › Decision Sciences › Management Science and Operations Research › Psychometric Methodologies and Testing
  • Social Sciences › Education › Medical Education and Admissions
Keywords
standard error of measurement, test reliability, Cronbach's alpha, postgraduate medical examination, range restriction, assessment quality, Monte Carlo simulation
MeSH terms
Education, Medical, Graduate, Educational Measurement, Humans, Monte Carlo Method, Reproducibility of Results, Models, Statistical

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review