CoChat

A New Phase Change Material Based on Potassium Nitrate with Silica and Alumina Nanoparticles for Thermal Energy Storage

Open access
Chieruzzi, Manila, Miliozzi, Adio, Crescenzi, Tommaso, Torre, Luigi, Kenny, José M · 2015 · Nanoscale Research Letters

The DOI matches its Crossref record; 64 of the 64 references it cites were found in a registry or an index.

Abstract

In this study different nanofluids with phase change behavior were developed by mixing a molten salt base fluid (KNO3 selected as phase change material) with nanoparticles using the direct synthesis method. The thermal properties of the nanofluids obtained were investigated. Following the improvement in the specific heat achieved, these nanofluids can be used in concentrating solar plants with a reduction of storage material. The nanoparticles used (1.0 wt.%) were silica (SiO2), alumina (Al2O3), and a mix of silica-alumina (SiO2-Al2O3) with an average diameter of 7, 13, and 2-200 nm respectively. Each nanofluid was prepared in water solution, sonicated, and evaporated. Measurements of the thermophysical properties were performed by DSC analysis, and the dispersion of the nanoparticles was analyzed by SEM microscopy. The results obtained show that the addition of 1.0 wt.% of nanoparticles to the base salt increases the specific heat of about 5-10 % in solid phase and of 6 % in liquid phase. In particular, this research shows that the addition of silica nanoparticles has significant potential for enhancing the thermal storage characteristics of KNO3. The phase-change temperature of potassium nitrate was lowered up to 3 °C, and the latent heat was increased to 12 % with the addition of silica nanoparticles. These results deviated from the predictions of theoretical simple mixing model used. The stored heat as a function of temperature was evaluated for the base salt, and the nanofluids and the maximum values obtained were 229, 234, 242, and 266 J/g respectively. The maximum total gain (16 %) due to the introduction of the nanoparticles (calculated as the ratio between the total stored heat of the nanofluids and the base salt in the range of temperatures 260-390 °C) was also recorded with the introduction of silica. SEM and EDX analysis showed the presence of aggregates in all nanofluids: with silica nanoparticles they were homogenously present while with alumina and silica-alumina also zones with pure salt could be detected.

Overview

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1186/s11671-015-0984-2

Cites

64 of 64 references verified0 citation errors · 0 not checkable

Statistics

Figures

Fig. 1 Heat flow curves. Heat flow versus temperature for KNO3 and the nanofluids with 1.0 wt.% of oxide nanoparticles
Fig. 1 Heat flow curves. Heat flow versus temperature for KNO3 and the nanofluids with 1.0 wt.% of oxide nanoparticlesCC BY · PubMed Central
Fig. 2 Specific heat curves. Variation of the specific heat with temperature of KNO3 and the nanofluids in the solid phase (a) and in the liquid phase (b)
Fig. 2 Specific heat curves. Variation of the specific heat with temperature of KNO3 and the nanofluids in the solid phase (a) and in the liquid phase (b)CC BY · PubMed Central
Fig. 3 Experimental and theoretical specific heat values. Comparison between KNO3 and the nanofluids with 1.0 wt.% of oxide nanoparticles
Fig. 3 Experimental and theoretical specific heat values. Comparison between KNO3 and the nanofluids with 1.0 wt.% of oxide nanoparticlesCC BY · PubMed Central
Fig. 4 Stored heat and ratio of energy storage versus temperature. Stored heat of KNO3 and the nanofluids with 1.0 wt.% of oxide nanoparticles (a); ratio of energy storage (total gain %) versus temperature calculated respect to KNO3 (b)
Fig. 4 Stored heat and ratio of energy storage versus temperature. Stored heat of KNO3 and the nanofluids with 1.0 wt.% of oxide nanoparticles (a); ratio of energy storage (total gain %) versus temperature calculated respect to KNO3 (b)CC BY · PubMed Central
Fig. 5 SEM image of KNO3. The magnification used is ×10,000
Fig. 5 SEM image of KNO3. The magnification used is ×10,000CC BY · PubMed Central
Fig. 6 SEM images at ×5,000 magnification. SEM images of the nanofluids based on KNO3 with 1.0 wt.% of a silica, b alumina, and c silica-alumina nanoparticles
Fig. 6 SEM images at ×5,000 magnification. SEM images of the nanofluids based on KNO3 with 1.0 wt.% of a silica, b alumina, and c silica-alumina nanoparticlesCC BY · PubMed Central
Fig. 7 SEM images at ×50,000 magnification. SEM images of the nanofluids based on KNO3 with 1.0 wt.% of a silica, b alumina, and c silica-alumina nanoparticles
Fig. 7 SEM images at ×50,000 magnification. SEM images of the nanofluids based on KNO3 with 1.0 wt.% of a silica, b alumina, and c silica-alumina nanoparticlesCC BY · PubMed Central
Fig. 8 EDX mapping. Nanofluids based on KNO3 with 1.0 wt.% of a-b silica (Si, red), c-d alumina (Al, red), e-g silica-alumina (Si, green; Al, red) nanoparticles
Fig. 8 EDX mapping. Nanofluids based on KNO3 with 1.0 wt.% of a-b silica (Si, red), c-d alumina (Al, red), e-g silica-alumina (Si, green; Al, red) nanoparticlesCC BY · PubMed Central

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Claims other papers make about this one

Each is checked against this paper’s own text: does it say what the citing paper says it does?

1 more claim about this paper

Create a free account to see every claim other papers make about this one.

See all claims — free account

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Show all 64 references

Research works printed but not linked: 1

  1. Choi S. Developments applications of non-Newtonian flows. New York: ASME; 1995.

Cited by

See all 154

Metadata

Authors
Chieruzzi, M., Miliozzi, A., Crescenzi, T., Torre, L., & Kenny, J. M.
Affiliations
  • University of Perugia (IT)
  • National Agency for New Technologies, Energy and Sustainable Economic Development (IT)
Corresponding author
Chieruzzi, Manila
Venue
Nanoscale Research Letters
Published
2015-06-28
Volume
10
Issue
1
Pages
984-984
ISSN
  • 1556-276X (ISSN-L)
  • 1931-7573
OpenAlex
W2166236553
Cited by
154
References
64
Citations by year
2026: 8 · 2025: 16 · 2024: 11 · 2023: 16 · 2022: 13 · 2021: 14 · 2020: 21 · 2019: 17 · 2018: 7 · 2017: 15 · 2016: 16
FWCI
12.42
Type
journal article
Language
en
Open access
Locations
  • Nanoscale Research Letters (publishedVersion, cc-by)
  • Europe PMC (PubMed Central) (publishedVersion, cc-by)
  • PubMed Central (publishedVersion, cc-by)
  • PubMed (publishedVersion)
  • ENEA Open Archive (National Agency for New Technologies, Energy and Sustainable Economic Development) (submittedVersion)
Funders
Ministero dello Sviluppo Economico
Topics
  • Physical Sciences › Engineering › Mechanical Engineering › Phase Change Materials Research
  • Physical Sciences › Engineering › Mechanical Engineering › Adsorption and Cooling Systems
  • Physical Sciences › Chemical Engineering › Fluid Flow and Transfer Processes › Nanofluid Flow and Heat Transfer
Keywords
phase change materials, potassium nitrate, molten salts, silica nanoparticles, Al2O3 nanoparticles, nanofluids, thermal energy storage, specific heat enhancement, latent heat, phase transition temperature, concentrated solar power, nanoparticle aggregation, direct synthesis

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

How to cite

Cite CoChat for the checks on this page, and the paper for its own findings.

This page
CoChat. (2026). Citation check: A New Phase Change Material Based on Potassium Nitrate with Silica and Alumina Nanoparticles for Thermal Energy Storage. https://app.cochat.ai/papers/10.1186/s11671-015-0984-2
The paper
Chieruzzi, M., Miliozzi, A., Crescenzi, T., Torre, L., & Kenny, J. M. (2015). A New Phase Change Material Based on Potassium Nitrate with Silica and Alumina Nanoparticles for Thermal Energy Storage. Nanoscale Research Letters. https://doi.org/10.1186/s11671-015-0984-2

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.