The DOI matches its Crossref record; 22 of the 22 references it cites were found in a registry or an index.
Mechanical properties of nacre constituents and their impact on mechanical performance
Abstract
The mechanical properties of nacre constituents from red abalone were investigated. Electron microscopy studies revealed that the tablets are composed of single-crystal aragonite with nanograin inclusions. Both nanoasperities and aragonite bridges are present within the interfaces between the tablets. By means of nanoindentation and axial compression tests, we identified single tablet elastic and inelastic properties. The elastic properties are very similar to those of single-crystal aragonite. However, their strength is higher than previously reported values for aragonite. A finite element model of the interface accounting for nanoasperities and the identified properties revealed that the nanoasperities are strong enough to withstand climbing and resist tablet sliding, at least over the initial stages of deformation. Furthermore, it was observed that the model over-predicts strength and under-predicts ductility. Therefore, we conclude that other interface features must be responsible for the enhanced performance of nacre over its constituents.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Oliver, W. C., & Pharr, G. M. (1992) · Journal of Materials Research · doi:10.1557/jmr.1992.1564 · Cited by 26,961
Lawn, B. (1993) · Cambridge University Press eBooks · doi:10.1017/cbo9780511623127 · Cited by 4,759
Materials become insensitive to flaws at nanoscale: Lessons from nature
Gao, H., Ji, B., Jäger, I. L., Arzt, E., & Fratzl, P. (2003) · Proceedings of the National Academy of Sciences · doi:10.1073/pnas.0631609100 · Cited by 1,922
Effects of the substrate on the determination of thin film mechanical properties by nanoindentation
Saha, R., & Nix, W. D. (2002) · Acta Materialia · doi:10.1016/s1359-6454(01)00328-7 · Cited by 1,564
The mechanical design of nacre
Jackson, A. P., Vincent, J. F. V., & Turner, R. M. (1988) · Proceedings of the Royal Society of London. Series B. Biological Sciences · doi:10.1098/rspb.1988.0056 · Cited by 1,269
Molecular mechanistic origin of the toughness of natural adhesives, fibres and composites
Smith, B. L., Schäffer, T. E., Viani, M., Thompson, J. B., Frederick, N. A., Kindt, J., Belcher, A., Stucky, G. D., Morse, D. E., & Hansma, P. K. (1999) · Nature · doi:10.1038/21607 · Cited by 1,218
Control of crystal phase switching and orientation by soluble mollusc-shell proteins
Belcher, A. M., Wu, X. H., Christensen, R. J., Hansma, P. K., Stucky, G. D., & Morse, D. E. (1996) · Nature · doi:10.1038/381056a0 · Cited by 1,153
Deformation mechanisms in nacre
Wang, R. Z., Suo, Z., Evans, A. G., Yao, N., & Aksay, I. A. (2001) · Journal of Materials Research · doi:10.1557/jmr.2001.0340 · Cited by 835
Mechanical properties of mother of pearl in tension
Currey, J. D. (1977) · Proceedings of the Royal Society of London. Series B. Biological Sciences · doi:10.1098/rspb.1977.0050 · Cited by 722
Rigid Biological Systems as Models for Synthetic Composites
Mayer, G. (2005) · Science · doi:10.1126/science.1116994 · Cited by 645
Cited by
Biological materials: Structure and mechanical properties
Meyers, M. A., Chen, P.-Y., Lin, A. Y.-M., & Seki, Y. (2008) · Progress in Materials Science · doi:10.1016/j.pmatsci.2007.05.002 · Cited by 2,573
Gower, L. B. (2008) · Chemical Reviews · doi:10.1021/cr800443h · Cited by 1,086
On the mechanics of mother-of-pearl: A key feature in the material hierarchical structure
BARTHELAT, F., TANG, H., ZAVATTIERI, P., LI, C., & ESPINOSA, H. (2007) · Journal of the Mechanics and Physics of Solids · doi:10.1016/j.jmps.2006.07.007 · Cited by 1,032
Self-citationMerger of structure and material in nacre and bone – Perspectives on de novo biomimetic materials
Espinosa, H. D., Rim, J. E., Barthelat, F., & Buehler, M. J. (2009) · Progress in Materials Science · doi:10.1016/j.pmatsci.2009.05.001 · Cited by 817
Self-citationBiological materials: Functional adaptations and bioinspired designs
Chen, P.-Y., McKittrick, J., & Meyers, M. A. (2012) · Progress in Materials Science · doi:10.1016/j.pmatsci.2012.03.001 · Cited by 766
Composites Reinforced in Three Dimensions by Using Low Magnetic Fields
Erb, R. M., Libanori, R., Rothfuchs, N., & Studart, A. R. (2012) · Science · doi:10.1126/science.1210822 · Cited by 675
Hierarchical structure and mechanical properties of nacre: a review
Sun, J., & Bhushan, B. (2012) · RSC Advances · doi:10.1039/c2ra20218b · Cited by 601
Structure and mechanical properties of selected biological materials
Chen, P.-Y., Lin, A. Y. M., Lin, Y.-S., Seki, Y., Stokes, A. G., Peyras, J., Olevsky, E. A., Meyers, M. A., & McKittrick, J. (2008) · Journal of the Mechanical Behavior of Biomedical Materials · doi:10.1016/j.jmbbm.2008.02.003 · Cited by 558
Layered nanocomposites inspired by the structure and mechanical properties of nacre
Wang, J., Cheng, Q., & Tang, Z. (2012) · Chem. Soc. Rev. · doi:10.1039/c1cs15106a · Cited by 539
An Experimental Investigation of Deformation and Fracture of Nacre–Mother of Pearl
Barthelat, F., & Espinosa, H. D. (2007) · Experimental Mechanics · doi:10.1007/s11340-007-9040-1 · Cited by 504
Self-citationWalther, A., Bjurhager, I., Malho, J.-M., Pere, J., Ruokolainen, J., Berglund, L. A., & Ikkala, O. (2010) · Nano Letters · doi:10.1021/nl1003224 · Cited by 467
Mechanical strength of abalone nacre: Role of the soft organic layer
Meyers, M. A., Lin, A. Y.-M., Chen, P.-Y., & Muyco, J. (2008) · Journal of the Mechanical Behavior of Biomedical Materials · doi:10.1016/j.jmbbm.2007.03.001 · Cited by 427
Tablet-level origin of toughening in abalone shells and translation to synthetic composite materials
Espinosa, H. D., Juster, A. L., Latourte, F. J., Loh, O. Y., Gregoire, D., & Zavattieri, P. D. (2011) · Nature Communications · doi:10.1038/ncomms1172 · Cited by 411
Self-citationDiscontinuous crack-bridging model for fracture toughness analysis of nacre
Shao, Y., Zhao, H.-P., Feng, X.-Q., & Gao, H. (2012) · Journal of the Mechanics and Physics of Solids · doi:10.1016/j.jmps.2012.04.011 · Cited by 335
Nacre-mimetics with synthetic nanoclays up to ultrahigh aspect ratios
Das, P., Malho, J.-M., Rahimi, K., Schacher, F. H., Wang, B., Demco, D. E., & Walther, A. (2015) · Nature Communications · doi:10.1038/ncomms6967 · Cited by 334
Multiscale engineered artificial tooth enamel
Zhao, H., Liu, S., Wei, Y., Yue, Y., Gao, M., Li, Y., Zeng, X., Deng, X., Kotov, N. A., Guo, L., et al. (2022) · Science · doi:10.1126/science.abj3343 · Cited by 317
Biomimetics for next generation materials
Barthelat, F. (2007) · Philosophical Transactions of the Royal Society A: Mathematical, Physical and Engineering Sciences · doi:10.1098/rsta.2007.0006 · Cited by 282
Self-citationTran, P., Ngo, T. D., Ghazlan, A., & Hui, D. (2017) · Composites Part B: Engineering · doi:10.1016/j.compositesb.2016.09.083 · Cited by 261
Nacre from mollusk shells: a model for high-performance structural materials
Barthelat, F. (2010) · Bioinspiration & Biomimetics · doi:10.1088/1748-3182/5/3/035001 · Cited by 241
Self-citationOrigin of flaw-tolerance in nacre
Huang, Z., & Li, X. (2013) · Scientific Reports · doi:10.1038/srep01693 · Cited by 111
Metadata
- Authors
- Barthelat, F., Li, C.-M., Comi, C., & Espinosa, H. D.
- Venue
- Journal of Materials Research
- Published
- 2006-08-01
- Volume
- 21
- Issue
- 8
- Pages
- 1977-1986
- ISSN
- 0884-1616 (ISSN-L)
- 0884-2914
- 2044-5326
- OpenAlex
- W2115235651
- Cited by
- 384
- References
- 22
- FWCI
- 5.94
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.