Catalytic Hydrothermal Liquefaction of Food Waste Using CeZrOx
Open accessThe DOI matches its Crossref record; 6 of the 6 references it cites were found in a registry or an index.
Abstract
Approximately 15 million dry tons of food waste is produced annually in the United States (USA), and 92% of this waste is disposed of in landfills where it decomposes to produce greenhouse gases and water pollution. Hydrothermal liquefaction (HTL) is an attractive technology capable of converting a broad range of organic compounds, especially those with substantial water content, into energy products. The HTL process produces a bio-oil precursor that can be further upgraded to transportation fuels and an aqueous phase containing water-soluble organic impurities. Converting small oxygenated compounds that partition into the water phase into larger, hydrophobic compounds can reduce aqueous phase remediation costs and improve energy yields. HTL was investigated at 300 °C and a reaction time of 1 h for conversion of an institutional food waste to bio-oil, using either homogeneous Na2CO3 or heterogeneous CeZrOx to promote in situ conversion of water-soluble organic compounds into less oxygenated, oil-soluble products. Results with food waste indicate that CeZrOx improves both bio-oil higher heating value (HHV) and energy recovery when compared both to non-catalytic and Na2CO3-catalyzed HTL. The aqueous phase obtained using CeZrOx as an HTL catalyst contained approximately half the total organic carbon compared to that obtained using Na2CO3—suggesting reduced water treatment costs using the heterogeneous catalyst. Experiments with model compounds indicated that the primary mechanism of action was condensation of aldehydes, a reaction which simultaneously increases molecular weight and oxygen-to-carbon ratio—consistent with the improvements in bio-oil yield and HHV observed with institutional food waste. The catalyst was stable under hydrothermal conditions (≥16 h at 300 °C) and could be reused at least three times for conversion of model aldehydes to water insoluble products. Energy and economic analysis suggested favorable performance for the heterogeneous catalyst compared either to non-catalytic HTL or Na2CO3-catalyzed HTL, especially once catalyst lifetime differences were considered. The results of this study establish the potential of heterogeneous catalysts to improve HTL economics and energetics.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
A review on hydrothermal liquefaction of biomass
Gollakota, A. R. K., Kishore, N., & Gu, S. (2018) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2017.05.178 · Cited by 1,306
A review on operating parameters for optimum liquid oil yield in biomass pyrolysis
Akhtar, J., & Saidina Amin, N. (2012) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2012.05.033 · Cited by 692
Hydrothermal processing of microalgae using alkali and organic acids
Ross, A. B., Biller, P., Kubacki, M. L., Li, H., Lea-Langton, A., & Jones, J. M. (2010) · Fuel · doi:10.1016/j.fuel.2010.01.025 · Cited by 617
Hydrothermal liquefaction of a microalga with heterogeneous catalysts
Duan, P., & Savage, P. E. (2011) · Industrial & Engineering Chemistry Research · doi:10.1021/ie100758s · Cited by 608 · cited 3×
“The molar composition of the gas was assumed to be 80% CO2, 10% CO and 10% H2; these values were based on literature sources that showed HTL gas is typically composed of 70–90% CO2, 5–15% H2 5–15%, and 5–14% CO [34,41].”
BackgroundShuping, Z., Yulong, W., Mingde, Y., Kaleem, I., Chun, L., & Tong, J. (2010) · Energy · doi:10.1016/j.energy.2010.07.013 · Cited by 461
Zhu, Y., Albrecht, K. O., Elliott, D. C., Hallen, R. T., & Jones, S. B. (2013) · Algal Research · doi:10.1016/j.algal.2013.07.003 · Cited by 181
Cited by
Hydrothermal carbonization and Liquefaction: differences, progress, challenges, and opportunities
Lachos-Perez, D., César Torres-Mayanga, P., Abaide, E. R., Zabot, G. L., & De Castilhos, F. (2022) · Bioresource Technology · doi:10.1016/j.biortech.2021.126084 · Cited by 355
Wu, Y., Wang, H., Li, H., Han, X., Zhang, M., Sun, Y., Fan, X., Tu, R., Zeng, Y., Xu, C. C., et al. (2022) · Renewable Energy · doi:10.1016/j.renene.2022.07.031 · Cited by 274
Wet organic waste treatment via hydrothermal processing: A critical review
Marzbali, M. H., Kundu, S., Halder, P., Patel, S., Hakeem, I. G., Paz-Ferreiro, J., Madapusi, S., Surapaneni, A., & Shah, K. (2021) · Chemosphere · doi:10.1016/j.chemosphere.2021.130557 · Cited by 147
Bayat, H., Dehghanizadeh, M., Jarvis, J. M., Brewer, C. E., & Jena, U. (2021) · Frontiers in Sustainable Food Systems · doi:10.3389/fsufs.2021.658592 · Cited by 94
“, 2018), which is in line with the HHV of bio-crude oils derived from food waste in previous studies (32–41 MJ/kg) (Zastrow and Jennings, 2013; Maag et al., 2018; Zhang et al., 2018).”
MethodResultInfluentialDjandja, O. S., Wang, Z., Chen, L., Qin, L., Wang, F., Xu, Y., & Duan, P. (2020) · Energy & Fuels · doi:10.1021/acs.energyfuels.0c01973 · Cited by 93
Metadata
- Authors
- Maag, A., Paulsen, A., Amundsen, T., Yelvington, P., Tompsett, G., & Timko, M.
- Venue
- Energies
- Publisher
- MDPI AG
- Published
- 2018-03-06
- Volume
- 11
- Issue
- 3
- Pages
- 564
- ISSN
- 1996-1073 (ISSN-L)
- OpenAlex
- W2790705629
- Cited by
- 73
- References
- 6
- FWCI
- 2.93
- Type
- journal article
- Language
- en
- Open access
- gold
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.