CoChat

A Green Electromagnetic Energy Harvester with Up-Frequency and Unidirectional Rotation for Smart Pavement

Open access

The DOI matches its Crossref record; 42 of the 42 references it cites were found in a registry or an index; 1 of the 14 sources its claims cite were checked for support.

Abstract

Smart pavement is composed of a monitor network, communication network, data center, and energy supply system, and it requires reliable and efficient energy sources to power sensors and devices. The mechanical energy is wasted and dissipated as heat in traditional pavement; this energy can be reused to power low-power devices and sensors for smart pavement. Mechanical energy harvesting systems typically perform through electromagnetic, piezoelectric, and triboelectric methods. Among the different methods, electromagnetic harvesters stand out for their higher output power. However, current electromagnetic harvesters face challenges such as bulky designs, low power density, and high input displacement requirements. This study proposed a green electromagnetic harvester (GEH) based on up-frequency and a unidirectional rotation mechanism to harvest mechanical energy from the pavement. A prototype was designed and prepared. The influence of different parameters on the electrical performance of the harvester was studied by using an MTS test instrument and simulation methods. The results demonstrate that increasing the frequency and optimizing the magnetic array significantly enhances electrical output. The open-circuit voltage in the N-S mode is 3.1 times higher than that in the N-N mode. At a frequency of 9 Hz and a displacement of 3.0 mm, the open-circuit voltage of the GEH is 6.73 V, the maximum power output is 171.14 mW, the peak power density is 1277.16 W/m3, and the voltage has almost no decay after 100,000 cycles. Further, the application of the GEH in charging sensors and capacitors was demonstrated, which indicates the potential of a GEH to power sensors for smart roads.

Overview

CoChat Summary

## TL;DR

This paper proposes a compact green electromagnetic energy harvester (GEH) for smart pavement that converts limited vertical road displacement into unidirectional, up-frequency rotation to improve power generation. In tests, the optimized prototype reached 6.73 V open-circuit voltage, 171.14 mW output power, and 1277.16 W/m³ power density at 9 Hz and 3.0 mm displacement, with only a 1.28 V voltage drop after 100,000 cycles.

## Key findings

  • Magnet-array optimization showed the N-S mode outperformed the N-N mode; the abstract states the open-circuit voltage in N-S mode was 3.1 times higher than in N-N mode.
  • With 8 magnets, the average magnetic field intensity was the largest, reported as 3.1 times that of 2 magnets.
  • At 9 Hz and 3.0 mm displacement, the harvester produced 6.73 V open-circuit voltage and 171.14 mW maximum output power; the abstract also reports a peak power density of 1277.16 W/m³.
  • Under 100,000 loading cycles at 3 mm displacement and 9 Hz, output voltage decreased by only 1.28 V and no cracks or damage were observed.
  • Practical charging tests showed capacitors of 100 μF, 470 μF, and 1000 μF were charged to 4.65 V, 3.77 V, and 3.60 V within 30 s at 5 Hz and 3.0 mm displacement, and a hygrometer could be powered for a period of time.

## Methods

  • The study designed a GEH with three parts: a motion conversion module, an up-frequency and unidirectional rotation module, and a magnet-coil electromechanical conversion module; the prototype height was designed to be no more than 5 cm and the test displacement was limited to 3.0 mm.
  • Magnet-array and magnet–coil distance optimization was performed using finite element simulation in COMSOL Multiphysics 6.0, and electrical performance was then tested on an MTS system at 3, 5, 7, and 9 Hz with a digital oscilloscope measuring voltage.
  • Long-term stability was assessed with 100,000 loading cycles at 3 mm displacement and 9 Hz; practical verification included rectified capacitor charging and powering a low-power hygrometer.

## Limitations

  • The paper states that field tests in the actual road environment will be carried out in follow-up work; this means the current evidence is from laboratory simulation rather than real-road deployment.
  • The text makes evident that the prototype was evaluated only under limited laboratory frequencies and displacements (3–9 Hz, 2.0–3.0 mm), so broader operating conditions were not tested here (evident from the test setup).
  • The paper notes voltage fluctuations during capacitor charging were large, which could cause instability of the output power supply; it suggests hybrid supercapacitors to reduce fluctuation.

Model-written summary. Check it against the paper before relying on it.

Integrity signals

Registry

Crossref · 10.3390/ma18040786

Cites

42 of 42 references verified0 citation errors · 0 not checkable

Statistics

Nothing to recompute.

Figures

Figure 1 The design of the green electromagnetic harvester.
Figure 1 The design of the green electromagnetic harvester.CC BY · PubMed Central
Figure 2 Schematic diagram of the working principle and energy harvesting of the energy harvester.
Figure 2 Schematic diagram of the working principle and energy harvesting of the energy harvester.CC BY · PubMed Central
Figure 3 Magnetic field density distribution of different numbers of magnets.
Figure 3 Magnetic field density distribution of different numbers of magnets.CC BY · PubMed Central
Figure 4 Performance comparison of two magnet arrays.
Figure 4 Performance comparison of two magnet arrays.CC BY · PubMed Central
Figure 5 Influence of magnet mass on output voltage.
Figure 5 Influence of magnet mass on output voltage.CC BY · PubMed Central
Figure 6 The magnetic field strength between coil and magnet under different gaps.
Figure 6 The magnetic field strength between coil and magnet under different gaps.CC BY · PubMed Central
Figure 7 (a) Loading process of car on GEH; (b) photograph of the GEH on the MTS.
Figure 7 (a) Loading process of car on GEH; (b) photograph of the GEH on the MTS.CC BY · PubMed Central
Figure 8 Open-circuit voltage of the GEH at different displacement and frequency.
Figure 8 Open-circuit voltage of the GEH at different displacement and frequency.CC BY · PubMed Central
Figure 9 The output voltages of harvesters under different displacement and different frequencies: (a) 2.0 mm; (b) 2.5 mm; (c) 3.0 mm; (d) the voltage curve of the GEH at 3.0 mm displacement.
Figure 9 The output voltages of harvesters under different displacement and different frequencies: (a) 2.0 mm; (b) 2.5 mm; (c) 3.0 mm; (d) the voltage curve of the GEH at 3.0 mm displacement.CC BY · PubMed Central
Figure 10 Output power of the GEH under different displacement and frequencies: (a) 2.0 mm; (b) 2.5 mm; (c) 3.0 mm. (d) Comparison of output power under different displacement.
Figure 10 Output power of the GEH under different displacement and frequencies: (a) 2.0 mm; (b) 2.5 mm; (c) 3.0 mm. (d) Comparison of output power under different displacement.CC BY · PubMed Central
Figure 11 GEH output voltage in fatigue testing. The blue dot indicates 10,000 loads, and the red dashed line indicates the voltage drop trend.
Figure 11 GEH output voltage in fatigue testing. The blue dot indicates 10,000 loads, and the red dashed line indicates the voltage drop trend.CC BY · PubMed Central
Figure 12 Energy harvester performance application test: (a) schematic diagram of circuit connections; (b) charging voltage on different capacitances; (c) charging the hygrothermograph.
Figure 12 Energy harvester performance application test: (a) schematic diagram of circuit connections; (b) charging voltage on different capacitances; (c) charging the hygrothermograph.CC BY · PubMed Central
Figure 13 Application scenario of GEH on the road.
Figure 13 Application scenario of GEH on the road.CC BY · PubMed Central

Verification

Claims the paper makes

1 Valid · 0 Not valid · 8 Not checked · 62 Own results and interpretations

44 more claims

Create a free account to see all 71 claims and every source verdict.

See all claims — free account
  • It may state two separate claims as one. 18
  • The quote only partly states this claim. 5

Create a free account to see these claims.

Citations

Cites

Cited by

See all 18

Metadata

Authors
Mou, K., Ji, X., Li, X., Zhou, H., Wu, Y., & Fang, Y.
Affiliations
  • Chang'an University (CN)
  • Technology Development Group Co., Ltd., Shaanxi Transportation Holding Group, Xi’an 710075, China
Corresponding author
Ji, Xiaoping
Venue
Materials
Publisher
MDPI AG
Published
2025-02-11
Volume
18
Issue
4
Pages
786
ISSN
1996-1944 (ISSN-L)
OpenAlex
W4407393404
Cited by
18
References
42
Citations by year
2026: 8 · 2025: 10
FWCI
5.17
Type
journal article
Language
en
Open access
Locations
  • Materials (publishedVersion, cc-by)
  • PubMed Central (publishedVersion, cc-by)
  • PubMed (publishedVersion)
Funders
  • National Natural Science Foundation of China (5247082732, 24-58k, 300102214909)
  • Shaanxi Provincial Transportation Technology Project (5247082732, 24-58k, 300102214909)
  • Fundamental Research Funds for the Central Universities of CHD (5247082732, 24-58k, 300102214909)
Topics
  • Physical Sciences › Engineering › Mechanical Engineering › Innovative Energy Harvesting Technologies
  • Physical Sciences › Engineering › Biomedical Engineering › Advanced Sensor and Energy Harvesting Materials
  • Physical Sciences › Materials Science › Electronic, Optical and Magnetic Materials › Magnetic Properties and Applications
Keywords
electromagnetic energy harvesting, smart pavements, unidirectional rotation, mechanical energy harvesting, open-circuit voltage, power density, sensor power supply, pavement vibration, low-power devices

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

The claim verdicts this report counts are experimental: their accuracy is not yet measured.

A language model drew the claims from the paper on 2026-10-09, under version 3 of the claim definition (model deepseek-v4.1-flash, prompt extract-v3).

A second model labelled each claim on 2026-10-09 (model jev-1.13-20260917, definition revision gold-guideline-v0.2).

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.