Own-Synthetize Nanoparticles to Develop Nano-Enhanced Phase Change Materials (NEPCM) to Improve the Energy Efficiency in Buildings
Open accessThe DOI matches its Crossref record; 26 of the 26 references it cites were found in a registry or an index.
Abstract
The use of adequate thermal energy storage (TES) systems is an opportunity to increase energy efficiency in the building sector, and so decrease both commercial and residential energy consumptions. Nano-enhanced phase change materials (NEPCM) have attracted attention to address one of the crucial barriers (i.e. low thermal conductivity) to the adoption of phase change materials (PCM) in this sector. In the present study two PCM based on fatty acids, capric and palmitic acid, were nano-enhanced with low contents (1.0 wt.%, 1.5 wt.% and 3.0 wt.%) of copper (II) oxide (CuO) nanoparticles. Copper (II) oxide (CuO) was synthesized via coprecipitation method obtaining 60–120 nm diameter sized nanoparticles. Thermal stability and high thermal conductivity were observed for the nano-enhanced phase change materials (NEPCM) obtained. Experimental results revealed remarkable increments in NEPCM thermal conductivity, for instance palmitic acid thermal conductivity was increased up to 60% with the addition of 3 wt.% CuO nanoparticles. Moreover, CuO nanoparticles sedimentation velocity decreases when increasing its content.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Figures








Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
The cited source doesn’t support the claim as written.
In the citing paper
“Thermal conductivity increased until 1.5 wt % NPs for the capric acid and up to 3.0 wt % for palmitic acid.”
From Nano-Enhanced Phase Change Materials in Latent Heat Thermal Energy Storage Systems: A Review (2021) · cites this paper as [61]
Checked by a reasoning model — may be wrong.
Experimental — accuracy not yet measuredThe cited source says what the claim attributes to it.
In the citing paper
“Maximum heat storage was achieved at 1.0 wt % for both [61].”
From Nano-Enhanced Phase Change Materials in Latent Heat Thermal Energy Storage Systems: A Review (2021) · cites this paper as [61]
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
A review on buildings energy consumption information
Pérez-Lombard, L., Ortiz, J., & Pout, C. (2008) · Energy and Buildings · doi:10.1016/j.enbuild.2007.03.007 · Cited by 6,649 · cited 1×
“In particular, heating, ventilation, and air conditioning (HVAC) systems are the major contributor (50%) of the buildings energy consumption [3].”
BackgroundMaterials used as PCM in thermal energy storage in buildings: A review
Cabeza, L. F., Castell, A., Barreneche, C., de Gracia, A., & Fernández, A. I. (2011) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2010.11.018 · Cited by 1,889
Self-citationReview on phase change materials (PCMs) for cold thermal energy storage applications
Oró, E., de Gracia, A., Castell, A., Farid, M. M., & Cabeza, L. F. (2012) · Applied Energy · doi:10.1016/j.apenergy.2012.03.058 · Cited by 1,144
Soares, N., Costa, J. J., Gaspar, A. R., & Santos, P. (2013) · Energy and Buildings · doi:10.1016/j.enbuild.2012.12.042 · Cited by 1,061
Tables of Spectral Data for Structure Determination of Organic Compounds
Pretsch, E., Clerc, T., Seibl, J., & Simon, W. (1989) · Chemical Laboratory Practice · doi:10.1007/978-3-662-10207-7 · Cited by 1,011
Phase change materials and thermal energy storage for buildings
de Gracia, A., & Cabeza, L. F. (2015) · Energy and Buildings · doi:10.1016/j.enbuild.2015.06.007 · Cited by 688
Organic phase change materials and their textile applications: An overview
Sarier, N., & Onder, E. (2012) · Thermochimica Acta · doi:10.1016/j.tca.2012.04.013 · Cited by 681
Kalnæs, S. E., & Jelle, B. P. (2015) · Energy and Buildings · doi:10.1016/j.enbuild.2015.02.023 · Cited by 585
Review on thermal properties of nanofluids: Recent developments
Angayarkanni, S. A., & Philip, J. (2015) · Advances in Colloid and Interface Science · doi:10.1016/j.cis.2015.08.014 · Cited by 492
Hasan, A., McCormack, S. J., Huang, M. J., & Norton, B. (2010) · Solar Energy · doi:10.1016/j.solener.2010.06.010 · Cited by 476
Phase-change materials (PCM) for automotive applications: a review
Jaguemont, J., Omar, N., Van den Bossche, P., & Mierlo, J. (2018) · Applied Thermal Engineering · doi:10.1016/j.applthermaleng.2017.12.097 · Cited by 451 · cited 1×
“Although the main application of this study is the use of PCM in buildings, there are many other uses for these materials, such as the following: thermal storing of solar energy [7], heating systems [8], integrated in clothes [9], food transport refrigeration [10], thermal protection in alimentation [11], and thermal…”
MethodInfluentialChieruzzi, M., Cerritelli, G. F., Miliozzi, A., & Kenny, J. M. (2013) · Nanoscale Research Letters · doi:10.1186/1556-276x-8-448 · Cited by 381
A review on thermophysical properties of nanoparticle dispersed phase change materials
Kibria, M. A., Anisur, M. R., Mahfuz, M. H., Saidur, R., & Metselaar, I. H. S. C. (2015) · Energy Conversion and Management · doi:10.1016/j.enconman.2015.02.028 · Cited by 317
Nano-enhanced phase change materials for improved building performance
Ma, Z., Lin, W., & Sohel, M. I. (2016) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2015.12.234 · Cited by 207
Bio-based PCM/carbon nanomaterials composites with enhanced thermal conductivity
Yu, S., Jeong, S.-G., Chung, O., & Kim, S. (2014) · Solar Energy Materials and Solar Cells · doi:10.1016/j.solmat.2013.09.037 · Cited by 202
Phase change materials for solar thermal energy storage in residential buildings in cold climate
Zhou, Z., Zhang, Z., Zuo, J., Huang, K., & Zhang, L. (2015) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2015.04.048 · Cited by 187
Solidification of a PCM with nanoparticles in triplex-tube thermal energy storage system
Mahdi, J. M., & Nsofor, E. C. (2016) · Applied Thermal Engineering · doi:10.1016/j.applthermaleng.2016.07.130 · Cited by 180
An investigation of melting/freezing characteristics of nanoparticle-enhanced phase change materials
Wu, S. Y., Wang, H., Xiao, S., & Zhu, D. S. (2012) · Journal of Thermal Analysis and Calorimetry · doi:10.1007/s10973-011-2080-x · Cited by 171
Thermal enhancement of paraffin as a phase change material with nanomagnetite
Şahan, N., & Paksoy, H. O. (2014) · Solar Energy Materials and Solar Cells · doi:10.1016/j.solmat.2014.03.018 · Cited by 108
Diarce, G., Campos‐Celador, Á., Martín-Escudero, K., Urresti, A., García-Romero, A., & Sala, J. M. (2014) · Applied Energy · doi:10.1016/j.apenergy.2014.03.080 · Cited by 99
Miró, L., Barreneche, C., Ferrer, G., Solé, A., Martorell, I., & Cabeza, L. F. (2016) · Thermochimica Acta · doi:10.1016/j.tca.2016.01.014 · Cited by 94
Self-citationŞahan, N., Fois, M., & Paksoy, H. (2016) · International Journal of Energy Research · doi:10.1002/er.3449 · Cited by 65
Study of the Thermal Properties and the Fire Performance of Flame Retardant-Organic PCM in Bulk Form
Palacios, A., de Gracia, Á., Haurie, L., Cabeza, L. F., Fernández, A. I., & Barreneche, C. (2018) · Materials · doi:10.3390/ma11010117 · Cited by 56
Self-citationSun, W., Zhou, Y., Feng, J., Fang, X., Ling, Z., & Zhang, Z. (2019) · Molecules · doi:10.3390/molecules24020363 · Cited by 29
Thermal Properties of Phase Change Composites Containing Ferric Oxide Nanoparticles
Wang, J., Xie, H., & Li, Y. (2014) · Journal of Nanoscience and Nanotechnology · doi:10.1166/jnn.2015.9625 · Cited by 11
Heat transfer modelling of encapsulated phase change materials for food packaging
Hoang, H., Leducq, D., Pérez Masia, R., et al. (2014) · HAL (Le Centre pour la Communication Scientifique Directe) · Cited by 4
Research works printed but not linked: 1
- Pavlík, Z., Fiala, L., and Černý, R. (2007, January 11–12). Application of Maxwell Mixing Rule in the Measurement of Thermal Conductivity of Porous Building Materials. Proceedings of the Meeting of the Thermophysical Society, Bratislava, Slovakia.
Cited by
Nano-Enhanced Phase Change Materials in Latent Heat Thermal Energy Storage Systems: A Review
Tofani, K., & Tiari, S. (2021) · Energies · doi:10.3390/en14133821 · Cited by 114
Metadata
- Authors
- Barreneche, C., Martín, M., Calvo-de la Rosa, J., Majó, M., & Fernández, A. I.
- Affiliations
- Universitat de Barcelona (ES)
- Department of Materials Science and Physical Chemistry, Universitat de Barcelona, Martí i Franqués 1–11, 08007 Barcelona, Spain
- Corresponding author
- Barreneche, Camila
- Fernández, A. Inés
- Venue
- Molecules
- Publisher
- MDPI AG
- Published
- 2019-03-29
- Volume
- 24
- Issue
- 7
- Pages
- 1232
- ISSN
- 1420-3049 (ISSN-L)
- PMC
- PMC6479347
- OpenAlex
- W2924730119
- Cited by
- 31
- References
- 26
- Citations by year
- 2026: 4 · 2025: 4 · 2024: 6 · 2023: 6 · 2022: 4 · 2021: 5 · 2020: 1 · 2019: 1
- FWCI
- 1.55
- Type
- journal article
- Language
- en
- Open access
- gold
- dx.doi.org
- Licence
- Locations
- Molecules (publishedVersion, cc-by)
- PubMed Central (publishedVersion, cc-by)
- PubMed (publishedVersion)
- Dipòsit Digital de la Universitat de Barcelona (Universitat de Barcelona) (submittedVersion, cc-by)
- DOAJ (DOAJ: Directory of Open Access Journals) (submittedVersion, cc-by-sa)
- Funders
- Ministerio de Economía y Competitividad (ENE2015-64117-C5-2-R)
- Catalan Government (2017 SGR118)
- Horizon 2020 (Marie Skłodowska-Curie grant agreement No 712949)
- Universitat de Barcelona (Ajuts a la Docència i a la Recerca (ADR))
- Topics
- Physical Sciences › Engineering › Mechanical Engineering › Phase Change Materials Research
- Physical Sciences › Engineering › Mechanical Engineering › Adsorption and Cooling Systems
- Physical Sciences › Materials Science › Materials Chemistry › Thermal properties of materials
- Keywords
- nano-enhanced phase change materials, copper oxide nanoparticles, capric acid, palmitic acid, thermal conductivity enhancement, thermal energy storage, building energy efficiency, nanoparticle sedimentation, co-precipitation synthesis, thermal stability
- MeSH terms
- Construction Materials, Spectrum Analysis, Thermal Conductivity, Thermogravimetry, Nanoparticles, Chemical Phenomena
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.