The DOI matches its Crossref record; 31 of the 31 references it cites were found in a registry or an index.
Mechanism of Lithium Metal Penetration through Inorganic Solid Electrolytes
Abstract
Li deposition is observed and measured on a solid electrolyte in the vicinity of a metallic current collector. Four types of ion‐conducting, inorganic solid electrolytes are tested: Amorphous 70/30 mol% Li 2 S‐P 2 S 5, polycrystalline β‐Li 3 PS 4, and polycrystalline and single‐crystalline Li 6 La 3 ZrTaO 12 garnet. The nature of lithium plating depends on the proximity of the current collector to defects such as surface cracks and on the current density. Lithium plating penetrates/infiltrates at defects, but only above a critical current density. Eventually, infiltration results in a short circuit between the current collector and the Li‐source (anode). These results do not depend on the electrolytes shear modulus and are thus not consistent with the Monroe–Newman model for “dendrites.” The observations suggest that Li‐plating in pre‐existing flaws produces crack‐tip stresses which drive crack propagation, and an electrochemomechanical model of plating‐induced Li infiltration is proposed. Lithium short‐circuits through solid electrolytes occurs through a fundamentally different process than through liquid electrolytes. The onset of Li infiltration depends on solid‐state electrolyte surface morphology, in particular the defect size and density.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Issues and challenges facing rechargeable lithium batteries
Tarascon, J.-M., & Armand, M. (2001) · Nature · doi:10.1038/35104644 · Cited by 21,130
Armand, M., & Tarascon, J.-M. (2008) · Nature · doi:10.1038/451652a · Cited by 19,612
Lithium Batteries: Status, Prospects and Future
Scrosati, B., & Garche, J. (2010) · Journal of Power Sources · doi:10.1016/j.jpowsour.2009.11.048 · Cited by 5,153
Flemings, M. C. (1974) · Metallurgical transactions · doi:10.1007/bf02643923 · Cited by 3,403
Stability of a Planar Interface During Solidification of a Dilute Binary Alloy
Mullins, W. W., & Sekerka, R. F. (1964) · Journal of Applied Physics · doi:10.1063/1.1713333 · Cited by 3,151
Selective deposition and stable encapsulation of lithium through heterogeneous seeded growth
Yan, K., Lu, Z., Lee, H.-W., Xiong, F., Hsu, P.-C., Li, Y., Zhao, J., Chu, S., & Cui, Y. (2016) · Nature Energy · doi:10.1038/nenergy.2016.10 · Cited by 2,116
Dendrite-Free Lithium Deposition via Self-Healing Electrostatic Shield Mechanism
Ding, F., Xu, W., Graff, G. L., Zhang, J., Sushko, M. L., Chen, X., Shao, Y., Engelhard, M. H., Nie, Z., Xiao, J., et al. (2013) · Journal of the American Chemical Society · doi:10.1021/ja312241y · Cited by 2,107
The Impact of Elastic Deformation on Deposition Kinetics at Lithium/Polymer Interfaces
Monroe, C., & Newman, J. (2005) · Journal of The Electrochemical Society · doi:10.1149/1.1850854 · Cited by 1,701
Aurbach, D. (2002) · Solid State Ionics · doi:10.1016/s0167-2738(02)00080-2 · Cited by 1,697
Electrolytes for solid-state lithium rechargeable batteries: recent advances and perspectives
Quartarone, E., & Mustarelli, P. (2011) · Chemical Society Reviews · doi:10.1039/c0cs00081g · Cited by 1,607
Progress and prospective of solid-state lithium batteries
Takada, K. (2013) · Acta Materialia · doi:10.1016/j.actamat.2012.10.034 · Cited by 1,056
Khurana, R., Schaefer, J. L., Archer, L. A., & Coates, G. W. (2014) · Journal of the American Chemical Society · doi:10.1021/ja502133j · Cited by 880
Anomalous High Ionic Conductivity of Nanoporous β-Li3PS4
Liu, Z., Fu, W., Payzant, E. A., Yu, X., Wu, Z., Dudney, N. J., Kiggans, J., Hong, K., Rondinone, A. J., & Liang, C. (2013) · Journal of the American Chemical Society · doi:10.1021/ja3110895 · Cited by 879
A review of lithium and non-lithium based solid state batteries
Kim, J. G., Son, B., Mukherjee, S., Schuppert, N., Bates, A., Kwon, O., Choi, M. J., Chung, H. Y., & Park, S. (2015) · Journal of Power Sources · doi:10.1016/j.jpowsour.2015.02.054 · Cited by 783
Electrochemical in situ investigations of SEI and dendrite formation on the lithium metal anode
Bieker, G., Winter, M., & Bieker, P. (2015) · Physical Chemistry Chemical Physics · doi:10.1039/c4cp05865h · Cited by 777
Solid Electrolyte: the Key for High‐Voltage Lithium Batteries
Li, J., Ma, C., Chi, M., Liang, C., & Dudney, N. J. (2015) · Advanced Energy Materials · doi:10.1002/aenm.201401408 · Cited by 721
Intergranular Li metal propagation through polycrystalline Li6.25Al0.25La3Zr2O12 ceramic electrolyte
Cheng, E. J., Sharafi, A., & Sakamoto, J. S. (2016) · Electrochimica Acta · doi:10.1016/j.electacta.2016.12.018 · Cited by 708
Sharafi, A., Meyer, H. M., Nanda, J., Wolfenstine, J., & Sakamoto, J. (2016) · Journal of Power Sources · doi:10.1016/j.jpowsour.2015.10.053 · Cited by 536
The Effect of Interfacial Deformation on Electrodeposition Kinetics
Monroe, C., & Newman, J. (2004) · Journal of The Electrochemical Society · doi:10.1149/1.1710893 · Cited by 394
Aguesse, F., Manalastas, W. W., Buannic, L., del Amo, J. M. L., Singh, G., Llordés, A., & Kilner, J. A. (2017) · ACS Applied Materials & Interfaces · doi:10.1021/acsami.6b13925 · Cited by 386
Sub-surface mechanical damage distributions during grinding of fused silica
Suratwala, T., Wong, L., Miller, P., Feit, M. D., Menapace, J., Steele, R., Davis, P., & Walmer, D. (2006) · Journal of Non-Crystalline Solids · doi:10.1016/j.jnoncrysol.2006.09.012 · Cited by 302
Aryanfar, A., Brooks, D., Merinov, B. V., Goddard, W. A., Colussi, A. J., & Hoffmann, M. R. (2014) · The Journal of Physical Chemistry Letters · doi:10.1021/jz500207a · Cited by 226
Wagner, R., Redhammer, G. J., Rettenwander, D., Senyshyn, A., Schmidt, W., Wilkening, M., & Amthauer, G. (2016) · Chemistry of Materials · doi:10.1021/acs.chemmater.6b00038 · Cited by 219
Self-citationSakuda, A., Hayashi, A., Takigawa, Y., Higashi, K., & Tatsumisago, M. (2013) · Journal of the Ceramic Society of Japan · doi:10.2109/jcersj2.121.946 · Cited by 217
Kim, J.-S., Kim, D. W., Jung, H. T., & Choi, J. W. (2015) · Chemistry of Materials · doi:10.1021/cm503447u · Cited by 199
Ultrastrong Polyoxyzole Nanofiber Membranes for Dendrite-Proof and Heat-Resistant Battery Separators
Hao, X., Zhu, J., Jiang, X., Wu, H., Qiao, J., Sun, W., Wang, Z., & Sun, K. (2016) · Nano Letters · doi:10.1021/acs.nanolett.5b05133 · Cited by 197
Wandt, J., Marino, C., Gasteiger, H. A., Jakes, P., Eichel, R.-A., & Granwehr, J. (2015) · Energy & Environmental Science · doi:10.1039/c4ee02730b · Cited by 194
Lithium Dendrite Formation on a Lithium Metal Anode from Liquid, Polymer and Solid Electrolytes
TAKEDA, Y., YAMAMOTO, O., & IMANISHI, N. (2016) · Electrochemistry · doi:10.5796/electrochemistry.84.210 · Cited by 192
Dendrite-separator interactions in lithium-based batteries
Jana, A., Ely, D. R., & García, R. E. (2015) · Journal of Power Sources · doi:10.1016/j.jpowsour.2014.11.056 · Cited by 184
The breakdown of β-alumina ceramic electrolyte
Armstrong, R. D., Dickinson, T., & Turner, J. (1974) · Electrochimica Acta · doi:10.1016/0013-4686(74)85065-6 · Cited by 124
Lithium Dendrite Suppression with UV-Curable Polysilsesquioxane Separator Binders
Na, W., Lee, A. S., Lee, J. H., Hwang, S. S., Kim, E., Hong, S. M., & Koo, C. M. (2016) · ACS Applied Materials & Interfaces · doi:10.1021/acsami.6b02735 · Cited by 85
Cited by
Fundamentals of inorganic solid-state electrolytes for batteries
Famprikis, T., Canepa, P., Dawson, J. A., Islam, M. S., & Masquelier, C. (2019) · Nature Materials · doi:10.1038/s41563-019-0431-3 · Cited by 2,525
Designing solid-state electrolytes for safe, energy-dense batteries
Zhao, Q., Stalin, S., Zhao, C.-Z., & Archer, L. A. (2020) · Nature Reviews Materials · doi:10.1038/s41578-019-0165-5 · Cited by 2,372
Albertus, P., Babinec, S., Litzelman, S., & Newman, A. (2017) · Nature Energy · doi:10.1038/s41560-017-0047-2 · Cited by 1,888
High electronic conductivity as the origin of lithium dendrite formation within solid electrolytes
Han, F., Westover, A. S., Yue, J., Fan, X., Wang, F., Chi, M., Leonard, D. N., Dudney, N. J., Wang, H., & Wang, C. (2019) · Nature Energy · doi:10.1038/s41560-018-0312-z · Cited by 1,695
Chen, R., Li, Q., Yu, X., Chen, L., & Li, H. (2020) · Chemical Reviews · doi:10.1021/acs.chemrev.9b00268 · Cited by 1,678
Metadata
- Authors
- Porz, L., Swamy, T., Sheldon, B. W., Rettenwander, D., Frömling, T., Thaman, H. L., Berendts, S., Uecker, R., Carter, W. C., & Chiang, Y.
- Venue
- Advanced Energy Materials
- Publisher
- Wiley
- Published
- 2017-07-06
- Volume
- 7
- Issue
- 20
- ISSN
- 1614-6832 (ISSN-L)
- 1614-6840
- OpenAlex
- W2725925537
- Cited by
- 1,117
- References
- 31
- FWCI
- 37.59
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.