The DOI matches its Crossref record; 29 of the 29 references it cites were found in a registry or an index.
The influence of small amounts of KCl(s) on the high temperature corrosion of a Fe‐2.25Cr‐1Mo steel at 400 and 500°C
Abstract
This paper reports the oxidation behaviour of a low‐alloyed steel (Fe‐2.25Cr‐1Mo) in the presence of small amounts of KCl(s) at 400 and 500°C. Cleaned and polished sample coupons were exposed in a horizontal tube furnace with exposure times ranging from one hour to one week. The flue gas composition was 5% O 2 with 40% H 2 O in N 2, and 0.1 mg KCl/cm 2 was deposited on the samples prior to exposure. X‐ray diffraction (XRD) and scanning electron microscopy (SEM) with energy dispersive X‐ray (EDX) analysis were used to characterize the samples. Cross sections were prepared by means of focused ion beam (FIB) and broad ion beam (BIB). At 400°C there was a modest mass gain in the absence of KCl. In the presence of KCl, mass gain is significantly increased and a rapid attack is evident already after short exposure times. At 500°C, the mass gains in the absence of KCl were considerably higher than at 400°C, especially after 168 hours of exposure. KCl had an effect at shorter exposure times, but after one week the samples exposed with and without KCl had mass gains of comparable magnitude.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
In the citing paper
“It is anticipated from literature [15,17,20,21], that a mixed deposit chemistry will decrease the melting point of the resulting mixture.This in turn is likely to shift the bell-shaped curve for fireside corrosion damage; moving it towards lower temperatures [15,17,20,21].”
From Fireside corrosion and deposition on heat exchangers in biomass combustion systems (2023) · cites this paper as [21]
Citations
Cites
Thermochemical Data of Pure Substances
Barin, I. (1995) · doi:10.1002/9783527619825 · Cited by 4,241
A quantitative demonstration of the grain boundary diffusion mechanism for the oxidation of metals
Atkinson, A., Taylor, R. I., & Hughes, A. E. (1982) · Philosophical Magazine A · doi:10.1080/01418618208239905 · Cited by 2,540
(2006) · Electrochemistry and Corrosion Science · doi:10.1007/1-4020-7860-9_10 · Cited by 1,814
Introduction to high temperature oxidation of metals
Birks, N., & Meier, G. H. (1983) · Cited by 848
The implications of chlorine-associated corrosion on the operation of biomass-fired boilers
Nielsen, H. P., Frandsen, F. J., Dam-Johansen, K., & Baxter, L. L. (2000) · Progress in Energy and Combustion Science · doi:10.1016/s0360-1285(00)00003-4 · Cited by 785
Review of the High-Temperature Oxidation of Iron and Carbon Steels in Air or Oxygen
Chen, R. Y., & Yeun, W. Y. D. (2003) · Oxidation of Metals · doi:10.1023/a:1023685905159 · Cited by 665
Grabke, H. J., Reese, E., & Spiegel, M. (1995) · Corrosion Science · doi:10.1016/0010-938x(95)00011-8 · Cited by 537
Stott, F. H. (1982) · Corrosion Science · doi:10.1016/0010-938x(82)90037-3 · Cited by 394
Zahs, A., Spiegel, M., & Grabke, H. J. (2000) · Corrosion Science · doi:10.1016/s0010-938x(99)00142-0 · Cited by 365
High temperature corrosion of coatings and boiler steels below chlorine-containing salt deposits
Uusitalo, M. A., Vuoristo, P. M. J., & Mäntylä, T. A. (2004) · Corrosion Science · doi:10.1016/j.corsci.2003.09.026 · Cited by 260
KCl Induced Corrosion of a 304-type Austenitic Stainless Steel at 600°C; The Role of Potassium
Pettersson, J., Asteman, H., Svensson, J. E., & Johansson, L. G. (2005) · Oxidation of Metals · doi:10.1007/s11085-005-5704-3 · Cited by 182
Self-citationPoint defects and cation tracer diffusion in (CrFe1 − )3 − O4 spinels
Töpfer, J., Aggarwal, S., & Dieckmann, R. (1995) · Solid State Ionics · doi:10.1016/0167-2738(95)00190-h · Cited by 169
Zahs, A., Spiegel, M., & Grabke, H. J. (1999) · Materials and Corrosion · doi:10.1002/(sici)1521-4176(199910)50:10<561::aid-maco561>3.0.co;2-l · Cited by 146
High temperature corrosion of coatings and boiler steels in oxidizing chlorine-containing atmosphere
Uusitalo, M. A., Vuoristo, P. M. J., & Mäntylä, T. (2003) · Materials Science and Engineering A · doi:10.1016/s0921-5093(02)00537-3 · Cited by 140
Wang, F., & Shu, Y. (2003) · Oxidation of Metals · doi:10.1023/a:1023083309041 · Cited by 110
Li, Y. S., Niu, Y., & Wu, W. T. (2003) · Materials Science and Engineering A · doi:10.1016/s0921-5093(02)00386-6 · Cited by 103
Oxidation of iron at 400–600°C in dry and wet O2
Pujilaksono, B., Jonsson, T., Halvarsson, M., Svensson, J., & Johansson, L. (2010) · Corrosion Science · doi:10.1016/j.corsci.2010.01.002 · Cited by 97
Self-citationAbels, J.-M., & Strehblow, H. (1997) · Corrosion Science · doi:10.1016/s0010-938x(96)00112-6 · Cited by 79
Jonsson, T., Froitzheim, J., Pettersson, J., Svensson, J.-E., Johansson, L.-G., & Halvarsson, M. (2009) · Oxidation of Metals · doi:10.1007/s11085-009-9156-z · Cited by 76
Self-citationLocal reactions of KCl particles with iron, nickel and chromium surfaces
Cha, S. C., & Spiegel, M. (2006) · Materials and Corrosion · doi:10.1002/maco.200503903 · Cited by 58
An ESEM in situ investigation of the influence of H2O on iron oxidation at 500°C
Jonsson, T., Pujilaksono, B., Hallström, S., Ågren, J., Svensson, J., Johansson, L.-G., & Halvarsson, M. (2009) · Corrosion Science · doi:10.1016/j.corsci.2009.05.016 · Cited by 55
Self-citationMa, H. T., Zhou, C., & Wang, L. (2009) · Corrosion Science · doi:10.1016/j.corsci.2009.05.014 · Cited by 49
Pettersson, C., Johansson, L.-G., & Svensson, J.-E. (2008) · Oxidation of Metals · doi:10.1007/s11085-008-9118-x · Cited by 40
Self-citationThe Effect of Traces of SO2 on Iron Oxidation: A Microstructural Study
Jonsson, T., Järdnäs, A., Svensson, J. E., Johansson, L.-G., & Halvarsson, M. (2007) · Oxidation of Metals · doi:10.1007/s11085-007-9051-4 · Cited by 36
Self-citationLow Temperature Oxidation of Pure Iron: Growth Kinetics and Scale Morphologies
Bertrand, N., Desgranges, C., Gauvain, D., Monceau, D., & Poquillon, D. (2004) · Materials science forum · doi:10.4028/www.scientific.net/msf.461-464.591 · Cited by 28
Proff, C., Jonsson, T., Pettersson, C., Svensson, J. E., Johansson, L.-G., & Halvarsson, M. (2009) · Materials at High Temperatures · doi:10.3184/096034009x464339 · Cited by 23
Self-citationŚroda, S., Mäkipää, M., Cha, S.-Y., & Spiegel, M. (2006) · Materials and Corrosion · doi:10.1002/maco.200503906 · Cited by 15
Środa, S., & Tuurna, S. (2006) · Materials and Corrosion · doi:10.1002/maco.200503931 · Cited by 14
Ueda, M., Kawamura, K., & Maruyama, T. (2006) · Materials science forum · doi:10.4028/0-87849-409-x.37 · Cited by 6
Research works printed but not linked: 5
- Pettersson J., 2008, High Temperature Corrosion and Protection of Materials 7, Pts 1 and 2, 367
- C.Gleave J. M.Calvert D. G.Lees P. C.Rowlands in:Proceedings of the Royal Society of London Series A – Mathematical Physical and Engineering Sciences1982. London. vol. 379 no.1777.
- Pujilaksono B., 2009, Oxidation of Metals
- Pujilaksono B., 2009, Oxidation of Metals
- Jonsson T., 2010, Corrosion Science
Cited by
Ma, W., Wenga, T., Frandsen, F. J., Yan, B., & Chen, G. (2020) · Progress in Energy and Combustion Science · doi:10.1016/j.pecs.2019.100789 · Cited by 275
Kassman, H., Liske, J., Steenari, B., & Åmand, L.-E. (2011) · Fuel Processing Technology · doi:10.1016/j.fuproc.2011.06.025 · Cited by 167
Alkali Induced High Temperature Corrosion of Stainless Steel: The Influence of NaCl, KCl and CaCl2
Karlsson, S., Pettersson, J., Johansson, L. G., & Svensson, J. E. (2012) · Oxidation of Metals · doi:10.1007/s11085-012-9293-7 · Cited by 118
Self-citationJafari, R., & Sadeghi, E. (2019) · Corrosion Science · doi:10.1016/j.corsci.2019.06.021 · Cited by 92
Jonsson, T., Folkeson, N., Svensson, J., Johansson, L.-G., & Halvarsson, M. (2011) · Corrosion Science · doi:10.1016/j.corsci.2011.03.007 · Cited by 88
Self-citation
Metadata
- Authors
- Folkeson, N., Jonsson, T., Halvarsson, M., Johansson, L. ‐., & Svensson, J. ‐.
- Affiliations
- Chalmers University of Technology (SE)
- Corresponding author
- Jonsson, T.
- Venue
- Materials and Corrosion
- Publisher
- Wiley
- Published
- 2010-12-23
- Volume
- 62
- Issue
- 7
- Pages
- 606-615
- ISSN
- 0043-2822 (ISSN-L)
- 0947-5117
- 1521-4176
- OpenAlex
- W2073148583
- Cited by
- 93
- References
- 29
- Citations by year
- 2026: 2 · 2025: 5 · 2024: 7 · 2023: 7 · 2022: 11 · 2021: 5 · 2020: 4 · 2019: 14 · 2018: 5 · 2017: 5 · 2016: 5 · 2015: 10 · 2014: 5 · 2013: 3 · 2012: 2
- FWCI
- 5.02
- Type
- journal article
- Language
- en
- Open access
- closed
- Locations
- Materials and Corrosion (publishedVersion)
- Chalmers Research (Chalmers University of Technology) (submittedVersion)
- Topics
- Physical Sciences › Materials Science › Surfaces, Coatings and Films › High-Temperature Coating Behaviors
- Physical Sciences › Engineering › Mechanical Engineering › High Temperature Alloys and Creep
- Physical Sciences › Materials Science › Materials Chemistry › Material Properties and Failure Mechanisms
- Keywords
- high-temperature corrosion, potassium chloride, chloride-induced corrosion, low-alloy steel, oxidation, mass gain, flue gas, water vapor, temperature dependence
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.