The DOI matches its Crossref record; 29 of the 29 references it cites were found in a registry or an index.
Nanosecond laser textured superhydrophobic metallic surfaces and their chemical sensing applications
Open accessAbstract
This work demonstrates superhydrophobic behavior on nanosecond laser patterned copper and brass surfaces. Compared with ultrafast laser systems previously used for such texturing, infrared nanosecond fiber lasers offer a lower cost and more robust system combined with potentially much higher processing rates. The wettability of the textured surfaces develops from hydrophilicity to superhydrophobicity over time when exposed to ambient conditions. The change in the wetting property is attributed to the partial deoxidation of oxides on the surface induced during laser texturing. Textures exhibiting steady state contact angles of up to ∼152° with contact angle hysteresis of around 3–4° have been achieved. Interestingly, the superhydrobobic surfaces have the self-cleaning ability and have potential for chemical sensing applications. The principle of these novel chemical sensors is based on the change in contact angle with the concentration of methanol in a solution. To demonstrate the principle of operation of such a sensor, it is found that the contact angle of methanol solution on the superhydrophobic surfaces exponentially decays with increasing concentration. A significant reduction, of 128°, in contact angle on superhydrophobic brass is observed, which is one order of magnitude greater than that for the untreated surface (12°), when percent composition of methanol reaches to 28%.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Wettability of porous surfaces
Cassie, A. B. D., & Baxter, S. (1944) · Transactions of the Faraday Society · doi:10.1039/tf9444000546 · Cited by 13,807
RESISTANCE OF SOLID SURFACES TO WETTING BY WATER
Wenzel, R. N. (1936) · Industrial & Engineering Chemistry · doi:10.1021/ie50320a024 · Cited by 13,316
Purity of the sacred lotus, or escape from contamination in biological surfaces
Barthlott, W., & Neinhuis, C. (1997) · Planta · doi:10.1007/s004250050096 · Cited by 6,860
Self-cleaning surfaces — virtual realities
Blossey, R. (2003) · Nature Materials · doi:10.1038/nmat856 · Cited by 2,314
Superhydrophobic surfaces: from structural control to functional application
Zhang, X., Shi, F., Niu, J., Jiang, Y., & Wang, Z. (2008) · J. Mater. Chem. · doi:10.1039/b711226b · Cited by 1,768
Direct femtosecond laser surface nano/microstructuring and its applications
Vorobyev, A. Y., & Guo, C. (2013) · Laser & Photonics Reviews · doi:10.1002/lpor.201200017 · Cited by 1,172
Reversible Switching between Superhydrophilicity and Superhydrophobicity
Sun, T., Wang, G., Feng, L., Liu, B., Ma, Y., Jiang, L., & Zhu, D. (2004) · Angewandte Chemie International Edition · doi:10.1002/anie.200352565 · Cited by 1,128
Yan, Y. Y., Gao, N., & Barthlott, W. (2011) · Advances in Colloid and Interface Science · doi:10.1016/j.cis.2011.08.005 · Cited by 1,000
Hydrophilic and superhydrophilic surfaces and materials
Drelich, J., Chibowski, E., Meng, D. D., & Terpilowski, K. (2011) · Soft Matter · doi:10.1039/c1sm05849e · Cited by 911
Microstructuring of silicon with femtosecond laser pulses
Her, T.-H., Finlay, R. J., Wu, C., Deliwala, S., & Mazur, E. (1998) · Applied Physics Letters · doi:10.1063/1.122241 · Cited by 813
Cited by
Yang, Z., Liu, X., & Tian, Y. (2019) · Journal of Colloid and Interface Science · doi:10.1016/j.jcis.2018.08.082 · Cited by 292
Laser textured superhydrophobic surfaces and their applications for homogeneous spot deposition
Ta, V. D., Dunn, A., Wasley, T. J., Li, J., Kay, R. W., Stringer, J., Smith, P. J., Esenturk, E., Connaughton, C., & Shephard, J. D. (2016) · Applied Surface Science · doi:10.1016/j.apsusc.2016.01.019 · Cited by 286
Self-citationSamanta, A., Wang, Q., Shaw, S. K., & Ding, H. (2020) · Materials & Design · doi:10.1016/j.matdes.2020.108744 · Cited by 275
Metadata
- Authors
- Ta, D. V., Dunn, A., Wasley, T. J., Kay, R. W., Stringer, J., Smith, P. J., Connaughton, C., & Shephard, J. D.
- Venue
- Applied Surface Science
- Publisher
- Elsevier BV
- Published
- 2015-12
- Volume
- 357
- Pages
- 248-254
- ISSN
- 0169-4332 (ISSN-L)
- OpenAlex
- W1229386342
- Cited by
- 351
- References
- 29
- FWCI
- 12.09
- Type
- journal article
- Language
- en
- Open access
- hybrid
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.