Student or educator? Sign up with your school email and get 6 months of Pro free.
CoChat
Cited by 240

The DOI matches its Crossref record; 7 of the 7 references it cites were found in a registry or an index.

Ultra-microporous adsorbents prepared from vine shoots-derived biochar with high CO2 uptake and CO2/N2 selectivity

Open access
Manyà, Joan J., González, Belén, Azuara, Manuel, Arner, Gabriel · 2018 · Chemical Engineering Journal

Abstract

There is a growing interest in developing renewable biomass-based adsorbents to be used in numerous applications, including CO2 capture in postcombustion conditions. In the present study, several activated carbons (ACs) were produced from vine shoots-derived biochar through both physical and chemical activation using CO2 and KOH, respectively. The performance of these ACs was tested in terms of CO2 uptake capacity at an absolute pressure of 15 kPa and at different temperatures (0, 25, and 75 °C), apparent selectivity towards CO2 over N2, and isosteric heat of adsorption. At 25 °C, the chemically ACs with KOH impregnation exhibited the highest CO2 adsorption capacity, which was similar or even higher than those recently reported for a number of carbon-based adsorbents. However, the AC prepared through physical activation with CO2 at 800 °C and a soaking time of 1 h appears as the most promising adsorbent analyzed here, due to its higher CO2 uptake capacity and adsorption rate at relatively high temperature (75 °C), its relatively high selectivity at this temperature, and its apparently low energy demand for regeneration. Given that physical activation with CO2 is more feasible at industrial scale than chemical activation using corrosive alkalis, the results reported here are encouraging for further development of vine shoots-derived adsorbents.

Overview

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1016/j.cej.2018.01.092

Cites

7 of 7 references verified0 citation errors · 0 not checkable

Statistics

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Show all 7 references

Research works printed but not linked: 38

  1. Yang, 2016, Adsorption of CO2 by petroleum coke nitrogen-doped porous carbons synthesized by combining ammoxidation with KOH activation, Ind. Eng. Chem. Res., 55, 757, 10.1021/acs.iecr.5b04038 · DOI
  2. Baxter, 2009, Nanoscale design to enable the revolution in renewable energy, Energy Environ. Sci., 2, 559, 10.1039/b821698c · DOI · Paper page
  3. Hudson, 2012, Unconventional, highly selective CO2 adsorption in Zeolite SSZ-13, J. Am. Chem. Soc., 134, 1970, 10.1021/ja210580b · DOI · Paper page
  4. Silvestre-Albero, 2014, Micro/mesoporous activated carbons derived from polyaniline: promising candidates for CO2 adsorption, Ind. Eng. Chem. Res., 53, 15398, 10.1021/ie5013129 · DOI
  5. McDonald, 2015, Cooperative insertion of CO2 in diamine-appended metal-organic frameworks, Nature, 519, 303, 10.1038/nature14327 · DOI · Paper page
  6. Yang, 2017, Efficient CO2 capture by porous carbons derived from coconut shell, Energy Fuels, 31, 4287, 10.1021/acs.energyfuels.7b00633 · DOI
  7. Heidari, 2014, Evaluation of CO2 adsorption with eucalyptus wood based activated carbon modified by ammonia solution through heat treatment, Chem. Eng. J., 254, 503, 10.1016/j.cej.2014.06.004 · DOI · Paper page
  8. Shahkarami, 2015, Selective CO2 capture by activated carbons: evaluation of the effects of precursors and pyrolysis process, Energy Fuels, 29, 7433, 10.1021/acs.energyfuels.5b00470 · DOI
  9. Li, 2015, Preparation of porous carbons with high low-pressure CO2 uptake by KOH activation of rice husk char, Fuel, 139, 68, 10.1016/j.fuel.2014.08.027 · DOI · Paper page
  10. Cheung, 2014, Zeolites and related sorbents with narrow pores for CO2 separation from flue gas, RSC Adv., 4, 14480, 10.1039/C3RA48052F · DOI · Paper page
  11. Zhao, 2015, Microporous carbonaceous adsorbents for CO2 separation via selective adsorption, RSC Adv., 5, 30310, 10.1039/C5RA00569H · DOI
  12. Sevilla, 2013, Assessment of the role of micropore size and N-doping in CO2 capture by porous carbons, ACS Appl. Mater. Interfaces, 5, 6360, 10.1021/am401423b · DOI · Paper page
  13. Kumar, 2015, Effect of nitrogen doping on the CO2 adsorption behavior in nanoporous carbon structures: a molecular simulation study, J. Phys. Chem. C, 119, 22310, 10.1021/acs.jpcc.5b06017 · DOI
  14. Azuara, 2017, Study on the effects of using a carbon dioxide atmosphere on the properties of vine shoots-derived biochar, J. Anal. Appl. Pyrol., 124, 719, 10.1016/j.jaap.2016.11.022 · DOI
  15. Corcho-Corral, 2005, Development of activated carbon using vine shoots (Vitis Vinifera) and its use for wine treatment, J. Agric. Food Chem., 53, 644, 10.1021/jf048824d · doi:10.1021/jf048824d
  16. Barroso-Bogeat, 2015, Temperature dependence of the electrical conductivity of activated carbons prepared from vine shoots by physical and chemical activation methods, Micropor. Mesopor. Mater., 209, 90, 10.1016/j.micromeso.2014.07.023 · DOI
  17. Nabais, 2010, Thermal conversion of a novel biomass agricultural residue (vine shoots) into activated carbon using activation with CO2, J. Anal. Appl. Pyrol., 87, 8, 10.1016/j.jaap.2009.09.004 · DOI
  18. Manyà, 2016, Effects of pressure and the addition of a rejected material from municipal waste composting on the pyrolysis of two-phase olive mill waste, Energy Fuels, 30, 8055, 10.1021/acs.energyfuels.6b01579 · DOI
  19. Lee, 2014, Preparation and characterization of pitch-based nanoporous carbons for improving CO2 capture, J. Solid State Chem., 215, 201, 10.1016/j.jssc.2014.03.038 · DOI
  20. Plaza, 2014, Production of microporous biochars by single-step oxidation: Effect of activation conditions on CO2 capture, Appl. Energy, 114, 551, 10.1016/j.apenergy.2013.09.058 · DOI · Paper page
  21. Rouquerol, 2007, Is the bet equation applicable to microporous adsorbents?, Stud. Surf. Sci. Catal., 160, 49, 10.1016/S0167-2991(07)80008-5 · DOI · Paper page
  22. Kim, 2016, Applicability of using CO2 adsorption isotherms to determine BET surface areas of microporous materials, Micropor. Mesopor. Mater., 224, 294, 10.1016/j.micromeso.2016.01.003 · DOI · Paper page
  23. Parshetti, 2015, Biomass derived low-cost microporous adsorbents for efficient CO2 capture, Fuel, 148, 246, 10.1016/j.fuel.2015.01.032 · DOI · Paper page
  24. Li, 2017, Improving low-pressure CO2 capture performance of N-doped active carbons by adjusting flow rate of protective gas during alkali activation, Carbon, 114, 496, 10.1016/j.carbon.2016.12.039 · DOI
  25. Ren, 2017, N-doped porous carbons with exceptionally high CO2 selectivity for CO2 capture, Carbon, 114, 473, 10.1016/j.carbon.2016.12.056 · DOI · Paper page
  26. Kruk, 1998, Comparative analysis of simple and advanced sorption methods for assessment of microporosity in activated carbons, Carbon, 36, 1447, 10.1016/S0008-6223(98)00137-7 · DOI
  27. Guo, 2016, Role of hydrogen peroxide preoxidizing on CO2 adsorption of nitrogen-doped carbons produced from coconut shell, ACS Sustain. Chem. Eng., 4, 2806, 10.1021/acssuschemeng.6b00327 · DOI
  28. Serafin, 2017, Highly microporous activated carbons from biomass for CO2 capture and effective micropores at different conditions, J. CO2 Util., 18, 73, 10.1016/j.jcou.2017.01.006 · DOI · Paper page
  29. Hao, 2017, High-performance magnetic activated carbon from solid waste from lignin conversion processes. 1. their use as adsorbents for CO2, ACS Sustain. Chem. Eng., 5, 3087, 10.1021/acssuschemeng.6b02795 · DOI
  30. Cong, 2015, Highly selective CO2 capture by nitrogen enriched porous carbons, Carbon, 92, 297, 10.1016/j.carbon.2015.04.052 · DOI
  31. Sethia, 2015, Comprehensive study of ultra-microporous nitrogen-doped activated carbon for CO2 capture, Carbon, 93, 68, 10.1016/j.carbon.2015.05.017 · DOI · Paper page
  32. Deng, 2014, Superior CO2 adsorption on pine nut shell-derived activated carbons and the effective micropores at different temperatures, Chem. Eng. J., 253, 46, 10.1016/j.cej.2014.04.115 · DOI · Paper page
  33. Coromina, 2016, Biomass-derived activated carbon with simultaneously enhanced CO2 uptake for both pre and post combustion capture applications, J. Mater. Chem. A, 4, 280, 10.1039/C5TA09202G · DOI · Paper page
  34. Chen, 2017, A new MOF-505@GO composite with high selectivity for CO2/CH4 and CO2/N2 separation, Chem. Eng. J., 308, 1065, 10.1016/j.cej.2016.09.138 · DOI · Paper page
  35. Landaverde-Alvarado, 2017, Gas sorption and kinetics of CO2 sorption and transport in a polymorphic microporous MOF with open Zn (II) coordination sites, J. CO2 Util., 19, 40, 10.1016/j.jcou.2017.01.029 · DOI
  36. Shafeeyan, 2015, Adsorption equilibrium of carbon dioxide on ammonia-modified activated carbon, Chem. Eng. Res. Des., 104, 42, 10.1016/j.cherd.2015.07.018 · DOI
  37. Jang, 2018, Development of a cost-effective CO2 adsorbent from petroleum coke via KOH activation, Appl. Surf. Sci., 429, 62, 10.1016/j.apsusc.2017.08.075 · DOI
  38. Chowdhury, 2016, Three-dimensional graphene-based porous adsorbents for postcombustion CO2 capture, Ind. Eng. Chem. Res., 55, 7906, 10.1021/acs.iecr.5b04052 · DOI

Cited by

Metadata

Authors
Manyà, J. J., González, B., Azuara, M., & Arner, G.
Venue
Chemical Engineering Journal
Publisher
Elsevier BV
Published
2018-08
Volume
345
Pages
631-639
ISSN
1385-8947 (ISSN-L)
OpenAlex
W2790168990
Cited by
240
References
7
FWCI
11.19
Type
journal article
Language
en
Open access
green
Licence
  • www.elsevier.com/tdm/userlicense/1.0/ (tdm)
  • www.elsevier.com/legal/tdmrep-license (tdm)

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.