Student or educator? Sign up with your school email and get 6 months of Pro free.
Cited by 189

The DOI matches its Crossref record; 24 of the 24 references it cites were found in a registry or an index.

Role of a Hydroxide Layer on Cu Electrodes in Electrochemical CO2 Reduction

Open access
Iijima, Go, Inomata, Tomohiko, Yamaguchi, Hitoshi, Ito, Miho, Masuda, Hideki·2019·ACS Catalysis

Abstract

Abstract Cu is known as one of the most promising metallic catalysts for conversion of CO2 to hydrocarbons such as methane, ethylene, and ethanol by electrochemical reduction. The oxide-derived Cu (OD-Cu) moiety has been investigated as a candidate for enhancing the activity for CO2 electrochemical reduction to C2+ products. The reduction process is affected by catalytic grain boundary, local pH, residual oxygen atoms, and other features of the catalysts. In order to understand the detailed mechanism, we performed in situ attenuated total reflection surface-enhanced infrared absorption spectroscopy (in situ ATR-SEIRAS) measurements for CO2 reduction using several different Cu electrodes whose oxidation states are controlled. The spectroscopic investigations demonstrate that a copper oxide electrode (Cu2O) has low activity against CO2 reduction on the basis of low-level detection of CO as an intermediate of CO2 reduction. On the other hand, other Cu electrodes possessing an OH layer on the Cu surface (Cu(OH)2/Cu) and metallic Cu exhibit higher CO2 reduction activity with significantly greater detection of produced CO. When the metallic Cu electrode is used, only one peak (2060 cm–1) assignable to CO bound to the atop site of Cu is observed. However, additional peaks are detected in the range of 1900–2100 cm–1 when the Cu(OH)2/Cu electrode is used. To understand these findings, the adsorption energy of CO on a Cu(OH)2/Cu electrode and the CO stretching frequency were evaluated by performing DFT calculations. The adsorption energy is enhanced and the CO stretching frequencies are shifted to lower energy in comparison with those using a metallic Cu electrode. These results indicate that it is predominantly favorable to adsorb some CO molecules near the OH moiety of the Cu(OH)2/Cu electrode and to induce interactions of CO molecules with each other. This observation is consistent with the results of controlled potential electrolysis (CPE), which generates C2+ products as previously reported. When CPE is carried out in D2O solution, residual and/or adsorbed OD– groups on Cu are detected by ATR-SEIRAS and the surface of the Cu(OH)2/Cu electrode is confirmed to be metallic Cu, as measured by in situ Raman and XPS. From the ATR-SEIRAS experiments when switching from under CO2 to Ar during the electrochemical reduction, the OH layer is suggested to prevent deactivation of the Cu electrode via formation of the CO layer, which is detected as a bridge-bounded form on the metallic Cu electrode. The above findings indicate that the OH layer provides the advantage of attracting CO molecules closer to each other while reducing them to C2+ products without any degradation during electrolysis.

Overview

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1021/acscatal.9b00896

Cites

24 of 24 references verified0 citation errors · 0 not checkable

Statistics

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Show all 24 references

Cited by

Metadata

Authors
Iijima, G., Inomata, T., Yamaguchi, H., Ito, M., & Masuda, H.
Venue
ACS Catalysis
Published
2019-06-03
Volume
9
Issue
7
Pages
6305-6319
ISSN
2155-5435 (ISSN-L)
OpenAlex
W2948819895
Cited by
189
References
24
FWCI
3.30
Type
journal article
Language
en
Open access
hybrid

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.