The DOI matches its Crossref record; 26 of the 26 references it cites were found in a registry or an index.
Polyethylenimine-Impregnated Mesoporous Silica: Effect of Amine Loading and Surface Alkyl Chains on CO2 Adsorption
Abstract
Poly(ethyleneimine) (PEI) supported on pore-expanded MCM-41 whose surface is covered with a layer of long-alkyl chains was found to be a more efficient CO(2) adsorbent than PEI supported on the corresponding calcined silica and all PEI-impregnated materials reported in the literature. The layer of surface alkyl chains plays an important role in enhancing the dispersion of PEI, thus decreasing the diffusion resistance. It was also found that at low temperature, adsorbents with relatively low PEI contents are more efficient than their highly loaded counterparts because of the increased adsorption rate. Extensive CO(2) adsorption-desorption cycling showed that the use of humidified feed and purge gases affords materials with enhanced stability, despite limited loss due to amine evaporation.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Adsorbent Materials for Carbon Dioxide Capture from Large Anthropogenic Point Sources
Choi, S., Drese, J. H., & Jones, C. W. (2009) · ChemSusChem · doi:10.1002/cssc.200900036 · Cited by 2,596
Caskey, S. R., Wong-Foy, A. G., & Matzger, A. J. (2008) · Journal of the American Chemical Society · doi:10.1021/ja8036096 · Cited by 1,815
Adsorption Equilibrium of Methane, Carbon Dioxide, and Nitrogen on Zeolite 13X at High Pressures
Cavenati, S., Grande, C. A., & Rodrigues, A. E. (2004) · Journal of Chemical & Engineering Data · doi:10.1021/je0498917 · Cited by 1,147
Xu, X., Song, C., Andresen, J. M., Miller, B. G., & Scaroni, A. W. (2002) · Energy & Fuels · doi:10.1021/ef020058u · Cited by 1,097
Amine-Grafted MCM-48 and Silica Xerogel as Superior Sorbents for Acidic Gas Removal from Natural Gas
Huang, H. Y., Yang, R. T., Chinn, D., & Munson, C. L. (2003) · Industrial & Engineering Chemistry Research · doi:10.1021/ie020440u · Cited by 713
Stabilization of Amine-Containing CO2 Adsorbents: Dramatic Effect of Water Vapor
Sayari, A., & Belmabkhout, Y. (2010) · Journal of the American Chemical Society · doi:10.1021/ja1013773 · Cited by 635
Self-citationAdsorptive removal of carbon dioxide using polyethyleneimine-loaded mesoporous silica materials
Son, W.-J., Choi, J.-S., & Ahn, W.-S. (2008) · Microporous and Mesoporous Materials · doi:10.1016/j.micromeso.2007.10.049 · Cited by 618
Flue gas treatment via CO2 adsorption
Sayari, A., Belmabkhout, Y., & Serna-Guerrero, R. (2011) · Chemical Engineering Journal · doi:10.1016/j.cej.2011.02.007 · Cited by 594
Self-citationHigh-Pressure Adsorption Equilibria of Methane and Carbon Dioxide on Several Activated Carbons
Himeno, S., Komatsu, T., & Fujita, S. (2005) · Journal of Chemical & Engineering Data · doi:10.1021/je049786x · Cited by 592
Adsorption characteristics of carbon dioxide on organically functionalized SBA-15
Hiyoshi, N., Yogo, K., & Yashima, T. (2005) · Microporous and Mesoporous Materials · doi:10.1016/j.micromeso.2005.06.010 · Cited by 588
“Molecular Basket” Sorbents for Separation of CO2 and H2S from Various Gas Streams
Ma, X., Wang, X., & Song, C. (2009) · Journal of the American Chemical Society · doi:10.1021/ja8074105 · Cited by 532
Qi, G., Wang, Y., Estevez, L., Duan, X., Anako, N., Park, A.-H. A., Li, W., Jones, C. W., & Giannelis, E. P. (2011) · Energy Environ. Sci. · doi:10.1039/c0ee00213e · Cited by 507
Harlick, P. J. E., & Sayari, A. (2007) · Industrial & Engineering Chemistry Research · doi:10.1021/ie060774+ · Cited by 488
Self-citationNew Insights into the Interactions of CO2 with Amine-Functionalized Silica
Serna-Guerrero, R., Da’na, E., & Sayari, A. (2008) · Industrial & Engineering Chemistry Research · doi:10.1021/ie801186g · Cited by 404
Self-citationFranchi, R. S., Harlick, P. J. E., & Sayari, A. (2005) · Industrial & Engineering Chemistry Research · doi:10.1021/ie0504194 · Cited by 400
Self-citationHarlick, P. J. E., & Sayari, A. (2006) · Industrial & Engineering Chemistry Research · doi:10.1021/ie051286p · Cited by 393
Self-citationChen, C., Yang, S.-T., Ahn, W.-S., & Ryoo, R. (2009) · Chemical Communications · doi:10.1039/b905589d · Cited by 340
Characterization of Large-Pore MCM-41 Molecular Sieves Obtained via Hydrothermal Restructuring
Sayari, A., Liu, P., Kruk, M., & Jaroniec, M. (1997) · Chemistry of Materials · doi:10.1021/cm970128o · Cited by 338
Self-citationBelmabkhout, Y., & Sayari, A. (2009) · Adsorption · doi:10.1007/s10450-009-9185-6 · Cited by 288
Self-citationCO2 adsorption on branched polyethyleneimine-impregnated mesoporous silica SBA-15
Sanz, R., Calleja, G., Arencibia, A., & Sanz-Pérez, E. S. (2010) · Applied Surface Science · doi:10.1016/j.apsusc.2009.12.070 · Cited by 269
Nanostructured silica as a support for regenerable high-capacity organoamine-based CO2 sorbents
Goeppert, A., Meth, S., Prakash, G. K. S., & Olah, G. A. (2010) · Energy & Environmental Science · doi:10.1039/c0ee00136h · Cited by 253
Improved immobilized carbon dioxide capture sorbents
Gray, M. L., Soong, Y., Champagne, K. J., Pennline, H., Baltrus, J. P., Stevens, R. W., Khatri, R., Chuang, S. S. C., & Filburn, T. (2005) · Fuel Processing Technology · doi:10.1016/j.fuproc.2005.01.005 · Cited by 250
Carbon dioxide capture using amine-impregnated HMS having textural mesoporosity
Chen, C., Son, W.-J., You, K.-S., Ahn, J.-W., & Ahn, W.-S. (2010) · Chemical Engineering Journal · doi:10.1016/j.cej.2010.04.019 · Cited by 176
Effect of the Pore Length on CO2 Adsorption over Amine-Modified Mesoporous Silicas
Heydari-Gorji, A., Yang, Y., & Sayari, A. (2011) · Energy & Fuels · doi:10.1021/ef200765f · Cited by 169
Self-citationDynamic performance of CO2 adsorption with tetraethylenepentamine-loaded KIT-6
Liu, Y., Shi, J., Chen, J., Ye, Q., Pan, H., Shao, Z., & Shi, Y. (2010) · Microporous and Mesoporous Materials · doi:10.1016/j.micromeso.2010.05.002 · Cited by 138
Wang, X. P., Yu, J. J., Cheng, J., Hao, Z., & Xu, Z. P. (2007) · Environmental Science & Technology · doi:10.1021/es072085a · Cited by 130
Cited by
Direct Capture of CO2 from Ambient Air
Sanz-Pérez, E. S., Murdock, C. R., Didas, S. A., & Jones, C. W. (2016) · Chemical Reviews · doi:10.1021/acs.chemrev.6b00173 · Cited by 2,406
Review of recent advances in carbon dioxide separation and capture
Kenarsari, S. D., Yang, D., Jiang, G., Zhang, S., Wang, J., Russell, A. G., Wei, Q., & Fan, M. (2013) · RSC Advances · doi:10.1039/c3ra43965h · Cited by 784
Air as the renewable carbon source of the future: an overview of CO2 capture from the atmosphere
Goeppert, A., Czaun, M., Surya Prakash, G. K., & Olah, G. A. (2012) · Energy & Environmental Science · doi:10.1039/c2ee21586a · Cited by 724
Sorbents for the Direct Capture of CO 2 from Ambient Air
Shi, X., Xiao, H., Azarabadi, H., Song, J., Wu, X., Chen, X., & Lackner, K. S. (2020) · Angewandte Chemie International Edition · doi:10.1002/anie.201906756 · Cited by 679
Understanding the Effect of Water on CO2 Adsorption
Kolle, J. M., Fayaz, M., & Sayari, A. (2021) · Chemical Reviews · doi:10.1021/acs.chemrev.0c00762 · Cited by 523
Self-citation
Metadata
- Authors
- Heydari-Gorji, A., Belmabkhout, Y., & Sayari, A.
- Venue
- Langmuir
- Publisher
- American Chemical Society (ACS)
- Published
- 2011-09-21
- Volume
- 27
- Issue
- 20
- Pages
- 12411-12416
- ISSN
- 0743-7463 (ISSN-L)
- 1520-5827
- OpenAlex
- W2068536827
- Cited by
- 335
- References
- 26
- FWCI
- 44.96
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.