The DOI matches its Crossref record; 29 of the 29 references it cites were found in a registry or an index.
Crystallographic controls on the frictional behavior of dry and water‐saturated sheet structure minerals
Abstract
We compare the frictional strengths of 17 sheet structure mineral powders, measured under dry and water‐saturated conditions, to identify the factors that cause many of them to be relatively weak. The dry coefficient of friction μ ranges upward from 0.2 for graphite, leveling off at 0.8 for margarite, clintonite, gibbsite, kaolinite, and lizardite. The values of μ (dry) correlate directly with calculated (001) interlayer bond strengths of the minerals. This correlation occurs because shear becomes localized along boundary and Riedel shears and the platy minerals in them rotate into alignment with the shear planes. For those gouges with μ (dry) < 0.8, shear occurs by breaking the interlayer bonds to form new cleavage surfaces. Where μ (dry) = 0.8, consistent with Byerlee's law, the interlayer bonds are sufficiently strong that other frictional processes dominate. The transition in dry friction mechanisms corresponds to calculated surface energies of 2–3 J/m 2. Adding water causes μ to decrease for every mineral tested except graphite. If the minerals are separated into groups with similar crystal structures, μ (wet) increases with increasing interlayer bond strength within each group. This relationship also holds for the swelling clay montmorillonite, whose water‐saturated strength is consistent with the strengths of nonswelling clays of similar crystal structure. Water in the saturated gouges forms thin, structured films between the plate surfaces. The polar water molecules are bonded to the plate surfaces in proportion to the mineral's surface energy, and μ (wet) reflects the stresses required to shear through the water films.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Byerlee, J. (1978) · pure and applied geophysics · doi:10.1007/bf00876528 · Cited by 4,029
The surface chemistry of soils
Sposito, G. (1984) · Cited by 1,850
Subcritical crack growth in geological materials
Atkinson, B. K. (1984) · Journal of Geophysical Research: Solid Earth · doi:10.1029/jb089ib06p04077 · Cited by 1,413
Residual strength of clays in landslides, folded strata and the laboratory
Skempton, A. W. (1985) · Géotechnique · doi:10.1680/geot.1985.35.1.3 · Cited by 895
Hey, M. H. (1954) · Mineralogical Magazine and Journal of the Mineralogical Society · doi:10.1180/minmag.1954.030.224.01 · Cited by 796
Pressure solution in nature, theory and experiment
Rutter, E. H. (1983) · Journal of the Geological Society · doi:10.1144/gsjgs.140.5.0725 · Cited by 744
Dynamic Properties of Molecularly Thin Liquid Films
Israelachvili, J. N., McGuiggan, P. M., & Homola, A. M. (1988) · Science · doi:10.1126/science.240.4849.189 · Cited by 664
Physico-Chemical Analysis of the Compressibility of Pure Clays
Bolt, G. H. (1956) · Géotechnique · doi:10.1680/geot.1956.6.2.86 · Cited by 453
The effect of mineral bond strength and adsorbed water on fault gouge frictional strength
Morrow, C. A., Moore, D. E., & Lockner, D. A. (2000) · Geophysical Research Letters · doi:10.1029/1999gl008401 · Cited by 386
Self-citationHomola, A. M., Israelachvili, J. N., Gee, M. L., & McGuiggan, P. M. (1989) · Journal of Tribology · doi:10.1115/1.3261994 · Cited by 341
The Hydrophilicity and Hydrophobicity of Clay Minerals
van Oss, C. J., & Giese, R. F. (1995) · Clays and Clay Minerals · doi:10.1346/ccmn.1995.0430411 · Cited by 310
Surface and interfacial free energies of quartz
Parks, G. A. (1984) · Journal of Geophysical Research: Solid Earth · doi:10.1029/jb089ib06p03997 · Cited by 305
Basal slip and mechanical anisotropy of biotite
Kronenberg, A. K., Kirby, S. H., & Pinkston, J. (1990) · Journal of Geophysical Research: Solid Earth · doi:10.1029/jb095ib12p19257 · Cited by 297
Direct measurement of long range forces between two mica surfaces in aqueous KNO3 solutions
ISRAELACHVILI, J. N., & ADAMS, G. E. (1976) · Nature · doi:10.1038/262774a0 · Cited by 257
Stranded on a Late Cambrian shoreline: Medusae from central Wisconsin
(2002) · doi:10.1130/0091-7613(2002)030 · Cited by 236
Strengths of serpentinite gouges at elevated temperatures
Moore, D. E., Lockner, D. A., Ma, S., Summers, R., & Byerlee, J. D. (1997) · Journal of Geophysical Research: Solid Earth · doi:10.1029/97jb00995 · Cited by 236
Self-citationEffect of humidity on time‐ and velocity‐dependent friction in rocks
Dieterich, J. H., & Conrad, G. (1984) · Journal of Geophysical Research: Solid Earth · doi:10.1029/jb089ib06p04196 · Cited by 231
Near infrared characterization of water and hydroxyl groups on silica surfaces
Anderson, J. H., & Wickersheim, K. A. (1964) · Surface Science · doi:10.1016/0039-6028(64)90064-0 · Cited by 213
Chapter 3 Frictional Strength and the Effective Pressure Law of Montmorillonite and lllite Clays
Morrow, C., Radney, B., & Byerlee, J. (1992) · International Geophysics · doi:10.1016/s0074-6142(08)62815-6 · Cited by 186
The structure of the silica/electrolyte interface
Yates, D. E., & Healy, T. W. (1976) · Journal of Colloid and Interface Science · doi:10.1016/0021-9797(76)90003-5 · Cited by 181
The chemical and mineralogical controls upon the residual strength of pure and natural clays
Moore, R. (1991) · Géotechnique · doi:10.1680/geot.1991.41.1.35 · Cited by 153
Renard, F., & Ortoleva, P. (1997) · Geochimica et Cosmochimica Acta · doi:10.1016/s0016-7037(97)00036-7 · Cited by 114
The area of real contact and the shear strength of monomolecular layers of a boundary lubricant
BAILEY, A. I., & Courtney‐Pratt, J. S. (1955) · Proceedings of the Royal Society of London A Mathematical and Physical Sciences · doi:10.1098/rspa.1955.0026 · Cited by 107
The Nature of Cation-Substitution Sites in Phyllosilicates
Bleam, W. F. (1990) · Clays and Clay Minerals · doi:10.1346/ccmn.1990.0380510 · Cited by 96
Molecular Aspects of Clay-Water Interactions
(1992) · doi:10.1346/cms-wls-4.1 · Cited by 87
Surface energy calculations for muscovite
Giese, R. F. (1974) · Nature · doi:10.1038/248580a0 · Cited by 46
How brucite may affect the frictional properties of serpentinite
MOORE, D. E., Lockner, D. A., Iwata, K., Tanaka, H., & Byerlee, J. D. (2001) · Antarctica A Keystone in a Changing World · doi:10.3133/ofr01320 · Cited by 14
Self-citationSample characterizations and strength measurements of serpentinite gouges
MOORE, D. E., Lockner, D. A., Summers, R., & Byerlee, J. D. (1996) · Antarctica A Keystone in a Changing World · doi:10.3133/ofr96702 · Cited by 10
Self-citationCleavage surface energy of phlogopite mica
Gutshall, P. L., Bryant, P. J., & Cole, G. M. (1970) · American Mineralogist · Cited by 6
Cited by
Faulkner, D. R., Jackson, C. A. L., Lunn, R. J., Schlische, R. W., Shipton, Z. K., Wibberley, C. A. J., & Withjack, M. O. (2010) · Journal of Structural Geology · doi:10.1016/j.jsg.2010.06.009 · Cited by 1,513
The Mechanics of Earthquakes and Faulting
Scholz, C. H. (2019) · Cambridge University Press eBooks · doi:10.1017/9781316681473 · Cited by 910
Frictional and hydrologic properties of clay‐rich fault gouge
Ikari, M. J., Saffer, D. M., & Marone, C. (2009) · Journal of Geophysical Research: Solid Earth · doi:10.1029/2008jb006089 · Cited by 474
Crawford, B. R., Faulkner, D. R., & Rutter, E. H. (2008) · Journal of Geophysical Research: Solid Earth · doi:10.1029/2006jb004634 · Cited by 271
Kelemen, P. B., McQueen, N., Wilcox, J., Renforth, P., Dipple, G., & Vankeuren, A. P. (2020) · Chemical Geology · doi:10.1016/j.chemgeo.2020.119628 · Cited by 258
Metadata
- Authors
- Moore, D. E., & Lockner, D. A.
- Venue
- Journal of Geophysical Research: Solid Earth
- Publisher
- American Geophysical Union (AGU)
- Published
- 2004-03
- Volume
- 109
- Issue
- B3
- ISSN
- 0148-0227 (ISSN-L)
- OpenAlex
- W2035467463
- Cited by
- 330
- References
- 29
- FWCI
- 2.19
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.