Development of a Power and Voltage Control Scheme for Multi-Port Solid State Transformers
The DOI matches its Crossref record; 16 of the 16 references it cites were found in a registry or an index.
Abstract
Solid State Transformers (SSTs) are being considered as a replacement to the classic transformers especially for renewable energy and energy storage systems mainly due to their much smaller size and controllability and regulation over the transferred power. Multi-Port SSTs share one high frequency core for the isolation between several devices and hence are even more compact and efficient but the system is complex and the control of such a system is a challenge. This paper considers a four-port, MPSST connected to a renewable source, battery, load, and the grid and discusses various scenarios and operating points. It is shown that several factors including the ratio of the renewable power to the load, battery SOC status and role of the battery in the system change the desired power flow in the system and there are several control structure needed for each mode of operation. These modes of operation and the boundary between them are recognized and eventually a MIMO control scheme is suggested that includes several switches to changes the structure of the controller to adjust the controller structure to the operating condition. Eventually, input-output linearization technique has been adopted to the system to linearize the model and achieve a better control performance.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Citations
Cites
Zhao, B., Song, Q., Liu, W., & Sun, Y. (2014) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2013.2289913 · Cited by 1,886 · cited 1×
“The power transfer equation for a two port SST, is shown in (1) where φ is the phase shift between ac voltages [15].”
BackgroundReview of Solid-State Transformer Technologies and Their Application in Power Distribution Systems
She, X., Huang, A. Q., & Burgos, R. (2013) · IEEE Journal of Emerging and Selected Topics in Power Electronics · doi:10.1109/jestpe.2013.2277917 · Cited by 1,164 · cited 3×
“However, because of the triangle wave of the current, the root-meansquare (rms) value of the current on switches and transformer can be higher which may lead higher conduction losses [13].”
BackgroundMethodFalcones, S., Ayyanar, R., & Mao, X. (2013) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2012.2215965 · Cited by 501 · cited 2×
“In [12], a three-port MPSST has been proposed for a fuel cell-storage hybrid energy system.”
BackgroundMethodGu, C., Zheng, Z., Xu, L., Wang, K., & Li, Y. (2016) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2015.2416212 · Cited by 221 · cited 3×
“Since both input and output of the SST are connected to power electronics converters and controlled continuously, multi-port SSTs (MPSSTs) have been presented to integrate more than one energy sources such as distributed generation (DG) and/or energy storage system into load or utility grid [7]– [9].”
BackgroundMethodDual-Transformer-Based Asymmetrical Triple-Port Active Bridge (DT-ATAB) Isolated DC–DC Converter
Jakka, V. N. S. R., Shukla, A., & Demetriades, G. D. (2017) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2017.2674586 · Cited by 160 · cited 1×
“Increasing renewable penetration to the grid and rising smart grid concept have made them popular for low to medium voltage level applications with their unique features such as VAR compensation, voltage regulation, fault isolation, and DC connectivity [5], [6].”
BackgroundZhu, Q., Wang, L., Huang, A. Q., Booth, K., & Zhang, L. (2019) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2018.2829174 · Cited by 155 · cited 1×
“The initial studies on SSTs have been presented in 1970s [1], and they have been investigated for high power density systems such as traction and power distribution system applications [2]–[4].”
BackgroundPhattanasak, M., Gavagsaz‐Ghoachani, R., Martin, J., Nahid‐Mobarakeh, B., Pierfederici, S., & Davat, B. (2014) · IEEE Transactions on Industry Applications · doi:10.1109/tia.2014.2336975 · Cited by 115
The Thyristor Electronic Transformer: a Power Converter Using a High-Frequency Link
McMurray, W. (1971) · IEEE Transactions on Industry and General Applications · doi:10.1109/tiga.1971.4181326 · Cited by 84 · cited 1×
“Triangular current modulation strategy which uses the duty cycle to control the power transferred among the bridges is also applied to the four-port MPSST [13], [14].”
MethodQuadruple Active Bridge DC-DC converter as the basic cell of a modular Smart Transformer
Costa, L. F., Buticchi, G., & Liserre, M. (2016) · Conference proceedings/Conference proceedings - IEEE Applied Power Electronics Conference and Exposition · doi:10.1109/apec.2016.7468209 · Cited by 29
Özdemir, Ş., Balcı, S., Altın, N., & Sefa, İ. (2017) · International Journal of Hydrogen Energy · doi:10.1016/j.ijhydene.2017.02.158 · Cited by 24 · cited 1×
“The initial studies on SSTs have been presented in 1970s [1], and they have been investigated for high power density systems such as traction and power distribution system applications [2]–[4].”
BackgroundApplication of multi-port solid state transformers for microgrid-based distribution systems
Rashidi, M., Nasiri, A., & Cuzner, R. M. (2016) · International Conference on Renewable Energy Research and Applications (ICRERA) · doi:10.1109/icrera.2016.7884406 · Cited by 20 · cited 1×
“Increasing renewable penetration to the grid and rising smart grid concept have made them popular for low to medium voltage level applications with their unique features such as VAR compensation, voltage regulation, fault isolation, and DC connectivity [5], [6].”
BackgroundSelf-citationMulti-port solid state transformer for inter-grid power flow control
Roy, S., De, A., & Bhattacharya, S. (2014) · International Power Electronics Conference (IPEC) · doi:10.1109/ipec.2014.6870158 · Cited by 16 · cited 1×
“However, it requires higher number of switches and two separate transformers [11].”
BackgroundQuad-active-bridge as cross-link for medium voltage modular inverters
Costa, L. F., Buticchi, G., & Liserre, M. (2015) · IEEE Energy Conversion Congress and Exposition (ECCE) · doi:10.1109/ecce.2015.7309750 · Cited by 15 · cited 1×
“In [10], a MPSST has been proposed and controlled as an inter-grid power flow controller.”
MethodA novel multi-port solid state transformer enabled isolated hybrid microgrid architecture
Nair, A. C., & Fernandes, B. G. (2017) · IECON 2017 - 43rd Annual Conference of the IEEE Industrial Electronics Society · doi:10.1109/iecon.2017.8216113 · Cited by 15 · cited 1×
“The initial studies on SSTs have been presented in 1970s [1], and they have been investigated for high power density systems such as traction and power distribution system applications [2]–[4].”
BackgroundApplication of a multi-port solid state transformer for volt-VAR control in distribution systems
Rashidi, M., Bani‐Ahmed, A., & Nasiri, A. (2017) · IEEE Power Engineering Society General Meeting · doi:10.1109/pesgm.2017.8274365 · Cited by 13
Self-citationKhayamy, M., Ojo, O., & Sota, E. (2014) · IET Renewable Power Generation · doi:10.1049/iet-rpg.2013.0341 · Cited by 4 · cited 1×
“Applying inputoutput linearization to the system, the general form of matrices E and A are found as (21) and (22) and lie derivative operator L is defined as (23), [16].”
MethodSelf-citation
Research works printed but not linked: 1
- zhu, 2018, 7.2 kV Single Stage Solid State Transformer Based on Current Fed Series Resonant Converter and 15 kV SiC MOSFETs, IEEE Transactions on PowerElectronics, 1
Cited by
Hannan, M. A., Ker, P. J., Lipu, M. S. H., Choi, Z. H., Rahman, M. S. A., Muttaqi, K. M., & Blaabjerg, F. (2020) · IEEE Access · doi:10.1109/access.2020.2967345 · Cited by 339
“AMPSST can act like a centralized controller that can control the power flow and regulate the voltages [95], [96].”
BackgroundA Review of Microgrid Control Strategies
Altın, N., & Eyimaya, S. E. (2021) · International Conference on Renewable Energy Research and Applications (ICRERA) · doi:10.1109/icrera52334.2021.9598699 · Cited by 44
Power Electronics Converters for the Internet of Energy: A Review
Granata, S., Benedetto, M. D., Terlizzi, C., Leuzzi, R., Bifaretti, S., & Zanchetta, P. (2022) · Energies · doi:10.3390/en15072604 · Cited by 22
A High Power High Frequency Transformer Design for Solid State Transformer Applications
Shafei, A. E., Özdemir, Ş., Altın, N., Jean-Pierre, G., & Nasiri, A. (2019) · International Conference on Renewable Energy Research and Applications (ICRERA) · doi:10.1109/icrera47325.2019.8996515 · Cited by 21
“It is a combination of a high-or medium frequency transformer and multiple power electronic converters [1]-[3].”
BackgroundSelf-citationKimura, N., Nakao, K., & Morizane, T. (2019) · International Conference on Renewable Energy Research and Applications (ICRERA) · doi:10.1109/icrera47325.2019.8997091 · Cited by 4
“SST can realize power flow control and energy management easily[13-17].”
Background
Metadata
- Authors
- Khayamy, M., Nasiri, A., & Altin, N.
- Affiliations
- University of Wisconsin–Milwaukee (US)
- Venue
- 2018 7th International Conference on Renewable Energy Research and Applications (ICRERA)
- Publisher
- IEEE
- Published
- 2018-10
- Volume
- iga 7
- Pages
- 926-932
- OpenAlex
- W2903782324
- Cited by
- 7
- References
- 16
- Citations by year
- 2024: 1 · 2022: 1 · 2021: 1 · 2020: 1 · 2019: 3
- FWCI
- 1.99
- Type
- conference paper
- Language
- en
- Open access
- closed
- Locations
- International Conference on Renewable Energy Research and Applications (ICRERA) (publishedVersion)
- Topics
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Advanced DC-DC Converters
- Physical Sciences › Engineering › Control and Systems Engineering › Microgrid Control and Optimization
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Multilevel Inverters and Converters
- Keywords
- power flow control, voltage regulation, multivariable control, input-output linearization, battery state of charge, renewable energy integration, energy storage, mode switching, high-frequency isolation
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.