Study of Current Density Influence on Bond Wire Degradation Rate in SiC MOSFET Modules
Open accessThe DOI matches its Crossref record; 4 of the 4 references it cites were found in a registry or an index.
Abstract
This paper proposes a separated test method for studying the current effect on the ageing process of a wire-bonded silicon carbide (SiC) MOSFET module under power cycling test (PCT). The separated test method enables testing SiC MOSFET at different load current densities, but under the same temperature swing and average temperature conditions. By analyzing the output characteristics in the linear region, the relationships among the gate voltage, on-state voltage, and junction temperature are revealed. Then, the one-to-one correspondence between gate voltage and conduction power loss can be used to adjust the current density under the same temperature conditions. Two six-pack SiC modules (1200 V/20 A) are tested under 12 and 24 A conditions to experimentally verify the proposed method. The ageing curves show that the high current can speed up the ageing rate of bond wires even under the same temperature conditions (65 °C-125 °C). Moreover, the high current density also has an impact on solder layer degradation as well as on the temperature conditions. Finally, a power device analyzer B1506A and a scanning acoustic microscope (SAM) are used to investigate the degradation of electrical parameters and the solder layer, respectively. The final summary of analytical results shows that the input current has a nonnegligible impact on the degradation process of power modules.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Selected failure mechanisms of modern power modules
Ciappa, M. (2002) · Microelectronics Reliability · doi:10.1016/s0026-2714(02)00042-2 · Cited by 1,039 · cited 1×
“Finally, due to the mismatch between coefficient of thermal expansion (CTE) values between different materials, the temperature swing is regarded as the main decisive cause for the package wear-out degradation [13], [14].”
BackgroundPower Cycling Reliability of Power Module: A Survey
Durand, C., Klingler, M., Coutellier, D., & Naceur, H. (2016) · IEEE Transactions on Device and Materials Reliability · doi:10.1109/tdmr.2016.2516044 · Cited by 239 · cited 2×
“power modules and discrete devices [8]–[11].”
BackgroundSmet, V., Forest, F., Huselstein, J.-J., Rashed, A., & Richardeau, F. (2013) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2012.2196894 · Cited by 232
Luo, H., Iannuzzo, F., Blaabjerg, F., Li, W., & He, X. (2017) · IECON 2017 - 43rd Annual Conference of the IEEE Industrial Electronics Society · doi:10.1109/iecon.2017.8216259 · Cited by 16 · cited 1×
“However, according to the extensive statistical test results, the correlations between the number of power cycles and the temperature swing are associated with many test conditions [15]–[17].”
BackgroundSelf-citation
Cited by
Overview of Real-Time Lifetime Prediction and Extension for SiC Power Converters
Ni, Z., Lyu, X., Yadav, O. P., Singh, B. N., Zheng, S., & Cao, D. (2020) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2019.2962503 · Cited by 261
Farhadi, M., Yang, F., Pu, S., Vankayalapati, B. T., & Akin, B. (2021) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2021.3049394 · Cited by 93
AC Power Cycling Test Setup and Condition Monitoring Tools for SiC-Based Traction Inverters
Farhadi, M., Vankayalapati, B. T., Sajadi, R., & Akin, B. (2023) · IEEE Transactions on Vehicular Technology · doi:10.1109/tvt.2023.3271251 · Cited by 24
“In addition to the thermal cycle, a high drain-current can accelerate bond-wire aging by expanding the internal void in Al bond-wires [43], [44].”
Background
Metadata
- Authors
- Luo, H., Iannuzzo, F., Baker, N., Blaabjerg, F., Li, W., & He, X.
- Venue
- IEEE Journal of Emerging and Selected Topics in Power Electronics
- Published
- 2020-06
- Volume
- 8
- Issue
- 2
- Pages
- 1622-1632
- ISSN
- 2168-6777 (ISSN-L)
- 2168-6785
- OpenAlex
- W2948198020
- Cited by
- 69
- References
- 4
- FWCI
- 1.59
- Type
- journal article
- Language
- en
- Open access
- green
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Study of Current Density Influence on Bond Wire Degradation Rate in SiC MOSFET Modules. https://app.cochat.ai/papers/10.1109/jestpe.2019.2920715
- The paper
- Luo, H., Iannuzzo, F., Baker, N., Blaabjerg, F., Li, W., & He, X. (2020). Study of Current Density Influence on Bond Wire Degradation Rate in SiC MOSFET Modules. IEEE Journal of Emerging and Selected Topics in Power Electronics. https://doi.org/10.1109/jestpe.2019.2920715
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.