The DOI matches its Crossref record; 3 of the 3 references it cites were found in a registry or an index.
State Detection of Bond Wires in IGBT Modules Using Eddy Current Pulsed Thermography
Open accessAbstract
Insulated gate bipolar transistor (IGBT) modules are important safety critical components in electrical power systems. Bond wire lift-off, a plastic deformation between wire bond and adjacent layers of a device caused by repeated power/thermal cycles, is the most common failure mechanism in IGBT modules. For the early detection and characterization of such failures, it is important to constantly detect or monitor the health state of IGBT modules, and the state of bond wires in particular. This paper introduces eddy current pulsed thermography (ECPT), a nondestructive evaluation technique, for the state detection and characterization of bond wire lift-off in IGBT modules. After the introduction of the experimental ECPT system, numerical simulation work is reported. The presented simulations are based on the 3-D electromagnetic-thermal coupling finite-element method and analyze transient temperature distribution within the bond wires. This paper illustrates the thermal patterns of bond wires using inductive heating with different wire statuses (lifted-off or well bonded) under two excitation conditions: nonuniform and uniform magnetic field excitations. Experimental results show that uniform excitation of healthy bonding wires, using a Helmholtz coil, provides the same eddy currents on each, while different eddy currents are seen on faulty wires. Both experimental and numerical results show that ECPT can be used for the detection and characterization of bond wires in power semiconductors through the analysis of the transient heating patterns of the wires. The main impact of this paper is that it is the first time electromagnetic induction thermography, so-called ECPT, has been employed on power/electronic devices. Because of its capability of contactless inspection of multiple wires in a single pass, and as such it opens a wide field of investigation in power/electronic devices for failure detection, performance characterization, and health monitoring.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Condition Monitoring for Device Reliability in Power Electronic Converters: A Review
Yang, S., Xiang, D., Bryant, A., Mawby, P., Ran, L., & Tavner, P. (2010) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2010.2049377 · Cited by 1,278
Selected failure mechanisms of modern power modules
Ciappa, M. (2002) · Microelectronics Reliability · doi:10.1016/s0026-2714(02)00042-2 · Cited by 1,039
Smet, V., Forest, F., Huselstein, J.-J., Rashed, A., & Richardeau, F. (2013) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2012.2196894 · Cited by 232
Cited by
Optically and non-optically excited thermography for composites: A review
Yang, R., & He, Y. (2016) · Infrared Physics & Technology · doi:10.1016/j.infrared.2015.12.026 · Cited by 308
Overview of Real-Time Lifetime Prediction and Extension for SiC Power Converters
Ni, Z., Lyu, X., Yadav, O. P., Singh, B. N., Zheng, S., & Cao, D. (2020) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2019.2962503 · Cited by 261
Review of Topside Interconnections for Wide Bandgap Power Semiconductor Packaging
Wang, L., Wang, W., Hueting, R. J. E., Rietveld, G., & Ferreira, J. A. (2023) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2022.3200469 · Cited by 73
A Critical Review on Charging Technologies of Electric Vehicles
Shahjalal, M., Shams, T., Tasnim, M. N., Ahmed, M. R., Ahsan, M., & Haider, J. (2022) · Energies · doi:10.3390/en15218239 · Cited by 66
“…an increment in the on-state voltage during power cycling causes power losses that increase the temperature of the entire chip of the converter/inverter, which speeds up the bond wire lift-off via the generated stress through the thermal expansion mismatch between the wire bond and the chip [71].”
Background
Metadata
- Authors
- Li, K., Tian, G. Y., Cheng, L., Yin, A., Cao, W., & Crichton, S.
- Venue
- IEEE Transactions on Power Electronics
- Published
- 2014-09
- Volume
- 29
- Issue
- 9
- Pages
- 5000-5009
- ISSN
- 0885-8993 (ISSN-L)
- 1941-0107
- OpenAlex
- W2008706439
- Cited by
- 189
- References
- 3
- FWCI
- 18.27
- Type
- journal article
- Language
- en
- Open access
- green
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: State Detection of Bond Wires in IGBT Modules Using Eddy Current Pulsed Thermography. https://app.cochat.ai/papers/10.1109/tpel.2013.2288334
- The paper
- Li, K., Tian, G. Y., Cheng, L., Yin, A., Cao, W., & Crichton, S. (2014). State Detection of Bond Wires in IGBT Modules Using Eddy Current Pulsed Thermography. IEEE Transactions on Power Electronics. https://doi.org/10.1109/tpel.2013.2288334
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.