The DOI matches its Crossref record.
Highly Conductive, Transparent Films of Sputtered In[sub 2−x]Sn[sub x]O[sub 3−y]
Open accessAbstract
Highly conductive, transparent films of have been deposited by d‐c diode sputtering with Ar, O 2 , N 2 , Xe, and O 2 ‐Ar mixtures. Sputtering targets with different ratios were utilized and the best results were obtained with pure Ar or Xe gas and targets containing 9–13 mole percent (m/o) . The lowest film resistivity achieved was , but routine films had resistivity values of about . The use of a very low sputtering gas throughput (10 −2 –10 −1 Torr liter/sec) was found to be necessary to develop films with a slight oxygen deficiency. Targets differing in density (porosity) differ in their susceptibility to reduction so that sputtering conditions depend on target density. The films have excellent adherence and will tolerate cleaning, heating, polishing, and bonding without failure. They may be etched in heated acids with standard photoresist techniques used to define electrode geometry. Exposure of the films to temperatures of 500 °C in air will cause an approximate factor of 3 increase in resistance at room temperature. Sputtered films with sheet resistance of 1.6 ohms/square, 73% light transmission, and 14% reflection at 500 nm have been obtained. Suitable antireflection coated films of 5–7 ohms/square possessing over 97% light transmission appear feasible.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cited by
New figure of merit for transparent conductors
Haacke, G. (1976) · Journal of Applied Physics · doi:10.1063/1.323240 · Cited by 2,107
Past achievements and future challenges in the development of optically transparent electrodes
Ellmer, K. (2012) · Nature Photonics · doi:10.1038/nphoton.2012.282 · Cited by 2,090
Kim, H., Gilmore, C. M., Piqué, A., Horwitz, J. S., Mattoussi, H., Murata, H., Kafafi, Z. H., & Chrisey, D. B. (1999) · Journal of Applied Physics · doi:10.1063/1.371708 · Cited by 1,291
X-ray photoemission spectroscopy studies of Sn-doped indium-oxide films
Fan, J. C. C., & Goodenough, J. B. (1977) · Journal of Applied Physics · doi:10.1063/1.324149 · Cited by 1,085
Tin doped indium oxide thin films: Electrical properties
Bel Hadj Tahar, R., Ban, T., Ohya, Y., & Takahashi, Y. (1998) · Journal of Applied Physics · doi:10.1063/1.367025 · Cited by 909
Electrical properties and defect model of tin-doped indium oxide layers
Frank, G., & K�stlin, H. (1982) · Applied Physics A Solids and Surfaces · doi:10.1007/bf00619080 · Cited by 617
Fabrication of silver nanowire transparent electrodes at room temperature
Tokuno, T., Nogi, M., Karakawa, M., Jiu, J., Nge, T. T., Aso, Y., & Suganuma, K. (2011) · Nano Research · doi:10.1007/s12274-011-0172-3 · Cited by 577
TCO/metal/TCO structures for energy and flexible electronics
Guillén, C., & Herrero, J. (2011) · Thin Solid Films · doi:10.1016/j.tsf.2011.06.091 · Cited by 490
A Materials Roadmap to Functional Neural Interface Design
Wellman, S. M., Eles, J. R., Ludwig, K. A., Seymour, J. P., Michelson, N. J., McFadden, W. E., Vazquez, A. L., & Kozai, T. D. Y. (2018) · Advanced Functional Materials · doi:10.1002/adfm.201701269 · Cited by 389
Radiative heating and cooling with spectrally selective surfaces
Granqvist, C. G. (1981) · Applied Optics · doi:10.1364/ao.20.002606 · Cited by 309
Structural and Electrical Properties of Atomic Layer Deposited Al‐Doped ZnO Films
Lee, D., Kim, H., Kwon, J., Choi, H., Kim, S., & Kim, K. (2011) · Advanced Functional Materials · doi:10.1002/adfm.201001342 · Cited by 265
Solution-Processed Transparent Electrodes for Emerging Thin-Film Solar Cells
Zhang, Y., Ng, S.-W., Lu, X., & Zheng, Z. (2020) · Chemical Reviews · doi:10.1021/acs.chemrev.9b00483 · Cited by 264
Jiang, S., Hou, P.-X., Chen, M.-L., Wang, B.-W., Sun, D.-M., Tang, D.-M., Jin, Q., Guo, Q.-X., Zhang, D.-D., Du, J.-H., et al. (2018) · Science Advances · doi:10.1126/sciadv.aap9264 · Cited by 260
Gross, G. W., Wen, W. Y., & Lin, J. W. (1985) · Journal of Neuroscience Methods · doi:10.1016/0165-0270(85)90105-0 · Cited by 255
Metadata
- Authors
- Fraser, D. B., & Cook, H. D.
- Venue
- Journal of The Electrochemical Society
- Publisher
- The Electrochemical Society
- Published
- 1972
- Volume
- 119
- Issue
- 10
- Pages
- 1368
- ISSN
- 0013-4651 (ISSN-L)
- OpenAlex
- W2114131683
- Cited by
- 323
- References
- 0
- FWCI
- 12.05
- Type
- journal article
- Language
- en
- Open access
- bronze
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.