The DOI matches its Crossref record; 23 of the 23 references it cites were found in a registry or an index.
Resistive Impedance Matching Circuit for Piezoelectric Energy Harvesting
Abstract
A two-stage power conditioning circuit consisting of an AC-DC converter followed by a DC-DC converter is proposed for a vibration-based energy harvesting system. The power conditioning circuit intends to maximize the amount of power extracted from a piezoelectric energy harvester by matching the source impedance with the circuit by adaptively adjusting the duty cycle. An equivalent electrical circuit representation derived from a distributed-parameter piezoelectric energy harvester model is adapted to enable the impedance matching method proposed here. For a given piezoelectric energy harvester, there is a theoretical maximum power output that is determined by the mechanical damping, base acceleration, and the effective mass of the harvester structure under base excitation. Experimental results are given to validate the effectiveness of the proposed resistive impedance matching circuit around the first resonance frequency of a cantilevered piezoelectric energy harvester.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Fundamentals of Power Electronics
Erickson, R. W., & Maksimović, D. (2001) · Springer eBooks · doi:10.1007/b100747 · Cited by 6,112
Fundamentals of Power Electronics
Erickson, R. W., & Maksimović, D. (2020) · Springer eBooks · doi:10.1007/978-3-030-43881-4 · Cited by 5,420
Energy harvesting vibration sources for microsystems applications
Beeby, S. P., Tudor, M. J., & White, N. M. (2006) · Measurement Science and Technology · doi:10.1088/0957-0233/17/12/r01 · Cited by 3,008 · cited 1×
“Energy harvesting from a variety of ambient sources (heat, solar, wind, vibration, and radio frequency radiation) provide possible solutions (Hagerty et al., 2000; Beeby et al., 2006; Singh et al., 2006; Alippi and Galperti, 2008; Lhermet et al., 2008; Torah et al., 2008).”
BackgroundEnergy Scavenging for Mobile and Wireless Electronics
Paradiso, J. A., & Starner, T. (2005) · IEEE Pervasive Computing · doi:10.1109/mprv.2005.9 · Cited by 2,653
A review of power harvesting using piezoelectric materials (2003–2006)
Anton, S. R., & Sodano, H. A. (2007) · Smart Materials and Structures · doi:10.1088/0964-1726/16/3/r01 · Cited by 2,652
Erturk, A., & Inman, D. J. (2009) · Smart Materials and Structures · doi:10.1088/0964-1726/18/2/025009 · Cited by 1,417
Self-citationA Distributed Parameter Electromechanical Model for Cantilevered Piezoelectric Energy Harvesters
Erturk, A., & Inman, D. J. (2008) · Journal of Vibration and Acoustics · doi:10.1115/1.2890402 · Cited by 1,249
Self-citationAdaptive piezoelectric energy harvesting circuit for wireless remote power supply
Ottman, G. K., Hofmann, H. F., Bhatt, A. C., & Lesieutre, G. A. (2002) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2002.802194 · Cited by 1,206
Toward energy harvesting using active materials and conversion improvement by nonlinear processing
Guyomar, D., Badel, A., Lefeuvre, E., & Richard, C. (2005) · IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control · doi:10.1109/tuffc.2005.1428041 · Cited by 1,049
Adaptive piezoelectric energy harvesting circuit for wireless, remote power supply
Ottman, G., Bhatt, A., Hofmann, H., & Lesieutre, G. (2001) · 19th AIAA Applied Aerodynamics Conference · doi:10.2514/6.2001-1505 · Cited by 953
Advances in energy harvesting using low profile piezoelectric transducers
Priya, S. (2007) · Journal of Electroceramics · doi:10.1007/s10832-007-9043-4 · Cited by 918
Ottman, G. K., Hofmann, H. F., & Lesieutre, G. A. (2003) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2003.809379 · Cited by 672
Issues in mathematical modeling of piezoelectric energy harvesters
Erturk, A., & Inman, D. J. (2008) · Smart Materials and Structures · doi:10.1088/0964-1726/17/6/065016 · Cited by 480
Self-citationBuck-Boost Converter for Sensorless Power Optimization of Piezoelectric Energy Harvester
Lefeuvre, E., Audigier, D., Richard, C., & Guyomar, D. (2007) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2007.904230 · Cited by 439
Small-scale energy harvesting through thermoelectric, vibration, and radiofrequency power conversion
Hudak, N. S., & Amatucci, G. G. (2008) · Journal of Applied Physics · doi:10.1063/1.2918987 · Cited by 343
Enhanced semi-passive damping using continuous switching of a piezoelectric device on an inductor:
Richard, C., Guyomar, D., Audigier, D., & Bassaler, H. (2000) · SPIE Proceedings · doi:10.1117/12.384569 · Cited by 299
Self-powered autonomous wireless sensor node using vibration energy harvesting
Torah, R., Glynne-Jones, P., Tudor, M., O'Donnell, T., Roy, S., & Beeby, S. (2008) · Measurement Science and Technology · doi:10.1088/0957-0233/19/12/125202 · Cited by 270
Resistor Emulation Approach to Low-Power RF Energy Harvesting
Paing, T., Shin, J., Zane, R., & Popovic, Z. (2008) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2008.921167 · Cited by 264
Energy scavenging for long-term deployable wireless sensor networks
Mathúna, C. Ó., O’Donnell, T., Martinez-Catala, R. V., Rohan, J., & O’Flynn, B. (2008) · Talanta · doi:10.1016/j.talanta.2007.12.021 · Cited by 256
A General Equivalent Circuit Model for Piezoelectric Generators
Elvin, N. G., & Elvin, A. A. (2009) · Journal of Intelligent Material Systems and Structures · doi:10.1177/1045389x08089957 · Cited by 204
1986 IEEE Applied Power Electronics Conference and Exposition
(1986) · doi:10.1109/apec.1986 · Cited by 203
Lhermet, H., Condemine, C., Plissonnier, M., et al. (2008) · IEEE Journal of Solid-State Circuits · doi:10.1109/jssc.2007.914725 · Cited by 198
Single crystals and nonlinear process for outstanding vibration-powered electrical generators
Badel, A., Benayad, A., Lefeuvre, E., Lebrun, L., Richard, C., & Guyomar, D. (2006) · IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control · doi:10.1109/tuffc.2006.1611027 · Cited by 181
Cited by
Safaei, M., Sodano, H. A., & Anton, S. R. (2019) · Smart Materials and Structures · doi:10.1088/1361-665x/ab36e4 · Cited by 874
“Kong et al in 2010 [303] developed an impedance matching circuit that combined a standard diode rectifier with a buck-boost converter operating in discontinuous conduction mode.”
MethodErturk, A., & Inman, D. J. (2011) · Journal of Sound and Vibration · doi:10.1016/j.jsv.2010.11.018 · Cited by 824
Self-citationPiezoelectric Energy Harvesting Solutions: A Review
Covaci, C., & Gontean, A. (2020) · Sensors · doi:10.3390/s20123512 · Cited by 691
Harvesting ambient wind energy with an inverted piezoelectric flag
Orrego, S., Shoele, K., Ruas, A., Doran, K., Caggiano, B., Mittal, R., & Kang, S. H. (2017) · Applied Energy · doi:10.1016/j.apenergy.2017.03.016 · Cited by 435
A Review on Piezoelectric Energy Harvesting: Materials, Methods, and Circuits
Priya, S., Song, H.-C., Zhou, Y., Varghese, R., Chopra, A., Kim, S.-G., Kanno, I., Wu, L., Ha, D. S., Ryu, J., et al. (2019) · Energy Harvesting and Systems · doi:10.1515/ehs-2016-0028 · Cited by 433
Self-citation
Metadata
- Authors
- Kong, N., Ha, D. S., Erturk, A., & Inman, D. J.
- Venue
- Journal of Intelligent Material Systems and Structures
- Publisher
- SAGE Publications
- Published
- 2010-01-07
- Volume
- 21
- Issue
- 13
- Pages
- 1293-1302
- ISSN
- 1045-389X (ISSN-L)
- 1530-8138
- OpenAlex
- W2112433033
- Cited by
- 344
- References
- 23
- FWCI
- 43.20
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.