The DOI matches its Crossref record; 30 of the 30 references it cites were found in a registry or an index.
Characterization and application of activated carbon produced by H3PO4 and water vapor activation
Open accessAbstract
Activated carbons have been prepared from woody biomass birch by using various activation procedures: a) treatment with phosphoric acid and pyrolysis at 600 °C in inert atmosphere, b) the same as in (a) followed by steam activation at the same temperature and c) treatment with phosphoric acid and direct pyrolysis in a stream of water vapor at 700 °C. The surface area and the porosity of the activated carbons were strongly dependent on the treatment after impregnation with H3PO4 (pyrolysis in inert atmosphere, steam pyrolysis or combination of both). Activated carbon, prepared by impregnation with phosphoric acid followed by steam pyrolysis (steam activation) had highly developed porous structure and the largest surface area among all prepared carbons (iodine number 1280 mg/g and BET surface area 1360 m2/g). The adsorption capacity of this sample for Hg(II) from aqueous solution was studied in varying treatment conditions: contact time, metal ion concentration and pH. The adsorption followed Langmuir isotherms and the adsorption capacity for Hg(II) at 293 K was 160 mg/g.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Adsorption Surface Area and Porosity
Gregg, S. J., Sing, K. S. W., & Salzberg, H. W. (1967) · Journal of The Electrochemical Society · doi:10.1149/1.2426447 · Cited by 9,507
Adsorption surface area and porosity
Steele, W. A. (1983) · Journal of Colloid and Interface Science · doi:10.1016/0021-9797(83)90305-3 · Cited by 7,928
The Infra-red Spectra of Complex Molecules
Bellamy, L. J. (1975) · Springer eBooks · doi:10.1007/978-94-011-6017-9 · Cited by 5,807
Some aspects of the surface chemistry of carbon blacks and other carbons
Boehm, H. P. (1994) · Carbon · doi:10.1016/0008-6223(94)90031-0 · Cited by 3,043
Infrared characteristic group frequencies
Goldstein, M. (1981) · Endeavour · doi:10.1016/0160-9327(81)90159-9 · Cited by 2,628
Infrared characteristic group frequencies
Socrates, G. (1980) · Medical Entomology and Zoology · Cited by 2,527
Chemical Identification of Surface Groups
Boehm, H. P. (1966) · Advances in Catalysis · doi:10.1016/s0360-0564(08)60354-5 · Cited by 1,307
Activated carbons from yellow poplar and white oak by H3PO4 activation
Jagtoyen, M., & Derbyshire, F. (1998) · Carbon · doi:10.1016/s0008-6223(98)00082-7 · Cited by 700
Mercury: major issues in environmental health.
Clarkson, T. W. (1993) · Environmental Health Perspectives · doi:10.1289/ehp.9310031 · Cited by 505
Biomass conversion to carbon adsorbents and gas
Savova, D., Apak, E., Ekinci, E., Yardim, F., Petrov, N., Budinova, T., Razvigorova, M., & Minkova, V (2001) · Biomass and Bioenergy · doi:10.1016/s0961-9534(01)00027-7 · Cited by 341
Self-citation
Cited by
Kambo, H. S., & Dutta, A. (2015) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2015.01.050 · Cited by 1,746
Yahya, M. A., Al-Qodah, Z., & Ngah, C. W. Z. (2015) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2015.02.051 · Cited by 1,202
Danish, M., & Ahmad, T. (2018) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2018.02.003 · Cited by 807
Removal of lead from water using biochars prepared from hydrothermal liquefaction of biomass
Liu, Z., & Zhang, F.-S. (2009) · Journal of Hazardous Materials · doi:10.1016/j.jhazmat.2009.01.085 · Cited by 710
Adsorption of Carbon Dioxide for post-combustion capture: a review
Raganati, F., Miccio, F., & Ammendola, P. (2021) · Energy & Fuels · doi:10.1021/acs.energyfuels.1c01618 · Cited by 661
Regmi, P., Garcia Moscoso, J. L., Kumar, S., Cao, X., Mao, J., & Schafran, G. (2012) · Journal of Environmental Management · doi:10.1016/j.jenvman.2012.04.047 · Cited by 557
Peng, C., Yan, X.-B., Wang, R.-T., Lang, J.-W., Ou, Y.-J., & Xue, Q.-J. (2013) · Electrochimica Acta · doi:10.1016/j.electacta.2012.09.082 · Cited by 538
Enhanced adsorption of Cu(II) and Cd(II) by phosphoric acid-modified biochars
Peng, H., Gao, P., Chu, G., Pan, B., Peng, J., & Xing, B. (2017) · Environmental Pollution · doi:10.1016/j.envpol.2017.07.004 · Cited by 521
Yorgun, S., & Yıldız, D. (2015) · Journal of the Taiwan Institute of Chemical Engineers · doi:10.1016/j.jtice.2015.02.032 · Cited by 392
Recent advances and challenges in biomass-derived porous carbon nanomaterials for supercapacitors
Li, Z., Guo, D., Liu, Y., Wang, H., & Wang, L. (2020) · Chemical Engineering Journal · doi:10.1016/j.cej.2020.125418 · Cited by 396
Petrovic, B., Gorbounov, M., & Masoudi Soltani, S. (2021) · Microporous and Mesoporous Materials · doi:10.1016/j.micromeso.2020.110751 · Cited by 381
Yagmur, E., Ozmak, M., & Aktas, Z. (2008) · Fuel · doi:10.1016/j.fuel.2008.05.005 · Cited by 349
Abd, A. A., Naji, S. Z., Hashim, A. S., & Othman, M. R. (2020) · Journal of Environmental Chemical Engineering · doi:10.1016/j.jece.2020.104142 · Cited by 346
Hoseinzadeh Hesas, R., Wan Daud, W. M. A., Sahu, J. N., & Arami-Niya, A. (2013) · Journal of Analytical and Applied Pyrolysis · doi:10.1016/j.jaap.2012.12.019 · Cited by 323
Butnan, S., Deenik, J. L., Toomsan, B., Antal, M. J., & Vityakon, P. (2015) · Geoderma · doi:10.1016/j.geoderma.2014.08.010 · Cited by 282
Zhang, Y.-J., Xing, Z.-J., Duan, Z.-K., Li, M., & Wang, Y. (2014) · Applied Surface Science · doi:10.1016/j.apsusc.2014.07.126 · Cited by 262
Miranda, R., Sosa, C., Bustos, D., Carrillo, E., & Rodrguez-Cant, M. (2012) · Lignocellulosic Precursors Used in the Synthesis of Activated Carbon - Characterization Techniques and Applications in the Wastewater Treatment · doi:10.5772/39368 · Cited by 12
“Activated carbons are versatile adsorbents with a wide range of applications such as adsorbents for treatment and purification of water, air as well as various chemical and natural products (Abdel-Nasser & El-Hendawy, 2005; Budinova et al., 2006).”
BackgroundTahsin, M., Shahinuzzaman, M., Akter, T., Abdur, R., Bashar, M. S., Kadir, M. R., Hoque, S., Jamal, M. S., & Hossain, M. (2025) · Carbon Trends · doi:10.1016/j.cartre.2025.100495 · Cited by 7
Metadata
- Authors
- Budinova, T., Ekinci, E., Yardim, F., Grimm, A., Björnbom, E., Minkova, V., & Goranova, M.
- Venue
- Fuel Processing Technology
- Publisher
- Elsevier BV
- Published
- 2006-10
- Volume
- 87
- Issue
- 10
- Pages
- 899-905
- ISSN
- 0378-3820 (ISSN-L)
- OpenAlex
- W2021694970
- Cited by
- 366
- References
- 30
- FWCI
- 7.13
- Type
- journal article
- Language
- en
- Open access
- hybrid
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.