Cited by 86Carbon Nanotubes in CompositesThermochemical Biomass Conversion ProcessesFiber-reinforced polymer composites

Carbon nanotubes synthetized from gaseous products of waste polymer pyrolysis and their application

Borsodi, N., Szentes, A., Miskolczi, N., Wu, Chunfei, Liu, Xiaotong·2016·Journal of Analytical and Applied Pyrolysis

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1016/j.jaap.2016.05.018

Cites

28 of 28 references verified0 citation errors · 0 not checkable

Statistics

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.

A few free checks a day · papers already verified open instantly · results are public

Claims other papers make about this one

Each is checked against this paper’s own text: does it say what the citing paper says it does?

  • Under Fe/Co catalysts, municipal mixed plastics yielded the highest gas production, while polypropylene (PP) yielded the optimal amount of oil.

    “Borsodi et al. [85] conducted a comparative analysis of the conversion of six plastic types (PE/PP/PS/PA/PVC/MPW) under the influence of Fe/Co catalysts, thereby confirming that municipal mixed plastics yielded the highest gas production, while polypropylene (PP) yielded the optimal amount of oil.”

    From Functional carbon materials from waste plastics: synthesis and applications (2025) · cites this paper as [85]

    The Abstract (p. 2) says municipal plastic waste gave the highest gas yield and virgin polypropylene the highest oil yield. But it says the plastics were pyrolyzed without a catalyst; Fe- and Co-based catalysts were used afterward to convert the gases into carbon nanotubes. The Introduction (p. 5) confirms this sequence, so the claim incorrectly places the yield comparison under Fe/Co catalysts. (LLM, conf=0.91)

    Experimental — accuracy not yet measured

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Cites

Flagged first, then by citations

Cited by

Sorted by citations

Authors
Borsodi, N., Szentes, A., Miskolczi, N., Wu, C., & Liu, X.
Affiliations
  • University of Pannonia (HU)
  • University of Hull (GB)
Corresponding author
Miskolczi, N.
Venue
Journal of Analytical and Applied Pyrolysis
Publisher
Elsevier BV
Published
2016-07
Volume
120
Pages
304-313
ISSN
0165-2370 (ISSN-L)
OpenAlex
W2404888759
Cited by
86
References
28
Citations by year
2026: 2 · 2025: 15 · 2024: 10 · 2023: 9 · 2022: 13 · 2021: 13 · 2020: 9 · 2019: 7 · 2018: 4 · 2017: 4
FWCI
2.23
Type
journal article
Language
en
Open access
closed
Locations
  • Journal of Analytical and Applied Pyrolysis (publishedVersion)
  • White Rose Research Online (University of Leeds, The University of Sheffield, University of York) (acceptedVersion)
  • Research Portal (Queen's University Belfast) (submittedVersion)
Topics
  • Physical Sciences › Materials Science › Materials Chemistry › Carbon Nanotubes in Composites
  • Physical Sciences › Engineering › Biomedical Engineering › Thermochemical Biomass Conversion Processes
  • Physical Sciences › Engineering › Mechanical Engineering › Fiber-reinforced polymer composites
Keywords
carbon nanotubes, plastic waste pyrolysis, pyrolysis gas, chemical vapor deposition, iron catalysts, cobalt catalysts, municipal plastic waste, polyethylene, polypropylene, polyamide, polyvinyl chloride, polyethylene terephthalate, bio-oil, low-density polyethylene composites, tensile properties, Charpy impact properties, reinforcement effect

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review