Inhomogeneity of human vertebral cancellous bone: systematic density and structure patterns inside the vertebral body
The DOI matches its Crossref record; 32 of the 32 references it cites were found in a registry or an index.
Abstract
In the spine, cancellous bone quality is usually assessed for the whole vertebral body in a transverse central slice. Correct identification and assessment of the weakest parts of the cancellous bone may lead to better prediction of fracture risk. The density and structural parameters were systematically investigated inside the thoracic (T-9), thoracolumbar (T12-L1), and lumbar (L-4) vertebral bodies of nine subjects. On both sides of the median sagittal plane, anterior and posterior 8.2 mm vertical cores were harvested in the thoracic vertebra. In the thoracolumbar and lumbar vertebrae, external samples were also cored. Peripheral quantitative computed tomographic (pQCT) density analysis of the 136 cores was performed at four different levels, from the lower to the upper endplate. The relatively thin slice thickness (300 microm) and small pixel size (70 microm x 70 microm) was considered sufficient to investigate the structural parameters on the four transverse slices and in the sagittal and coronal planes (total of 816 images). Using a constant threshold a binary image was generated and the morphometric data were extracted. The binary image was further skeletonized and classical strut analysis was performed. Cancellous bone density was 20% higher in the posterior cores than in the anterior and external cores. Moreover, clear vertical inhomogeneity was noted because the lowest half of the vertebral body presented lower density than the upper half (differences ranging from 25% to 15%). All structural parameters were strongly dependent on the location of the measurement. Structural differences between anterior, posterior, and external areas were mild and followed the density patterns. On the other hand, vertical inhomogeneity of the structural parameters was important. For example, in the thoracolumbar and lumbar vertebrae, the numbers of nodes or node-to-node struts were almost twofold higher in the inferior half than in the superior half (p < 0.01), whereas trabecular thickness and number of free-ends presented a center/close-to-endplate structural pattern, with central trabeculae being 15% thicker (p < 0.05) and presenting 30% fewer free-ends (p < 0.01) than the close-to-endplate ones. Variability of density and structural parameters was high and a substantial part of this variability could be explained by the place inside the vertebral body where the measurement was made. The weak part was not in the center of the body but in its upper half where the lower density did not seem to be compensated by a higher structural architecture. Further clinical investigation could enhance fracture prediction by tracking and focusing on the weakest part of the vertebral body.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
In the citing paper
“For example, in the vertebrae, variations in density and architecture have been observed along the superior–inferior and posterior–anterior directions (87).”
From Bone Mechanical Properties in Healthy and Diseased States (2018) · cites this paper as [87]
Citations
Cites
Parfitt, A. M., Drezner, M. K., Glorieux, F. H., Kanis, J. A., Malluche, H., Meunier, P. J., Ott, S. M., & Recker, R. R. (1987) · Journal of Bone and Mineral Research · doi:10.1002/jbmr.5650020617 · Cited by 5,016
Bone Histomorphometry : Standardization of Nomenclature, Symbols, and Units
PARFITT, A. M., Drezner, M. K., Glorieux, F. H., Kanis, J. А., Malluche, H. H., Meunier, P. J., Ott, S. M., & Recker, R. R. (1987) · Journal of Bone and Mineral Research · Cited by 3,258
Noninvasive assessment of bone mineral and structure: State of the art
Genant, H. K., Engelke, K., Fuerst, T., Glüer, C.-C., Grampp, S., Harris, S. T., Jergas, M., Lang, T., Lu, Y., Majumdar, S., et al. (1996) · Journal of Bone and Mineral Research · doi:10.1002/jbmr.5650110602 · Cited by 941
Prediction of vertebral body compressive fracture using quantitative computed tomography.
McBroom, R. J., Hayes, W. C., Edwards, W. T., Goldberg, R. P., & White, A. A. (1985) · The Journal of Bone & Joint Surgery · doi:10.2106/00004623-198567080-00010 · Cited by 432
Variations in strength of vertebrae with age and their relation to osteoporosis
Bell, G. H., Dunbar, O., Beck, J. S., & Gibb, A. (1967) · Calcified Tissue Research · doi:10.1007/bf02008077 · Cited by 347
Age-related changes in vertebral trabecular bone architecture—assessed by a new method
Mosekilde, L. (1988) · Bone · doi:10.1016/8756-3282(88)90038-5 · Cited by 314
Trabecular bone exhibits fully linear elastic behavior and yields at low strains
Keaveny, T. M., Guo, X. E., Wachtel, E. F., McMahon, T. A., & Hayes, W. C. (1994) · Journal of Biomechanics · doi:10.1016/0021-9290(94)90053-1 · Cited by 300
Biologically meaningful determinants of the in vitro strength of lumbar vertebrae
Vesterby, A., Mosekilde, L., Gundersen, H. J. G., Melsen, F., Mosekilde, L., Holme, K., & Sørensen, S. (1991) · Bone · doi:10.1016/8756-3282(91)90044-j · Cited by 233
Ritzel, H., Amling, M., Pösl, M., Hahn, M., & Delling, G. (1997) · Journal of Bone and Mineral Research · doi:10.1359/jbmr.1997.12.1.89 · Cited by 220
Implications of architecture for the pathogenesis and prevention of vertebral fracture
PARFITT, A. (1992) · Bone · doi:10.1016/8756-3282(92)90196-4 · Cited by 202
Research works printed but not linked: 1
- Edwards, 1986, Variation of the density in the vertebral body measured by quantitative computed tomography, Trans Orthop Res Soc, 11, 205
Cited by
Bone Mechanical Properties in Healthy and Diseased States
Morgan, E. F., Unnikrisnan, G. U., & Hussein, A. I. (2018) · Annual Review of Biomedical Engineering · doi:10.1146/annurev-bioeng-062117-121139 · Cited by 1,026
“For example, in the vertebrae, variations in density and architecture have been observed along the superior–inferior and posterior– anterior directions (87).”
Bone mechanical properties and changes with osteoporosis
Osterhoff, G., Morgan, E. F., Shefelbine, S. J., Karim, L., McNamara, L. M., & Augat, P. (2016) · Injury · doi:10.1016/s0020-1383(16)47003-8 · Cited by 557
Crawford, R. P., Cann, C. E., & Keaveny, T. M. (2003) · Bone · doi:10.1016/s8756-3282(03)00210-2 · Cited by 547
“differences [9,13] and densitometric inhomogeneities [14,15] on vertebral strength.”
BackgroundBanse, X., Sims, T. J., & Bailey, A. J. (2002) · Journal of Bone and Mineral Research · doi:10.1359/jbmr.2002.17.9.1621 · Cited by 267
“Our sampling strategy was rigorous and proved its sensitivity to the within-subject variations in the structure or density.((25)) The end-cap technique was used for measurement of properties of vertebral cancellous bone because it was designed specially to eliminate end artifacts thus allowing a precise measurement of…”
BackgroundMethodInfluentialSelf-citationRegional variation in vertebral bone morphology and its contribution to vertebral fracture strength
Hulme, P. A., Boyd, S. K., & Ferguson, S. J. (2007) · Bone · doi:10.1016/j.bone.2007.08.019 · Cited by 239
Metadata
- Authors
- Banse, X., Devogelaer, J. P., Munting, E., Delloye, C., Cornu, O., & Grynpas, M.
- Affiliations
- UCLouvain (BE)
- Mount Sinai Hospital (CA)
- Corresponding author
- Grynpas, M
- Venue
- Bone
- Publisher
- Elsevier BV
- Published
- 2001-05
- Volume
- 28
- Issue
- 5
- Pages
- 563-571
- ISSN
- 1873-2763 (ISSN-L)
- 8756-3282
- OpenAlex
- W2100843879
- Cited by
- 130
- References
- 31
- Citations by year
- 2026: 4 · 2025: 5 · 2024: 2 · 2023: 7 · 2022: 5 · 2021: 6 · 2020: 3 · 2019: 1 · 2018: 7 · 2017: 1 · 2016: 3 · 2015: 8 · 2014: 7 · 2013: 10 · 2012: 6
- FWCI
- 3.65
- Type
- journal article
- Language
- en
- Open access
- closed
- Licence
- www.elsevier.com/tdm/userlicense/1.0/ (tdm)
- Locations
- Bone (publishedVersion)
- PubMed (publishedVersion)
- DIAL (Catholic University of Leuven) (submittedVersion)
- Funders
- Fonds De La Recherche Scientifique - FNRS
- Topics
- Health Sciences › Medicine › Orthopedics and Sports Medicine › Bone health and osteoporosis research
- Health Sciences › Medicine › Surgery › Spinal Fractures and Fixation Techniques
- Physical Sciences › Engineering › Biomedical Engineering › Medical Imaging and Analysis
- Keywords
- vertebral cancellous bone, vertebral body, bone mineral density, trabecular structure, trabecular thickness, vertebral fracture risk, endplate, thoracic vertebrae, lumbar vertebrae, bone quality assessment, quantitative computed tomography, bone morphometry, trabecular bone score
- MeSH terms
- Adult, Aged, Aged, 80 and over, Female, Humans, Lumbar Vertebrae, Male, Middle Aged, Osteoporosis, Predictive Value of Tests, Spine, Thoracic Vertebrae, Tomography, X-Ray Computed, Bone Density, Causality, Fractures, Bone
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Inhomogeneity of human vertebral cancellous bone: systematic density and structure patterns inside the vertebral body. https://app.cochat.ai/papers/10.1016/s8756-3282(01)00425-2
- The paper
- Banse, X., Devogelaer, J. P., Munting, E., Delloye, C., Cornu, O., & Grynpas, M. (2001). Inhomogeneity of human vertebral cancellous bone: systematic density and structure patterns inside the vertebral body. Bone. https://doi.org/10.1016/s8756-3282(01)00425-2
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.