CoChat

Quantized conductance coincides with state instability and excess noise in tantalum oxide memristors

Open access
Yi, Wei, Savel'ev, Sergey E., Medeiros-Ribeiro, Gilberto, Miao, Feng, Zhang, M.-X., Yang, J. Joshua, Bratkovsky, Alexander M., Williams, R. Stanley · 2016 · Nature Communications

The DOI matches its Crossref record; 59 of the 59 references it cites were found in a registry or an index.

Abstract

Tantalum oxide memristors can switch continuously from a low-conductance semiconducting to a high-conductance metallic state. At the boundary between these two regimes are quantized conductance states, which indicate the formation of a point contact within the oxide characterized by multistable conductance fluctuations and enlarged electronic noise. Here, we observe diverse conductance-dependent noise spectra, including a transition from 1/ f 2 (activated transport) to 1/ f (flicker noise) as a function of the frequency f , and a large peak in the noise amplitude at the conductance quantum G Q =2 e 2 / h , in contrast to suppressed noise at the conductance quantum observed in other systems. We model the stochastic behaviour near the point contact regime using Molecular Dynamics–Langevin simulations and understand the observed frequency-dependent noise behaviour in terms of thermally activated atomic-scale fluctuations that make and break a quantum conductance channel. These results provide insights into switching mechanisms and guidance to device operating ranges for different applications.

Overview

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1038/ncomms11142

Cites

59 of 59 references verified0 citation errors · 0 not checkable

Statistics

Figures

Figure 1 I–V and stress characterizations of TaOx devices. Multistate resistance fluctuations resembling telegraph noise are evident for nominal (a) SET and (b) RESET sweeps. Conductance fluctuations (red, experimental data) were observed among a set of nonlinear I-V curves (indicated by colored lines: initial states I, intermediate states II, quantum resistance states III) for both positive and negative current ramps applied to TaOx memristors when one of the states had a zero-bias resistance near the resistance quantum RQ (h/2e2=12.9 kΩ). (a) SET operation from R0V=29.9 kΩ. (b) RESET operation from R0V=12.9 kΩ (grey) and R0V=18.8 kΩ (red with solid circles). (c) Temporal evolution of zero-bias conductance states in TaOx memristors during low-voltage stress tests that has been performed by applying a pulse with 150 mV amplitude and 20-μs duration followed by reading the device conductance at 50 mV, with the sequence repeated at a time interval of 20 s. The device conductance jumps between values corresponding to an integer times the conductance quantum (2e2/h). Three traces with different colours (red, black and green) represent three separate tests on the same device.
Figure 1 I–V and stress characterizations of TaOx devices. Multistate resistance fluctuations resembling telegraph noise are evident for nominal (a) SET and (b) RESET sweeps. Conductance fluctuations (red, experimental data) were observed among a set of nonlinear I-V curves (indicated by colored lines: initial states I, intermediate states II, quantum resistance states III) for both positive and negative current ramps applied to TaOx memristors when one of the states had a zero-bias resistance near the resistance quantum RQ (h/2e2=12.9 kΩ). (a) SET operation from R0V=29.9 kΩ. (b) RESET operation from R0V=12.9 kΩ (grey) and R0V=18.8 kΩ (red with solid circles). (c) Temporal evolution of zero-bias conductance states in TaOx memristors during low-voltage stress tests that has been performed by applying a pulse with 150 mV amplitude and 20-μs duration followed by reading the device conductance at 50 mV, with the sequence repeated at a time interval of 20 s. The device conductance jumps between values corresponding to an integer times the conductance quantum (2e2/h). Three traces with different colours (red, black and green) represent three separate tests on the same device.CC BY · PubMed Central
Figure 2 Conductance behaviour in consecutive ON/OFF switching events. Conductance switching data of a TaOx memristor for 100,000 switching cycles showing larger variance in the regime close to a quantum of conductance. The solid symbols represent conductance data of ON (blue) and OFF (red) states and the green dash dot lines represents the corresponding average values during the 100,000 cycles. The mean conductance value and s.d. are <GON>=3.67 × 10−2 S and σON=5.7 × 10−3 S for ON states, and are <GOFF>=7.06 × 10−5 S and σOFF=3.38 × 10−3 S for OFF states. Thick olive dash dot line highlights the conductance quantum (2e2/h).
Figure 2 Conductance behaviour in consecutive ON/OFF switching events. Conductance switching data of a TaOx memristor for 100,000 switching cycles showing larger variance in the regime close to a quantum of conductance. The solid symbols represent conductance data of ON (blue) and OFF (red) states and the green dash dot lines represents the corresponding average values during the 100,000 cycles. The mean conductance value and s.d. are <GON>=3.67 × 10−2 S and σON=5.7 × 10−3 S for ON states, and are <GOFF>=7.06 × 10−5 S and σOFF=3.38 × 10−3 S for OFF states. Thick olive dash dot line highlights the conductance quantum (2e2/h).CC BY · PubMed Central
Figure 3 Conductance dependence of normalized noise spectral density. The normalized noise spectral density S/I2 for a TaOx memristor are plotted as a function of GQ-normalized zero-bias conductance. (a) S/I2 at 1kHz for two temperatures, T=295 K and 174 K (b) two-dimensional colour plot showing S/I2 as a function of conductance G/GQ and frequency f at T=295 K. The continuous scale on the colour plot was obtained by linear interpolation between measured data points. This representation clearly reveals the markedly increased noise near the first conductance quantum GQ and the tails of the noise distribution as a function of frequency. In addition, increased noise above the ambient trend can be seen for several other integer multiples of GQ. The error bars in a are s.d. calculated from evaluating S/I2 at different sourced currents (Supplementary Note 1). Small temperature dependence of noise at around G=GQ and at smaller conductance values (corresponding to a tunneling regime) confirms the present picture of local heating as the main source of noise (see text).
Figure 3 Conductance dependence of normalized noise spectral density. The normalized noise spectral density S/I2 for a TaOx memristor are plotted as a function of GQ-normalized zero-bias conductance. (a) S/I2 at 1kHz for two temperatures, T=295 K and 174 K (b) two-dimensional colour plot showing S/I2 as a function of conductance G/GQ and frequency f at T=295 K. The continuous scale on the colour plot was obtained by linear interpolation between measured data points. This representation clearly reveals the markedly increased noise near the first conductance quantum GQ and the tails of the noise distribution as a function of frequency. In addition, increased noise above the ambient trend can be seen for several other integer multiples of GQ. The error bars in a are s.d. calculated from evaluating S/I2 at different sourced currents (Supplementary Note 1). Small temperature dependence of noise at around G=GQ and at smaller conductance values (corresponding to a tunneling regime) confirms the present picture of local heating as the main source of noise (see text).CC BY · PubMed Central
Figure 4 Frequency dependence of normalized noise spectral density. The normalized noise spectral density S/I2 are plotted as a function of frequency f for seven different conductance states of a TaOx memristor. (a) states with G≥GQ. (b) states with G≤GQ. The general trends are that the lower conductance states have larger normalized noise amplitudes, metallic states (for example, R(III)=8.24 kΩ and R(IV)=1.28 kΩ) show a 1/f functional dependence (cyan dashed lines), while semiconducting states with higher resistance follow a 1/f2 law (black dashed lines). The spectrum of a system close to one resistance quantum of R(I)=12.3 kΩ is two orders of magnitude higher in amplitude at high frequency than the others represented in the plot. Also shown for the device conductance states at multiples of GQ the characteristic Lorentzian spectrum signature of atomic fluctuators (short dashed lines as Lorentzian fits for R(I)=12.3 kΩ and R(II)=6.4 kΩ). Note peculiar crossover between 1/f law at lower frequencies to 1/f2 law at higher frequencies in R(VII)=23.3 kΩ sample that matches the simulation in Supplementary Fig. 5c. More resistive R(VI)=49.4 kΩ and R(V)=80.6 kΩ samples mostly follow 1/f2 law.
Figure 4 Frequency dependence of normalized noise spectral density. The normalized noise spectral density S/I2 are plotted as a function of frequency f for seven different conductance states of a TaOx memristor. (a) states with G≥GQ. (b) states with G≤GQ. The general trends are that the lower conductance states have larger normalized noise amplitudes, metallic states (for example, R(III)=8.24 kΩ and R(IV)=1.28 kΩ) show a 1/f functional dependence (cyan dashed lines), while semiconducting states with higher resistance follow a 1/f2 law (black dashed lines). The spectrum of a system close to one resistance quantum of R(I)=12.3 kΩ is two orders of magnitude higher in amplitude at high frequency than the others represented in the plot. Also shown for the device conductance states at multiples of GQ the characteristic Lorentzian spectrum signature of atomic fluctuators (short dashed lines as Lorentzian fits for R(I)=12.3 kΩ and R(II)=6.4 kΩ). Note peculiar crossover between 1/f law at lower frequencies to 1/f2 law at higher frequencies in R(VII)=23.3 kΩ sample that matches the simulation in Supplementary Fig. 5c. More resistive R(VI)=49.4 kΩ and R(V)=80.6 kΩ samples mostly follow 1/f2 law.CC BY · PubMed Central

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Claims other papers make about this one

Each is checked against this paper’s own text: does it say what the citing paper says it does?

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Show all 59 references

Research works printed but not linked: 1

  1. Waser, R. in Nanoelectronics and Information Technology Vol. Nanoelectronics and Information Technology Wiley-VCH (2012).

Cited by

Metadata

Authors
Yi, W., Savel'ev, S. E., Medeiros-Ribeiro, G., Miao, F., Zhang, M.-X., Yang, J. J., Bratkovsky, A. M., & Williams, R. S.
Affiliations
  • Hewlett-Packard (United States) (US)
  • Loughborough University (GB)
Venue
Nature Communications
Published
2016-04-04
Volume
7
Issue
1
Pages
11142-11142
ISSN
2041-1723 (ISSN-L)
OpenAlex
W2336669647
Cited by
141
References
59
Citations by year
2026: 4 · 2025: 21 · 2024: 18 · 2023: 8 · 2022: 12 · 2021: 17 · 2020: 21 · 2019: 21 · 2018: 7 · 2017: 9 · 2016: 3
FWCI
6.14
Type
journal article
Language
en
Open access
Licence
Locations
  • Nature Communications (publishedVersion, cc-by)
  • Europe PMC (PubMed Central) (publishedVersion, cc-by)
  • PubMed Central (publishedVersion, cc-by)
  • PubMed (publishedVersion)
  • LA Referencia (Red Federada de Repositorios Institucionales de Publicaciones Científicas) (publishedVersion, other-oa)
  • RePEc: Research Papers in Economics (submittedVersion)
  • DOAJ (DOAJ: Directory of Open Access Journals) (submittedVersion, cc-by-sa)
  • Loughborough University Institutional Repository (Loughborough University) (submittedVersion, cc-by)
  • Loughborough University Research Repository (Loughborough University) (submittedVersion, cc-by)
Funders
Conselho Nacional de Desenvolvimento Científico e Tecnológico
Topics
  • Physical Sciences › Engineering › Electrical and Electronic Engineering › Advanced Memory and Neural Computing
  • Physical Sciences › Engineering › Electrical and Electronic Engineering › Molecular Junctions and Nanostructures
  • Physical Sciences › Physics and Astronomy › Condensed Matter Physics › Quantum and electron transport phenomena
Keywords
conductance quantization, point contacts, conductance fluctuations, excess noise, 1/f noise, 1/f2 noise, switching mechanism, semiconductor-metal transition

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.