CoChat

Integrated photonic quantum gates for polarization qubits

Open access

The DOI matches its Crossref record; 54 of the 56 references it cites were found in a registry or an index; 9 of the 15 sources its claims cite were checked for support.

Abstract

The ability to manipulate quantum states of light by integrated devices may open new perspectives both for fundamental tests of quantum mechanics and for novel technological applications. However, the technology for handling polarization-encoded qubits, the most commonly adopted approach, is still missing in quantum optical circuits. Here we demonstrate the first integrated photonic controlled-NOT (CNOT) gate for polarization-encoded qubits. This result has been enabled by the integration, based on femtosecond laser waveguide writing, of partially polarizing beam splitters on a glass chip. We characterize the logical truth table of the quantum gate demonstrating its high fidelity to the expected one. In addition, we show the ability of this gate to transform separable states into entangled ones and vice versa. Finally, the full accessibility of our device is exploited to carry out a complete characterization of the CNOT gate through a quantum process tomography. As quantum information processing continues to develop apace, the need for integrated photonic devices becomes ever greater for both fundamental measurements and technological applications. To this end, Crespiet al.demonstrate a high-fidelity photonic controlled-NOT gate on a glass chip.

Overview

CoChat Summary

TL;DR

The paper demonstrates the first integrated photonic controlled-NOT (CNOT) gate for polarization-encoded qubits, enabled by femtosecond-laser-written partially polarizing beam splitters on a glass chip. It reports high-fidelity logical operation, entanglement generation/disentanglement, Bell-state discrimination, and full quantum process tomography.

Key findings

  • The integrated CNOT gate was realized with partially polarizing directional couplers fabricated in borosilicate glass; the device footprint is 500 μm × 3 cm.
  • The measured average fidelity of the logical basis truth table was F = 0.940 ± 0.004, compared with an expected fidelity estimated from measured coupler transmissivities (numerical expected value not present in the provided text).
  • The gate converted separable input states into Bell states and discriminated the four Bell states with probability 0.877 ± 0.007; the average Bell-state output fidelity value is not given in the provided text.
  • Quantum process tomography gave a process fidelity with the ideal CNOT of 0.906 ± 0.003.

Methods

  • Waveguides were micromachined in Corning EAGLE2000 borosilicate glass using 400 fs pulses at 960 kHz, 240 nJ energy, focused 170 μm below the surface with a 0.6 NA objective, and 20 mm s⁻¹ translation; measured propagation losses were 0.8 dB cm⁻¹, coupling losses about 1.3 dB per facet, birefringence B = 7×10⁻⁵, and bending radius 30 mm.
  • Directional couplers were calibrated with interaction lengths from 0 mm to 2 mm and 5.6 mm to 8.2 mm at 7 μm waveguide separation; selected lengths were L1 ≈ 7.4 mm for PPDC1 and L2 ≈ 7 mm for PPDC2/PPDC3.
  • Quantum measurements included the four computational-basis truth-table inputs, entangling and Bell-state discrimination tests, and quantum process tomography with 16 input states and projections on H, V, D, A, R, L polarizations.

Limitations

  • The authors attribute the discrepancy between experimental and expected fidelities mainly to partial distinguishability of photon wavepackets and non-perfect compensation of polarization rotation in the single-mode optical fibres.
  • They note that the Bell-state discrimination probability is slightly lower than the previous fidelities due to imperfections in the entanglement source.
  • Evident from the text: the CNOT operation succeeds probabilistically (success probability value omitted in the provided text), and on-chip one-qubit gates are left to future work.

Model-written summary. Check it against the paper before relying on it.

Integrity signals

Registry

Crossref · 10.1038/ncomms1570

Cites

54 of 54 references verified0 citation errors · 0 not checkable

Statistics

Nothing to recompute.

Figures

Figure 1 Partially polarizing directional couplers. (a) Schematic representation of a waveguide directional coupler; IN1 and IN2 are the input ports, whereas OUT1 and OUT2 are the output ports of the device. (b) H (squares) and V (triangles) polarization transmissions of directional couplers with different interaction lengths, based on slightly birefringent waveguides. First, the 0–2 mm interaction length range was investigated to evaluate the beating length difference between the two polarizations; the interval of interest to obtain the required PPDCs was estimated to be in the 5.6–8.2 mm range, which was consequently explored. Transmission for 0 mm interaction length is non-zero, because some coupling already occurs in the curved portions of the approaching/departing waveguides. Error bars indicate fabrication reproducibility.
Figure 1 Partially polarizing directional couplers. (a) Schematic representation of a waveguide directional coupler; IN1 and IN2 are the input ports, whereas OUT1 and OUT2 are the output ports of the device. (b) H (squares) and V (triangles) polarization transmissions of directional couplers with different interaction lengths, based on slightly birefringent waveguides. First, the 0–2 mm interaction length range was investigated to evaluate the beating length difference between the two polarizations; the interval of interest to obtain the required PPDCs was estimated to be in the 5.6–8.2 mm range, which was consequently explored. Transmission for 0 mm interaction length is non-zero, because some coupling already occurs in the curved portions of the approaching/departing waveguides. Error bars indicate fabrication reproducibility.CC BY-NC-ND · PubMed Central
Figure 2 Experimental setup. Sketch of the experimental setup that can be conceptually divided into three parts. The first part is the source: photon pairs at wavelength λ=806 nm are generated via spontaneous parametric down conversion in a 1.5 mm β-barium borate crystal (C) cut for type-II non-collinear phase matching, pumped by a CW diode laser with power P=50 mW (ref. 27). Photon polarization states are prepared by using polarizing beam splitters (PBSs) and waveplates (WPs). A delay line (DL) is inserted to control the temporal superposition of the photons, which are then coupled to single mode fibres (SMFs) and injected into the integrated CNOT gate. Interference filters (IFs) determine the photon bandwidth Δλ=6 nm. The second part shows the integrated CNOT for polarization-encoded qubits (see inset) realized by ultrafast laser writing technique. The final part represents the analysis apparatus: the polarization state of qubits emerging from the chip is analyzed by standard analysis setups (WP+PBS). Photons are then delivered to single photon counting modules (SPCM) through multimode fibres (MMFs) and coincidences between the two channels are measured. Polarization controllers (PCs) are used before and after the CNOT device to compensate polarization rotations induced by the fibres. A waveplate controller (WPC) drives the motorized waveplates to automatize the measurements.
Figure 2 Experimental setup. Sketch of the experimental setup that can be conceptually divided into three parts. The first part is the source: photon pairs at wavelength λ=806 nm are generated via spontaneous parametric down conversion in a 1.5 mm β-barium borate crystal (C) cut for type-II non-collinear phase matching, pumped by a CW diode laser with power P=50 mW (ref. 27). Photon polarization states are prepared by using polarizing beam splitters (PBSs) and waveplates (WPs). A delay line (DL) is inserted to control the temporal superposition of the photons, which are then coupled to single mode fibres (SMFs) and injected into the integrated CNOT gate. Interference filters (IFs) determine the photon bandwidth Δλ=6 nm. The second part shows the integrated CNOT for polarization-encoded qubits (see inset) realized by ultrafast laser writing technique. The final part represents the analysis apparatus: the polarization state of qubits emerging from the chip is analyzed by standard analysis setups (WP+PBS). Photons are then delivered to single photon counting modules (SPCM) through multimode fibres (MMFs) and coincidences between the two channels are measured. Polarization controllers (PCs) are used before and after the CNOT device to compensate polarization rotations induced by the fibres. A waveplate controller (WPC) drives the motorized waveplates to automatize the measurements.CC BY-NC-ND · PubMed Central
Figure 3 Truth table and entanglement generation. (a) Measured truth table. (b) Experimental tomographic reconstruction of the Bell state |Φ+〉 obtained by injecting the separable state |+0〉 in the CNOT. (c) Measured probabilities of the output Bell states corresponding to the different input separable states. (d) Measured probabilities of the output separable states corresponding to the different input Bell states.
Figure 3 Truth table and entanglement generation. (a) Measured truth table. (b) Experimental tomographic reconstruction of the Bell state |Φ+〉 obtained by injecting the separable state |+0〉 in the CNOT. (c) Measured probabilities of the output Bell states corresponding to the different input separable states. (d) Measured probabilities of the output separable states corresponding to the different input Bell states.CC BY-NC-ND · PubMed Central
Figure 4 Process matrix measurement. (a) Ideal χCNOT and (b) experimental χexp matrices (real part) obtained from the quantum process tomography of the CNOT gate. Imaginary part of χexp is negligible. X, Y and Z correspond to Pauli matrices σ1, σ2 and σ3, respectively.
Figure 4 Process matrix measurement. (a) Ideal χCNOT and (b) experimental χexp matrices (real part) obtained from the quantum process tomography of the CNOT gate. Imaginary part of χexp is negligible. X, Y and Z correspond to Pauli matrices σ1, σ2 and σ3, respectively.CC BY-NC-ND · PubMed Central

Verification

Claims the paper makes

6 Valid · 1 Not valid · 5 Not checked · 24 Own results and interpretations

20 more claims · 1 with their cited sources checked

Create a free account to see all 36 claims and every source verdict.

See all claims — free account
  • Probably not a substantial claim. 3
  • It may state two separate claims as one. 8

Create a free account to see these claims.

Claims other papers make about this one

Each is checked against this paper’s own text: does it say what the citing paper says it does?

2 more claims about this paper

Create a free account to see every claim other papers make about this one.

See all claims — free account

Citations

Cites

Cited by

See all 355

Metadata

Authors
Crespi, A., Ramponi, R., Osellame, R., Sansoni, L., Bongioanni, I., Sciarrino, F., Vallone, G., & Mataloni, P.
Affiliations
  • Istituto di Fotonica e Nanotecnologie (IT)
  • Sapienza University of Rome (IT)
  • National Institute of Optics (IT)
  • Centro Ricerche Enrico Fermi (IT)
Corresponding author
Osellame, Roberto
Venue
Nature Communications
Published
2011-11-29
Volume
2
Issue
1
Pages
566-566
ISSN
2041-1723 (ISSN-L)
OpenAlex
W1964244689
Cited by
351
References
56
Citations by year
2026: 14 · 2025: 33 · 2024: 21 · 2023: 17 · 2022: 19 · 2021: 15 · 2020: 24 · 2019: 31 · 2018: 25 · 2017: 23 · 2016: 24 · 2015: 30 · 2014: 36 · 2013: 22 · 2012: 16
FWCI
11.87
Type
journal article
Language
en
Open access
Licence
Locations
  • Nature Communications (publishedVersion, cc-by-nc-nd)
  • Europe PMC (PubMed Central) (publishedVersion, cc-by-nc-nd)
  • PubMed Central (publishedVersion, cc-by-nc-nd)
  • PubMed (publishedVersion)
  • arXiv (Cornell University) (submittedVersion)
  • Padua Research Archive (University of Padova) (submittedVersion, cc-by-nc-nd)
  • RePEc: Research Papers in Economics (submittedVersion)
  • INO Open Portal (submittedVersion)
  • IRIS Research product catalog (Sapienza University of Rome) (submittedVersion)
  • Virtual Community of Pathological Anatomy (University of Castilla La Mancha) (submittedVersion)
  • arXiv (Cornell University)
Topics
  • Physical Sciences › Physics and Astronomy › Atomic and Molecular Physics, and Optics › Quantum Information and Cryptography
  • Physical Sciences › Engineering › Electrical and Electronic Engineering › Photonic and Optical Devices
  • Physical Sciences › Computer Science › Artificial Intelligence › Quantum Computing Algorithms and Architecture
Keywords
integrated photonics, CNOT gate, polarization qubits, glass photonics, quantum process tomography, entanglement generation, gate fidelity

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

The claim verdicts this report counts are experimental: their accuracy is not yet measured.

A language model drew the claims from the paper on 2026-10-07, under version 3 of the claim definition (model deepseek-v4.1-flash, prompt extract-v3).

A second model labelled each claim on 2026-10-07 (model jev-1.13-20260917, definition revision gold-guideline-v0.2).

Cited sources are checked with a language model’s help (gpt-6-sol).

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.