The DOI matches its Crossref record; 8 of the 8 references it cites were found in a registry or an index.
Multiferroic BiFeO3 thin films processed via chemical solution deposition: Structural and electrical characterization
Abstract
Polycrystalline BiFeO3 thin films were fabricated on (111)Pt∕Ti∕SiO2∕Si substrates via Bi-acetate- and Fe-acetylacetonate-based chemical solution deposition and spin-coating techniques. The processing parameters were optimized in order to obtain films with high resistivity. The optical properties (refractive indices and extinction coefficients) were measured by means of ellipsometry (HeNe laser, λ=632.8Å). Microstructure characterization was made by means of atomic force microscopy, grazing incidence x-ray diffractometry (XRD), and texture analysis. Additionally, powders prepared from a stoichiometric precursor were investigated by means of thermogravimetric and differential thermal analyses and XRD. It is demonstrated that the formation of perovskite-type BiFeO3 is accompanied by the appearance of bismuth oxide at low temperatures which then transforms into Bi36Fe2O57. For the films it was found that annealing in oxygen leads to higher indices of refraction, lower roughness, and smaller grain size. Complete crystallization of the films was achieved at a substantially lower temperature compared to that of the powders. A (100) (pseudocubic) out-of-plane preferred orientation was revealed for specimens annealed in air and oxygen. It is supposed that the crystal lattice of the thin film is close to cubic possibly due to stress development at the substrate∕film interface. The electrical properties of the films were measured at room temperature by impedance analysis. The piezoelectric properties were determined using a laser vibrometer. Room temperature resistances measured at 1 kHz for metal-film-metal configurations for the specimens annealed in air and O2 were 14 Ω and 1.35 kΩ, respectively. This is explained in terms of the high sensitivity of the oxidation state (+2 or +3) of iron ions to oxygen stoichiometry in the specimens. Further electrical characterization of the specimen annealed in O2 revealed very low frequency dispersion of the dielectric constant. A dielectric loss of 1% or less was detected in a wide range of frequency. The films annealed in oxygen showed piezoelectric activity with a value of the piezoelectric coefficient d33 of 12 pm∕V. A relatively weak ferroelectricity (remnant polarization 2Pr of approximately 1μC∕cm2) was detected for the specimens annealed in oxygen.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Epitaxial BiFeO 3 Multiferroic Thin Film Heterostructures
Wang, J., Neaton, J. B., Zheng, H., Nagarajan, V., Ogale, S. B., Liu, B., Viehland, D., Vaithyanathan, V., Schlom, D. G., Waghmare, U. V., et al. (2003) · Science · doi:10.1126/science.1080615 · Cited by 6,217
Structure of a ferroelectric and ferroelastic monodomain crystal of the perovskite BiFeO3
Kubel, F., & Schmid, H. (1990) · Acta Crystallographica Section B Structural Science · doi:10.1107/s0108768190006887 · Cited by 1,317
Wang, Y. P., Zhou, L., Zhang, M. F., Chen, X. Y., Liu, J.-M., & Liu, Z. G. (2004) · Applied Physics Letters · doi:10.1063/1.1667612 · Cited by 1,050
Wenk, H.-R. (2002) · Reviews in Mineralogy and Geochemistry · doi:10.2138/gsrmg.51.1.291 · Cited by 931
Observation of saturated polarization and dielectric anomaly in magnetoelectric BiFeO3 thin films
Palkar, V. R., John, J., & Pinto, R. (2002) · Applied Physics Letters · doi:10.1063/1.1458695 · Cited by 460
Structural and multiferroic properties of BiFeO3 thin films at room temperature
Yun, K. Y., Noda, M., Okuyama, M., Saeki, H., Tabata, H., & Saito, K. (2004) · Journal of Applied Physics · doi:10.1063/1.1775045 · Cited by 272
Prominent ferroelectricity of BiFeO3 thin films prepared by pulsed-laser deposition
Yun, K. Y., Noda, M., & Okuyama, M. (2003) · Applied Physics Letters · doi:10.1063/1.1626267 · Cited by 225
Investigation of the unusual magnetic spiral arrangement in BiFeO3
Sosnowska, I. M., Loewenhaupt, M., David, W. I. F., & Ibberson, R. M. (1992) · Physica B Condensed Matter · doi:10.1016/0921-4526(92)90678-l · Cited by 153
Cited by
Mehring, M. (2007) · Coordination Chemistry Reviews · doi:10.1016/j.ccr.2006.06.005 · Cited by 293
Text Mining the Literature to Inform Experiments and Rationalize Impurity Phase Formation for BiFeO3
Cruse, K., Baibakova, V., Abdelsamie, M., Hong, K., Bartel, C. J., Trewartha, A., Jain, A., Sutter-Fella, C. M., & Ceder, G. (2024) · Chemistry of Materials · doi:10.1021/acs.chemmater.3c02203 · Cited by 13
Metadata
- Authors
- Iakovlev, S., Solterbeck, C.-H., Kuhnke, M., & Es-Souni, M.
- Venue
- Journal of Applied Physics
- Publisher
- AIP Publishing
- Published
- 2005-04-14
- Volume
- 97
- Issue
- 9
- ISSN
- 0021-8979 (ISSN-L)
- 1089-7550
- OpenAlex
- W2055171741
- Cited by
- 266
- References
- 8
- FWCI
- 10.72
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.