The DOI matches its Crossref record; 11 of the 11 references it cites were found in a registry or an index.
Theory of Sputtering. I. Sputtering Yield of Amorphous and Polycrystalline Targets
Abstract
Sputtering of a target by energetic ions or recoil atoms is assumed to result from cascades of atomic collisions. The sputtering yield is calculated under the assumption of random slowing down in an infinite medium. An integrodifferential equation for the yield is developed from the general Boltzmann transport equation. Input quantities are the cross sections for ion-target and target-target collisions, and atomic binding energies. Solutions of the integral equation are given that are asymptotically exact in the limit of high ion energy as compared to atomic binding energies. Two main stages of the collision cascade have to be distinguished: first, the slowing down of the primary ion and all recoiling atoms that have comparable energies---these particles determine the spatial extent of the cascade; second, the creation and slowing down of low-energy recoils that constitute the major part of all atoms set in motion. The separation between the two stages is essentially complete in the limit of high ion energy, as far as the calculation of the sputtering yield is concerned. High-energy collisions are characterized by Thomas-Fermi-type cross sections, while a Born-Mayer-type cross section is applied in the low-energy region. Electronic stopping is included when necessary. The separation of the cascade into two distinct stages has the consequence that two characteristic depths are important for the qualitative understanding of the sputtering process. First, the scattering events that eventually lead to sputtering take place within a certain layer near the surface, the thickness of which depends on ion mass and energy and on ion-target geometry. In the elastic collision region, this thickness is a sizable fraction of the ion range. Second, the majority of sputtered particles originate from a very thin surface layer (\ensuremath{\sim}5 \AA{}), because small energies dominate. The general sputtering-yield formula is applied to specific situations that are of interest for comparison with experiment. These include backsputtering of thick targets by ion beams at perpendicular and oblique incidence and ion energies above \ensuremath{\sim}100 eV, transmission sputtering of thin foils, sputtering by recoil atoms from $\ensuremath{\alpha}$-active atoms distributed homogeneously or inhomogeneously in a thick target, sputtering of fissionable specimens by fission fragments, and sputtering of specimens that are irradiated in the core of a reactor or bombarded with a neutron beam. There is good agreement with experimental results on polycrystalline targets within the estimated accuracy of the data and the input parameters entering the theory. There is no need for adjustable parameters in the usual sense, but specific experimental setups are discussed that allow independent checks or accurate determination of some input quantities.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Mathematical Methods of Statistics.
Geary, R. C., & Cramer, H. (1947) · The Economic Journal · doi:10.2307/2226151 · Cited by 5,927
Selected Values of Thermodynamic Properties of Metals and Alloys
Hultgren, R. (1963) · Cited by 1,518
II. The energy spectrum of ejected atoms during the high energy sputtering of gold
Thompson, M. W. (1968) · Philosophical Magazine · doi:10.1080/14786436808227358 · Cited by 1,198
Cohesion of Ionic Solids in the Born Model
Tosi, M. P. (1964) · Solid State Physics · doi:10.1016/s0081-1947(08)60515-9 · Cited by 1,053
Atomic and Ionic Impact Phenomena on Metal Surfaces
Kaminsky, M. (1965) · Springer eBooks · doi:10.1007/978-3-642-46025-8 · Cited by 748
Patter, D. M. V. (1957) · Journal of the Franklin Institute · doi:10.1016/0016-0032(57)90992-4 · Cited by 566
Sputtering Yields for Low Energy He+-, Kr+-, and Xe+-Ion Bombardment
Rosenberg, D., & Wehner, G. K. (1962) · Journal of Applied Physics · doi:10.1063/1.1728843 · Cited by 429
Collection and sputtering experiments with noble gas ions
Almén, O., & Bruce, G. (1961) · Nuclear Instruments and Methods · doi:10.1016/0029-554x(61)90026-x · Cited by 415
Theory of Electron Penetration
Spencer, L. V. (1955) · Physical Review · doi:10.1103/physrev.98.1597 · Cited by 353
ON THE NUMBER OF ATOMS DISPLACED BY IMPLANTED IONS OR ENERGETIC RECOIL ATOMS
Sigmund, P. (1969) · Applied Physics Letters · doi:10.1063/1.1652730 · Cited by 348
Self-citation
Cited by
A proposed method of calculating displacement dose rates
Norgett, M. J., Robinson, M. T., & Torrens, I. M. (1975) · Nuclear Engineering and Design · doi:10.1016/0029-5493(75)90035-7 · Cited by 1,690
Energy dependence of the ion-induced sputtering yields of monatomic solids
Matsunami, N., Yamamura, Y., Itikawa, Y., Itoh, N., Kazumata, Y., Miyagawa, S., Morita, K., Shimizu, R., & Tawara, H. (1984) · Atomic Data and Nuclear Data Tables · doi:10.1016/0092-640x(84)90016-0 · Cited by 805
High power impulse magnetron sputtering discharge
Gudmundsson, J. T., Brenning, N., Lundin, D., & Helmersson, U. (2012) · Journal of Vacuum Science & Technology A: Vacuum, Surfaces, and Films · doi:10.1116/1.3691832 · Cited by 761
Intrinsic stress in sputter-deposited thin films
Windischmann, H. (1992) · Critical Reviews in Solid State and Materials Sciences · doi:10.1080/10408439208244586 · Cited by 662
Overview of atomic layer etching in the semiconductor industry
Kanarik, K. J., Lill, T., Hudson, E. A., Sriraman, S., Tan, S., Marks, J., Vahedi, V., & Gottscho, R. A. (2015) · Journal of Vacuum Science & Technology A: Vacuum, Surfaces, and Films · doi:10.1116/1.4913379 · Cited by 623
Knaster, J., Moeslang, A., & Muroga, T. (2016) · Nature Physics · doi:10.1038/nphys3735 · Cited by 553
Physics and technology of magnetron sputtering discharges
Gudmundsson, J. T. (2020) · Plasma Sources Science and Technology · doi:10.1088/1361-6595/abb7bd · Cited by 532
Plasma nanoscience: from nano-solids in plasmas to nano-plasmas in solids
Ostrikov, K., Neyts, E. C., & Meyyappan, M. (2013) · Advances in Physics · doi:10.1080/00018732.2013.808047 · Cited by 513
Dynamic Scaling of Ion-Sputtered Surfaces
Cuerno, R., & Barabási, A.-L. (1995) · Physical Review Letters · doi:10.1103/physrevlett.74.4746 · Cited by 513
Morphology of ion-sputtered surfaces
Makeev, M. A., Cuerno, R., & Barabási, A.-L. (2002) · Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms · doi:10.1016/s0168-583x(02)01436-2 · Cited by 503
Surface science aspects of etching reactions
Winters, H. F., & Coburn, J. W. (1992) · Surface Science Reports · doi:10.1016/0167-5729(92)90009-z · Cited by 502
Making waves: Kinetic processes controlling surface evolution during low energy ion sputtering
Chan, W. L., & Chason, E. (2007) · Journal of Applied Physics · doi:10.1063/1.2749198 · Cited by 493
Tutorial: Reactive high power impulse magnetron sputtering (R-HiPIMS)
Anders, A. (2017) · Journal of Applied Physics · doi:10.1063/1.4978350 · Cited by 424
Reduction of oxides of iron, cobalt, titanium and niobium by low-energy ion bombardment
Choudhury, T., Saied, S. O., Sullivan, J. L., & Abbot, A. M. (1989) · Journal of Physics D: Applied Physics · doi:10.1088/0022-3727/22/8/026 · Cited by 403
Magnetism in curved geometries
Streubel, R., Fischer, P., Kronast, F., Kravchuk, V. P., Sheka, D. D., Gaididei, Y., Schmidt, O. G., & Makarov, D. (2016) · Journal of Physics D: Applied Physics · doi:10.1088/0022-3727/49/36/363001 · Cited by 371
Review Article: Tracing the recorded history of thin-film sputter deposition: From the 1800s to 2017
Greene, J. E. (2017) · Journal of Vacuum Science & Technology A: Vacuum, Surfaces, and Films · doi:10.1116/1.4998940 · Cited by 343
Recoil mixing in solids by energetic ion beams
Littmark, U., & Hofer, W. O. (1980) · Nuclear Instruments and Methods · doi:10.1016/0029-554x(80)91274-4 · Cited by 316
Sputtering—a review of some recent experimental and theoretical aspects
Oechsner, H. (1975) · Applied Physics · doi:10.1007/bf00896610 · Cited by 299
Custer, J. S., Thompson, M. O., Jacobson, D. C., Poate, J. M., Roorda, S., Sinke, W. C., & Spaepen, F. (1994) · Applied Physics Letters · doi:10.1063/1.111121 · Cited by 281
SIMS analysis of oxygen isotopes: matrix effects in complex minerals and glasses
Eiler, J. M., Graham, C., & Valley, J. W. (1997) · Chemical Geology · doi:10.1016/s0009-2541(97)00015-6 · Cited by 263
Nano SIMS: Technical Aspects and Applications in Cosmochemistry and Biological Geochemistry
Hoppe, P., Cohen, S., & Meibom, A. (2013) · Geostandards and Geoanalytical Research · doi:10.1111/j.1751-908x.2013.00239.x · Cited by 254
Holste, K., Dietz, P., Scharmann, S., Keil, K., Henning, T., Zschätzsch, D., Reitemeyer, M., Nauschütt, B., Kiefer, F., Kunze, F., et al. (2020) · Review of Scientific Instruments · doi:10.1063/5.0010134 · Cited by 207
Isotopic fractionation of negative ions produced by Cs sputtering in a high-intensity source
Middleton, R., Juenemann, D., & Klein, J. (1994) · Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms · doi:10.1016/0168-583x(94)95455-0 · Cited by 15
Metadata
- Authors
- Sigmund, P.
- Venue
- Physical Review
- Publisher
- American Physical Society (APS)
- Published
- 1969-08-10
- Volume
- 184
- Issue
- 2
- Pages
- 383-416
- ISSN
- 0031-899X (ISSN-L)
- OpenAlex
- W4230053467
- Cited by
- 3,589
- References
- 11
- FWCI
- 20.43
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.