The DOI matches its Crossref record; 9 of the 9 references it cites were found in a registry or an index.
Self-powered signal processing using vibration-based power generation
Abstract
Low power design trends raise the possibility of using ambient energy to power future digital systems. A chip has been designed and tested to demonstrate the feasibility of operating a digital system from power generated by vibrations in its environment. A moving coil electromagnetic transducer was used as a power generator. Calculations show that power on the order of 400 /spl mu/W can be generated. The test chip integrates an ultra-low power controller to regulate the generator voltage using delay feedback techniques, and a low power subband filter DSP load circuit. Tests verify 500 kHz self-powered operation of the subband filter, a level of performance suitable for sensor applications. The entire system, including the DSP load, consumes 18 /spl mu/W of power. The chip is implemented in a standard 0.8 /spl mu/m CMOS process. A single generator excitation produced 23 ms of valid DSP operation at a 500 kHz clock frequency, corresponding to 11,700 cycles.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Analysis of a micro-electric generator for microsystems
Williams, C. B., & Yates, R. B. (1996) · Sensors and Actuators A: Physical · doi:10.1016/0924-4247(96)80118-x · Cited by 1,407
Principles of Power Electronics
Kassakian, J. G., Perreault, D. J., Verghese, G. C., & Schlecht, M. F. (2023) · Cambridge University Press eBooks · doi:10.1017/9781009023894 · Cited by 1,394
Human-powered wearable computing
Starner, T. (1996) · IBM Systems Journal · doi:10.1147/sj.353.0618 · Cited by 876
Embedded power supply for low-power DSP
Gutnik, V., & Chandrakasan, A. P. (1997) · IEEE Transactions on Very Large Scale Integration (VLSI) Systems · doi:10.1109/92.645069 · Cited by 260
Self-citationA low-voltage CMOS DC-DC converter for a portable battery-operated system
Stratakos, A. J., Sanders, S. R., & Brodersen, R. W. (2002) · Proceedings of 1994 Power Electronics Specialist Conference - PESC'94 · doi:10.1109/pesc.1994.349672 · Cited by 228
Ultra low power control circuits for PWM converters
Dancy, A. P., & Chandrakasan, A. P. (2002) · PESC97. Record 28th Annual IEEE Power Electronics Specialists Conference. Formerly Power Conditioning Specialists Conference 1970-71. Power Processing and Electronic Specialists Conference 1972 · doi:10.1109/pesc.1997.616620 · Cited by 185
Self-citationAnalysis Of A Micro-electric Generator For Microsystems
Williams, C. B., & Yates, R. B. (2005) · Proceedings of the International Solid-State Sensors and Actuators Conference - TRANSDUCERS '95 · doi:10.1109/sensor.1995.717207 · Cited by 175
A low power switching power supply for self-clocked systems
Wei, G.-Y., & Horowitz, M. (1996) · doi:10.5555/252493.252627 · Cited by 107
A low power switching power supply for self-clocked systems
Wei, G.-Y., & Horowitz, M. (2002) · International Symposium on Low Power Electronics and Design (ISLPED) · doi:10.1109/lpe.1996.547531 · Cited by 49
Cited by
Energy harvesting vibration sources for microsystems applications
Beeby, S. P., Tudor, M. J., & White, N. M. (2006) · Measurement Science and Technology · doi:10.1088/0957-0233/17/12/r01 · Cited by 3,008
A study of low level vibrations as a power source for wireless sensor nodes
Roundy, S., Wright, P. K., & Rabaey, J. (2003) · Computer Communications · doi:10.1016/s0140-3664(02)00248-7 · Cited by 2,819
Energy Harvesting From Human and Machine Motion for Wireless Electronic Devices
Mitcheson, P. D., Yeatman, E. M., Rao, G. K., Holmes, A. S., & Green, T. C. (2008) · Proceedings of the IEEE · doi:10.1109/jproc.2008.927494 · Cited by 1,888
A piezoelectric vibration based generator for wireless electronics
Roundy, S., & Wright, P. K. (2004) · Smart Materials and Structures · doi:10.1088/0964-1726/13/5/018 · Cited by 1,818
A Review of Power Harvesting from Vibration Using Piezoelectric Materials
Sodano, H. A., Inman, D. J., & Park, G. (2004) · The Shock and Vibration Digest · doi:10.1177/0583102404043275 · Cited by 1,361
Cook-Chennault, K. A., Thambi, N., & Sastry, A. M. (2008) · Smart Materials and Structures · doi:10.1088/0964-1726/17/4/043001 · Cited by 1,241
Advances in energy harvesting using low profile piezoelectric transducers
Priya, S. (2007) · Journal of Electroceramics · doi:10.1007/s10832-007-9043-4 · Cited by 918
Vibration-to-electric energy conversion
Meninger, S., Mur-Miranda, J. O., Amirtharajah, R., Chandrakasan, A., & Lang, J. H. (2001) · IEEE Transactions on Very Large Scale Integration (VLSI) Systems · doi:10.1109/92.920820 · Cited by 867
Self-citationDESIGN CONSIDERATIONS FOR MEMS-SCALE PIEZOELECTRIC MECHANICAL VIBRATION ENERGY HARVESTERS
DUTOIT, N. E., WARDLE, B. L., & KIM, S.-G. (2005) · Integrated Ferroelectrics · doi:10.1080/10584580590964574 · Cited by 759
Architectures for Vibration-Driven Micropower Generators
Mitcheson, P. D., Green, T. C., Yeatman, E. M., & Holmes, A. S. (2004) · Journal of Microelectromechanical Systems · doi:10.1109/jmems.2004.830151 · Cited by 753
Kinetic Energy Harvesting Using Piezoelectric and Electromagnetic Technologies—State of the Art
Khaligh, A., Zeng, P., & Zheng, C. (2010) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2009.2024652 · Cited by 669
On the Effectiveness of Vibration-based Energy Harvesting
Roundy, S. (2005) · Journal of Intelligent Material Systems and Structures · doi:10.1177/1045389x05054042 · Cited by 654
MEMS electrostatic micropower generator for low frequency operation
Mitcheson, P. D., Miao, P., Stark, B. H., Yeatman, E. M., Holmes, A. S., & Green, T. C. (2004) · Sensors and Actuators A: Physical · doi:10.1016/j.sna.2004.04.026 · Cited by 593
Review of Microscale Magnetic Power Generation
Arnold, D. P. (2007) · IEEE Transactions on Magnetics · doi:10.1109/tmag.2007.906150 · Cited by 549
A survey of energy harvesting sources for embedded systems
Chalasani, S., & Conrad, J. M. (2008) · IEEE SoutheastCon 2008 · doi:10.1109/secon.2008.4494336 · Cited by 482
A MEMS-based piezoelectric power generator array for vibration energy harvesting
Liu, J.-Q., Fang, H.-B., Xu, Z.-Y., Mao, X.-H., Shen, X.-C., Chen, D., Liao, H., & Cai, B.-C. (2008) · Microelectronics Journal · doi:10.1016/j.mejo.2007.12.017 · Cited by 481
Fang, H.-B., Liu, J.-Q., Xu, Z.-Y., Dong, L., Wang, L., Chen, D., Cai, B.-C., & Liu, Y. (2006) · Microelectronics Journal · doi:10.1016/j.mejo.2006.07.023 · Cited by 479
Design and fabrication of a new vibration-based electromechanical power generator
El-hami, M., Glynne-Jones, P., White, N. M., Hill, M., Beeby, S., James, E., Brown, A. D., & Ross, J. N. (2001) · Sensors and Actuators A: Physical · doi:10.1016/s0924-4247(01)00569-6 · Cited by 476
Power Approaches for Implantable Medical Devices
Amar, A., Kouki, A., & Cao, H. (2015) · Sensors · doi:10.3390/s151128889 · Cited by 432
Hu, Y., & Wang, Z. L. (2015) · Nano Energy · doi:10.1016/j.nanoen.2014.11.038 · Cited by 413
An electromagnetic micro power generator for wideband environmental vibrations
Sari, I., Balkan, T., & Kulah, H. (2008) · Sensors and Actuators A: Physical · doi:10.1016/j.sna.2007.11.021 · Cited by 405
Kulah, H., & Najafi, K. (2008) · IEEE Sensors Journal · doi:10.1109/jsen.2008.917125 · Cited by 361
Towards a piezoelectric vibration-poweredmicrogenerator
Glynne-Jones, P., Beeby, S. P., & White, N. M. (2001) · IEE Proceedings - Science, Measurement and Technology · doi:10.1049/ip-smt:20010323 · Cited by 354
Small-scale energy harvesting through thermoelectric, vibration, and radiofrequency power conversion
Hudak, N. S., & Amatucci, G. G. (2008) · Journal of Applied Physics · doi:10.1063/1.2918987 · Cited by 343
Design considerations for distributed microsensor systems
Chandrakasan, A., Amirtharajah, R., Cho, S., Goodman, J., Konduri, G., Kulik, J., Rabiner, W., & Wang, A. (2003) · Proceedings of the IEEE 1999 Custom Integrated Circuits Conference (Cat. No.99CH36327) · doi:10.1109/cicc.1999.777291 · Cited by 339
Self-citationEnergy harvesting for the implantable biomedical devices: issues and challenges
Hannan, M. A., Mutashar, S., Samad, S. A., & Hussain, A. (2014) · BioMedical Engineering OnLine · doi:10.1186/1475-925x-13-79 · Cited by 322
Micro-Electrostatic Vibration-to-Electricity Converters
Roundy, S., Wright, P. K., & Pister, K. S. J. (2002) · Microelectromechanical Systems · doi:10.1115/imece2002-39309 · Cited by 303
Gu, L., & Livermore, C. (2011) · Smart Materials and Structures · doi:10.1088/0964-1726/20/4/045004 · Cited by 299
Public Key Cryptography in Sensor Networks—Revisited
Gaubatz, G., Kaps, J.-P., & Sunar, B. (2005) · Lecture Notes in Computer Science · doi:10.1007/978-3-540-30496-8_2 · Cited by 289
Experimental Verification of Models for Microfabricated Piezoelectric Vibration Energy Harvesters
duToit, N. E., & Wardle, B. L. (2007) · AIAA Journal · doi:10.2514/1.25047 · Cited by 273
Energy scavenging sources for biomedical sensors
Romero, E., Warrington, R. O., & Neuman, M. R. (2009) · Physiological Measurement · doi:10.1088/0967-3334/30/9/r01 · Cited by 165
Survey of energy scavenging for wearable and implantable devices
Ghomian, T., & Mehraeen, S. (2019) · Energy · doi:10.1016/j.energy.2019.04.088 · Cited by 126
Zhu, D., & Beeby, S. (2011) · Energy Harvesting Systems · doi:10.1007/978-1-4419-7566-9_1 · Cited by 62
Metadata
- Authors
- Amirtharajah, R., & Chandrakasan, A. P.
- Venue
- IEEE Journal of Solid-State Circuits
- Published
- 1998-05
- Volume
- 33
- Issue
- 5
- Pages
- 687-695
- ISSN
- 0018-9200 (ISSN-L)
- OpenAlex
- W2161620971
- Cited by
- 621
- References
- 9
- FWCI
- 18.14
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.