Crossbar RRAM Arrays: Selector Device Requirements During Write Operation
The DOI matches its Crossref record; 35 of the 40 references it cites were found in a registry or an index.
Abstract
A comprehensive analysis of write operations (SET and RESET) in a resistance-change memory (resistive random access memory) crossbar array is carried out. Three types of resistive switching memory cells-nonlinear, rectifying-SET, and rectifying-RESET-are compared with each other in terms of voltage delivery, current delivery, and power consumption. Two different write schemes, V/2 and V/3, were considered, and the V/2 write scheme is preferred due to much lower power consumption. A simple numerical method was developed that simulates entire current flows and node voltages within a crossbar array and provides a quantitative tool for the accurate analysis of crossbar arrays and guidelines for developing reliable write operation.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Citations
Cites
Nanoionics-based resistive switching memories
Waser, R., & Aono, M. (2007) · Nature Materials · doi:10.1038/nmat2023 · Cited by 4,923
Memristive devices for computing
Yang, J. J., Strukov, D. B., & Stewart, D. R. (2013) · Nature Nanotechnology · doi:10.1038/nnano.2012.240 · Cited by 3,885
Lee, M.-J., Lee, C. B., Lee, D., Lee, S. R., Chang, M., Hur, J. H., Kim, Y.-B., Kim, C.-J., Seo, D. H., Seo, S., et al. (2011) · Nature Materials · doi:10.1038/nmat3070 · Cited by 2,228 · cited 14×
“1(b) and (c) apply to both serially connected 1S1R cell structures, as well as RRAM cells with intrinsic nonlinear or self-rectifying behaviors, since the simulations 0018-9383 © 2014 IEEE.”
BackgroundMethodInfluentialComplementary resistive switches for passive nanocrossbar memories
Linn, E., Rosezin, R., Kügeler, C., & Waser, R. (2010) · Nature Materials · doi:10.1038/nmat2748 · Cited by 1,274
Two Series Oxide Resistors Applicable to High Speed and High Density Nonvolatile Memory
Lee, M. ‐., Park, Y., Suh, D. ‐., Lee, E. ‐., Seo, S., Kim, D. ‐., Jung, R., Kang, B. ‐., Ahn, S. ‐., Lee, C. B., et al. (2007) · Advanced Materials · doi:10.1002/adma.200700251 · Cited by 435
Liang, J., & Wong, H.-S. P. (2010) · IEEE Transactions on Electron Devices · doi:10.1109/ted.2010.2062187 · Cited by 276
Writing to and reading from a nano-scale crossbar memory based on memristors
Vontobel, P. O., Robinett, W., Kuekes, P. J., Stewart, D. R., Straznicky, J., & Stanley Williams, R. (2009) · Nanotechnology · doi:10.1088/0957-4484/20/42/425204 · Cited by 262
Chen, A. (2013) · IEEE Transactions on Electron Devices · doi:10.1109/ted.2013.2246791 · Cited by 230 · cited 1×
“Although several quantitative analyses of crossbar array architecture for read operation have been recently conducted [11]–[13], the study of the write operation for the three types of 1S1R systems has not yet been reported.”
BackgroundComplementary resistive switching in tantalum oxide-based resistive memory devices
Yang, Y., Sheridan, P., & Lu, W. (2012) · Applied Physics Letters · doi:10.1063/1.4719198 · Cited by 224
Self-citationLee, M., Kim, S. I., Lee, C. B., Yin, H., Ahn, S., Kang, B. S., Kim, K. H., Park, J. C., Kim, C. J., Song, I., et al. (2009) · Advanced Functional Materials · doi:10.1002/adfm.200801032 · Cited by 217
Self-citation
Research works printed but not linked: 1
- lee, 2012, Varistor-type bidirectional switch (JMAX> \( \sim {10^7}\) A/cm \( \sim {10^2}\) , selectivity \( \sim {10^4}\) ) for 3D bipolar resistive memory arrays, Proc Symp VLSIT, 37
Cited by
Items 201–221 of 221
Resistive Switching Devices: Mechanism, Performance and Integration
Liu, M., Liu, Q., Lv, H., & Long, S. (2019) · Springer eBooks · doi:10.1007/978-3-319-76375-0_30 · Cited by 1
Bio-inspired Neuromorphic Computing Using Memristor Crossbar Networks
Jeong, Y. (2018) · Deep Blue (University of Michigan)
Xie, H., Zhu, G., Xu, X., et al. (2019) · International Workshop on the Electromagnetic Compatibility of Integrated Circuits (EMC Compo) · doi:10.1109/emccompo.2019.8919912
“The resistive random access memory (RRAM) is one of the most promising candidates for next generation high capacity data storage because of its low operating voltage, fast read/write speed, long retention time and cost-effective fabrication [4]-[7].”
BackgroundEnabling New Computing Paradigms with Emerging Symmetric-Access Memories
Wu, J., Gu, M., Zhong, H., Tao, Y., Qiao, F., Yang, H., & Li, X. (2019) · IEEE/ACM International Symposium on Nanoscale Architectures (NANOARCH) · doi:10.1109/nanoarch47378.2019.181291 · Cited by 1
“[38] presents a typical I-V characteristic of the nonlinear selector as shown in Fig.”
BackgroundMethodImproving Performance and Endurance for Crossbar Resistive Memory
Wen, W. (2020) · D-Scholarship@Pitt (University of Pittsburgh)
Coding for Resistive Random-Access Memory Channels
Song, G., Cai, K., Zhong, X., et al. (2020) · Globecom · doi:10.1109/globecom42002.2020.9322291
Transfer Modeling for 1T1R Crossbar Arrays with Line ResistancesPreprint
Zhang, X., & Zeng, Y. (2021) · Research Square · doi:10.21203/rs.3.rs-356720/v1
“If only the LRS and HRS of the eNVM devices are used to represent the 1bit memory/weight, the sensing margin in this work is calculated from the difference between the potential on the sensing resistor of Case 10 and Case 1 relative to the selected BL’s applied voltage [7,30], which is sens_SL_case10 sens_SL_case1”
MethodFilamentary physics and modelling in redox-based resistive devices
Loy, D. J. (2020) · DR-NTU (Nanyang Technological University) · doi:10.32657/10356/147065
Development of Compute-in-Memory Memristive Crossbar Architecture with Composite Memory Cells
Teimoory, M., Amirsoleimani, A., Ahmadi, A., & Ahmadi, M. A. (2021) · IntechOpen eBooks · doi:10.5772/intechopen.99634
“SRAM [37] Memory [38] Memory [16] 4M1M [15] 2M1M Density (Gbt/cm2) 0.338 1.6 — 50 80 Energy (fj/bit) 28.4 — 0.011 2.5 10 4 23.2 10 9 Table 7.”
BackgroundInfluentialTatulian, A., & DeMara, R. F. (2021) · IEEE Transactions on Computer-Aided Design of Integrated Circuits and Systems · doi:10.1109/tcad.2021.3119275
“…the robustness of the proposed architecture, a variety of line resistance values, r, corresponding to values commonly used in [22], [24], and [25], are tested to determine the necessary voltage parameters to maintain the measurement matrix characterizations listed in Table I. Parameters of…”
MethodStrategy of Mitigating Breakdown Interference and Yield Loss in Crossbar Memory
Chang, C., Wang, I., Huang, H., Hudec, B., Wu, M.-H., Chang, C.-C., Liu, P., & Hou, T. (2021) · IEEE Transactions on Electron Devices · doi:10.1109/ted.2021.3118989
The effect of external stimuli on the performance of memristive oxides
Li, Y., Christensen, D. V., Sanna, S., Esposito, V., & Pryds, N. (2022) · Elsevier eBooks · doi:10.1016/b978-0-12-814629-3.00011-8
Ang, J. M. (2023) · DR-NTU (Nanyang Technological University) · doi:10.32657/10356/174211
Co-Optimization of Selector–Memory Combinations in Cross-Point Array
Chae, S., Choi, M.-G., Ban, S., Kim, M., Ghosh, D., Chae, S., & Lee, S. H. (2025) · IEEE Transactions on Electron Devices · doi:10.1109/ted.2025.3625139
“Compared with the V / 3 scheme, which increases leakage with array size, the half-bias scheme keeps unselected cells at zero potential di ff erence, suppressing sneak currents and reducing power [21].”
Threshold Switching Behavior and Underlying Mechanisms in Pure SiO 2 -Based Selectors
Kim, H. R., Ha, T. J., Song, J. H., Park, S., Moon, J. S., Choi, M., Lee, J. H., Han, J. H., Choi, B. J., Jang, J. H., et al. (2026) · ACS Applied Materials & Interfaces · doi:10.1021/acsami.5c25598 · Cited by 1
Self-citationChung, P. H., Ryu, J., Seo, D., Min, K., & Yoon, T. (2026) · npj Unconventional Computing · doi:10.1038/s44335-026-00065-5
Cho, Y., Kim, D., Lee, J., Kim, D., Park, S., Bae, J., Jang, T., & Choi, S. (2026) · Advanced Science · doi:10.1002/advs.75594
Programmable Read‐Only Memory ( PROM )
Chen, D., Hsieh, E.-R., & Huang, Y. (2026) · doi:10.1002/9783527847419.ch8
Qiao, C., Xu, Q., Yuan, S. Y., et al. (2026) · physica status solidi (RRL) - Rapid Research Letters · doi:10.1002/pssr.70194
“V ) characteristic of OTS material enables it to control the switch of the PCM and suppress the leakage current in 3D PCM [12, 13].”
Seo, Y., Kim, D., Park, Y. B., et al. (2026) · Advanced Materials · doi:10.1002/adma.74743
Chen, Y., Kozicki, M. N., & Hou, T. (2026) · Nanotechnology · doi:10.1088/1361-6528/aea332
“This cumulative parasitic current adds noise to the actual signal, rapidly degrading the read margin (RM) and making reliable data retrieval impossible as the array size increases [11–13].”
Metadata
- Authors
- Kim, S., Zhou, J., & Lu, W. D.
- Affiliations
- University of Michigan (US)
- ORCID
- Venue
- IEEE Transactions on Electron Devices
- Published
- 2014-08
- Volume
- 61
- Issue
- 8
- Pages
- 2820-2826
- ISSN
- 0018-9383 (ISSN-L)
- 1557-9646
- OpenAlex
- W2031559328
- Cited by
- 219
- References
- 40
- Citations by year
- 2026: 8 · 2025: 8 · 2024: 8 · 2023: 13 · 2022: 12 · 2021: 31 · 2020: 26 · 2019: 31 · 2018: 16 · 2017: 25 · 2016: 18 · 2015: 21 · 2014: 2
- FWCI
- 11.68
- Type
- journal article
- Language
- en
- Open access
- closed
- Locations
- IEEE Transactions on Electron Devices (publishedVersion)
- Funders
- Air Force Office of Scientific Research, Arlington, VA, USA, through the Multidisciplinary University Research Initiative (FA9550-12-1-0038)
- National Science Foundation (ECCS-0954621)
- Basic Science Research Program through the Ministry of Education, Science and Technology, National Research Foundation of Korea (2013R1A6A3A03061299)
- Topics
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Advanced Memory and Neural Computing
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Ferroelectric and Negative Capacitance Devices
- Physical Sciences › Materials Science › Materials Chemistry › Phase-change materials and chalcogenides
- Keywords
- resistive random access memory, crossbar arrays, selector devices, write operation, power consumption
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.