The DOI matches its Crossref record; 28 of the 28 references it cites were found in a registry or an index.
Fault Tolerant Three-Phase AC Motor Drive Topologies: A Comparison of Features, Cost, and Limitations
Abstract
This paper compares the many fault tolerant three-phase ac motor drive topologies that have been proposed to provide output capacity for the inverter faults of switch short or open-circuits, phase-leg short-circuits, and single-phase open-circuits. Also included is a review of the respective control methods for fault tolerant inverters including two-phase and unipolar control methods. The output voltage and current space in terms of dq components is identified for each topology and fault. These quantities are then used to normalize the power capacity of each system during a fault to a standard inverter during normal operation. A silicon overrating cost factor is adopted as a metric to compare the relative switching device costs of the topologies compared to a standard three-phase inverter.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Power electronics converters, applications and design
Robinson, F. V. P. (1997) · Microelectronics Journal · doi:10.1016/s0026-2692(97)87859-7 · Cited by 5,075
Power Electronics: Converters, Applications and Design
Mohan, N., Undeland, T. M., & Robbins, W. P. (1989) · Cited by 4,771
Vector Control and Dynamics of AC Drives
Novotny, D. W., & Lipo, T. A. (1996) · doi:10.1093/oso/9780198564393.001.0001 · Cited by 1,841
Self-citationFault detection of open-switch damage in voltage-fed PWM motor drive systems
de Araujo Ribeiro, R. L., Jacobina, C. B., da Silva, E. R. C., & Lima, A. M. N. (2003) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2003.809351 · Cited by 441
Investigation of fault modes of voltage-fed inverter system for induction motor drive
Kastha, D., & Bose, B. K. (1994) · IEEE Transactions on Industry Applications · doi:10.1109/28.297920 · Cited by 386
Fault detection and isolation on a PWM inverter by knowledge-based model
Peuget, R., Courtine, S., & Rognon, J.-P. (1998) · IEEE Transactions on Industry Applications · doi:10.1109/28.739017 · Cited by 384
Experimental fault-tolerant control of a PMSM drive
Bolognani, S., Zordan, M., & Zigliotto, M. (2000) · IEEE Transactions on Industrial Electronics · doi:10.1109/41.873223 · Cited by 382
A strategy for improving reliability of field-oriented controlled induction motor drives
Liu, T.-H., Fu, J.-R., & Lipo, T. A. (1993) · IEEE Transactions on Industry Applications · doi:10.1109/28.245714 · Cited by 374
Self-citationDisturbance-free operation of a multiphase current-regulated motor drive with an opened phase
Fu, J.-R., & Lipo, T. A. (1994) · IEEE Transactions on Industry Applications · doi:10.1109/28.315238 · Cited by 372
Self-citationInvestigation of fault modes of voltage-fed inverter system for induction motor drive
Kastha, D., & Bose, B. K. (2003) · Conference Record of the 1992 IEEE Industry Applications Society Annual Meeting · doi:10.1109/ias.1992.244307 · Cited by 370
Jack, A. G., Mecrow, B. C., & Haylock, J. A. (1996) · IEEE Transactions on Industry Applications · doi:10.1109/28.511646 · Cited by 368
Improved Reliability in Solid-State AC Drives by Means of Multiple Independent Phase Drive Units
Jahns, T. M. (1980) · IEEE Transactions on Industry Applications · doi:10.1109/tia.1980.4503793 · Cited by 358
Self-citationVan Der Broeck, H. W., & Van Wyk, J. D. (1984) · IEEE Transactions on Industry Applications · doi:10.1109/tia.1984.4504413 · Cited by 322
Disturbance free operation of a multiphase current regulated motor drive with an opened phase
Fu, J.-R., & Lipo, T. A. (2002) · Conference Record of the 1993 IEEE Industry Applications Conference Twenty-Eighth IAS Annual Meeting · doi:10.1109/ias.1993.298884 · Cited by 318
Self-citationJack, A. G., Mecrow, B. C., & Haylock, J. (2002) · IAS '95. Conference Record of the 1995 IEEE Industry Applications Conference Thirtieth IAS Annual Meeting · doi:10.1109/ias.1995.530372 · Cited by 306
Fault detection and isolation on a PWM inverter by knowledge-based model
Peuget, R., Courtine, S., & Rognon, J. P. (2002) · IAS '97. Conference Record of the 1997 IEEE Industry Applications Conference Thirty-Second IAS Annual Meeting · doi:10.1109/ias.1997.629048 · Cited by 304
A discussion on IGBT short-circuit behavior and fault protection schemes
Chokhawala, R. S., Catt, J., & Kiraly, L. (1995) · IEEE Transactions on Industry Applications · doi:10.1109/28.370271 · Cited by 280
Performance characteristics of a cascaded two-level converter
Corzine, K. A., Sudhoff, S. D., & Whitcomb, C. A. (1999) · IEEE Transactions on Energy Conversion · doi:10.1109/60.790893 · Cited by 233
An induction motor drive system with improved fault tolerance
Beltrao de Rossiter Correa, M., Brandao Jacobina, C., Cabral da Silva, E. R., & Nogueira Lima, A. M. (2001) · IEEE Transactions on Industry Applications · doi:10.1109/28.924770 · Cited by 174
An induction motor drive system with improved fault tolerance
Correa, M. B. D. R., Jacobina, C. B., da Silva, E. R. C., & Lima, A. M. N. (2002) · IEEE Industry Applications Society Annual Meeting (IAS) · doi:10.1109/ias.2000.883112 · Cited by 146
Remedial strategies for brushless DC drive failures
Speed, R., & Wallace, A. K. (1990) · IEEE Transactions on Industry Applications · doi:10.1109/28.54251 · Cited by 131
A strategy to isolate the switching device fault of a current regulated motor drive
Fu, J.-R., & Lipo, T. A. (2002) · Conference record · doi:10.1109/ias.1993.299023 · Cited by 101
Self-citationFault tolerant motor drive system with redundancy for critical applications
Ertuğrul, N., Soong, W. L., Dostal, G., & Saxon, D. (2003) · IEEE Power Electronics Specialists Conference (PESC) · doi:10.1109/psec.2002.1022381 · Cited by 100
Analysis of PM synchronous motor drive failures during flux weakening operation
Bianchi, N., Bolognani, S., & Zigliotto, M. (2002) · IEEE Power Electronics Specialists Conference (PESC) · doi:10.1109/pesc.1996.548786 · Cited by 90
A strategy for improving reliability of motor drive systems using a four-leg three-phase converter
Ribeiro, R. L. A., Jacobina, C. B., Lima, A. M. N., et al. (2002) · doi:10.1109/apec.2001.911676 · Cited by 53
Fault tolerant operation of induction motor drives with automatic controller reconfiguration
Sepe, R. B., Fahimi, B., Morrison, C., & Miller, J. M. (2002) · IEEE International Electric Machines & Drives Conference (IEMDC) · doi:10.1109/iemdc.2001.939291 · Cited by 48
IGBT behavior during desat detection and short circuit fault protection
Bhalla, A., Shekhawat, S., Gladish, J., Yedinak, J., & Dolny, G. (2002) · IEEE International Symposium on Power Semiconductor Devices and ICs/Proceedings of the International Symposium on Power Semiconductor Devices & ICs/Proceedings of the ... International Symposium on Power Semiconductor Devices & ICs/Proceedings of the ... International Symposium on Power Semiconductor Devices and ICs · doi:10.1109/ispsd.1998.702679 · Cited by 37
Reluctance motor control for fault-tolerant capability
Qin, D., Luo, X., & Lipo, T. A. (2002) · IEEE International Electric Machines & Drives Conference (IEMDC) · doi:10.1109/iemdc.1997.604282 · Cited by 32
Self-citation
Research works printed but not linked: 5
- 10.1109/IAS.1993.298887 · doi:10.1109/ias.1993.298887
- 10.1109/IAS.2000.882152 · doi:10.1109/ias.2000.882152
- 10.1109/PESC.2001.954281 · doi:10.1109/pesc.2001.954281
- Stemmler, Configurations of high-power voltage source inverter drives, 7
- 10.1109/28.968186 · doi:10.1109/28.968186
Cited by
Overview of Electric Motor Technologies Used for More Electric Aircraft (MEA)
Cao, W., Mecrow, B. C., Atkinson, G. J., Bennett, J. W., & Atkinson, D. J. (2012) · IEEE Transactions on Industrial Electronics · doi:10.1109/tie.2011.2165453 · Cited by 1,026
Study and Handling Methods of Power IGBT Module Failures in Power Electronic Converter Systems
Choi, U.-M., Blaabjerg, F., & Lee, K.-B. (2015) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2014.2373390 · Cited by 700
Transitioning to Physics-of-Failure as a Reliability Driver in Power Electronics
Wang, H., Liserre, M., Blaabjerg, F., de Place Rimmen, P., Jacobsen, J. B., Kvisgaard, T., & Landkildehus, J. (2014) · IEEE Journal of Emerging and Selected Topics in Power Electronics · doi:10.1109/jestpe.2013.2290282 · Cited by 693
“Switch redundant topology for fault tolerant control [83].”
BackgroundSurvey on Fault-Tolerant Techniques for Power Electronic Converters
Zhang, W., Xu, D., Enjeti, P. N., Li, H., Hawke, J. T., & Krishnamoorthy, H. S. (2014) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2014.2304561 · Cited by 587
Design considerations for fractional-slot winding configurations of synchronous machines
Bianchi, N., Bolognani, S., Pre, M. D., & Grezzani, G. (2006) · IEEE Transactions on Industry Applications · doi:10.1109/tia.2006.876070 · Cited by 447
Metadata
- Authors
- Welchko, B. A., Lipo, T. A., Jahns, T. M., & Schulz, S. E.
- Venue
- IEEE Transactions on Power Electronics
- Published
- 2004-07
- Volume
- 19
- Issue
- 4
- Pages
- 1108-1116
- ISSN
- 0885-8993 (ISSN-L)
- OpenAlex
- W2131789431
- Cited by
- 724
- References
- 28
- FWCI
- 17.98
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.