The DOI matches its Crossref record; 24 of the 24 references it cites were found in a registry or an index.
Specific surface area and pore‐size distribution in clays and shales
Abstract
One of the biggest challenges in estimating the elastic, transport and storage properties of shales has been a lack of understanding of their complete pore structure. The shale matrix is predominantly composed of micropores (pores less than 2 nm diameter) and mesopores (pores with 2–50 nm diameter). These small pores in the shale matrix are mainly associated with clay minerals and organic matter and comprehending the controls of these clays and organic matter on the pore‐size distribution is critical to understand the shale pore network. Historically, mercury intrusion techniques are used for pore‐size analysis of conventional reservoirs. However, for unconventional shale reservoirs, very high pressures (> 414 MPa (60 000 psi)) would be required for mercury to access the full pore structure, which has potential pitfalls. Current instrumental limitations do not allow reliable measurement of significant portions of the total pore volume in shales. Nitrogen gas‐adsorption techniques can be used to characterize materials dominated by micro‐ and mesopores (2–50 nm). A limitation of this technique is that it fails to measure large pores (diameter >200 nm). We use a nitrogen gas‐adsorption technique to study the micro‐ and mesopores in shales and clays and compare the results from conventional mercury porosimetry techniques. Our results on pure clay minerals and natural shales show that (i) they have a multiscale pore structure at different dimensions (ii) fine mesopores, with a characteristic 3 nm pore size obtained with N 2 gas‐adsorption are associated with an illite‐smectite group of clays but not with kaolinite; (iii) compaction results in a decrease of pore volume and a reduction of pore size in the ‘inter‐aggregate’ macropores of the illite‐smectite clays while the fine ‘intra‐tachoid’ mesopores are shielded from compaction; (iv) for natural shales, mineralogy controls the pore‐size distributions for shales and the presence of micropores and fine mesopores in natural shales can be correlated with the dominance of the illite‐smectite type of clays in the rock. Our assessment of incompressible 3 nm sized pores associated with illite‐smectite clays provides an important building block for their mineral modulus.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Adsorption of Gases in Multimolecular Layers
Brunauer, S., Emmett, P. H., & Teller, E. (1938) · Journal of the American Chemical Society · doi:10.1021/ja01269a023 · Cited by 28,156
Sing, K. S. W. (1985) · Pure and Applied Chemistry · doi:10.1351/pac198557040603 · Cited by 24,485
Adsorption Surface Area and Porosity
Gregg, S. J., Sing, K. S. W., & Salzberg, H. W. (1967) · Journal of The Electrochemical Society · doi:10.1149/1.2426447 · Cited by 9,507
Ross, D. J. K., & Marc Bustin, R. (2009) · Marine and Petroleum Geology · doi:10.1016/j.marpetgeo.2008.06.004 · Cited by 2,217
Groen, J. C., Peffer, L. A. A., & Pérez-Ramı́rez, J. (2003) · Microporous and Mesoporous Materials · doi:10.1016/s1387-1811(03)00339-1 · Cited by 2,131
Is the bet equation applicable to microporous adsorbents?
(2007) · Studies in Surface Science and Catalysis · doi:10.1016/s0167-2991(07)80008-5 · Cited by 1,147
Anisotropic effective-medium modeling of the elastic properties of shales
Hornby, B. E., Schwartz, L. M., & Hudson, J. A. (1994) · Geophysics · doi:10.1190/1.1443546 · Cited by 604
Impact of Shale Properties on Pore Structure and Storage Characteristics
Bustin, R. M., Bustin, A. M. M., Cui, X., Ross, D. J. K., & Pathi, V. S. M. (2008) · SPE Shale Gas Production Conference · doi:10.2118/119892-ms · Cited by 514
Quantitative X-Ray Diffraction Analysis of Clay-Bearing Rocks From Random Preparations
Środoń, J., Drits, V. A., McCarty, D. K., Hsieh, J. C. C., & Eberl, D. D. (2001) · Clays and Clay Minerals · doi:10.1346/ccmn.2001.0490604 · Cited by 489
Chemistry and Physics of Carbon
(2021) · CRC Press eBooks · doi:10.1201/9781003210184 · Cited by 455
Cases, J. M., Berend, I., Besson, G., Francois, M., Uriot, J. P., Thomas, F., & Poirier, J. E. (1992) · Langmuir · doi:10.1021/la00047a025 · Cited by 430
Pore Size Distributions in Clays
Diamond, S. (1970) · Clays and Clay Minerals · doi:10.1346/ccmn.1970.0180103 · Cited by 339
Omotoso, O. E., McCarty, D. K., Hillier, S., & Kleeberg, R. (2006) · Clays and Clay Minerals · doi:10.1346/ccmn.2006.0540609 · Cited by 222
Penumadu, D., & Dean, J. (2000) · Canadian Geotechnical Journal · doi:10.1139/cgj-37-2-393 · Cited by 205
Mason, G. (1982) · Journal of Colloid and Interface Science · doi:10.1016/0021-9797(82)90153-9 · Cited by 174
Surface area and layer charge of smectite from CEC and EGME/H 2 O-retention measurements
Środoń, J., & McCarty, D. K. (2008) · Clays and Clay Minerals · doi:10.1346/ccmn.2008.0560203 · Cited by 166
Domains and Quasi‐Crystalline Regions in Clay Systems
Quirk, J. P., & Aylmore, L. A. G. (1971) · Soil Science Society of America Journal · doi:10.2136/sssaj1971.03615995003500040046x · Cited by 139
Effects of Exchanged Cation on the Microporosity of Montmorillonite
Rutherford, D. W., Chiou, C. T., & Eberl, D. D. (1997) · Clays and Clay Minerals · doi:10.1346/ccmn.1997.0450405 · Cited by 139
Diamond, S. (1971) · Cement and Concrete Research · doi:10.1016/0008-8846(71)90058-5 · Cited by 138
Porous structure and adsorption properties of active carbon
Polyakov, N. S., Dubinin, M. M., Kataeva, L. I., & Петухова, Г. А. (1993) · Pure and Applied Chemistry · doi:10.1351/pac199365102189 · Cited by 113
Kim, J.-W., Peacor, D. R., Tessier, D., & Elsass, F. (1995) · Clays and Clay Minerals · doi:10.1346/ccmn.1995.0430106 · Cited by 102
A comparison of nitrogen and mercury pore size distributions of silicas of varying pore volume
Brown, S. M., & Lard, E. W. (1974) · Powder Technology · doi:10.1016/0032-5910(74)80031-8 · Cited by 42
Lowell, S., Shields, J. E., Thomas, M. A., & Thommes, M. (2004) · Particle technology series · doi:10.1007/978-1-4020-2303-3_8 · Cited by 20
Connell-Madore, S., & Katsube, T. J. (2006) · doi:10.4095/222398 · Cited by 11
Cited by
Tian, H., Pan, L., Xiao, X., Wilkins, R. W. T., Meng, Z., & Huang, B. (2013) · Marine and Petroleum Geology · doi:10.1016/j.marpetgeo.2013.07.008 · Cited by 540
Labani, M. M., Rezaee, R., Saeedi, A., & Hinai, A. A. (2013) · Journal of Petroleum Science and Engineering · doi:10.1016/j.petrol.2013.11.022 · Cited by 463
Water distribution characteristic and effect on methane adsorption capacity in shale clay
Li, J., Li, X., Wang, X., Li, Y., Wu, K., Shi, J., Yang, L., Feng, D., Zhang, T., & Yu, P. (2016) · International Journal of Coal Geology · doi:10.1016/j.coal.2016.03.012 · Cited by 337
Zhou, X., Liu, D., Bu, H., Deng, L., Liu, H., Yuan, P., Du, P., & Song, H. (2018) · Solid Earth Sciences · doi:10.1016/j.sesci.2017.12.002 · Cited by 323
Nanoscale pore structure characterization of the Bakken shale in the USA
Liu, K., Ostadhassan, M., Zhou, J., Gentzis, T., & Rezaee, R. (2017) · Fuel · doi:10.1016/j.fuel.2017.08.034 · Cited by 305
Metadata
- Authors
- Kuila, U., & Prasad, M.
- Venue
- Geophysical Prospecting
- Publisher
- Wiley
- Published
- 2013-01-29
- Volume
- 61
- Issue
- 2
- Pages
- 341-362
- ISSN
- 0016-8025 (ISSN-L)
- 1365-2478
- OpenAlex
- W2104076412
- Cited by
- 1,126
- References
- 24
- FWCI
- 49.90
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.