Pyrolysis biochar systems, balance between bioenergy and carbon sequestration
Open accessThe DOI matches its Crossref record; 14 of the 14 references it cites were found in a registry or an index.
Abstract
This study aimed to investigate the extent to which it is possible to marry the two seemingly opposing concepts of heat and/or power production from biomass with carbon sequestration in the form of biochar. To do this, we investigated the effects of feedstock, highest heating temperature (HTT), residence time at HTT and carrier gas flow rate on the distribution of pyrolysis co‐products and their energy content, as well as the carbon sequestration potential of biochar. Biochar was produced from wood pellets (WP) and straw pellets (SP) at two temperatures (350 and 650 °C), with three residence times (10, 20 and 40 min) and three carrier gas flow rates (0, 0.33 and 0.66 l min−1). The energy balance of the system was determined experimentally by quantifying the energy contained within pyrolysis co‐products. Biochar was also analysed for physicochemical and soil functional properties, namely environmentally stable‐C and labile‐C content. Residence time showed no considerable effect on any of the measured properties. Increased HTT resulted in higher concentrations of fixed C, total C and stable‐C in biochar, as well as higher heating value (HHV) due to the increased release of volatile compounds. Increased carrier gas flow rate resulted in decreased biochar yields and reduced biochar stable‐C and labile‐C content. Pyrolysis at 650 °C showed an increased stable‐C yield as well as a decreased proportion of energy stored in the biochar fraction but increased stored energy in the liquid and gas co‐products. Carrier gas flow rate was also seen to be influential in determining the proportion of energy stored in the gas phase. Understanding the influence of production conditions on long term biochar stability in addition to the energy content of the co‐products obtained from pyrolysis is critical for the development of specifically engineered biochar, be it for agricultural use, carbon storage, energy generation or combinations of the three.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Pyrolysis of Wood/Biomass for Bio-oil: A Critical Review
Mohan, D., Pittman, C. U., & Steele, P. H. (2006) · Energy & Fuels · doi:10.1021/ef0502397 · Cited by 5,663 · cited 3×
“The increase in these species could be a result of aromatic condensation and secondary thermal cracking of heavy hydrocarbons occurring above 550 °C (Chen et al., 2003, 2012; Mohan et al., 2006; Yang et al., 2006; Duman et al., 2011; Fu et al., 2011).”
BackgroundReview of fast pyrolysis of biomass and product upgrading
Bridgwater, A. V. (2012) · Biomass and Bioenergy · doi:10.1016/j.biombioe.2011.01.048 · Cited by 4,856 · cited 2×
“(Bridgwater, 2012).”
BackgroundAn overview of the chemical composition of biomass
Vassilev, S. V., Baxter, D., Andersen, L. K., & Vassileva, C. G. (2010) · Fuel · doi:10.1016/j.fuel.2009.10.022 · Cited by 2,519 · cited 2×
“The distribution of the liquid and gas fraction was largely dependent (P < 0.0001) on feedstock composition, thus potentially resulting in the varying yields and properties between the two biomass types (Vassilev et al., 2010; Crombie et al., 2013).”
BackgroundInfluentialInterpretation of the correlation coefficient: A basic review
Taylor, R. (1990) · Journal of Diagnostic Medical Sonography · doi:10.1177/875647939000600106 · Cited by 2,390 · cited 1×
“…were performed using Spearman rank method and R values were categorized by considering correlation coefficients 0.35 to represent low or weak correlations, 0.36–0.67 to be moderate correlations, 0.68–0.90 strong or high correlations and >0.9 to be a very high correlation (Taylor, 1990).”
MethodInfluentialA review of biochar and its use and function in soil
Sohi, S. P., Krull, E., Lopez-Capel, E., & Bol, R. (2010) · Advances in Agronomy · doi:10.1016/s0065-2113(10)05002-9 · Cited by 2,240 · cited 2×
“349 (Sohi et al., 2010; Ronsse et al., 2013).”
BackgroundThe Art, Science, and Technology of Charcoal Production
Antal, M. J., & Grønli, M. (2003) · Industrial & Engineering Chemistry Research · doi:10.1021/ie0207919 · Cited by 1,623 · cited 1×
“…has long been associated with decreasing the severity of pyrolysis, resulting in a loss of energy as a result of reduced liquid and gas fractions (Antal & Grønli, 2003; Demirbas, 2004; Demiral & Ayan, 2011; Hossain et al., 2011; Angin, 2012; Chen et al., 2012; Many a, 2012; Crombie et al., 2013;…”
BackgroundReview of the stability of biochar in soils: predictability of O:C molar ratios
Spokas, K. A. (2010) · Carbon Management · doi:10.4155/cmt.10.32 · Cited by 1,160 · cited 2×
“There was a distinct separation between low and high temperature biochar with 650 °C char being classified as highly stable according to criteria proposed by Spokas (Spokas, 2010), IBI Guidelines (IBI Guidelines, 2012) and European biochar guidelines (Schmidt et al., 2012).”
MethodEffects of temperature and particle size on bio-char yield from pyrolysis of agricultural residues
Demirbas, A. (2004) · Journal of Analytical and Applied Pyrolysis · doi:10.1016/j.jaap.2004.07.003 · Cited by 1,154
Characterization of biochars to evaluate recalcitrance and agronomic performance
Enders, A., Hanley, K., Whitman, T., Joseph, S., & Lehmann, J. (2012) · Bioresource Technology · doi:10.1016/j.biortech.2012.03.022 · Cited by 1,113
Ronsse, F., van Hecke, S., Dickinson, D., & Prins, W. (2013) · GCB Bioenergy · doi:10.1111/gcbb.12018 · Cited by 1,000
Angın, D. (2013) · Bioresource Technology · doi:10.1016/j.biortech.2012.10.150 · Cited by 733
Quality variations of poultry litter biochar generated at different pyrolysis temperatures
Song, W., & Guo, M. (2012) · Journal of Analytical and Applied Pyrolysis · doi:10.1016/j.jaap.2011.11.018 · Cited by 693 · cited 1×
“As all of these are potentially valuable co-products, biomass pyrolysis is a polygeneration technology, which offers more than one product, and is thus a highly efficient process for biomass conversion (Demirbas, 2007; Chen et al., 2012; Song & Guo, 2012).”
BackgroundThe effect of pyrolysis conditions on biochar stability as determined by three methods
Crombie, K., Mašek, O., Sohi, S. P., Brownsort, P., & Cross, A. (2013) · GCB Bioenergy · doi:10.1111/gcbb.12030 · Cited by 533
Self-citationA method for screening the relative long‐term stability of biochar
Cross, A., & Sohi, S. P. (2013) · GCB Bioenergy · doi:10.1111/gcbb.12035 · Cited by 247 · cited 3×
“Proximate analysis of all biochar samples and corresponding feedstock was carried out using thermo gravimetric analysis (MettlerToledo TGA/DSC1, UKBRC, Edinburgh, UK).”
BackgroundMethod
Cited by
Al-Rumaihi, A., Shahbaz, M., Mckay, G., Mackey, H., & Al-Ansari, T. (2022) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2022.112715 · Cited by 650
Hassan, M., Liu, Y., Naidu, R., Parikh, S. J., Du, J., Qi, F., & Willett, I. R. (2020) · Science of The Total Environment · doi:10.1016/j.scitotenv.2020.140714 · Cited by 610
An overview of the effect of pyrolysis process parameters on biochar stability
Leng, L., & Huang, H. (2018) · Bioresource Technology · doi:10.1016/j.biortech.2018.09.030 · Cited by 503
Recent advances in engineered biochar productions and applications
Wang, B., Gao, B., & Fang, J. (2017) · Critical Reviews in Environmental Science and Technology · doi:10.1080/10643389.2017.1418580 · Cited by 501
Zhang, C., Zeng, G., Huang, D., Lai, C., Chen, M., Cheng, M., Tang, W., Tang, L., Dong, H., Huang, B., et al. (2019) · Chemical Engineering Journal · doi:10.1016/j.cej.2019.05.139 · Cited by 439
Metadata
- Authors
- Crombie, K., & Mašek, O.
- Venue
- GCB Bioenergy
- Publisher
- Wiley
- Published
- 2014-03-25
- Volume
- 7
- Issue
- 2
- Pages
- 349-361
- ISSN
- 1757-1693 (ISSN-L)
- 1757-1707
- OpenAlex
- W1974325851
- Cited by
- 149
- References
- 14
- FWCI
- 3.81
- Type
- journal article
- Language
- en
- Open access
- hybrid
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.