Elastic Anisotropy of Trabecular Bone in the Elderly Human Vertebra
Open accessThe DOI matches its Crossref record; 24 of the 24 references it cites were found in a registry or an index.
Abstract
Knowledge of the nature of the elastic symmetry of trabecular bone is fundamental to the study of bone adaptation and failure. Previous studies have classified human vertebral trabecular bone as orthotropic or transversely isotropic but have typically obtained samples from only selected regions of the centrum. In this study, the elastic symmetry of human vertebral trabecular bone was characterized using microfinite element (μFE) analyses performed on 1019 cubic regions of side length equal to 5 mm, obtained via thorough sampling of the centrums of 18 human L1 vertebrae (age = 81.17 ± 7.7 yr; eight males and ten females). An optimization procedure was used to find the closest orthotropic representation of the resulting stiffness tensor for each cube. The orthotropic elastic constants and orientation of the principal elastic axes were then recorded for each cube and were compared to the constants predicted from Cowin's fabric-based constitutive model (Cowin, 1985, “The Relationship Between the Elasticity Tensor and the Fabric Tensor,” Mech. Mater., 4(2), pp. 137–147.) and the orientation of the principal axes of the fabric tensor, respectively. Deviations from orthotropy were quantified by the “orthotropic error” (van Rietbergen et al., 1996, “Direct Mechanics Assessment of Elastic Symmetries and Properties of Trabecular Bone Architecture,” J. Biomech., 29(12), pp. 1653–1657), and deviations from transverse isotropy were determined by statistical comparison of the secondary and tertiary elastic moduli. The orthotropic error was greater than 50% for nearly half of the cubes, and the secondary and tertiary moduli differed from one another (p < 0.0001). Both the orthotropic error and the difference between secondary and tertiary moduli decreased with increasing bone volume fraction (BV/TV; p ≤ 0.007). Considering only the cubes with an orthotropic error less than 50%, only moderate correlations were observed between the fabric-based and the μFE-computed elastic moduli (R2 ≥ 0.337; p < 0.0001). These results indicate that when using a criterion of 5 mm for a representative volume element (RVE), transverse isotropy or orthotropy cannot be assumed for elderly human vertebral trabecular bone. Particularly at low values of BV/TV, this criterion does not ensure applicability of theories of continuous media. In light of the very sparse and inhomogeneous microstructure found in the specimens analyzed in this study, further work is needed to establish guidelines for selecting a RVE within the aged vertebral centrum.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
The cited source says what the claim attributes to it.
In the citing paper
“Note, however, that in regions of the vertebrae with low volume fraction, the trabecular network may be too sparse and spatially heterogeneous to allow proper definition of the type of anisotropy and the material properties (96).”
From Bone Mechanical Properties in Healthy and Diseased States (2018) · cites this paper as [96]
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Picture Thresholding Using an Iterative Selection Method
(1978) · IEEE Transactions on Systems, Man, and Cybernetics · doi:10.1109/tsmc.1978.4310039 · Cited by 2,262
A new method for the model‐independent assessment of thickness in three‐dimensional images
Hildebrand, T., & Rüegsegger, P. (1997) · Journal of Microscopy · doi:10.1046/j.1365-2818.1997.1340694.x · Cited by 1,818
Dependence of yield strain of human trabecular bone on anatomic site
Morgan, E. F., & Keaveny, T. M. (2001) · Journal of Biomechanics · doi:10.1016/s0021-9290(01)00011-2 · Cited by 705
Self-citationCharacterization of microstructural anisotropy in orthotropic materials using a second rank tensor
Harrigan, T. P., & Mann, R. W. (1984) · Journal of Materials Science · doi:10.1007/bf00540446 · Cited by 603
The quantitative morphology of anisotropic trabecular bone
Whitehouse, W. J. (1974) · Journal of Microscopy · doi:10.1111/j.1365-2818.1974.tb03878.x · Cited by 579 · cited 1×
“fabric tensor (mean intercept length [13,14] as calculated using the Scanco software for the 5 mm sphere circumscribed by the cube), were selected as the initial guess for the optimization procedure in order to avoid local optima in the optimization.”
MethodThe relationship between the elasticity tensor and the fabric tensor
Cowin, S. C. (1985) · Mechanics of Materials · doi:10.1016/0167-6636(85)90012-2 · Cited by 570
Crawford, R. P., Cann, C. E., & Keaveny, T. M. (2003) · Bone · doi:10.1016/s8756-3282(03)00210-2 · Cited by 547
Fabric and elastic principal directions of cancellous bone are closely related
Odgaard, A., Kabel, J., van Rietbergen, B., Dalstra, M., & Huiskes, R. (1997) · Journal of Biomechanics · doi:10.1016/s0021-9290(96)00177-7 · Cited by 338
Limitations of the continuum assumption in cancellous bone
Harrigan, T. P., Jasty, M., Mann, R. W., & Harris, W. H. (1988) · Journal of Biomechanics · doi:10.1016/0021-9290(88)90257-6 · Cited by 305
Direct mechanics assessment of elastic symmetries and properties of trabecular bone architecture
van Rietbergen, B., Odgaard, A., Kabel, J., & Huiskes, R. (1996) · Journal of Biomechanics · doi:10.1016/0021-9290(96)00093-0 · Cited by 263
Cited by
Bone Mechanical Properties in Healthy and Diseased States
Morgan, E. F., Unnikrisnan, G. U., & Hussein, A. I. (2018) · Annual Review of Biomedical Engineering · doi:10.1146/annurev-bioeng-062117-121139 · Cited by 1,026
“Note, however, that in regions of the vertebrae with low volume fraction, the trabecular network may be too sparse and spatially heterogeneous to allow proper definition of the type of anisotropy and the material properties (96).”
Self-citationSynthetic bone: Design by additive manufacturing
Barba, D., Alabort, E., & Reed, R. C. (2019) · Acta Biomaterialia · doi:10.1016/j.actbio.2019.07.049 · Cited by 316
Kang, J., Dong, E., Li, D., Dong, S., Zhang, C., & Wang, L. (2020) · Materials & Design · doi:10.1016/j.matdes.2020.108608 · Cited by 123
Palanca, M., Donno, G. D., & Dall’Ara, E. (2021) · PLoS ONE · doi:10.1371/journal.pone.0251873 · Cited by 26
On the human vertebra computational modeling: a literature review
Molinari, L., & Falcinelli, C. (2021) · Meccanica · doi:10.1007/s11012-021-01452-x · Cited by 19
Metadata
- Authors
- Unnikrishnan, G. U., Gallagher, J. A., Hussein, A. I., Barest, G. D., & Morgan, E. F.
- Affiliations
- Boston University (US)
- Corresponding author
- Morgan, Elise F.
- Venue
- Journal of Biomechanical Engineering
- Publisher
- ASME International
- Published
- 2015-10-01
- Volume
- 137
- Issue
- 11
- Pages
- 114503-114503
- ISSN
- 0148-0731 (ISSN-L)
- 1528-8951
- PMC
- PMC4844108
- OpenAlex
- W2156486697
- Cited by
- 13
- References
- 24
- Citations by year
- 2026: 2 · 2025: 2 · 2024: 1 · 2022: 1 · 2021: 4 · 2020: 1 · 2019: 1 · 2018: 1
- FWCI
- 0.34
- Type
- journal article
- Language
- en
- Open access
- green
- www.ncbi.nlm.nih.gov
- Locations
- Journal of Biomechanical Engineering (publishedVersion)
- PubMed Central (publishedVersion)
- PubMed (publishedVersion)
- Funders
- National Institutes of Health (AR054620)
- National Institute of Arthritis and Musculoskeletal and Skin Diseases (R56AR054620, R01AR054620, AR054620)
- Topics
- Health Sciences › Medicine › Orthopedics and Sports Medicine › Bone health and osteoporosis research
- Physical Sciences › Engineering › Biomedical Engineering › Elasticity and Material Modeling
- Physical Sciences › Engineering › Mechanics of Materials › Composite Material Mechanics
- Keywords
- trabecular bone, elastic anisotropy, vertebral bone, older adults, transverse isotropy, orthotropy, stiffness tensor, fabric tensor, representative volume element, bone volume fraction, elastic modulus, L1 vertebra, bone failure, bone adaptation, microarchitecture
- MeSH terms
- Aged, 80 and over, Female, Humans, Male, Spine, Anisotropy, Finite Element Analysis, X-Ray Microtomography, Elastic Modulus
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
How to cite
Cite CoChat for the checks on this page, and the paper for its own findings.
- This page
- CoChat. (2026). Citation check: Elastic Anisotropy of Trabecular Bone in the Elderly Human Vertebra. https://app.cochat.ai/papers/10.1115/1.4031415
- The paper
- Unnikrishnan, G. U., Gallagher, J. A., Hussein, A. I., Barest, G. D., & Morgan, E. F. (2015). Elastic Anisotropy of Trabecular Bone in the Elderly Human Vertebra. Journal of Biomechanical Engineering. https://doi.org/10.1115/1.4031415
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.