The DOI matches its Crossref record; 1 of the 1 references it cites were found in a registry or an index.
In Situ Detection of Lithium Plating on Graphite Electrodes by Electrochemical Calorimetry
Open accessAbstract
The measured heat flow of graphite/NMC lithium ion cells under charging conditions show a characteristic and easily identifiable signal at the onset of lithium plating on the graphite electrode. A marked decrease in heat flow signals the full lithiation of the graphite host. The origin of this signal is shown to arise from the combined effects of entropy and cell over potentials. This signal allows for an accurate measure of the maximum amount of lithium intercalation possible in the host. Metallic lithium deposition begins within 5–7 mAh/g after the heat flow begins to decrease. Two different types of graphite were examined; G25 and MCMB. The onset of lithium plating was detected at 336 mAh/g for the G25 graphite and 297 mAh/g for the MCMB graphite, yielding empirical formulas of Li 0.888 C 6 and Li 0.804 C 6 , respectively. The effect of plated lithium on the electrode/electrolyte reactivity was also examined by precise measurement of the coulombic efficiency, parasitic thermal energy and cell capacity fade. These measurements then allowed for the calculation of the efficiency of lithium plating on the graphite surface: 0.98 and 0.97 for G25 and MCMB graphites, respectively.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Studies on Charging Lithium-Ion Cells at Low Temperatures
Fan, J., & Tan, S. (2006) · Journal of The Electrochemical Society · doi:10.1149/1.2190029 · Cited by 211
Cited by
Challenges and opportunities towards fast-charging battery materials
Liu, Y., Zhu, Y., & Cui, Y. (2019) · Nature Energy · doi:10.1038/s41560-019-0405-3 · Cited by 1,781
Lithium-ion battery fast charging: A review
Tomaszewska, A., Chu, Z., Feng, X., O'Kane, S., Liu, X., Chen, J., Ji, C., Endler, E., Li, R., Liu, L., et al. (2019) · eTransportation · doi:10.1016/j.etran.2019.100011 · Cited by 1,592
Temperature dependent ageing mechanisms in Lithium-ion batteries – A Post-Mortem study
Waldmann, T., Wilka, M., Kasper, M., Fleischhammer, M., & Wohlfahrt-Mehrens, M. (2014) · Journal of Power Sources · doi:10.1016/j.jpowsour.2014.03.112 · Cited by 1,203
A Growing Appreciation for the Role of LiF in the Solid Electrolyte Interphase
Tan, J., Matz, J., Dong, P., Shen, J., & Ye, M. (2021) · Advanced Energy Materials · doi:10.1002/aenm.202100046 · Cited by 1,019
Li plating as unwanted side reaction in commercial Li-ion cells – A review
Waldmann, T., Hogg, B.-I., & Wohlfahrt-Mehrens, M. (2018) · Journal of Power Sources · doi:10.1016/j.jpowsour.2018.02.063 · Cited by 895
Niobium tungsten oxides for high-rate lithium-ion energy storage
Griffith, K. J., Wiaderek, K. M., Cibin, G., Marbella, L. E., & Grey, C. P. (2018) · Nature · doi:10.1038/s41586-018-0347-0 · Cited by 860
Enabling fast charging – A battery technology gap assessment
Ahmed, S., Bloom, I., Jansen, A. N., Tanim, T., Dufek, E. J., Pesaran, A., Burnham, A., Carlson, R. B., Dias, F., Hardy, K., et al. (2017) · Journal of Power Sources · doi:10.1016/j.jpowsour.2017.06.055 · Cited by 498
Lithium Plating Mechanism, Detection, and Mitigation in Lithium-Ion Batteries
Lin, X., Khosravinia, K., Hu, X., Li, J., & Lu, W. (2021) · Progress in Energy and Combustion Science · doi:10.1016/j.pecs.2021.100953 · Cited by 490
Understanding undesirable anode lithium plating issues in lithium-ion batteries
Liu, Q., Du, C., Shen, B., Zuo, P., Cheng, X., Ma, Y., Yin, G., & Gao, Y. (2016) · RSC Advances · doi:10.1039/c6ra19482f · Cited by 473
Zheng, J., Kim, M. S., Tu, Z., Choudhury, S., Tang, T., & Archer, L. A. (2020) · Chemical Society Reviews · doi:10.1039/c9cs00883g · Cited by 466
Du, H., Wang, Y., Kang, Y., Zhao, Y., Tian, Y., Wang, X., Tan, Y., Liang, Z., Wozny, J., Li, T., et al. (2024) · Advanced Materials · doi:10.1002/adma.202401482 · Cited by 376
In-Situ Detection of Lithium Plating Using High Precision Coulometry
Burns, J. C., Stevens, D. A., & Dahn, J. R. (2015) · Journal of The Electrochemical Society · doi:10.1149/2.0621506jes · Cited by 357
Self-citationElectrolyte Design for Fast-Charging Li-Ion Batteries
Logan, E. R., & Dahn, J. R. (2020) · Trends in Chemistry · doi:10.1016/j.trechm.2020.01.011 · Cited by 334
Self-citationChallenges and development of lithium-ion batteries for low temperature environments
Piao, N., Gao, X., Yang, H., Guo, Z., Hu, G., Cheng, H.-M., & Li, F. (2022) · eTransportation · doi:10.1016/j.etran.2021.100145 · Cited by 324
Schindler, S., Bauer, M., Petzl, M., & Danzer, M. A. (2016) · Journal of Power Sources · doi:10.1016/j.jpowsour.2015.11.044 · Cited by 299
Nanostructuring versus microstructuring in battery electrodes
Jain, R., Lakhnot, A. S., Bhimani, K., Sharma, S., Mahajani, V., Panchal, R. A., Kamble, M., Han, F., Wang, C., & Koratkar, N. (2022) · Nature Reviews Materials · doi:10.1038/s41578-022-00454-9 · Cited by 298
Heubner, C., Maletti, S., Auer, H., Hüttl, J., Voigt, K., Lohrberg, O., Nikolowski, K., Partsch, M., & Michaelis, A. (2021) · Advanced Functional Materials · doi:10.1002/adfm.202106608 · Cited by 277
Lithium-Ion Battery Degradation Indicators Via Incremental Capacity Analysis
Ansean, D., Garcia, V. M., Gonzalez, M., Blanco-Viejo, C., Viera, J. C., Pulido, Y. F., & Sanchez, L. (2019) · IEEE Transactions on Industry Applications · doi:10.1109/tia.2019.2891213 · Cited by 261
Ecker, M., Shafiei Sabet, P., & Sauer, D. U. (2017) · Applied Energy · doi:10.1016/j.apenergy.2017.08.034 · Cited by 181
Kunz, A., Kirst, C., Durdel, A., Singer, J. P., & Jossen, A. (2025) · Journal of Power Sources · doi:10.1016/j.jpowsour.2024.235732 · Cited by 6
Metadata
- Authors
- Downie, L. E., Krause, L. J., Burns, J. C., Jensen, L. D., Chevrier, V. L., & Dahn, J. R.
- Venue
- Journal of The Electrochemical Society
- Publisher
- The Electrochemical Society
- Published
- 2013
- Volume
- 160
- Issue
- 4
- Pages
- A588-A594
- ISSN
- 0013-4651 (ISSN-L)
- 1945-7111
- OpenAlex
- W2039118470
- Cited by
- 161
- References
- 1
- FWCI
- 6.74
- Type
- journal article
- Language
- en
- Open access
- bronze
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.