Hydrothermal liquefaction of wood: a critical review
The DOI matches its Crossref record; 21 of the 21 references it cites were found in a registry or an index.
Abstract
This article provides an overview of previous research contributions and the current status of technology on the hydrothermal liquefaction (HTL) of wood biomass into liquid fuels and valuable chemicals. This process involves the direct liquefaction of biomass, which operates from 200°C to 400°C, 5 to 25 MPa, and 10 to 60 min reaction time in hot-compressed water or solvent and with or without a catalyst in the presence of inert or reducing gas. The influence of process variables, including biomass composition, temperature, residence time, pressure, heating rate, particle size, catalysts, and so on, which are significant for the bio-oil yield and product quality, has been addressed in this review. This review focuses on the HTL fundamentals based on current knowledge and summarizes the state-of-the-art knowledge of the HTL of wood biomass.
Overview
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Wood: Chemistry, ultrastructure, reactions
(1983) · doi:10.1515/9783110839654 · Cited by 2,846
An overview of the chemical composition of biomass
Vassilev, S. V., Baxter, D., Andersen, L. K., & Vassileva, C. G. (2010) · Fuel · doi:10.1016/j.fuel.2009.10.022 · Cited by 2,519 · cited 1×
“According to their biological diversity, source, and origin, wood and woody biomass as solid fuel resources is classified as biomass coniferous or deciduous; angiospermous or gymnospermous; soft or hard; and stems, branches, foliage, bark, chips, lumps, pellets, briquettes, sawdust, sawmill, and others from various wo…”
BackgroundPeterson, A. A., Vogel, F., Lachance, R. P., Fröling, M., Antal, Jr., & Tester, J. W. (2008) · Energy & Environmental Science · doi:10.1039/b810100k · Cited by 2,132 · cited 1×
“It is significantly less resistant towards hydrothermal extraction and hydrolysis (Peterson et al. 2008).”
BackgroundHydrothermal liquefaction of biomass: A review of subcritical water technologies
Toor, S. S., Rosendahl, L., & Rudolf, A. (2011) · Energy · doi:10.1016/j.energy.2011.03.013 · Cited by 1,840
Roles of Water for Chemical Reactions in High-Temperature Water
Akiya, N., & Savage, P. E. (2002) · Chemical Reviews · doi:10.1021/cr000668w · Cited by 1,581 · cited 1×
“Subcritical/near-critical water has widely been used for biomass liquefaction in comparison to supercritical water mainly for gasification of aqueous biomass (Akiya and Savage 2002).”
BackgroundCatalytic conversion of lignocellulosic biomass to fine chemicals and fuels
Zhou, C.-H., Xia, X., Lin, C.-X., Tong, D.-S., & Beltramini, J. (2011) · Chemical Society Reviews · doi:10.1039/c1cs15124j · Cited by 1,420
Biller, P., & Ross, A. B. (2011) · Bioresource Technology · doi:10.1016/j.biortech.2010.06.028 · Cited by 1,131
Competitive liquid biofuels from biomass
Demirbas, A. (2011) · Applied Energy · doi:10.1016/j.apenergy.2010.07.016 · Cited by 796
A review of hydrothermal biomass processing
Tekin, K., Karagöz, S., & Bektaş, S. (2014) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2014.07.216 · Cited by 730
Vardon, D. R., Sharma, B. K., Scott, J., Yu, G., Wang, Z., Schideman, L., Zhang, Y., & Strathmann, T. J. (2011) · Bioresource Technology · doi:10.1016/j.biortech.2011.06.041 · Cited by 662
Kabyemela, B. M., Adschiri, T., Malaluan, R. M., & Arai, K. (1999) · Industrial & Engineering Chemistry Research · doi:10.1021/ie9806390 · Cited by 592
Hydrothermal conversion of lignin: A review
Kang, S., Li, X., Fan, J., & Chang, J. (2013) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2013.07.013 · Cited by 552
Towards Sustainable Production of Biofuels from Microalgae
Patil, V., Tran, K.-Q., & Giselrød, H. R. (2008) · International Journal of Molecular Sciences · doi:10.3390/ijms9071188 · Cited by 495 · cited 1×
“However, fossil fuels are formed by the exposure of biomass to high temperatures and pressures underground for many years, whereas liquid fuel in HTL is obtained within hours or even minutes (Patil et al. 2008).”
BackgroundBiochar : potential for countering land degradation and for improving agriculture
Barrow, C. J. (2012) · Applied Geography · doi:10.1016/j.apgeog.2011.09.008 · Cited by 441
Cellulose decomposition in hot-compressed water with alkali or nickel catalyst
Minowa, T., Zhen, F., & Ogi, T. (1998) · The Journal of Supercritical Fluids · doi:10.1016/s0896-8446(98)00059-x · Cited by 387
Effects of various solvents on the liquefaction of biomass to produce fuels and chemical feedstocks
Liu, Z., & Zhang, F.-S. (2008) · Energy Conversion and Management · doi:10.1016/j.enconman.2008.08.009 · Cited by 384
Hydrothermal Conversion of Biomass: I, Glucose Conversion in Hot Compressed Water
Knežević, D., van Swaaij, W. P. M., & Kersten, S. R. A. (2009) · Industrial & Engineering Chemistry Research · doi:10.1021/ie801387v · Cited by 180
Kinetic Analysis of Lignin Hydrothermal Conversion in Sub- and Supercritical Water
Yong, T. L.-K., & Matsumura, Y. (2013) · Industrial & Engineering Chemistry Research · doi:10.1021/ie400600x · Cited by 149
Reaction Kinetics of the Lignin Conversion in Supercritical Water
Yong, T. L.-K., & Matsumura, Y. (2012) · Industrial & Engineering Chemistry Research · doi:10.1021/ie300921d · Cited by 144 · cited 2×
“Yong and Matsumura (2012, 2013) well described the reaction path of lignin degradation in subcritical (300– 370°C) and supercritical (390–450°C) water with residence times of 0.5–10 s at a pressure of 25 MPa.”
BackgroundInfluentialDoassans-Carrère, N., Ferrasse, J.-H., Boutin, O., Mauviel, G., & Lédé, J. (2014) · Energy & Fuels · doi:10.1021/ef500641c · Cited by 49
Hydrothermolysis of Cellulose Under Static and Dynamic Conditions at High Temperatures
Schwald, W., & Bobleter, O. (1989) · Journal of Carbohydrate Chemistry · doi:10.1080/07328308908048017 · Cited by 40 · cited 1×
“1981, Schwald and Bobleter 1989), hydrothermal decomposition (Kabyemela et al.”
Background
Cited by
A review on hydrothermal liquefaction of biomass
Gollakota, A. R. K., Kishore, N., & Gu, S. (2018) · Renewable and Sustainable Energy Reviews · doi:10.1016/j.rser.2017.05.178 · Cited by 1,306
A review on biomass: importance, chemistry, classification, and conversion
Tursi, A. (2019) · Biofuel Research Journal · doi:10.18331/brj2019.6.2.3 · Cited by 896
Sub- and Supercritical Water Liquefaction of Kraft Lignin and Black Liquor Derived Lignin
Lappalainen, J., Baudouin, D., Hornung, U., Schuler, J., Melin, K., Bjelić, S., Vogel, F., Konttinen, J., & Joronen, T. (2020) · Energies · doi:10.3390/en13133309 · Cited by 87
“Those HTL review articles that do exist either focus on the HTL of biomasses from different sources [21,22], the HTL of pure lignin compounds [23], or the HTL of a specific biomass, such as wood [24], algae [25–27], agricultural and forestry waste [28], and even swine manure [29].”
Background
Metadata
- Authors
- Jindal, M. K., & Jha, M. K.
- Venue
- Reviews in Chemical Engineering
- Publisher
- Walter de Gruyter GmbH
- Published
- 2016-01-01
- Volume
- 32
- Issue
- 4
- ISSN
- 0167-8299 (ISSN-L)
- 2191-0235
- OpenAlex
- W2477846568
- Cited by
- 80
- References
- 21
- FWCI
- 1.52
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.