Student or educator? Sign up with your school email and get 6 months of Pro free.
CoChat

The DOI matches its Crossref record; 42 of the 42 references it cites were found in a registry or an index.

High‐Speed and Low‐Energy Nitride Memristors

Open access

Abstract

High‐performance memristors based on AlN films have been demonstrated, which exhibit ultrafast ON/OFF switching times (≈85 ps for microdevices with waveguide) and relatively low switching current (≈15 μA for 50 nm devices). Physical characterizations are carried out to understand the device switching mechanism, and rationalize speed and energy performance. The formation of an Al‐rich conduction channel through the AlN layer is revealed. The motion of positively charged nitrogen vacancies is likely responsible for the observed switching.

Overview

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.1002/adfm.201600680

Cites

42 of 42 references verified0 citation errors · 0 not checkable

Statistics

Figures

Image 1
CC-BY-NC-ND · From the PDF
Figure 1 Nanoscale memristors with low switching current. a) Scanning electron microscopy image of a 1 × 17 memristor array with a material stack of TiN (15 nm)/AlN (6 nm)/Pt (15 nm). The inset shows the atomic force microscopy image of the 50 nm × 50 nm memristors. b) Typical quasi-DC switching I -V loops of a nanodevice, showing both the electroforming and subsequent switching loops. The inset presents the same data in a semilog scale plot.
Figure 1 Nanoscale memristors with low switching current. a) Scanning electron microscopy image of a 1 × 17 memristor array with a material stack of TiN (15 nm)/AlN (6 nm)/Pt (15 nm). The inset shows the atomic force microscopy image of the 50 nm × 50 nm memristors. b) Typical quasi-DC switching I -V loops of a nanodevice, showing both the electroforming and subsequent switching loops. The inset presents the same data in a semilog scale plot.CC-BY-NC-ND · From the PDF
Figure 2 Ultrafast switching of the AlN memristor. a) OFF switching using an 85 ps voltage pulse and b) ON switching using an 85 ps voltage pulse. The insets to (a) and (b) give the zoom-in image of the switching pulses. Before and after the switching pulse, a read pulse was applied to verify the device resistance state. In both ON and OFF switching, three attempts with an increasing voltage magnitude were used. The devices were successfully switched when the voltage reached the threshold voltage, i.e., -1.9 V for OFF switching (red curve in (a)) and + 2.1 V for ON switching (purple curve in (b)). c) The optical microscopy image of the measurement setup. The inset shows the scanning electron microscopy image of the device used for the high speed measurements.
Figure 2 Ultrafast switching of the AlN memristor. a) OFF switching using an 85 ps voltage pulse and b) ON switching using an 85 ps voltage pulse. The insets to (a) and (b) give the zoom-in image of the switching pulses. Before and after the switching pulse, a read pulse was applied to verify the device resistance state. In both ON and OFF switching, three attempts with an increasing voltage magnitude were used. The devices were successfully switched when the voltage reached the threshold voltage, i.e., -1.9 V for OFF switching (red curve in (a)) and + 2.1 V for ON switching (purple curve in (b)). c) The optical microscopy image of the measurement setup. The inset shows the scanning electron microscopy image of the device used for the high speed measurements.CC-BY-NC-ND · From the PDF
Figure 3 Comparison of two memristors with different material stacks and similar switching characteristics, including switching polarity and voltages. The insets present the same data in a semi-log plot.
Figure 3 Comparison of two memristors with different material stacks and similar switching characteristics, including switching polarity and voltages. The insets present the same data in a semi-log plot.CC-BY-NC-ND · From the PDF
Image 5
CC-BY-NC-ND · From the PDF
Image 6
CC-BY-NC-ND · From the PDF

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Claims other papers make about this one

Each is checked against this paper’s own text: does it say what the citing paper says it does?

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Show all 42 references

Research works printed but not linked: 8

  1. Borkar S., 2010, Proc. Symp. VLSI‐DAT, 2
  2. Van Den Hove L., 2012, IEDM Tech. Dig., 12
  3. Naruke Y., 2013, Int. Solid‐State Circuits Conf. (ISSCC), 210
  4. Chen Y. Y., 2012, IEDM Tech. Dig., 10
  5. Govoreanu B., 2011, IEDM Tech. Dig., 729
  6. De B., 1970, Nat. Stand. Ref. Data Ser., 1
  7. Dean J. A., 1999, Handbook of Chemistry
  8. Shewmon P., 1963, Diffusion in Solids

Cited by

See all 356

Metadata

Authors
Choi, B. J., Torrezan, A. C., Strachan, J. P., Kotula, P. G., Lohn, A. J., Marinella, M. J., Li, Z., Williams, R. S., & Yang, J. J.
Affiliations
  • Seoul National University of Science and Technology (KR)
  • Hewlett-Packard (United States) (US)
  • Sandia National Laboratories (US)
Corresponding author
  • Williams, R. Stanley
  • Yang, J. Joshua
Venue
Advanced Functional Materials
Publisher
Wiley
Published
2016-05-24
Volume
26
Issue
29
Pages
5290-5296
ISSN
  • 1616-301X (ISSN-L)
  • 1616-3028
OpenAlex
W2397312330
Cited by
356
References
42
Citations by year
2026: 19 · 2025: 35 · 2024: 35 · 2023: 45 · 2022: 54 · 2021: 46 · 2020: 47 · 2019: 29 · 2018: 22 · 2017: 22 · 2016: 2
FWCI
11.53
Type
journal article
Language
en
Open access
Locations
  • Advanced Functional Materials (publishedVersion, cc-by-nc-nd)
  • OSTI OAI (U.S. Department of Energy Office of Scientific and Technical Information) (submittedVersion, other-oa)
Funders
Ministry of Education (2014R1A1A2054597)
Topics
  • Physical Sciences › Engineering › Electrical and Electronic Engineering › Advanced Memory and Neural Computing
  • Physical Sciences › Engineering › Electrical and Electronic Engineering › Ferroelectric and Negative Capacitance Devices
  • Physical Sciences › Engineering › Electrical and Electronic Engineering › Semiconductor materials and devices
Keywords
memristors, aluminum nitride, aluminum nitride thin films, ultrafast switching, energy efficiency, waveguide devices, nitrogen vacancies, switching mechanism, resistive switching

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.