The DOI matches its Crossref record; 32 of the 32 references it cites were found in a registry or an index.
Enhancing surface free energy and hydrophilicity through chemical modification of microstructured titanium implant surfaces
Abstract
Roughness‐induced hydrophobicity, well‐known from natural plant surfaces and intensively studied toward superhydrophobic surfaces, has currently been identified on microstructured titanium implant surfaces. Studies indicate that microstructuring by sandblasting and acid etching (SLA) enhances the osteogenic properties of titanium. The undesired initial hydrophobicity, however, presumably decelerates primary interactions with the aqueous biosystem. To improve the initial wettability and to retain SLA microstructure, a novel surface modification was tested. This modification differs from SLA by its preparation after acid etching, which was done under protective gas conditions following liquid instead of dry storage. We hypothesized that this modification should have increased wettability due to the prevention of contaminations that occurs during air contact. The main outcome of dynamic wettability measurements was that the novel modification shows increased surface free energy (SFE) and increased hydrophilicity with initial water contact angles of 0° compared to 139.9° for SLA. This hydrophilization was kept even after any drying. Reduced hydrocarbon contaminations were identified to play a possible role in altered surface thermodynamics. Such surfaces aim to retain the hydrophilicity and natural high surface energy of the Ti dioxide surface until surgical implants' insertion and are compared in this in vitro study with structural surface variants of titanium to compare roughness and chemically induced wettability. © 2005 Wiley Periodicals, Inc. J Biomed Mater Res, 2006
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
Wettability of porous surfaces
Cassie, A. B. D., & Baxter, S. (1944) · Transactions of the Faraday Society · doi:10.1039/tf9444000546 · Cited by 13,807
RESISTANCE OF SOLID SURFACES TO WETTING BY WATER
Wenzel, R. N. (1936) · Industrial & Engineering Chemistry · doi:10.1021/ie50320a024 · Cited by 13,316
Estimation of the surface free energy of polymers
Owens, D. K., & Wendt, R. C. (1969) · Journal of Applied Polymer Science · doi:10.1002/app.1969.070130815 · Cited by 9,476
Purity of the sacred lotus, or escape from contamination in biological surfaces
Barthlott, W., & Neinhuis, C. (1997) · Planta · doi:10.1007/s004250050096 · Cited by 6,860
Biomaterial-Centered Infection: Microbial Adhesion Versus Tissue Integration
Gristina, A. G. (1987) · Science · doi:10.1126/science.3629258 · Cited by 2,156
Relation of the Equilibrium Contact Angle to Liquid and Solid Constitution
ZISMAN, W. A. (1964) · Advances in Chemistry · doi:10.1021/ba-1964-0043.ch001 · Cited by 1,927
Bollenl, C. M. L., Lambrechts, P., & Quirynen, M. (1997) · Dental Materials · doi:10.1016/s0109-5641(97)80038-3 · Cited by 1,911
Principles and applications of aquatic chemistry
(1993) · Choice Reviews Online · doi:10.5860/choice.31-0941 · Cited by 1,725
Transformation of a Simple Plastic into a Superhydrophobic Surface
Erbil, H. Y., Demirel, A. L., Avcı, Y., & Mert, O. (2003) · Science · doi:10.1126/science.1078365 · Cited by 1,724
Buser, D., Schenk, R. K., Steinemann, S., Fiorellini, J. P., Fox, C. H., & Stich, H. (1991) · Journal of Biomedical Materials Research · doi:10.1002/jbm.820250708 · Cited by 1,719
Chemistry of the solid-water interface
Stumm, W. (1992) · Cited by 1,644
Dispersion-Polar Surface Tension Properties of Organic Solids
Kaelble, D. H. (1970) · The Journal of Adhesion · doi:10.1080/0021846708544582 · Cited by 1,499
Chemistry of the solid-water interface
Sposito, G. (1993) · Marine Chemistry · doi:10.1016/0304-4203(93)90021-f · Cited by 1,453
Wetting on Hydrophobic Rough Surfaces: To Be Heterogeneous or Not To Be?
Marmur, A. (2003) · Langmuir · doi:10.1021/la0344682 · Cited by 1,447
Enhanced Bone Apposition to a Chemically Modified SLA Titanium Surface
Buser, D., Broggini, N., Wieland, M., Schenk, R. K., Denzer, A. J., Cochran, D. L., Hoffmann, B., Lussi, A., & Steinemann, S. G. (2004) · Journal of Dental Research · doi:10.1177/154405910408300704 · Cited by 1,202
Self-citationMartin, J. Y., Schwartz, Z., Hummert, T. W., Schraub, D. M., Simpson, J., Lankford, J., Dean, D. D., Cochran, D. L., & Boyan, B. D. (1995) · Journal of Biomedical Materials Research · doi:10.1002/jbm.820290314 · Cited by 1,111
High surface energy enhances cell response to titanium substrate microstructure
Zhao, G., Schwartz, Z., Wieland, M., Rupp, F., Geis‐Gerstorfer, J., Cochran, D. L., & Boyan, B. D. (2005) · Journal of Biomedical Materials Research Part A · doi:10.1002/jbm.a.30320 · Cited by 922
Self-citationHerminghaus, S. (2000) · Europhysics Letters (EPL) · doi:10.1209/epl/i2000-00418-8 · Cited by 848
An equation-of-state approach to determine surface tensions of low-energy solids from contact angles
Neumann, A. W., Good, R. J., Hope, C. J., & Sejpal, M. (1974) · Journal of Colloid and Interface Science · doi:10.1016/0021-9797(74)90365-8 · Cited by 707
Cochran, D. L., Buser, D., Ten Bruggenkate, C. M., Weingart, D., Taylor, T. M., Bernard, J., Peters, F., & Simpson, J. P. (2002) · Clinical Oral Implants Research · doi:10.1034/j.1600-0501.2002.130204.x · Cited by 568
Kieswetter, K., Schwartz, Z., Hummert, T. W., Cochran, D. L., Simpson, J., Dean, D. D., & Boyan, B. D. (1996) · Journal of Biomedical Materials Research · doi:10.1002/(sici)1097-4636(199609)32:1<55::aid-jbm7>3.0.co;2-o · Cited by 565
Suggested guidelines for the topographic evaluation of implant surfaces.
Wennerberg, A., & Albrektsson, T. O. (2000) · PubMed · Cited by 462
Underlying mechanisms at the bone–biomaterial interface.
Schwartz, Z., & Boyan, B. D. (1994) · Journal of Cellular Biochemistry · doi:10.1002/jcb.240560310 · Cited by 397
Wagner, P., Fürstner, R., Barthlott, W., & Neinhuis, C. (2003) · Journal of Experimental Botany · doi:10.1093/jxb/erg127 · Cited by 357
Roughness induced dynamic changes of wettability of acid etched titanium implant modifications
Rupp, F., Scheideler, L., Rehbein, D., Axmann, D., & Geis-Gerstorfer, J. (2004) · Biomaterials · doi:10.1016/j.biomaterials.2003.08.015 · Cited by 355
Self-citationA reformulation of the equation of state for interfacial tensions
Li, D., & Neumann, A. W. (1990) · Journal of Colloid and Interface Science · doi:10.1016/0021-9797(90)90067-x · Cited by 340
The Role of Implant Surface Characteristics in the Healing of Bone
Kieswetter, K., Schwartz, Z., Dean, D. D., & Boyan, B. D. (1996) · Critical Reviews in Oral Biology & Medicine · doi:10.1177/10454411960070040301 · Cited by 338
A role for surface topography in creating and maintaining bone at titanium endosseous implants
Cooper, L. F. (2000) · The Journal of Prosthetic Dentistry · doi:10.1067/mpr.2000.111966 · Cited by 336
Sharma, P. K., & Hanumantha Rao, K. (2002) · Advances in Colloid and Interface Science · doi:10.1016/s0001-8686(02)00004-0 · Cited by 335
Biomaterial adherent macrophage apoptosis is increased by hydrophilic and anionic substrates in vivo
Brodbeck, W. G., Patel, J., Voskerician, G., Christenson, E., Shive, M. S., Nakayama, Y., Matsuda, T., Ziats, N. P., & Anderson, J. M. (2002) · Proceedings of the National Academy of Sciences · doi:10.1073/pnas.162124199 · Cited by 245
Massaro, C., Rotolo, P., De Riccardis, F., Milella, E., Napoli, A., Wieland, M., Textor, M., Spencer, N. D., & Brunette, D. M. (2002) · Journal of Materials Science: Materials in Medicine · doi:10.1023/a:1015170625506 · Cited by 216
Self-citationRupp, F., Axmann, D., Ziegler, C., & Geis‐Gerstorfer, J. (2002) · Journal of Biomedical Materials Research · doi:10.1002/jbm.10198 · Cited by 53
Self-citation
Cited by
Review of the anatase to rutile phase transformation
Hanaor, D. A. H., & Sorrell, C. C. (2011) · Journal of Materials Science · doi:10.1007/s10853-010-5113-0 · Cited by 3,394
A review on the wettability of dental implant surfaces II: Biological and clinical aspects
Gittens, R. A., Scheideler, L., Rupp, F., Hyzy, S. L., Geis-Gerstorfer, J., Schwartz, Z., & Boyan, B. D. (2014) · Acta Biomaterialia · doi:10.1016/j.actbio.2014.03.032 · Cited by 849
Self-citationGittens, R. A., McLachlan, T., Olivares-Navarrete, R., Cai, Y., Berner, S., Tannenbaum, R., Schwartz, Z., Sandhage, K. H., & Boyan, B. D. (2011) · Biomaterials · doi:10.1016/j.biomaterials.2011.01.029 · Cited by 827
Biomaterial strategies for engineering implants for enhanced osseointegration and bone repair
Agarwal, R., & García, A. J. (2015) · Advanced Drug Delivery Reviews · doi:10.1016/j.addr.2015.03.013 · Cited by 789
Engineering biocompatible implant surfaces
Bauer, S., Schmuki, P., von der Mark, K., & Park, J. (2013) · Progress in Materials Science · doi:10.1016/j.pmatsci.2012.09.001 · Cited by 780
Metadata
- Authors
- Rupp, F., Scheideler, L., Olshanska, N., de Wild, M., Wieland, M., & Geis‐Gerstorfer, J.
- Venue
- Journal of Biomedical Materials Research Part A
- Publisher
- Wiley
- Published
- 2005-11-03
- Volume
- 76A
- Issue
- 2
- Pages
- 323-334
- ISSN
- 1549-3296 (ISSN-L)
- 1552-4965
- OpenAlex
- W2167071495
- Cited by
- 651
- References
- 32
- FWCI
- 14.86
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.