CoChat

Occurrence, Concentration, and Distribution of 35 PFASs and Their Precursors Retained in 20 Stormwater Biofilters

Open access

The DOI matches its Crossref record; 90 of the 90 references it cites were found in a registry or an index; 14 of the 45 sources its claims cite were checked for support.

Abstract

High Resolution Image Download MS PowerPoint Slide Current knowledge about the fate and transport behaviors of per- and polyfluoroalkyl substances (PFASs) in urban stormwater biofilter facilities is very limited. C5–14,16 perfluoroalkyl carboxylic acids [perfluorinated carboxylic acids (PFCAs)], C4,8,10 perfluoroalkanesulfonic acids (PFSAs), methyl-perfluorooctane sulfonamide acetic acid (MeFOSAA, a PFSA precursor), and unknown C6–8 PFCA and perfluorooctanesulfonic acid precursors were frequently found in bioretention media and forebay sediments at Σ 35 PFAS concentrations of <0.03–19 and 0.064–16 μg/kg-DW, respectively. Unknown C6–8 PFCA precursor concentrations were up to ten times higher than the corresponding PFCAs, especially at forebays and biofilters’ top layer. No significant trend could be attributed to PFAS and precursor concentrations versus depth of filter media, though PFAS concentrations were 2–3 times higher in the upper layers on average (significant difference between the upper (0–5 cm) and deepest (35–50 cm) layer). PFASs had a similar spatial concentration distribution in each filter media (no clear difference between short- and long-chain PFASs). Commercial land use and organic matter were important factors explaining the concentration variations among the biofilters and between the sampling depths, respectively. Given the comparable PFAS accumulations in deeper and superficial layers and possible increased mobility after precursor biotransformation, designing shallow-depth, nonamended sand biofilters or maintaining only the top layer may be insufficient for stormwater PFAS management.

Overview

CoChat Summary

TL;DR

This field study reports the first survey of 35 PFASs and their precursors retained in 20 mature stormwater biofilters, finding frequent PFOS/PFOA and substantial unknown C6–8 PFCA precursors. PFASs accumulated in upper layers but also penetrated deeper media, suggesting that top-layer-only maintenance or shallow sand biofilters may be insufficient for stormwater PFAS management.

Key findings

  • Σ35PFAS concentrations ranged from <0.03 to 19 μg/kg-DW (median 1.6) in filter media and 0.064 to 16 μg/kg-DW (median 0.665) in forebay sediments; PFOS and PFOA were the most frequent compounds, detected in 97% and 78% of filter materials and 93% and 43% of forebays, respectively.
  • Unknown C6–8 PFCA precursor concentrations were up to ten times higher than corresponding PFCAs; TOP assay Σ30PFASTOP ranged from 0.1 to 21.9 μg/kg-DW, with mean C6–8 PFCA increases of 1616% in forebays and 654% in biofilter media.
  • Σ35PFAS in the top layer (D1, 0–5 cm; median 2.1 μg/kg-DW) was about 2.0 ± 1.5 and 3.0 ± 2.7 times higher than in D2 and D3, respectively, with a significant D1 vs D3 difference (pairwise Wilcoxon p < 0.05), but no significant trend versus distance from inlet for most PFASs.
  • RDA showed 11 of 18 environmental parameters explained 45.1% of PFAS concentration variance (R² = 0.45, p = 0.001); commercial land use and organic matter were important positive factors, while depth had a negative association.

Methods

  • Sampled 20 mature vegetated urban stormwater biofilter facilities aged 8–16 years in Ohio, Michigan, and Kentucky, USA, in November 2019; 128 samples were collected from forebay sediments and filter material at two distances from the inlet (L1 < 1 m, L2 ≈ 3 m) and three depths (D1 0–5 cm, D2 10–15 cm, D3 35–50 cm).
  • Targeted analysis quantified 35 PFASs by UPLC-MS/MS, and the total oxidizable precursor (TOP) assay measured 30 PFASs; limits of quantification were 0.03–1 μg/kg-DW for targeted PFASs and 0.1–2 μg/kg-DW for TOP, with measurement uncertainties of ±23% and ±36%, respectively.
  • Statistical analysis used NADA-R for left-censored data, Kendall’s tau correlation, Wilcoxon tests, and multivariate redundancy analysis (RDA) with environmental variables including depth, land use, organic matter, soil composition, and hydraulic parameters.

Limitations

  • The paper states that the limited number of sites relative to many explanatory factors limits identification of relevant drivers, and that limited age variation (8–16 years; mean ± SD 10.8 ± 2.2) prevented clear assessment of biofilter age effects.
  • The paper notes that the TOP assay’s higher LoQ may underestimate unknown precursors, that bioavailability and biodegradation rates of precursors remain unclear, and that limited SSA measurements may have influenced correlations.
  • Evident from the text: this is a cross-sectional field survey without direct measurement of precursor biotransformation rates or long-term temporal trends, so causal links between environmental factors and PFAS accumulation cannot be established.

Model-written summary. Check it against the paper before relying on it.

Integrity signals

Registry

Crossref · 10.1021/acs.est.4c05170

Cites

90 of 90 references verified0 citation errors · 0 not checkable

Statistics

Nothing to recompute.

Figures

Figure 1 Cross-section of a biofilter facility showing the seven sampling locations: one from forebay (FB) and six from filter material at two distances (L1 and L2) from the inlet and at three depths (D1, D2, and D3).
Figure 1 Cross-section of a biofilter facility showing the seven sampling locations: one from forebay (FB) and six from filter material at two distances (L1 and L2) from the inlet and at three depths (D1, D2, and D3).CC BY · PubMed Central
Figure 2 Concentration distribution of selected PFASs at forebays (FB) and biofilter materials at different depths (D1–D3) and distances from the inlet (L1 and L2). Cross and circle symbols represent censored and quantified data, respectively. Dashed lines represent the LoQ of substances, and the data below the LoQ are an approximate illustration of censored data jittered around half of the LoQ. “Sum PFAS 4” is the sum of PFOS, PFOA, PFNA, and PFHxS, and “Sum PFAS” is Σ35PFASs, both excluding censored data.
Figure 2 Concentration distribution of selected PFASs at forebays (FB) and biofilter materials at different depths (D1–D3) and distances from the inlet (L1 and L2). Cross and circle symbols represent censored and quantified data, respectively. Dashed lines represent the LoQ of substances, and the data below the LoQ are an approximate illustration of censored data jittered around half of the LoQ. “Sum PFAS 4” is the sum of PFOS, PFOA, PFNA, and PFHxS, and “Sum PFAS” is Σ35PFASs, both excluding censored data.CC BY · PubMed Central
Figure 3 Comparison of PFAS concentrations before and after the TOP assay and the quantifiable increased concentrations after TOP assay at some selected facilities to identify the contribution of unknown precursors.
Figure 3 Comparison of PFAS concentrations before and after the TOP assay and the quantifiable increased concentrations after TOP assay at some selected facilities to identify the contribution of unknown precursors.CC BY · PubMed Central
Figure 4 Type I (left) and type II (right) scaling plots as RDA1 and RDA2, the two most important components of the RDA model. The type I plot illustrates the similarities in the response variables (PFAS concentrations), and type II, the effect and correlation of explanatory (environmental) variables in explaining the response variations. The scores of site observations for biofilter materials at three different sampling depths are shown by symbols and categorized by their corresponding 95% confidence ellipses; the scores of response variables at six different classes are shown by colored names; the effect of explanatory variables is shown by arrows from the centroid.
Figure 4 Type I (left) and type II (right) scaling plots as RDA1 and RDA2, the two most important components of the RDA model. The type I plot illustrates the similarities in the response variables (PFAS concentrations), and type II, the effect and correlation of explanatory (environmental) variables in explaining the response variations. The scores of site observations for biofilter materials at three different sampling depths are shown by symbols and categorized by their corresponding 95% confidence ellipses; the scores of response variables at six different classes are shown by colored names; the effect of explanatory variables is shown by arrows from the centroid.CC BY · PubMed Central

Verification

Claims the paper makes

8 Valid · 0 Not valid · 10 Not checked · 125 Own results and interpretations

94 more claims

Create a free account to see all 143 claims and to verify the 3 references still open.

See all claims — free account
  • Probably not a substantial claim. 9
  • It may state two separate claims as one. 38
  • The quote only partly states this claim. 1

Create a free account to see these claims.

Claims other papers make about this one

Each is checked against this paper’s own text: does it say what the citing paper says it does?

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

Each contradiction between two passages listed here was confirmed by an independent check.

3 of 3

Citations

Cites

Show all 90 references

Cited by

See all 22

Metadata

Authors
Beryani, A., Furén, R., Österlund, H., Tirpak, A., Smith, J., Dorsey, J., Winston, R. J., Viklander, M., & Blecken, G.-T.
Affiliations
  • Luleå University of Technology (SE)
  • The Ohio State University (US)
Corresponding author
Beryani, Ali
Venue
Environmental Science & Technology
Published
2024-07-30
Volume
58
Issue
32
Pages
14518-14529
ISSN
  • 0013-936X (ISSN-L)
  • 1520-5851
OpenAlex
W4401115518
Cited by
22
References
90
Citations by year
2026: 10 · 2025: 11 · 2024: 1
FWCI
2.89
Type
journal article
Language
en
Open access
Locations
  • Environmental Science & Technology (publishedVersion, cc-by)
  • PubMed Central (publishedVersion, cc-by)
  • PubMed (publishedVersion)
  • KTH Publication Database DiVA (KTH Royal Institute of Technology) (submittedVersion, cc-by)
Funders
  • VINNOVA (2016-05176)
  • Naturv?rdsverket (NV-03810-23)
  • Development Fund of the Swedish Construction Industry (13623)
Topics
  • Physical Sciences › Environmental Science › Environmental Chemistry › Per- and polyfluoroalkyl substances research
  • Physical Sciences › Environmental Science › Environmental Engineering › Urban Stormwater Management Solutions
  • Physical Sciences › Environmental Science › Pollution › Pharmaceutical and Antibiotic Environmental Impacts
Keywords
per- and polyfluoroalkyl substances, PFAS precursors, stormwater biofilters, bioretention media, perfluorinated carboxylic acids, PFOS, depth distribution, land use, organic matter, stormwater management
MeSH terms
Environmental Monitoring, Filtration, Fluorocarbons, Water Pollutants, Chemical

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

The claim verdicts this report counts are experimental: their accuracy is not yet measured.

A language model drew the claims from the paper on 2026-10-10, under version 3 of the claim definition (model deepseek-v4.1-flash, prompt extract-v3).

A second model labelled each claim on 2026-10-10 (model jev-1.13-20260917, definition revision gold-guideline-v0.2).

Cited sources are checked with a language model’s help (gpt-6-sol and qwen3.8-omni-flash).

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.