The DOI matches its Crossref record; 29 of the 29 references it cites were found in a registry or an index.
Optimization of mesoporous carbon structures for lithium–sulfur battery applications
Abstract
Mesoporous carbon (MC) with tunable pore sizes (22 nm, 12 nm, 7 nm, and 3 nm) and pore volumes (from 1.3 to 4.8 cm3 g−1) containing sulfur in the pores was studied as a mesoporous carbon–sulfur (MCS) composite electrode for lithium–sulfur (Li–S) batteries. Systematic investigation of these MCS composites reveals that MC with a larger pore volume can hold a higher maximum sulfur loading, but overall the battery performance is very similar for different MCS composites at full sulfur-filling conditions (i.e., the condition at which the sulfur loading approaches the maximum limit set by the pore volume of the individual MC and, therefore, the pores of each MC are fully filled by sulfur). For the same MC, partial sulfur-filling (i.e., the condition at which the sulfur loading is lower than the maximum limit and, therefore, the pores are only partially filled with sulfur) leads to an improved initial discharge capacity and cycle stability, probably because of improved electrical and ionic transport during electrochemical reactions. Based on this understanding, an MCS composite electrode using MC with a large pore volume, partial sulfur filling, and a novel surface modification was designed for Li–S batteries. An initial capacity of ∼1390 mA h g−1 (based on sulfur) and a capacity retention of ∼840 mA h g−1 over 100 cycles at a 0.1 C rate were obtained using MC (22 nm, 4.8 cm3 g−1) with 50 wt% sulfur loading and a commercially available Clevios P (poly(3,4-ethylenedioxythiophene)poly(styrenesulfonate) (PEDT/PSS)) coating.
Overview
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
The claims and statistics of this paper haven’t been checked yet.
Run the check — free, no account needed. It reads the open-access text and checks the sources it cites.
Self-check
Percentages, sums and reported differences re-computed from the paper’s own numbers.
The self-check needs the paper’s full text.
Citations
Cites
A highly ordered nanostructured carbon–sulphur cathode for lithium–sulphur batteries
Ji, X., Lee, K. T., & Nazar, L. F. (2009) · Nature Materials · doi:10.1038/nmat2460 · Cited by 5,988
Synthesis of New, Nanoporous Carbon with Hexagonally Ordered Mesostructure
Jun, S., Joo, S. H., Ryoo, R., Kruk, M., Jaroniec, M., Liu, Z., Ohsuna, T., & Terasaki, O. (2000) · Journal of the American Chemical Society · doi:10.1021/ja002261e · Cited by 2,424
Porous Hollow Carbon@Sulfur Composites for High‐Power Lithium–Sulfur Batteries
Jayaprakash, N., Shen, J., Moganty, S. S., Corona, A., & Archer, L. A. (2011) · Angewandte Chemie International Edition · doi:10.1002/anie.201100637 · Cited by 1,811
On the Surface Chemical Aspects of Very High Energy Density, Rechargeable Li–Sulfur Batteries
Aurbach, D., Pollak, E., Elazari, R., Salitra, G., Kelley, C. S., & Affinito, J. (2009) · Journal of The Electrochemical Society · doi:10.1149/1.3148721 · Cited by 1,443
Stabilizing lithium–sulphur cathodes using polysulphide reservoirs
Ji, X., Evers, S., Black, R., & Nazar, L. F. (2011) · Nature Communications · doi:10.1038/ncomms1293 · Cited by 864
Hierarchically Structured Sulfur/Carbon Nanocomposite Material for High-Energy Lithium Battery
Liang, C., Dudney, N. J., & Howe, J. Y. (2009) · Chemistry of Materials · doi:10.1021/cm902050j · Cited by 862
A Novel Conductive Polymer-Sulfur Composite Cathode Material for Rechargeable Lithium Batteries
Wang, J., Yang, J., Xie, J., & Xu, N. (2002) · Advanced Materials · doi:10.1002/1521-4095(20020704)14:13/14<963::aid-adma963>3.0.co;2-s · Cited by 818
A Lithium/Dissolved Sulfur Battery with an Organic Electrolyte
Rauh, R. D., Abraham, K. M., Pearson, G. F., Surprenant, J. K., & Brummer, S. B. (1979) · Journal of The Electrochemical Society · doi:10.1149/1.2129079 · Cited by 592
Rechargeable Lithium Sulfur Battery
Cheon, S.-E., Ko, K.-S., Cho, J.-H., Kim, S.-W., Chin, E.-Y., & Kim, H.-T. (2003) · Journal of The Electrochemical Society · doi:10.1149/1.1571532 · Cited by 553
The Lithium/Sulfur Rechargeable Cell
Shim, J., Striebel, K. A., & Cairns, E. J. (2002) · Journal of The Electrochemical Society · doi:10.1149/1.1503076 · Cited by 478
Rechargeable Lithium Sulfur Battery
Cheon, S.-E., Ko, K.-S., Cho, J.-H., Kim, S.-W., Chin, E.-Y., & Kim, H.-T. (2003) · Journal of The Electrochemical Society · doi:10.1149/1.1571533 · Cited by 424
Sulfur-graphene composite for rechargeable lithium batteries
Wang, J.-Z., Lu, L., Choucair, M., Stride, J. A., Xu, X., & Liu, H.-K. (2011) · Journal of Power Sources · doi:10.1016/j.jpowsour.2010.09.106 · Cited by 380
Wang, J., Chew, S. Y., Zhao, Z. W., Ashraf, S., Wexler, D., Chen, J., Ng, S. H., Chou, S. L., & Liu, H. K. (2008) · Carbon · doi:10.1016/j.carbon.2007.11.007 · Cited by 371
Yuan, L., Yuan, H., Qiu, X., Chen, L., & Zhu, W. (2009) · Journal of Power Sources · doi:10.1016/j.jpowsour.2008.12.149 · Cited by 369
Sandwich-type functionalized graphene sheet-sulfur nanocomposite for rechargeable lithium batteries
Cao, Y., Li, X., Aksay, I. A., Lemmon, J., Nie, Z., Yang, Z., & Liu, J. (2011) · Physical Chemistry Chemical Physics · doi:10.1039/c0cp02477e · Cited by 356
Self-citationFormation of lithium polysulfides in aprotic media
Rauh, R. D., Shuker, F. S., Marston, J. M., & Brummer, S. B. (1977) · Journal of Inorganic and Nuclear Chemistry · doi:10.1016/0022-1902(77)80198-x · Cited by 338
Improved dischargeability and reversibility of sulfur cathode in a novel ionic liquid electrolyte
Yuan, L. X., Feng, J. K., Ai, X. P., Cao, Y. L., Chen, S. L., & Yang, H. X. (2006) · Electrochemistry Communications · doi:10.1016/j.elecom.2006.02.007 · Cited by 336
Self-citationA Solid Sulfur Cathode for Aqueous Batteries
Peramunage, D., & Licht, S. L. (1993) · Science · doi:10.1126/science.261.5124.1029 · Cited by 285
Synthesis and Electrochemical Performance of Sulfur/Highly Porous Carbon Composites
Lai, C., Gao, X. P., Zhang, B., Yan, T. Y., & Zhou, Z. (2009) · The Journal of Physical Chemistry C · doi:10.1021/jp809473e · Cited by 265
Lithium-sulfur batteries: Problems and solutions
Kolosnitsyn, V. S., & Karaseva, E. V. (2008) · Russian Journal of Electrochemistry · doi:10.1134/s1023193508050029 · Cited by 244
Han, S.-C., Song, M.-S., Lee, H., Kim, H.-S., Ahn, H.-J., & Lee, J.-Y. (2003) · Journal of The Electrochemical Society · doi:10.1149/1.1576766 · Cited by 232
Sun, M., Zhang, S., Jiang, T., Zhang, L., & Yu, J. (2008) · Electrochemistry Communications · doi:10.1016/j.elecom.2008.09.012 · Cited by 224
Zheng, W., Liu, Y. W., Hu, X. G., & Zhang, C. F. (2006) · Electrochimica Acta · doi:10.1016/j.electacta.2005.06.021 · Cited by 205
Chang, D.-R., Lee, S.-H., Kim, S.-W., & Kim, H.-T. (2002) · Journal of Power Sources · doi:10.1016/s0378-7753(02)00418-4 · Cited by 204
New approaches to improve cycle life characteristics of lithium–sulfur cells
JUNG, Y., & KIM, S. (2007) · Electrochemistry Communications · doi:10.1016/j.elecom.2006.09.013 · Cited by 165
Electrochemical properties of lithium–sulfur batteries
Jin, B., Kim, J., & Gu, H.-B. (2003) · Journal of Power Sources · doi:10.1016/s0378-7753(03)00113-7 · Cited by 148
Improvement of cycle property of sulfur electrode for lithium/sulfur battery
Choi, Y., Kim, K.-W., Ahn, H., & Ahn, J. (2007) · Journal of Alloys and Compounds · doi:10.1016/j.jallcom.2006.02.098 · Cited by 141
Cheon, S.-E., Cho, J., Ko, K.-S., et al. (2002) · Journal of The Electrochemical Society · doi:10.1149/1.1511187 · Cited by 123
Preparation and electrochemical characterization of the porous sulfur cathode using a gelatin binder
Sun, J., Huang, Y., Wang, W., et al. (2008) · Electrochemistry Communications · doi:10.1016/j.elecom.2008.04.016 · Cited by 77
Cited by
Rechargeable Lithium–Sulfur Batteries
Manthiram, A., Fu, Y., Chung, S.-H., Zu, C., & Su, Y.-S. (2014) · Chemical Reviews · doi:10.1021/cr500062v · Cited by 4,665
Lithium–Sulfur Batteries: Electrochemistry, Materials, and Prospects
Yin, Y., Xin, S., Guo, Y., & Wan, L. (2013) · Angewandte Chemie International Edition · doi:10.1002/anie.201304762 · Cited by 2,707
Nanostructured sulfur cathodes
Yang, Y., Zheng, G., & Cui, Y. (2013) · Chemical Society Reviews · doi:10.1039/c2cs35256g · Cited by 1,947
More Reliable Lithium‐Sulfur Batteries: Status, Solutions and Prospects
Fang, R., Zhao, S., Sun, Z., Wang, D., Cheng, H., & Li, F. (2017) · Advanced Materials · doi:10.1002/adma.201606823 · Cited by 1,785
Lithium–Sulfur Batteries: Progress and Prospects
Manthiram, A., Chung, S., & Zu, C. (2015) · Advanced Materials · doi:10.1002/adma.201405115 · Cited by 1,620
Metadata
- Authors
- Li, X., Cao, Y., Qi, W., Saraf, L. V., Xiao, J., Nie, Z., Mietek, J., Zhang, J.-G., Schwenzer, B., & Liu, J.
- Venue
- Journal of Materials Chemistry
- Publisher
- Royal Society of Chemistry (RSC)
- Published
- 2011
- Volume
- 21
- Issue
- 41
- Pages
- 16603
- ISSN
- 0959-9428 (ISSN-L)
- 1364-5501
- OpenAlex
- W2022253997
- Cited by
- 454
- References
- 29
- FWCI
- 28.74
- Type
- journal article
- Language
- en
- Open access
- closed
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.