Location Fingerprinting With Bluetooth Low Energy Beacons
The DOI matches its Crossref record; 21 of the 21 references it cites were found in a registry or an index.
Abstract
The complexity of indoor radio propagation has resulted in location-awareness being derived from empirical fingerprinting techniques, where positioning is performed via a previously-constructed radio map, usually of WiFi signals. The recent introduction of the Bluetooth Low Energy (BLE) radio protocol provides new opportunities for indoor location. It supports portable battery-powered beacons that can be easily distributed at low cost, giving it distinct advantages over WiFi. However, its differing use of the radio band brings new challenges too. In this work, we provide a detailed study of BLE fingerprinting using 19 beacons distributed around a ~600 m2testbed to position a consumer device. We demonstrate the high susceptibility of BLE to fast fading, show how to mitigate this, and quantify the true power cost of continuous BLE scanning. We further investigate the choice of key parameters in a BLE positioning system, including beacon density, transmit power, and transmit frequency. We also provide quantitative comparison with WiFi fingerprinting. Our results show advantages to the use of BLE beacons for positioning. For one-shot (push-to-fix) positioning we achieve2), compared to2) and <; 8.5 m for an established WiFi network in the same area.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
In the citing paper
“Because the Wi-Fi APs and BLE beacons share the same frequency range (2.4 GHz) there may be interference problems [15], although: (1) interference problems usually occur when the number of access points is very large, something that did not happen in our case; (2) possible interference problems could be overcome by avoiding certain channels and taking into account the fact that Bluetooth”
From Study on an Indoor Positioning System for Harsh Environments Based on Wi-Fi and Bluetooth Low Energy (2017) · cites this paper as [15]
In the citing paper
“this is simply the consequence of the fact that BLE technology transmits advertisements on these channels to mitigate interference with other devices [15].”
From Study on an Indoor Positioning System for Harsh Environments Based on Wi-Fi and Bluetooth Low Energy (2017) · cites this paper as [15]
Citations
Cites
Survey of Wireless Indoor Positioning Techniques and Systems
Liu, H., Darabi, H., Banerjee, P., & Liu, J. (2007) · IEEE Transactions on Systems, Man and Cybernetics, Part C (Applications and Reviews) · doi:10.1109/tsmcc.2007.905750 · Cited by 4,098 · cited 1×
“Indoor positioning is a mature research field, with many proposed technologies and techniques—comprehensive overviews can be found in [19], [18], [2].”
BackgroundThe Horus WLAN location determination system
Youssef, M., & Agrawala, A. (2005) · Proceedings of the 3rd international conference on Mobile systems, applications, and services · doi:10.1145/1067170.1067193 · Cited by 1,653 · cited 1×
“Here the focus is on radio positioning, specifically using the empirical fingerprinting techniques [3], [15], [17], [22] that avoid the need to model the complex radio propagation environment indoors by patternmatching to a previously surveyed map of radio signal strengths.”
BackgroundA Survey of Indoor Inertial Positioning Systems for Pedestrians
Harle, R. (2013) · IEEE Communications Surveys & Tutorials · doi:10.1109/surv.2012.121912.00075 · Cited by 814 · cited 1×
“fingerprints with other sources to form hybrid systems, many of which are based on the idea of Simultaneous Localization and Mapping (SLAM) [10], [16] being applied to pedestrian dead reckoning [13].”
BackgroundSelf-citationWiFi-SLAM Using G aussian Process Latent Variable Models
Ferris, B., Fox, D., & Lawrence, N. D. (2007) · International Joint Conference on Artificial Intelligence · Cited by 610
Network Time Protocol Version 4: Protocol and Algorithms Specification
Mills, D., Burbank, J., & Kasch, W. (2010) · doi:10.17487/rfc5905 · Cited by 577
A comparative survey of WLAN location fingerprinting methods
Honkavirta, V., Perala, T., Ali-Loytty, S., & Piche, R. (2009) · 2009 6th Workshop on Positioning, Navigation and Communication · doi:10.1109/wpnc.2009.4907834 · Cited by 522
Enhancements to the RADAR User Location and Tracking System
Bahl, V., & Padmanabhan, V. (2000) · Cited by 507
Implementing a sentient computing system
Addlesee, M., Curwen, R., Hodges, S., Newman, J., Steggles, P., Ward, A., & Hopper, A. (2001) · Computer · doi:10.1109/2.940013 · Cited by 490 · cited 1×
“Ground Truth Location: The Active Bat system [1] was available throughout the testbed and was used to provide ground truth position.”
MethodA Survey of Indoor Positioning and Object Locating Systems
Koyuncu, H., & Yang, S. H. (2010) · Cited by 251
COMPASS: A probabilistic indoor positioning system based on 802.11 and digital compasses
King, T., Kopf, S., Haenselmann, T., Lubberger, C., & Effelsberg, W. (2006) · Proceedings of the 1st international workshop on Wireless network testbeds, experimental evaluation & characterization · doi:10.1145/1160987.1160995 · Cited by 223
Research works printed but not linked: 2
- ferris, 0, WiFi-SLAM using Gaussian process latent variable models, Proc 20th IJCAI, 2480
- 2010, Bluetooth Specification Version 4 0
Cited by
Items 901–917 of 917
PyDopplerSim: A Physical-Layer Simulator for Concurrent Transmitter-Receiver Doppler Motion
Delsing, K., & Hopkinson, K. M. (2026) · IEEE National Aerospace and Electronics Conference (NAECON) · doi:10.1109/naecon70028.2026.11675014
“Bluetooth and Bluetooth Low-Energy (BLE) localization approaches rely on beacon advertisements, RSSI, or fingerprinting, while GNSS-based systems provide outdoor self-localization through satellite navigation signals [7]–[11].”
Ekici, M. Y. (2026) · Pamukkale University Journal of Engineering Sciences · doi:10.65206/pajes.2001967
Sarmiento-Rojas, J., Aya-Parra, P.-A., & Perdomo, O. (2026) · IEEE Colombian Conference on Applications of Computational Intelligence (ColCACI) · doi:10.1109/colcaci71483.2026.11691453
“Technologies such as WiFi, Bluetooth Low Energy (BLE), Ultra-Wideband (UWB), and IMU have been used for indoor localization [12], while received signal strength-based methods (RSSI) allow for the creation of radio footprints using low-cost wireless infrastructure [13].”
InfluentialHybrid indoor navigation with BLE RSSI probabilistic homing and vision-assisted guidance
Ray, A., Seal, P., Bucha, K., & Laskar, M. J. (2026) · Discover Robotics · doi:10.1007/s44430-026-00041-5
“The Blue-tooth Low Energy (BLE) beaconing occupies in a practical average ground: the devices are inexpensive, power consumption is low, wearable integration is straightforward, and no pre-generated signal map is needed for directional guidance based on RSSI trend analysis [1, 7].”
Mecamaps : plataforma de localização e geração de rotas indoor utilizando QR Codes
Meneghini, J. V., & Carazzi, V. L. L. (2021) · doi:10.11606/003132187
Gao, X. (2026) · Big Data and Information Analytics · doi:10.3934/bdia.2026013
Regime-Aware Hybrid BLE Fingerprinting for Mobile Robot Localization
Kim, D., & Seo, S.-W. (2026) · IEEE Robotics and Automation Letters · doi:10.1109/lra.2026.3734894
“Most prior BLE studies have focused on smartphone-carrying pedestrians [1]; the mobile-robot setting we target — fixed platform geometry, a wheel-odometry motion prior, and constrained trajectories — has received comparatively little attention.”
Advancing BLE Angle-of-Arrival Estimation with Deep Learning
Martín-Frechina, S., Dura, E., & Torres-Sospedra, J. (2026) · IEEE International Instrumentation and Measurement Technology Conference · doi:10.1109/i2mtc66907.2026.11694644
“This technique involves creating a map of signal strengths from various beacons at known locations and then matching a device’s live BLE readings to this map to estimate its position [7].”
UAV navigation for serving Flexible Manufacturing Systems
Savvakis, P. (2025) · DSpace - NTUA (National Technical University of Athens) · doi:10.26240/heal.ntua.28902
Indoor positioning as a contribution to building occupant modelling
Mashuk, M. S. (2020) · Nottingham ePrints (University of Nottingham)
Cybersecurity system software of Honey IoT devices for educational network attacks
Ткаченко, О. С. (2026) · Central Ukrainian National Technical University Repozitory
Lin, H. (2026) · oURspace (University of Regina) · doi:10.82465/44
Improving BLE-Based Localization in Multipath-Affected Indoor Environments
Jamil, S., Kim, D., & Pyun, J.-Y. (2026) · Sensors · doi:10.3390/s26216767
Review of Bluetooth Low Energy RSS-Based Positioning
Aranda, F. J., Román-Jiménez, J., Álvarez, F. J., & Torres-Sospedra, J. (2026) · Sensors · doi:10.3390/s26216776
Zone-Based Indoor Localization from Incomplete RSSI Fingerprints via Missing Data Marginalization
Winheim, L., Frisch, D., & Hanebeck, U. D. (2026) · International Conference on Information Fusion (FUSION) · doi:10.23919/fusion67272.2026.11726427
“They can easily be deployed in various environments and provide Received Signal Strength Indicator (RSSI) data that can be used for estimating the location of devices [1].”
Wang, X., Bian, X., Wu, H., Tian, T., Hu, N., Cheng, G. H., & Xiaoyan, H. (2026) · Computer Networks · doi:10.1016/j.comnet.2026.112904
Scalable BLE Channel Sounding Localization with Ranging-Assisted PDoAPreprint
Wieme, J., Poorter, E. D., & Hoebeke, J. (2026) · arXiv (Cornell University) · doi:10.48550/arxiv.2611.09451
Metadata
- Authors
- Faragher, R., & Harle, R.
- Affiliations
- University of Cambridge (GB)
- Venue
- IEEE Journal on Selected Areas in Communications
- Published
- 2015-11
- Volume
- 33
- Issue
- 11
- Pages
- 2418-2428
- ISSN
- 0733-8716 (ISSN-L)
- OpenAlex
- W1893431417
- Cited by
- 879
- References
- 21
- Citations by year
- 2026: 39 · 2025: 70 · 2024: 63 · 2023: 63 · 2022: 82 · 2021: 105 · 2020: 114 · 2019: 111 · 2018: 114 · 2017: 76 · 2016: 38 · 2015: 3
- FWCI
- 37.13
- Type
- journal article
- Language
- en
- Open access
- closed
- Locations
- IEEE Journal on Selected Areas in Communications (publishedVersion)
- Topics
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Indoor and Outdoor Localization Technologies
- Physical Sciences › Computer Science › Computer Networks and Communications › Bluetooth and Wireless Communication Technologies
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Optical Wireless Communication Technologies
- Keywords
- Bluetooth Low Energy, location fingerprinting, indoor positioning, radio maps, beacons, fast fading, power consumption, transmission power
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.