Student or educator? Sign up with your school email and get 6 months of Pro free.

The DOI matches its Crossref record; 93 of the 93 references it cites were found in a registry or an index; 26 of the 91 sources its claims cite were checked for support.

Silica Aerogels as a Promising Vehicle for Effective Water Splitting for Hydrogen Production

Open access
Vadanagekar, Apurva, Lapcik, Lubomir, Kvitek, Libor, Lapcikova, Barbora·2025·Molecules

Abstract

This comprehensive review explores silica aerogels and their application in environmental remediation. Due to rapid growth in the consumption of energy and water resources, the purification of contaminated resources for use by humankind should be considered important. The primary objectives of this review are to assess the evolving landscape of silica aerogels, their preparation, and drying techniques, and to discuss the main findings from a wide range of empirical studies and theoretical perspectives. Based on a significant amount of research, this review provides information about aerogels’ capabilities as an adsorbent and catalyst. The analysis spans a variety of contexts for the generation of hydrogen and the degradation of the dyes employed in industry, showing better performance in environmental remediation. The implications of this review point to the need for well-informed policies, innovative synthesis strategies, and ongoing research to harness the full potential for environmental management.

Overview

CoChat Summary

TL;DR

This review argues that silica aerogels are promising materials for environmental remediation and hydrogen production via catalytic or photocatalytic water splitting, owing to their high porosity and surface area. It surveys synthesis and drying methods, electrocatalysis metrics, and dye adsorption, while noting cost, dust, and limited catalyst-loading literature as barriers.

Key findings

  • Silica aerogels have high porosity often above 80 vol% and specific surface area around 100–1000 m²/g; cross-linked pores range from 5 to 100 nm with an average diameter of 20–40 nm. Conventional silica aerogel density is about 0.120 g/cm³; densities below 0.090 g/cm³ are not brittle, while they become brittle at 0.150 g/cm³.
  • In hydrogen generation, a cobalt-based silica aerogel (Co/SAG) nanocomposite showed a hydrogen generation rate surpassing Co/MCM-41 by 41%; TiO₂@SiO₂ composites demonstrated H₂ production rates about three-times greater than P25 TiO₂; Pt/Ru-promoted TiO₂ on mesoporous silica had a surface area of 140.6 m²/g and a hydrogen yield of 4791.43 μmol/h/g TiO₂, reported as 30-times greater than P25 (161 mmol/h/g TiO₂); CP-APTES-HCl silica aerogel produced 1860 mL min⁻¹ g⁻¹ of hydrogen at 298 K.
  • For dye adsorption, hydrophilic silica aerogel (HSA) removed 98% of dyes; mesocellular silica foam pore diameter and pore volume decreased from 9.34 nm and 1.36 cm³ g⁻¹ to 8.03 nm and 0.67 cm³ g⁻¹ after methylene blue adsorption, with surface area decreasing from 585 to 399 m² g⁻¹; laccase with ABTS increased decolorization of Indigo and Alizarin red by 73% and 97%, respectively.
  • Proposed activity descriptors for silica-based aerogels in water splitting include surface area and porosity, hydrophilicity and surface functionalization, electronic band structure, charge carrier dynamics and photocatalytic efficiency, stability and reusability, and metal/oxide doping effects.

Methods

  • Comprehensive narrative review of silica aerogels, their preparation, drying techniques, and applications in environmental remediation, hydrogen generation, and dye degradation; no primary experiments are reported.
  • Synthesizes empirical studies and theoretical perspectives, covering sol–gel chemistry, aging, drying methods, electrocatalysis parameters (overpotential, Tafel slope, current density, Faraday efficiency, turnover frequency, stability), and characterization techniques.
  • No systematic search strategy, inclusion criteria, or meta-analysis is stated in the provided text.

Limitations

  • Stated: existing literature on SiO₂ aerogels for catalyst loading is quite limited; cost remains significantly greater than traditional insulation materials; dust generated during production is difficult to eliminate; viability for sorption systems cannot be determined until dynamic adsorption/desorption under practical working conditions is examined.
  • Stated: all three drying techniques have disadvantages and restrictions; supercritical drying requires high pressure and temperature and raises safety concerns; CO₂ supercritical drying is prolonged.
  • Evident: as a narrative review, it lacks a systematic review protocol and quantitative synthesis; several claims rely on cited studies without detailed methods, and some section headings in the provided text are empty or fragmented.

Model-written summary. Check it against the paper before relying on it.

Integrity signals

Registry

Crossref · 10.3390/molecules30061212

Cites

93 of 93 references verified0 citation errors · 0 not checkable

Statistics

Nothing to recompute.

Figures

Figure 1 Modification of aerogel through the years.
Figure 1 Modification of aerogel through the years.CC BY · PubMed Central
Figure 2 Electron microscope image of highly porous, continuous 3D network structure of aerogel layer (reprinted from S Alwin et al. [3] with permission. Copyright 2020, Spinger nature).
Figure 2 Electron microscope image of highly porous, continuous 3D network structure of aerogel layer (reprinted from S Alwin et al. [3] with permission. Copyright 2020, Spinger nature).CC BY · PubMed Central
Figure 3 The flow chart represents different methods for the removal of dyes.
Figure 3 The flow chart represents different methods for the removal of dyes.CC BY · PubMed Central
Figure 4 Classification of aerogel based on synthesis, drying, appearance, microstructure, as well as chemical structure.
Figure 4 Classification of aerogel based on synthesis, drying, appearance, microstructure, as well as chemical structure.CC BY · PubMed Central
Figure 5 Typical schematic methodology representation for the sol–gel formation based on drying of gel.
Figure 5 Typical schematic methodology representation for the sol–gel formation based on drying of gel.CC BY · PubMed Central
Figure 6 Phase diagram of liquid to convert into gel network (reprinted from Suhail Ahmad, Sameer Ahmad, Javed Nabibaksha Sheikh [11] with permission. Copyright 2023, Elsevier).
Figure 6 Phase diagram of liquid to convert into gel network (reprinted from Suhail Ahmad, Sameer Ahmad, Javed Nabibaksha Sheikh [11] with permission. Copyright 2023, Elsevier).CC BY · PubMed Central
Figure 7 Phase diagram for freeze-drying of water (reprinted from Robert Ettema, Gokhan Kirkil, Steven Daly [40] with permission. Copyright 2009, Elsevier).
Figure 7 Phase diagram for freeze-drying of water (reprinted from Robert Ettema, Gokhan Kirkil, Steven Daly [40] with permission. Copyright 2009, Elsevier).CC BY · PubMed Central
Figure 8 The process of Oswald ripening.
Figure 8 The process of Oswald ripening.CC BY · PubMed Central
Figure 9 Traditional SEM image of Si aerogels alongside a schematic depiction of primary and secondary silica particles (left); (1) neck development process of secondary silica particles and (2) comparative aging rate as a function of time for two mechanisms (a, b) (reprinted from S. Ahmad et al., [11] with permission. Copyright 2023, Elsevier).
Figure 9 Traditional SEM image of Si aerogels alongside a schematic depiction of primary and secondary silica particles (left); (1) neck development process of secondary silica particles and (2) comparative aging rate as a function of time for two mechanisms (a, b) (reprinted from S. Ahmad et al., [11] with permission. Copyright 2023, Elsevier).CC BY · PubMed Central
Scheme 1 Typical schematic representation of silica gel network formation through sol–gel method.
Scheme 1 Typical schematic representation of silica gel network formation through sol–gel method.CC BY · PubMed Central
Scheme 2 The primary mechanism of the network formation in the aerogel with metal.
Scheme 2 The primary mechanism of the network formation in the aerogel with metal.CC BY · PubMed Central
Figure 10 Schematic representation of HER reaction pathways.
Figure 10 Schematic representation of HER reaction pathways.CC BY · PubMed Central
Figure 11 Schematic representation of OER reaction pathways. (The numbers in the pathway represent the reaction in ordered form from 1–4. The different colour arrows, i.e., green represents the reaction occurring for active catalytic sites, whereas the pink colour arrows explains about the electron/proton transfer in the pathways).
Figure 11 Schematic representation of OER reaction pathways. (The numbers in the pathway represent the reaction in ordered form from 1–4. The different colour arrows, i.e., green represents the reaction occurring for active catalytic sites, whereas the pink colour arrows explains about the electron/proton transfer in the pathways).CC BY · PubMed Central

Verification

Claims the paper makes

16 Valid · 6 Not valid · 49 Not checked · 3 Own results and interpretations

11 more claims · 1 with their cited sources checked

Create a free account to see all 74 claims and every source verdict.

See all claims — free account
  • It may state two separate claims as one. 35
  • Probably not a substantial claim. 36
  • The quote only partly states this claim. 1

Create a free account to see these claims.

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

Each contradiction between two passages listed here was confirmed by an independent check.

2 of 2

Cited works that were retracted

Works this paper cites that were later retracted, from the retraction notices publishers deposit. Major when the notice came out before this paper was published.

1 of 1

Citations

Cites

1 retracted

Show all 92 references

Research works printed but not linked: 3

  1. Faez, 2005, The State of Art and Possible New Applications of Nano/Meso Porous Silica Aerogel, Electron. J. Biol., 1, 76
  2. Brinker, C.J., and Scherer, G.W. (2013). Sol-Gel Science: The Physics and Chemistry of Sol-Gel Processing, Academic Press.
  3. Gores, H.J., and Schweiger, H. (2014). Encyclopedia of Applied Electrochemistry, Springer.

Metadata

Authors
Vadanagekar, A., Lapcik, L., Kvitek, L., & Lapcikova, B.
Affiliations
  • Palacký University Olomouc (CZ)
  • Department of Physical Chemistry, Faculty of Science, Palacky University in Olomouc, Listopadu 12, 771 46 Olomouc, Czech Republic
Venue
Molecules
Publisher
MDPI AG
Published
2025-03-08
Volume
30
Issue
6
Pages
1212
ISSN
1420-3049 (ISSN-L)
OpenAlex
W4408296865
Cited by
4
References
92
Citations by year
2026: 3 · 2025: 1
FWCI
0.35
Type
journal article
Language
en
Open access
Locations
  • Molecules (publishedVersion, cc-by)
  • PubMed Central (publishedVersion, cc-by)
  • PubMed (publishedVersion)
  • DOAJ (DOAJ: Directory of Open Access Journals) (submittedVersion, cc-by-sa)
Funders
  • Internal Student Grant Agency of the Palacký University in Olomouc, Czech Republic and Fischer Scholarship (ASV) (IGA_PrF_2025_022, NW25-08-00288)
  • Czech Health Research Council (AZV), Ministry of Health of the Czech Republic (IGA_PrF_2025_022, NW25-08-00288)
Topics
  • Physical Sciences › Materials Science › Materials Chemistry › Aerogels and thermal insulation
  • Physical Sciences › Materials Science › Materials Chemistry › Mesoporous Materials and Catalysis
  • Physical Sciences › Energy › Renewable Energy, Sustainability and the Environment › Advanced Photocatalysis Techniques
Keywords
silica aerogel, water splitting, hydrogen production, environmental remediation, adsorbents, catalysts, dye degradation, aerogel synthesis, drying methods, water purification

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

The claim verdicts this report counts are experimental: their accuracy is not yet measured.

A language model drew the claims from the paper on 2026-10-11, under version 3 of the claim definition (model deepseek-v4.1-flash, prompt extract-v3).

A second model labelled each claim on 2026-10-11 (model jev-1.13-20260917, definition revision gold-guideline-v0.2).

Cited sources are checked with a language model’s help (gpt-6-sol).

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

How to cite

Cite CoChat for the checks on this page, and the paper for its own findings.

This page
CoChat. (2026). Citation check: Silica Aerogels as a Promising Vehicle for Effective Water Splitting for Hydrogen Production. https://app.cochat.ai/papers/10.3390/molecules30061212
The paper
Vadanagekar, A., Lapcik, L., Kvitek, L., & Lapcikova, B. (2025). Silica Aerogels as a Promising Vehicle for Effective Water Splitting for Hydrogen Production. Molecules. https://doi.org/10.3390/molecules30061212

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.