CoChat

Laser ablation of a platinum target in water. II. Ablation rate and nanoparticle size distributions

Nichols, William T., Sasaki, Takeshi, Koshizaki, Naoto · 2006 · Journal of Applied Physics

The DOI matches its Crossref record; 27 of the 27 references it cites were found in a registry or an index.

Abstract

This is the second in a series of three papers examining nanomaterial formation in laser ablation in liquids (LAL). Here we study the effect of the laser wavelength and fluence on the mass yield and size distribution of nanoparticles prepared by laser ablation of a platinum target immersed in water. For all wavelengths tested, laser fluences in the range of 10–70J∕cm2 resulted in spheroidal, nonagglomerated platinum nanoparticles with sizes ranging from 1to30nm. Nanoparticle size distributions are found to be composed of two modes that are attributed to thermal vaporization and explosive boiling mechanisms. The peak of the smaller size mode remains nearly constant at 3nm for all laser conditions, which is suggested to be due to the strong confinement of the vapor plume by the liquid. The larger size mode peaks in the range of 5–15nm with a population that is strongly dependent on the laser parameters. It is concluded that changes in the mean size reported in many earlier studies on LAL of metal targets are a result of the relative quantity of nanoparticles from each mechanism rather than direct control over the ablation process. Additionally, it was observed that the yield of platinum nanoparticles was significantly larger for 1064nm wavelength at fluences greater than 10J∕cm2. The maximum ablation rate was approximately 4.4mg∕h, with an estimated ablation and collection efficiency of 0.9μg∕J. Dependence of the mass yield on wavelength and fluence is seen to be dependent primarily on the extent of the explosive mechanism.

Overview

Integrity signals

Registry

Crossref · 10.1063/1.2390641

Cites

27 of 27 references verified0 citation errors · 0 not checkable

Statistics

Recomputing p-values needs the paper’s full text.

Verification

Claims the paper makes

This paper’s full text isn’t openly available, so its claims and self-check weren’t run. The registry and citation checks still apply.

Claims other papers make about this one

Each is checked against this paper’s own text: does it say what the citing paper says it does?

Citations

Cites

Show all 27 references

Cited by

Metadata

Authors
Nichols, W. T., Sasaki, T., & Koshizaki, N.
Affiliations
National Institute of Advanced Industrial Science and Technology (JP)
Venue
Journal of Applied Physics
Published
2006-12-01
Volume
100
Issue
11
ISSN
  • 0021-8979 (ISSN-L)
  • 1089-7550
OpenAlex
W2003525881
Cited by
122
References
27
Citations by year
2026: 1 · 2025: 6 · 2024: 4 · 2023: 9 · 2022: 6 · 2021: 6 · 2020: 6 · 2019: 4 · 2018: 3 · 2017: 6 · 2016: 8 · 2015: 10 · 2014: 5 · 2013: 5 · 2012: 13
FWCI
2.30
Type
journal article
Language
en
Open access
closed
Locations
Journal of Applied Physics (publishedVersion)
Funders
Japan Society for the Promotion of Science
Topics
  • Physical Sciences › Materials Science › Materials Chemistry › Laser-Ablation Synthesis of Nanoparticles
  • Physical Sciences › Chemistry › Spectroscopy › Laser-induced spectroscopy and plasma
  • Physical Sciences › Engineering › Industrial and Manufacturing Engineering › Laser Material Processing Techniques
Keywords
laser ablation in liquid, platinum nanoparticles, nanoparticle size distribution, ablation rate, laser wavelength dependence, laser fluence, thermal vaporization, explosive boiling, mass yield, ablation efficiency

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.