Transient Thermal Performance of IGBT Power Modules Attached by Low-Temperature Sintered Nanosilver
The DOI matches its Crossref record; 19 of the 20 references it cites were found in a registry or an index.
Abstract
Recently, to accurately study the transient thermal behavior of power modules, a transient thermal measurement system was developed to investigate the transient thermal behavior of insulated-gate bipolar transistor (IGBT) modules attached by nanosilver paste and two kinds of lead-free solders. We found that the transient thermal impedance of IGBT modules attached by nanosilver paste was 9% lower than that of the modules using SAC305 and SN100C with 40-ms heating pulse. In addition, finite-element analysis is employed to simulate thermal performance of the IGBT devices. The simulation shows that the transient thermal impedance of IGBT modules attached by nanosilver paste was also lower than that of the modules using lead-free solders. A convenient way was introduced to well predict the transient thermal behavior of IGBT power module. The calculated results agreed well with the measured one. The interface thermal impedance of sintered nanosilver and SNC100C are calculated to be 0.011 ~ 0.031 K/W and 0.022 ~ 0.042 K/W, respectively.
Overview
Integrity signals
Registry
Cites
Statistics
Verification
Claims the paper makes
Claims other papers make about this one
Each is checked against this paper’s own text: does it say what the citing paper says it does?
In the citing paper
“Silver-sintered joints provide excellent electrical/thermal conductivity and high-temperature stability but face electromigration (EM) and cost challenges [2,30-35].”
From Thermal Management of Wide-Bandgap Power Semiconductors: Strategies and Challenges in SiC and GaN Power Devices (2025) · cites this paper as [32]
In the citing paper
“IMC growth is often accelerated by microstructural defects at the solder interface (e.g., grain boundaries, oxides, interfacial roughness), which act as heterogeneous nucleation sites; in addition, unbalanced Cu/Sn interdiffusion can induce Kirkendall voiding, degrading thermo-mechanical integrity over life [30,32].”
From Thermal Management of Wide-Bandgap Power Semiconductors: Strategies and Challenges in SiC and GaN Power Devices (2025) · cites this paper as [32]
In the citing paper
“IMC growth is often accelerated by microstructural defects at the solder interface (e.g., grain boundaries, oxides, interfacial roughness), which act as heterogeneous nucleation sites; in addition, unbalanced Cu/Sn interdiffusion can induce Kirkendall voiding, degrading thermo-mechanical integrity over life [30,32].”
From Thermal Management of Wide-Bandgap Power Semiconductors: Strategies and Challenges in SiC and GaN Power Devices (2025) · cites this paper as [32]
Citations
Cites
Physics of Semiconductor Devices
(2002) · Kluwer Academic Publishers eBooks · doi:10.1007/b117561 · Cited by 13,963
Physics of Semiconductor Devices: Proceedings of the Fourth International Workshop
JAIN, S. C., & RADHAKRISHNA, S. (1987) · Physics of Semiconductor Devices · doi:10.1142/9789814542012 · Cited by 4,151
Fundamentals of Power Semiconductor Devices
Baliga, B. J. (2008) · Springer eBooks · doi:10.1007/978-0-387-47314-7 · Cited by 2,174
Bai, J. G., Zhang, Z. Z., Calata, J. N., & Lu, G.-Q. (2006) · IEEE Transactions on Components and Packaging Technologies · doi:10.1109/tcapt.2005.853167 · Cited by 375
Self-citationLow-Temperature Sintering with Nano-Silver Paste in Die-Attached Interconnection
Wang, T., Chen, X., Lu, G.-Q., & Lei, G.-Y. (2007) · Journal of Electronic Materials · doi:10.1007/s11664-007-0230-5 · Cited by 345
Self-citationBai, J. G., & Lu, G.-Q. (2006) · IEEE Transactions on Device and Materials Reliability · doi:10.1109/tdmr.2006.882196 · Cited by 214
Self-citationLu, G., Calata, J. N., Zhang, Z., & Bai, J. G. (2004) · International Symposium on High Density packaging and Microsystem Integration · doi:10.1109/hpd.2004.1346671 · Cited by 93
Self-citationPower Electronics Cooling Effectiveness Versus Thermal Inertia
Meysenc, L., Jylhakallio, M., & Barbosa, P. (2005) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2005.846548 · Cited by 64
Important properties of transient thermal impedance for MOS-gated power semiconductors
Jakopovic, Z., Benčić, Z., & Kolonić, F. (2003) · IEEE International Symposium on Industrial Electronics (ISIE) · doi:10.1109/isie.1999.798675 · Cited by 40
Shaw, M. C., Waldrop, J. R., Chandrasekaran, S., Kagalwala, B., Jing, X., Brown, E. R., Dhir, V. J., & Fabbeo, M. (2003) · ITherm 2002. Eighth Intersociety Conference on Thermal and Thermomechanical Phenomena in Electronic Systems (Cat. No.02CH37258) · doi:10.1109/itherm.2002.1012567 · Cited by 39
Thermomechanical reliability of low-temperature sintered silver die-attachment
Bai, J. G., Calata, J. N., Lei, G., & Lu, G. (2006) · I-THERM :/I-THERM - Intersociety Conference on Thermal Phenomena in Electronic Systems · doi:10.1109/itherm.2006.1645471 · Cited by 34
Self-citationReliability of High-Power Light Emitting Diode Attached With Different Thermal Interface Materials
Li, X., Chen, X., & Lu, G. (2010) · Journal of Electronic Packaging · doi:10.1115/1.4002299 · Cited by 33
Self-citationIntegrated Circuit Characteristics at 260°C for Aircraft Engine-Control Applications
Palkuti, L. J., Prince, J. L., & Glista, A. S. (1979) · IEEE Transactions on Components Hybrids and Manufacturing Technology · doi:10.1109/tchmt.1979.1135474 · Cited by 30
High temperature electronics application in well logging
Traeger, R. K., & Lysne, P. C. (1988) · IEEE Transactions on Nuclear Science · doi:10.1109/23.12845 · Cited by 29
Improved thermal performance of high-power LED by using low-temperature sintered chip attachment
Wang, T., Lei, G., Chen, X., Guido, L. J., Ngo, K. D. T., & Lu, G.-Q. (2009) · International Conference on Electronic Packaging Technology (ICEPT) · doi:10.1109/icept.2009.5270684 · Cited by 15
Self-citationInvestigations on assembling of electronic packages onto glass substrates using lead-free technology
Plotog, I., Codreanu, N., Svasta, P. M., Cucu, T. C., Turcu, C., Vărzaru, G., Lazar, G., & Batuca, A. (2008) · International Spring Seminar on Electronics Technology · doi:10.1109/isse.2008.5276639 · Cited by 13
Wiley, J. D., & Dening, D. C. (1988) · Proceedings of the ... American Control Conference/Proceedings of the American Control Conference · doi:10.23919/acc.1988.4790025 · Cited by 5
Thermally Induced Delamination Buckling of a Thin Metal Layer on a Ceramic Substrate
Liu, C. J., Ernst, L. J., Wisse, G., Zhang, G. Q., & Vervoort, M. (2003) · Journal of Electronic Packaging · doi:10.1115/1.1604152 · Cited by 4
Thermal Resistance Analysis of a Multi-Stack Flip Chip 3-D Package
Chan, Y. S., & Lee, S. W. R. (2006) · International Conference on Electronic Materials and Packaging · doi:10.1109/emap.2006.4430581 · Cited by 3
Research works printed but not linked: 2
- zarebski, 1993, Thermal transients in bipolar transistors: Measurements and simulations, Malta Proc Int Conf Inf Syst Methods Appl Eng Probl, 111
- mantooth, 2006, Emerging capabilities in electronics technologies for extreme environments. Part I—High temperature electronics, IEEE Power Electron Soc Newsl, 18, 9
Cited by
Joining of Silver Nanomaterials at Low Temperatures: Processes, Properties, and Applications
Peng, P., Hu, A., Gerlich, A. P., Zou, G., Liu, L., & Zhou, Y. N. (2015) · ACS Applied Materials & Interfaces · doi:10.1021/acsami.5b02134 · Cited by 364
Thermal Management on IGBT Power Electronic Devices and Modules
Qian, C., Gheitaghy, A. M., Fan, J., Tang, H., Sun, B., Ye, H., & Zhang, G. (2018) · IEEE Access · doi:10.1109/access.2018.2793300 · Cited by 342
Ji, B., Pickert, V., Cao, W., & Zahawi, B. (2013) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2013.2251358 · Cited by 329
Ji, B., Song, X., Sciberras, E. A., Cao, W., Hu, Y., & Pickert, V. (2014) · IEEE Transactions on Power Electronics · doi:10.1109/tpel.2014.2365531 · Cited by 160
A Temperature-Dependent Thermal Model of IGBT Modules Suitable for Circuit-Level Simulations
Wu, R., Wang, H., Pedersen, K. B., Ma, K., Ghimire, P., Iannuzzo, F., & Blaabjerg, F. (2016) · IEEE Transactions on Industry Applications · doi:10.1109/tia.2016.2540614 · Cited by 125
Metadata
- Authors
- Chen, G., Han, D., Mei, Y.-H., Cao, X., Wang, T., Chen, X., & Lu, G.-Q.
- Affiliations
- Tianjin University (CN)
- Virginia Tech (US)
- Venue
- IEEE Transactions on Device and Materials Reliability
- Published
- 2012-03
- Volume
- 12
- Issue
- 1
- Pages
- 124-132
- ISSN
- 1530-4388 (ISSN-L)
- 1558-2574
- OpenAlex
- W2091469028
- Cited by
- 71
- References
- 20
- Citations by year
- 2026: 1 · 2025: 4 · 2024: 3 · 2023: 4 · 2022: 6 · 2021: 1 · 2020: 2 · 2019: 6 · 2018: 5 · 2017: 4 · 2016: 7 · 2015: 7 · 2014: 11 · 2013: 8 · 2012: 2
- FWCI
- 4.70
- Type
- journal article
- Language
- en
- Open access
- closed
- Locations
- IEEE Transactions on Device and Materials Reliability (publishedVersion)
- Topics
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Electronic Packaging and Soldering Technologies
- Physical Sciences › Engineering › Electrical and Electronic Engineering › Silicon Carbide Semiconductor Technologies
- Physical Sciences › Materials Science › Materials Chemistry › Thermal properties of materials
- Keywords
- IGBT modules, transient thermal impedance, low-temperature soldering, lead-free solder, SAC305, interfacial thermal resistance, power electronics thermal management
About these checks
Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.
Statistics and arithmetic are recomputed, not judged.
Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.
What counts as a claim ›How we measure confidence ›How we check this ›
Are you an author, or do you see a problem with this page? Request a review
Data sources
Bibliographic data: Semantic Scholar, OpenAlex, Crossref.
Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).
Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.