Student or educator? Sign up with your school email and get 6 months of Pro free.
CoChat

The DOI matches its Crossref record; 129 of the 143 references it cites were found in a registry or an index; 36 of the 157 sources its claims cite were checked for support.

Silage review: Factors affecting dry matter and quality losses in silages

Open access
Borreani, G., Tabacco, E., Schmidt, R.J., Holmes, B.J., Muck, R.E. · 2018 · Journal of Dairy Science

Abstract

An overview was made of dry matter (DM) and quality losses that occur during the ensiling process from the field through the feeding phase. The aim was to review the relevant published literature of the last 15 yr focusing on developments achieved after the publication of the book Silage Science and Technology. This review discusses the factors affecting DM and quality losses in terms of field and pre-ensiling conditions, respiration and temperature at ensiling, fermentation patterns, methods of covering and weighting the silage cover, and management of aerobic deterioration. The possibility of reducing DM and quality losses during the ensiling process requires knowledge of how to measure losses on farm and establish the status of the silage during the feed-out phase, implementing the most effective management practices to avoid air exposure during conservation and reduce silage aerobic deterioration during feeding. The paper concludes with future perspectives and recommended management practices to reduce losses and increase efficiency over the whole ensiling process in view of increasing sustainability of the livestock production chain.

Overview

CoChat Summary

TL;DR

This review synthesizes factors causing dry matter (DM) and quality losses across the entire ensiling process, from field wilting through feed-out, with emphasis on respiration, fermentation, covering, density, additives, and aerobic deterioration. It concludes that most losses can be reduced through integrated management, especially rapid sealing, high density, effective oxygen barriers, and adequate feed-out rates.

Key findings

  • Aerobic deterioration during feed-out can involve up to 20% of total stored DM, with losses reaching 70% in peripheral areas near bunker sidewalls; when mold counts exceed 5 log10 cfu/g, DM losses are greater than 20%, and above 6 log10 cfu/g losses can exceed 40% of original ensiled DM.
  • Covering is critical: in bunker silos, uncovered silage lost 78.8% (alfalfa), 80.4% (corn), and 77.0% (sorghum) DM in the top 25 cm, whereas polyethylene cover reduced these losses to 7.2, 22.5, and 21.3%, respectively; in a 1,000-tonne horizontal silo, more than 25% of initial mass is within the top meter.
  • Recommended management targets include a minimum average bulk density of 705 kg/m3 to limit porosity to ≤0.4, and feed-out rates above 1.10 m/wk in winter and 1.75 m/wk in summer to keep moldy surface below 2% in northern Italy corn silage.
  • Additives can help: a meta-analysis found aerobic stability in corn silage increased from 25 h (untreated) to 35 h with *Lactobacillus buchneri* at ≤10^5 cfu/g and 503 h at >10^5 cfu/g, though *L. buchneri* reduced DM recovery by about 1 percentage point; homofermentative inoculants improved DM recovery by 6 percentage points in studies where recovery was affected, and by an average of 2.8 percentage points in temperate and tropical grass silages but not in corn or sorghum.

Methods

  • Narrative review of published literature from the last 15 years, focusing on developments after the book *Silage Science and Technology*.
  • Synthesizes field-scale, pilot-scale, and laboratory studies on field and pre-ensiling conditions, respiration and temperature, fermentation patterns, covering and weighting, aerobic deterioration, loss measurement, additives, plastic films, and feed-out management.
  • Main analysis is qualitative synthesis with selected quantitative summaries, tables, figures, and regression relationships drawn from cited studies; no new experimental data are reported.

Limitations

  • The paper states that further study is needed to understand microbial dynamics before and during ensiling, and notes considerable variation in results by location.
  • It also states that silage density measurement at farm scale is difficult, with no known accurate means during filling, and that feed-out face probing is time-consuming and dangerous.
  • Evident from the text: this is a narrative review rather than a systematic meta-analysis, and several management effects (e.g., weighting, film joints, additive success) are described as based on limited or anecdotal evidence or as inconsistent across trials.

Model-written summary. Check it against the paper before relying on it.

Integrity signals

Registry

Crossref · 10.3168/jds.2017-13837

Cites

129 of 129 references verified0 citation errors · 0 not checkable

Statistics

Nothing to recompute.

Verification

Claims the paper makes

30 Valid · 2 Not valid · 95 Not checked · 24 Own results and interpretations

67 more claims · 10 with their cited sources checked

Create a free account to see all 151 claims and to verify the 2 references still open.

See all claims — free account
  • It may state two separate claims as one. 66
  • Probably not a substantial claim. 17
  • The quote only partly states this claim. 1

Create a free account to see these claims.

Claims other papers make about this one

Each is checked against this paper’s own text: does it say what the citing paper says it does?

Citations

Cites

Show all 143 references

Research works printed but not linked: 15

  1. Anonymous, 1953, Packaged silage: Will plastics replace silos?, New Jersey Agric., 35, 4
  2. Ashbell, 1991, A simple system to study the aerobic deterioration of silages, Can. Agric. Eng., 33, 171
  3. Berger, L. L., and K. K. Bolsen. 2006. Sealing strategies for bunker silos and drive-over piles. Pages 1–18 in Proc. Silage for Dairy Farms: Growing, Harvesting, Storing, and Feeding. NRAES 181. Ithaca, NY.
  4. Bolsen, K. K. 2006. Silage management: common problems and their solution. Pages 83–93 in Tri-State Dairy Nutrition Conference, Wayne, IN.
  5. Cassinis, 1993, Analisi di insilati per foraggiamento mediante termografia (Forage silage analysis by infrared thermography), Inf. Agric., 49, 67
  6. Clark, 2008, Feedout losses from forage storage systems, Focus on Forage, 4, 1
  7. Clemente, G., J. L. Monge, F. M. Clemente, and K. D. Cervigni. 2015. Use of thermographic images for evaluation of superficial and subsurface temperature in the exposed area of corn silos. Pages 308–309 in Proc. 17th Int. Silage Conf., Piracicaba, São Paulo, Brazil.
  8. Collombier, J., E. Daburon, Y. Gallard, and B. Bailhache. 2001. Utilization of infrared thermography for visualizing aerobic deteriorations of maize silage and efficacy of a silage inoculant. In Proc. 8th Rencontres Autour des Recherches sur les Ruminants, Paris, France.
  9. Hoffman, 1997, Quantification of milk yield losses associated with feeding aerobically unstable high moisture corn, J. Dairy Sci., 80, 234
  10. Honig, H., G. Pahlow, and J. Thaysen. 1999. Aerobic instability–Effects and possibilities for its prevention. Pages 288–289 in Proc. 12th Int. Silage Conf., Uppsala, Sweden.
  11. Lättamäe, 2012, Effect of a silo sealing system based on an oxygen barrier film on composition and losses from the upper layer of grass/clover crops ensiled in farm-scale silos, Agraarteadus (Tartu), 23, 43
  12. Nutcher, K., R. Salacci, C. P. Kuber, R. Kuber, M. E. Uriarte, and K. K. Bolsen. 2015. Effects of sealing time post-filling and sealing material on fermentation, nutritional quality, and organic matter loss of whole-plant maize ensiled in a drive-over pile. Pages 320–321 in Proc. 17th Int. Silage Conf., Piracicaba, São Paulo, Brazil.
  13. Rankin, 2000, Rain damage to forage during hay and silage making, Focus on Forage, 2, 1
  14. Visser, B. 2005. Forage density and fermentation variation: A survey of bunkers, piles, and bags across Minnesota and Wisconsin dairy farms. Pages 233–240 in Proc. Four State Dairy Nutrition and Management Conf., MWPS-4SD18, Dubuque, IA.
  15. Windle, 2013, The effect of a feed additive on the feeding value of a silage-based TMR exposed to air, J. Dairy Sci., 91, 16

Cited by

See all 802

Metadata

Authors
Borreani, G., Tabacco, E., Schmidt, R. J., Holmes, B. J., & Muck, R. E.
Affiliations
  • University of Turin (IT)
  • University of Wisconsin–Madison (US)
  • Agricultural Research Service (US)
Corresponding author
Borreani, G.
Venue
Journal of Dairy Science
Published
2018-05
Volume
101
Issue
5
Pages
3952-3979
ISSN
0022-0302 (ISSN-L)
OpenAlex
W2800294979
Cited by
802
References
143
Citations by year
2026: 97 · 2025: 106 · 2024: 121 · 2023: 122 · 2022: 117 · 2021: 87 · 2020: 91 · 2019: 53 · 2018: 8
FWCI
9.03
Type
journal article
Language
en
Open access
Licence
www.elsevier.com/tdm/userlicense/1.0/ (tdm)
Locations
  • Journal of Dairy Science (publishedVersion)
  • PubMed (publishedVersion)
  • Institutional Research Information System University of Turin (University of Turin) (submittedVersion, other-oa)
Topics
  • Life Sciences › Agricultural and Biological Sciences › Animal Science and Zoology › Ruminant Nutrition and Digestive Physiology
  • Physical Sciences › Engineering › Mechanical Engineering › Agricultural Engineering and Mechanization
  • Life Sciences › Agricultural and Biological Sciences › Plant Science › Mycotoxins in Agriculture and Food
Keywords
silage, dry matter loss, silage quality, silage fermentation, aerobic deterioration, forage preservation, sustainable livestock production
MeSH terms
Animals, Animal Feed, Fermentation, Food Handling, Humans, Silage

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

The claim verdicts this report counts are experimental: their accuracy is not yet measured.

A language model drew the claims from the paper on 2026-10-10, under version 3 of the claim definition (model deepseek-v4.1-flash, prompt extract-v3).

A second model labelled each claim on 2026-10-10 (model jev-1.13-20260917, definition revision gold-guideline-v0.2).

Cited sources are checked with a language model’s help (gpt-6-sol).

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

How to cite

Cite CoChat for the checks on this page, and the paper for its own findings.

This page
CoChat. (2026). Citation check: Silage review: Factors affecting dry matter and quality losses in silages. https://app.cochat.ai/papers/10.3168/jds.2017-13837
The paper
Borreani, G., Tabacco, E., Schmidt, R. J., Holmes, B. J., & Muck, R. E. (2018). Silage review: Factors affecting dry matter and quality losses in silages. Journal of Dairy Science. https://doi.org/10.3168/jds.2017-13837

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.