CoChat

Towards Biochar and Hydrochar Engineering—Influence of Process Conditions on Surface Physical and Chemical Properties, Thermal Stability, Nutrient Availability, Toxicity and Wettability

Open access

The DOI matches its Crossref record; 70 of the 70 references it cites were found in a registry or an index.

Abstract

The impact of conversion process parameters in pyrolysis (maximum temperature, inert gas flow rate) and hydrothermal carbonization (maximum temperature, residence time and post-washing) on biochar and hydrochar properties is investigated. Pine wood (PW) and corn digestate (CD), with low and high inorganic species content respectively, are used as feedstock. CD biochars show lower H/C ratios, thermal recalcitrance and total specific surface area than PW biochars, but higher mesoporosity. CD and PW biochars present higher naphthalene and phenanthrene contents, respectively, which may indicate different reaction pathways. High temperatures (>500 °C) lead to lower PAH (polycyclic aromatic hydrocarbons) content (<12 mg/kg) and higher specific surface area. With increasing process severity the biochars carbon content is also enhanced, as well as the thermal stability. High inert gas flow rates increase the microporosity and wettability of biochars. In hydrochars the high inorganic content favor decarboxylation over dehydration reactions. Hydrochars show mainly mesoporosity, with a higher pore volume but generally lower specific surface area than biochars. Biochars present negligible availability of NO 3 − and NH 4 + , irrespective of the nitrogen content of the feedstock. For hydrochars, a potential increase in availability of NO 3 − , NH 4 + , PO 4 3 − , and K + with respect to the feedstock is possible. The results from this work can be applied to “engineer” appropriate biochars with respect to soil demands and certification requirements.

Overview

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Integrity signals

Registry

Crossref · 10.3390/en11030496

Cites

70 of 70 references verified0 citation errors · 0 not checkable

Statistics

Figures

Figure 1 Left : Van Krevelen diagram, i.e., H/C molar ratio versus O/C molar ratio of PW and CD biochars and hydrochars. Right : H/C and O/C molar ratios versus volatiles content (% mass, daf) for PWand CD biochars and hydrochars.
Figure 1 Left : Van Krevelen diagram, i.e., H/C molar ratio versus O/C molar ratio of PW and CD biochars and hydrochars. Right : H/C and O/C molar ratios versus volatiles content (% mass, daf) for PWand CD biochars and hydrochars.CC-BY · From the PDF
Figure 2 pH versus ash (% mass, db) in ( a , b ), H/C molar ratio in ( c , d ) and O/C molar ratio in ( e , f ) for CD (left) and PW (right) biochars and hydrochars. The strength of the correlations is indicated with the Pearson correlation coefficient (r).
Figure 2 pH versus ash (% mass, db) in ( a , b ), H/C molar ratio in ( c , d ) and O/C molar ratio in ( e , f ) for CD (left) and PW (right) biochars and hydrochars. The strength of the correlations is indicated with the Pearson correlation coefficient (r).CC-BY · From the PDF
Figure 3 Surface oxygen-containing functional groups of the biochars determined with the Boehm titration method. ( a , b ) show the amount of functional groups with respect to the mass of the chars organic fraction versus the O/C and H/C molar ratios; ( c ) shows the amount of functional groups with respect to the total chars mass versus the H/C molar ratio; ( d ) shows the amount of functional groups versus the pH.
Figure 3 Surface oxygen-containing functional groups of the biochars determined with the Boehm titration method. ( a , b ) show the amount of functional groups with respect to the mass of the chars organic fraction versus the O/C and H/C molar ratios; ( c ) shows the amount of functional groups with respect to the total chars mass versus the H/C molar ratio; ( d ) shows the amount of functional groups versus the pH.CC-BY · From the PDF
Figure 4 ( a ): Total specific surface area (SSA) determined with the BET method (N2 adsorption) versus the volatiles content (% mass, daf) for PW and CD biochars and hydrochars; ( b ): SSA determined with the BET method (N2 adsorption) versus H/C molar ratio for PW and CD biochars and hydrochars; ( c ): SSA determined with CO2 adsorption applying the NLDFT method versus H/C molar ratio for PW and CD biochars and hydrochars.
Figure 4 ( a ): Total specific surface area (SSA) determined with the BET method (N2 adsorption) versus the volatiles content (% mass, daf) for PW and CD biochars and hydrochars; ( b ): SSA determined with the BET method (N2 adsorption) versus H/C molar ratio for PW and CD biochars and hydrochars; ( c ): SSA determined with CO2 adsorption applying the NLDFT method versus H/C molar ratio for PW and CD biochars and hydrochars.CC-BY · From the PDF
Figure 5 Pore size distribution (PSD) of PW and CD biochars ( top ) and hydrochars ( bottom ). Top left : SSA distribution with pore size for biochars according to the BET method (for total specific surface area), quenched solid density functional theory (QSDFT, for total specific surface area, surface area due to pores < 2 nm and pores 2 nm < pore size < 34 nm) method, and BJH method (surface area due to pores > 3 nm). Total specific surface area for pores < 1.5 nm determined with CO2 adsorption. Top right : Volume distribution with pore size for biochars. Bottom left : SSA distribution with pore size for hydrochars according to the aforementioned methods. Bottom right : Volume distribution with pore size for hydrochars. CO2 adsorption was not measured for samples PW400-40 and PW240-360.
Figure 5 Pore size distribution (PSD) of PW and CD biochars ( top ) and hydrochars ( bottom ). Top left : SSA distribution with pore size for biochars according to the BET method (for total specific surface area), quenched solid density functional theory (QSDFT, for total specific surface area, surface area due to pores < 2 nm and pores 2 nm < pore size < 34 nm) method, and BJH method (surface area due to pores > 3 nm). Total specific surface area for pores < 1.5 nm determined with CO2 adsorption. Top right : Volume distribution with pore size for biochars. Bottom left : SSA distribution with pore size for hydrochars according to the aforementioned methods. Bottom right : Volume distribution with pore size for hydrochars. CO2 adsorption was not measured for samples PW400-40 and PW240-360.CC-BY · From the PDF
Figure 6 Conversion rate of char oxidation for PW hydrochars ( top left ), CD hydrochars ( top right ), PWand CD biochars ( bottom ).
Figure 6 Conversion rate of char oxidation for PW hydrochars ( top left ), CD hydrochars ( top right ), PWand CD biochars ( bottom ).CC-BY · From the PDF
Figure 7 Top : Total content in PAHs (16 EPA PAHs) for PW and CD biochars. Horizontal lines correspond to the limits of PAHs content for basic (12 mg/kg) and premium (4 mg/kg) class biochars (EBC). Bottom : Content of PAHs species for PW and CD biochars.
Figure 7 Top : Total content in PAHs (16 EPA PAHs) for PW and CD biochars. Horizontal lines correspond to the limits of PAHs content for basic (12 mg/kg) and premium (4 mg/kg) class biochars (EBC). Bottom : Content of PAHs species for PW and CD biochars.CC-BY · From the PDF
Figure 8 Water and hexane absorption curves of PW600-40, PW400-20, CD600-40, CD400-20.
Figure 8 Water and hexane absorption curves of PW600-40, PW400-20, CD600-40, CD400-20.CC-BY · From the PDF
Figure 9 Conclusions. The direction of the arrows indicates increasing values for all properties.
Figure 9 Conclusions. The direction of the arrows indicates increasing values for all properties.CC-BY · From the PDF

Verification

Claims the paper makes

The claims and statistics of this paper haven’t been checked yet.

Free: it reads the open-access text and checks the first 5 claims that cite a source we can check. Create a free account to check every claim.

A few free checks a day · papers already verified open instantly · results are public

Claims other papers make about this one

Each is checked against this paper’s own text: does it say what the citing paper says it does?

Self-check

Percentages, sums and reported differences re-computed from the paper’s own numbers.

The self-check needs the paper’s full text.

Citations

Cites

Research works printed but not linked: 1

  1. Chan, K.Y., and Xu, Z. (2009). Nutrient Properties and Their Enhancement. Biochar for Environmental Management. Science and Technology, Earthscan. Chapter 5.

Cited by

See all 149

Metadata

Authors
Dieguez-Alonso, A., Funke, A., Anca-Couce, A., Rombolà, A., Ojeda, G., Bachmann, J., & Behrendt, F.
Affiliations
  • Technische Universität Berlin (DE)
  • Karlsruhe Institute of Technology (DE)
  • Institute of Thermal Engineering, Graz University of Technology, Inffeldgasse 25b, 8010 Graz, Austria
  • University of Bologna (IT)
  • Centre for Research on Ecology and Forestry Applications (ES)
  • Leibniz University Hannover (DE)
Corresponding author
Dieguez-Alonso, Alba
Venue
Energies
Publisher
MDPI AG
Published
2018-02-27
Volume
11
Issue
3
Pages
496
ISSN
1996-1073 (ISSN-L)
OpenAlex
W2789957287
Cited by
141
References
70
Citations by year
2026: 14 · 2025: 23 · 2024: 15 · 2023: 19 · 2022: 17 · 2021: 16 · 2020: 22 · 2019: 10 · 2018: 4
FWCI
5.20
Type
journal article
Language
en
Open access
Locations
  • Energies (publishedVersion, cc-by)
  • Repository KITopen (Karlsruhe Institute of Technology) (submittedVersion, cc-by)
  • Dipòsit Digital de Documents de la UAB (Universitat Autònoma de Barcelona) (submittedVersion, cc-by)
  • Institutional Repository of Leibniz Universität Hannover (Leibniz Universität Hannover) (submittedVersion, cc-by-nc-nd)
  • RePEc: Research Papers in Economics (submittedVersion)
  • Archivio istituzionale della ricerca (Alma Mater Studiorum Università di Bologna) (submittedVersion)
  • LA Referencia (Red Federada de Repositorios Institucionales de Publicaciones Científicas) (submittedVersion, cc-by)
  • DOAJ (DOAJ: Directory of Open Access Journals) (submittedVersion, cc-by-sa)
  • Leibniz Universität Hannover (cc-by)
  • KITopen (cc-by)
Funders
  • Deutsche Forschungsgemeinschaft
  • Technische Universität Berlin
  • Leibniz-Gemeinschaft
Topics
  • Physical Sciences › Energy › Fuel Technology › Thermochemical Biomass Conversion Processes
  • Life Sciences › Agricultural and Biological Sciences › Soil Science › Soil Carbon and Nitrogen Dynamics
  • Physical Sciences › Environmental Science › Water Science and Technology › Adsorption and biosorption for pollutant removal
Keywords
biochar, hydrochar, pyrolysis, hydrothermal carbonization, pine forest, processing conditions, thermal stability, specific surface area, porosity, polycyclic aromatic hydrocarbons, wettability, nutrient availability, nitrogen availability, inorganic content, decarboxylation, soil amendment

About these checks

Registry, retraction, Cites and statistics results are computed, not judged, with one exception: a printed reference that no index lists is read once by a model before it counts as a citation error. Claims are extracted by a model and kept only when their quote appears verbatim in the text; each cited source is then checked, with a model’s help, for whether it says what the claim relies on. Those verdicts can be wrong — read the claim’s quote and the cited source before relying on one.

Statistics and arithmetic are recomputed, not judged.

Confidence bands are shown only for fields calibrated on our annotated test set. None is calibrated yet, so no band is shown.

What counts as a claim ›How we measure confidence ›How we check this ›

Are you an author, or do you see a problem with this page? Request a review

Data sources

Bibliographic data: Semantic Scholar, OpenAlex, Crossref.

Contains information from the Semantic Scholar Academic Graph Datasets, made available under the ODC Attribution License (ODC-BY 1.0).

Semantic Scholar’s data is described in: Kinney, R., et al. (2023). The Semantic Scholar Open Data Platform. arXiv:2301.10140.